• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.3
• /
• pp.477-482
• /
• 2007

This paper examines and analyzes improvement of structure of bulb, increase of luminous efficiency through application of reflector globe through aluminum coating and development of 60[W] basking neodymium lamp through optimum insertion ratio of krypton gas and nitrogen gas. The results of this development shows that the life of the lamp was 7,200 hours, and the luminous flux was 620[1m]. This brings in superior color temperature and superior color rendering index, which allows us to use that lamp for agricultural or general purpose.

• Analytical Science and Technology
• /
• v.21 no.6
• /
• pp.487-494
• /
• 2008

An experiment was performed for zone refined Re-filament and normal (nonzone refined) Re-filament to reduce the background effect on the measurement of low level uranium samples. From both filaments, the signals which seemed to come from a cluster of light alkali elements, $(^{39}K_6)^+$, $(^{39}K_5+^{41}K)^+$ and $PbO_2$ were identified as the isobaric effect of the uranium isotopes. The isobaric effect signal was completely disappeared by heating the filament about $2000^{\circ}C$ at < $10^{-7}$ torr of vacuum for more than 1.5 hour in zone refined Refilaments, while that from the normal Re-filaments was not disappeared completely and was still remained as 3 pg. of uranium as the impurities after the degassing treatment was performed for more than 5 hours at the same condition of zone refined filaments. A threshold condition eliminating impurities were proved to be at 5 A and 30 minutes of degassing time. The uranium content as an impurity in rhenium filament was checked with a filament degassing treatment using the U-233 spike by isotope dilution mass spectrometry. A 0.31 ng of U was detected in rhenium filament without degassing, while only 3 pg of U was detected with baking treatment at a current of 5.5 A for 1 hr. Using normal Re-filaments for the ultra trace of uranium sample analysis had something problem because uranium remains to be 3 pg on the filament even though degassed for long hours. If the 1 ng uranium were measured, 0.3% error occurred basically. It was also conformed that ionization filament current was recommended not to be increased over 5.5 A to reduce the background. Finally, the contents of uranium isotopes in uranium standard materials (KRISS standard material and NIST standard materials, U-005 and U-030) were measured and compared with certified values. The differences between them showed 0.04% for U-235, 2% for U-234 and 2% for U-236, respectively.

• Analytical Science and Technology
• /
• v.22 no.5
• /
• pp.415-421
• /
• 2009

A study was performed to investigate the isobaric effects of impurities in isotope measurement of gadolinium by TIMS. Especially, the ratio of $^{155}Gd/^{158}Gd$ showed the higher value than that of natural gadolinium and also decreased as the measuring time increased. This phenomenon is considered to be due to the oxide form of La ($LaO^+$, m/z=155) causing to create a serious bias on the measurement of $^{155}Gd$ abundance by La as an impurity, and due to $LaO^+$ produced more than the $Gd^+$ in the early time which disappears as the time goes on because of lower melting point and ionization potential of La than Gd. Although isobaric effects from Ba($BaO^+$), Ce($CeO^+$), Sm($SmO^+$), La($LaO^+$), and $K_4{^+}$(m/z=156)-cluster were detected even when blank rhenium filaments were used, these could be avoided by preconditioning(baking out) the filament. And we found that the measurement of $GdO^+$ instead of $Gd^+$ is more suitable in avoiding the isobaric effect from impurities such as La, Ce and Ba in the measurement of Gd isotope only in case of absence or extremely low level of Yb, Sm, Dy, Er, Lu.