• 한국환경과학회지
• /
• 제17권11호
• /
• pp.1295-1305
• /
• 2008

This study aims at the analyze of unsteady downstream flow due to dam failure along dam failure scenario and applied to Yeoncheon Dam which was collapsed August 1st 1999, using HEC-RAS simulation model. The boundary conditions of this unsteady flow simulation are that dam failure arrival time could be at 02:45 a.m. August 1st 1999 and failure duration time could be also 30 minutes. Downstream 19.5 km from dam site was simulated for unsteady flow analysis in terms of dam failure and non-failure cases. For the parameter calibration, observed data of Jeonkok station were used and roughness coefficient was applied to simulation model. The result of the peak discharge difference was 2,696 to $1,745\;m^3/sec$ along the downstream between dam failure and non-failure and also peak elevation of water level showed meanly 0.6m difference. Those results of these studies show that dam failure scenarios for the unknown failure time and duration were rational because most results were coincident with observed records. And also those results and procedure could suggest how and when dam failure occurs and downstream unsteady flow analyzes.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 A
• /
• pp.204-205
• /
• 2006

This paper describes the protective ability of lightning arrestor in combined distribution system with power cable. To evaluate the protective ability, change of arrestor and grounding location are considered. On the other hand, arrestor developed by Cooper Power Systems for underground power cable system, is considered to evaluate surge protective ability as in underground system, when arrestor occurs failure has overhead line. The result shows that lightning arrestor in combined distribution system with power cable protect effectively when failure at arrestor in overhead line. On the other hand, arrestor developed by Cooper Power Systems for underground power cable system, is considered to evaluate surge protective ability in underground distribution system, when arrestor of overhead line has failure. The result shows that lightning arrestor installed in underground cable can effectively protected cables from surge when arrestor of overhead line has failure. And also even though grounding locations are decreased, it is revealed that protective ability is nearly similar.

• 한국복합재료학회:학술대회논문집
• /
• 한국복합재료학회 2001년도 춘계학술발표대회 논문집
• /
• pp.163-167
• /
• 2001

A two-dimensional progressive failure analysis method is presented for the strength characterization of the composite joints under pin loading. The eight-nodes laminated she]1 element is utilized based on the updated Lagrangian formulation. The criteria by Yamada-Sun, Tsai-Wu, and the maximum stress are used for the failure estimation. The stiffness of failed layer is degraded by the complete unloading method. No factor depending on test is included in the finite element analysis except for the material strength and stiffness. Total 20 plate specimens with and without hole are tested to validate the finite element prediction. The Tsai-Wu failure criterion most conservatively estimates the strength of laminate, and the maximum stress criterion yields the highest strength because it does not consider the coupling of the failure modes. The strength by Yamada-Sun method neglecting the matrix failure effect are located between other two methods and shows best agreement with test result for laminate with hole.

• 한국신뢰성학회지:신뢰성응용연구
• /
• 제4권2호
• /
• pp.121-131
• /
• 2004

HALT (Highly Accelerated Life Test) was performed to improve the reliability by removing the potential failure for newly developing PCB used for the vibration condition from 2OHz to 2OOHz. During HALT, it is found that the lead of Al electrolytic capacitor of SMD type is detached from PCB. As the result for the failure analysis and FEM (Finite Element Method), it is clarified that the root cause for this failure is the improper attachment of an Al electrolytic capacitor on PCB by the mistake of a PCB design. HALT was performed in previous condition to verify the failure analysis after molding an epoxy resin to overcome the PCB design mistake and it is not observed the same failure. Therefore, it is assumed that the same failure in field will be not occurred by the proper implementation.

• 지질공학
• /
• 제27권3호
• /
• pp.267-274
• /
• 2017

암반은 암석재료 자체의 역학적 성질과 암반내에 분포하는 불연속면의 기하학적 특징에 의해 그 역학적 특성이 좌우된다. 암반사면의 경우에는 불연속면에 의해 특히 파괴면의 위치와 파괴후의 거동 등이 달라진다. 본 논문에서는 불연속면의 규모에 따라 암반사면의 파괴형태가 달라지는 점을 고려하여, 원호파괴와 평면파괴 안정해석을 위한 2개의 3D 해석방법을 개발하고 실제 사면에 적용하여 그 적용성을 검토하였다. 결과, 원호파괴의 경우, 자연건조상태에서는 안정하지만 강우에 의해 표층 함수비가 증가하면 불안정해지는 해석 결과를 얻었다. 평면파괴의 경우도 강우에 의해 불연속면 자체의 마찰각이 감소하는 영향에 의해 건조상태보다 불안정해지는 결과가 나타났다. 이상의 해석 결과로부터 실제 사면에서의 현상을 잘 반영하는 것으로 보아, 개발된 해석방법이 사면안정성 검토 또는 유지관리의 목적으로 적용가능하다고 판단된다.

• Clinical and Experimental Pediatrics
• /
• 제50권9호
• /
• pp.841-847
• /
• 2007

Acute liver failure (ALF) is a very rare but devastating illness in children. Specific treatment to recovery is often not available, and the underlying cause of the liver failure is often unknown and diverse especially in children. Liver transplantation has increased the chance of survival; however it needs an optimal timing to reach the best result which is not familiar to pediatrician. This article discusses the current knowledge of the epidemiology, backgrounds and factors to be considered before establishing the treatment of ALF in children.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 봄 학술발표회 논문집
• /
• pp.391-396
• /
• 2003

The concrete corbels consist of various failure mechanisms such as the yielding of the tension reinforcement, the crushing or splitting from compression concrete struts, and localized bearing or shearing failure under the loading plate. However, predicting those failure mechanisms is very difficult. In this study, the ACI 318-02, the softened strut-tie model approach, and the nonlinear strut-tie model approach are applied to ultimate strength analysis of normal strength concrete corbels tested to failure. From the result of the analysis, an effective analysis and design method of normal strength concrete corbels is suggested.

• 한국경영과학회지
• /
• 제27권2호
• /
• pp.1-13
• /
• 2002

In this paper, we compares the business failure prediction accuracy among Linear Programming Discriminant Analysis(LPDA) model, Multivariate Discriminant Analysis (MDA) model and logit analysis model. The Data for 417 companies analyzed were gathered from KIS-FAS Published by Korea Information Service in 1999. The result of comparison for four time horizons shows that LPDA Is advantageous in prediction accuracy over the other two models when over all tilt ratio and business failure accuracy are considered simultaneously.

• 한국추진공학회지
• /
• 제1권1호
• /
• pp.111-121
• /
• 1997

본 연구에서는 탄소/에폭시 복합재료의 기계적 결합부위의 결합강도 예측을 위한 구조해석과 실험을 수행하였다. 복합재료 구조물의 Joint설계에 있어 베어링 파괴는 대단히 중요한 파괴형태 중하나이다. 그래서 본 연구에서는 베어링 파괴를 해석적으로 예측하고 실험적으로 확인하였다. 순수인장 파괴(Net Tension Failure)와 베어링 파괴(Bearing Failure) 실험을 위해서 각각 두 가지 형상의 시편을 선택하였다. 기계적 결합강도 예측에 사용된 방법은 특성길이(Characteristic Length)법과 연관시킨 Yamada-Sun 파괴기준(Failure Criterion)과 Tsai-Hill 최대일 이론이다. 그리고 인장특성길이와 압축특성길이는 실험을 통하여 얻어지며, 특히 압축특성길이 결정은 최근에 착안된 베어링파괴 실험으로부터 결정하였다. 위와 같은 예측 방법을 준등방성(Quasi-Isotropic) Carbon/Epoxy HT245/RS3232에 적용하였다. 연구결과, 이론적인 복합재료 파괴예측이 실험결과와 잘 일치함을 확인할 수 있었다.

• 한국정보기술응용학회:학술대회논문집
• /
• 한국정보기술응용학회 2005년도 6th 2005 International Conference on Computers, Communications and System
• /
• pp.143-146
• /
• 2005

The software reliability growth depends on the testing time because the failure rate varies whether it is long or not. On the other hand, it might be difficult to reduce failure rate for most of the cases are not available for debugging during operational phase, hence, there are some literatures to study that the failure rate is uniform throughout the operational time. The failure rate reduces and the reliability grows with time regardless of debugging. As a result, the products reliability varies with the time duration of these products in point of customer view. The reason of this is that it accumulates the products experience, studies the exact operational method, and then finds and takes action against the fault circumstances. I propose the simple model to represent this status in this paper.