• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.80.2-80.2
• /
• 2011

Fossil fuel was a major energy resource but the consumption of fossil fuel will decrease gradually because of limited deposits and non-environmental features. In contrast, because the renewable energy resources are infinite and sustainable, their consumption has increased annually. To promote the supply of these infinite natural energy we have to develop more efficient and inexpensive heat recovery system. In this study a simple device was designed as a heat exchanger, that is a direct contact heat exchanger. This heat exchanger was manufactured in cylindrical shape with height of 1,500 mm and diameter of 1,000 mm. To test the efficiency of this heat exchanger, it was connected to the evaporator of heat pump system. During the experimental tests, the humid air of $10{\sim}30^{\circ}C$ was supplied to this air-to-water heat exchanger and then the water flow rate was set to 2500~3500 L/h. Heat recovery rate of this heat exchanger increased in proportion to entering air temperature and water flow rate.

• Journal of the Korean Society for Heat Treatment
• /
• v.26 no.4
• /
• pp.173-177
• /
• 2013

Separation and recovery of valuable metals such as zinc, nickel or tin from copper alloy dross has recently attracted from the viewpoints of environmental protection and resource recycling. In this report, preliminary study on concentration and separation of tin from copper alloy dross using selective dissolution method was performed. The tin in the copper alloy dross did not dissolve in the nitric acid solution which could allow the concentration and separation of the tin from the copper alloy dross. Precipitation of tin as $H_2SnO_3$ (metastannic acid) occurred in the solution and transformed to tin dioxide ($SnO_2$) after drying process. The dried sample was heat-treated at low temperature and its phase characteristics, surface morphology and chemical composition were investigated.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.5
• /
• pp.647-654
• /
• 2009

Since the end of the 1990s, sewer pipe improvement works have been going on: most septic tanks have been thrown away and discarded. These discarded septic tanks amounts up to 370,000 based on the project plan 2005-2008: it is a serious squander of nation's resources, a contaminating means that buries toxins under soil, and a cause of a expensive waste. Research on recycling of discarded septic tank as a new resource is in urgent need. This research suggests plans to recycle discarded septic tank as a rainwater management facility, solutions to water cycle recovery in the limelight, and economic analysis of the plan. In the case of a recycling discarded septic tank as a rainwater management facility will socially benefit to support economical adequacy, discard cost saving of septic tank and water supply and sewage cost reduction will come out. Consequently a rainwater management facility converted from a discarded septic tank leads to decentralization of the rainwater management system, which anticipates a positive effect on recovery of urban water cycle.

• Resources Recycling
• /
• v.8 no.3
• /
• pp.37-42
• /
• 1999

Ths sludy was canied out to recover gold and sllics from abandoned gold mine talings with about 4.5 ghonAu and 84.88 wt% SOz. Tl~bee nef~cialiop~ro~c esses including crushing, screening, magnelic and gravity (humprey sp~rals,h aking table) separation \ulcornervex employed. Results were Feasible to rccovn h e gold concentrates (307.1 gltoilon .4u . 0.60 wr%, 97.7 giton Au : 0.27 wl%, 15.3 &/ton Au . 5.23 wt%, 21.2 g/ton Au : 2.42 wl%) and silica (96.40 wi% SiO\ulcorner yield 60 65 ~ 1 % )

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.24 no.2
• /
• pp.84-87
• /
• 2014

Separation/recovery of valuable metals such as zinc, nickel or tin from copper alloy dross has recently attracted from the viewpoints of environmental protection and resource recycling. In this study, preliminary investigation on separation of tin (Sn) from copper alloy dross using selective dissolution method was performed. The tin in the copper alloy dross did not dissolve in an aqueous nitric acid solution which could allow the concentration/separation of tin from the copper alloy dross. Precipitation of tin as $H_2SnO_3$ (meta stannic acid)occurred in the solution and transformed to tin dioxide ($SnO_2$) after drying process. The dried sample was heat-treated at low temperature and its crystal structure, surface morphology and chemical composition were investigated.

• Preventive Nutrition and Food Science
• /
• v.18 no.4
• /
• pp.234-241
• /
• 2013

The aim of this study was to develop rice wine (Yakju) containing various amounts and particle sizes of ginseng powder and to analyze the physicochemical characteristics and content of ginsenosides in ginseng-Yakju. Soluble solid content, pH, ethanol concentration, acidity, amino acid content, and evaluation of preference showed no difference between four kinds of Yakju groups, regardless of ginseng supplementation and particle size of the ginseng powder. During fermentation of Yakju containing ginseng, the contents of ginsenosides Rb1, Rb2, Rb3, and Rc were decreased. Otherwise, the content of ginsenoside Rh1 was increased highly by brewing microorganisms in Yakju. Recovery ratios of ginsenosides in ginseng-Yakju were approximately 25.4% (coarse ginseng power) and 23.8% (fine ginseng powder), which were superior to the recovery ratio of ginsenosides in Yakju containing ginseng slices (5%).

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.1
• /
• pp.241-269
• /
• 2012

Wireless networks composed of multimedia-enabled resource-constrained sensor nodes have enriched a large set of monitoring sensing applications. In such communication scenario, however, new challenges in data transmission and energy-efficiency have arisen due to the stringent requirements of those sensor networks. Generally, congested nodes may deplete the energy of the active congested paths toward the sink and incur in undesired communication delay and packet dropping, while bit errors during transmission may negatively impact the end-to-end quality of the received data. Many approaches have been proposed to face congestion and provide reliable communications in wireless sensor networks, usually employing some transport protocol that address one or both of these issues. Nevertheless, due to the unique characteristics of multimedia-based wireless sensor networks, notably minimum bandwidth demand, bounded delay and reduced energy consumption requirement, communication protocols from traditional scalar wireless sensor networks are not suitable for multimedia sensor networks. In the last decade, such requirements have fostered research in adapting existing protocols or proposing new protocols from scratch. We survey the state of the art of transport protocols for wireless multimedia sensor networks, addressing the recent developments and proposed strategies for congestion control and loss recovery. Future research directions are also discussed, outlining the remaining challenges and promising investigation areas.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.21 no.4
• /
• pp.46-52
• /
• 2022

In the existing wired communication network, wired communication is frequently interrupted by lightning, which accompanies rain, and remote management cannot be performed when it is actually necessary. In the case of communication interruption, field data stored in the database are lost, and data at an important point in time may go missing; this causes a decrease in the reliability of the stored data. Therefore, in this study, wireless communication using the Internet of Things (IoT) communication network of the 4^th industrial technology is installed in the prototype to reduce wired communication construction costs, prevent resource waste and environmental damage due to communication facility construction, and prepare for communication loss.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.16 no.8
• /
• pp.2666-2687
• /
• 2022

As a new alternative communication scheme in 5G, unmanned aerial vehicle (UAV) is used as a relay in the remote base station (BS) for assistant communication. In order to ameliorate the quality of the backhaul link, a UAV backhaul transmission scheme based on improved Nash equilibrium (NE) strategy is proposed. First, the capacity of air-to-ground (A2G) channel by the link preprocess is maximized. Then, the maximum utility function of each UAV is used as the basis of obtaining NE point according to the backhaul channel and the backhaul congestion. Finally, the improved NE strategy is applied in multiple iterations until maximum utility functions of all the UAVs are reached, and the UAVs which are rejected by air-to-air (A2A) link during the process would participate in the source recovery process to construct a multi-hop backhaul network. Simulation results show that average effective backhaul rate, minimum effective backhaul rate increases by 10%, 28.5% respectively in ideal A2G channel, and 11.8%, 42.3% respectively in fading channel, comparing to pure NE strategy. And the average number of iterations is decreased by 5%.

• New & Renewable Energy
• /
• v.19 no.4
• /
• pp.61-71
• /
• 2023

The necessity of energy utilization using livestock manure has been proposed with the decrease in domestic agricultural land. Livestock manure solid fuel has been investigated as a promising energy resource owing to its convenient storage and use in agricultural and livestock fields. Additional electricity production is possible through the integration of a biomass combustion boiler with the organic Rankine cycle (ORC). In this study, a mathematical system model of the cattle manure solid fuel boiler integrated with the ORC was developed to analyze the components' performance under variable operating conditions. A sensitivity analysis was conducted to confirm the electrical efficiency of the ORC turbine and the applicability of this system. The minimum required waste heat recovery rate was derived considering the system marginal price and levelized cost of electricity of the ORC. The simulation results showed that, in Korea, more than 77.98% of waste heat recovery and utilization in ORC turbines is required to achieve economic feasibility through ORC application.