• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제49권3호
• /
• pp.186-195
• /
• 2000

In this paper, partial discharge (PD) measurement was performed to evaluate the quality of the cable joint and termination constructions. The resistive coupling technique for PD detection using resistivity of semiconducting layer of the cable in the accessories, such as joints and terminations. With high frequency PD (HEPD) measurement, an excellent sensitivity below 20pC could be achieved under unshielded condition. The localization of the defects in the accessories could be identified. During heating cycle, PDs were monitored and analyzed. At that time, the PDs were dependent on the temperature of the heating cycle and showed cyclic behaviors, which were attributed to local delamination of the interfaces, between epoxy unit and stress relief cone(SRC) and between SRC and cable, due to the difference of thermal expansion. As a conclusion, HFPD measurement technique was proven to be an effective diagnostic method for qualification of extra high voltage (EHV) cable accessories. With this technique, the optimal design of the components of the accessories could be verified not only in an early stage but also under operating condition. This technique would result in the improvement of the reliability of the EHV cable accessories.

• Composites Research
• /
• 제17권4호
• /
• pp.18-24
• /
• 2004

본 논문에서는 복합재 구조물에 대하여 형상기억합금 선을 이용한 능동 형상 제어에 관한 연구를 수행하였다. 형상기억합금 선의 열-기계적인 특성을 실험적으로 측정하였으며, 복합재 보 시편의 표면에 볼트를 이용하여 형상기억합금 작동기를 고정하는 방법으로 하이브리드 복합재 구조물을 제작하였다 형상기억합금 작동기는 온도 상승에 의한 상변화에 의해 작동되며, 본 연구에서는 형상기억합금 작동기에 전력을 가하여 내부 저항을 통해 발생하는 열을 이용하여 구동하였다. 보다 빠르고 정확한 형상 및 변형 제어를 위하여 수치적 시뮬레이션을 통한 PID 되먹임 제어기를 설계하였으며, 형상기억합금 작동기에 적용하는 실험을 수행하였다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제9권2호
• /
• pp.7-10
• /
• 2007

Persistent mode HTS pancake coil has been fabricated using a coated conductor by a "wind-and-flip" method. A coated conductor with the length of 1.2 meters was divided at the center along the length. The sliced coated conductor was wound on a pair of bobbins with a diameter of around 4 cm and two pancake coils connected superconductively without a resistive joint were prepared. By flipping one of the pancake coils, the magnetic field generated by each coil is to be aligned to the same direction and generate meaningful magnetic field while the magnetic fields of two spit coils are canceled without flipping. Permanent current was induced by flowing current to the coil immersed in liquid nitrogen pool using a power supply. A magnetic field of 48.8 Gauss was generated when 20 A of current was flowing in the pancake coils. The "Wind and flip" method can be applied for the fabrication of a long solenoid magnet by winding a sliced coated conductor on a cylindrical bobbin. It is also introduced that the construction of multiple sets of pancake (or solenoid) coils is possible by a "wind-and-flip" method using a wide coated conductor.

• 자원환경지질
• /
• 제30권2호
• /
• pp.137-142
• /
• 1997

호주 남부 부룩캉가지역의 폐광된 황철석광산의 광미댐 (Tailings Dam)에서는 광미와 지하수의 반응으로 황산이 형성, 배출되어 주변의 토양, 하천 및 지하수를 오염시키고 있다. 이와 같은 산성 폐수에 의한 환경오염 확산 방지를 위해서는 광미댐을 통하여 흐르는 지하수의 흐름경로를 파악하고 이를 감소시키는 노력이 필요하다. 본 논문에서는 지하수면 깊이의 변화를 파악하고 이를 통하여 지하수의 주 흐름경로를 확인하기 위하여 기존 유용광물 탐사에 주로 사용된 물리탐사방법들이 사용되었다. 본 연구에서 물리탐사방법으로는 시간영역 전자탐사 (TEM), DC 전기비저항탐사 그리고 자연전위 (SP)탐사법들이 사용되었다. SP법에 의하여 측정된 자연전위들은 매우 작았으며, SP자료해석만으로 주 지하수흐름의 경로규명이 어려웠다 TEM과 DC전기비저항 자료해석을 통하여 지하수면의 깊이를 정확하게 결정할 수 있었으며, DC 전기비저항법은 주로 10m내의 천부 대수층 구분에 유용한 반면에 TEM법은 성부구조 결정에 더욱 좋은 분해능을 보였다 TEM과 DC탐사자료들의 복합역산 (Joint Inversion)은 각각의 역산 (Inversion)보다 정확한 지전기적 (Geoelectric) 단면도를 제공하였으며, 물리탐사에 의하여 결정된 지하수면 깊이들은 각 측점에 설치된 관측공에서 피에조미터 (piezometer)에 의하여 측정된 지하수 수위와 거의 일치하였다. 모든 TEM 및 DC탐사 자료해석을 통하여 산출된 지하수 수위도는 탐사지역의 남동부에서 약 1m의 가장 얄은 수위를 나타나며, 반면에 가장 깊은 심도 (약 17 m)의 지하수 수위는 탐사지역의 북서부에서 위치하였다. 또한, TEM 및 DC탐사 자료해석에 의하여 산출된 탐사지역내의 대수층의 전기비저항 분포도에서는 높은 전기전도도의 대수층은 광미댐의 북동부에 존재하며, 가장 낮은 전기전도도를 갖는 대수층은 댐의 남동부에 분포하였다. 이와 같은 결과들로부터 오염이 되지 않은 신선한 (전기비저항이 높은) 지하수 유입의 근원은 광미댐의 남동부에 있음을 시사한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 B
• /
• pp.1234-1236
• /
• 2005

High temperature superconducting(HTS) windings for an HTS transformer which have been developed have two kinds of type, one is the layer type and the other is disk type. The disk type windings have advantages over the layer type ones for a power transformer such as good insulation and limit of voltage stress. But this kind of HTS winding generates excessive AC losses caused by strong magnetic field component perpendicular to the surface of the HTS wire. Nevertheless, the layer type windings have adopted for an HTS power transformer so far because of the small AC losses of the HTS windings. We propose a new winding method for a high voltage HTS transformer which has advantages of both type of HTS windings, and we call it continuous disk type HTS winding. This new type of HTS winding consists of pile of lots of HTS disk windings which have no resistive joint between them. A prototype of an HTS winding was fabricated by the new winding method we proposed and characteristic test was carried out. The test result shows that the new type HTS windings can be applied to HTS power transformers, especially to the high voltage ones.

• 대한물리치료과학회지
• /
• 제26권1호
• /
• pp.1-8
• /
• 2019

Background: PNF patterns are the basis of human motion and can be expected to improve joint motion and coordination. Combined physical training with CLX training and PNF patterns can help to improve balance and perform functional mobility in the lower limb. The purpose of this study is to confirm the effect of CLX training combined with PNF pattern on balance ability. Design: Randomized Controlled Trial. Methods: Total 16 persons participate in this study and were randomly divided in two groups the experimental group and control group. In the experimental group, exercise program with PNF pattern and CLX was performed total 24 times for 8 weeks. In the exercise program, the PNF pattern composed of D1F and D2F was applied with CLX in five positions. Single limb hop test, Y-balance test and Balance Error scoring system were performed to evaluate the balance ability according to the interventions. Results: In the single limb hop, the experimental group revealed a significant difference than a control group (p<0.05).The result of balance error scoring system, experimental group revealed significant differences between before and after training and revealed significant differences than a control group (p<0.05). In the Y-balance test, the experimental group revealed significant differences than a control group in both side. Conclusion: The results of this study showed that the CLX exercise in combination with the PNF pattern had a positive effect on enhancing the balance ability of the normal adult and performing the functional mobility of the lower limb.