• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.10 no.4
• /
• pp.423-430
• /
• 1998

Single phase heat transfer coefficients were measured for turbulent water flow in a micro-fin tube by using Wilson plot technique. An experiment for counterflow heat exchange between the micro-fin tube and its outer annulus passage was performed. The annulus side heat transfer resistance was varied and the overall heat transfer coefficients were measured. The single-phase heat transfer coefficients in a micro-fin tube were obtained by Wilson plot technique. Nusselt numbers based on the real heat transfer area and the nominal area were about 35% and 50% larger than those for smooth tube respectively Also, single-phase heat transfer correlations based on real heat transfer area and nominal area have been proposed for a micro-fin tube.

• Journal of Ocean Engineering and Technology
• /
• v.34 no.5
• /
• pp.294-303
• /
• 2020

This study discusses data collection, calculation of wind and wave-induced resistance, and speed-power analysis of an 8,600 TEU container ship. Data acquisition system of the ship operator was improved to obtain the data necessary for the analysis, which was accomplished using SPA (Ship Performance Analysis, Park et al., 2019) in conformation with ISO15016:2015. From a previous operation profile of the container, the standard operating conditions of mean draft were 12.5 m and 13.6 m, which were defined with the mean stowage configuration of each condition. Model tests, including the load-variation test, were conducted to validate new ship performance and for the speed-power analysis. The major part of the added resistance of container ship is due to the wind. To check the reliability of wind-resistance calculation results, the resistance coefficients, added resistance, and speed-power analysis results using the Fujiwara regression formula (ISO15016:2015) and Computational fluid dynamics (Ryu et al., 2016; Jeon et al., 2017) analysis were compared. Wind speed and direction measured using an anemometer were used for wind-resistance calculation and the wave resistance was calculated using the wave-height and direction-data from weather information. Also, measured water temperature was used to calculate the increase in resistance owing to the deviation in water density. As a result, the SPA analysis using measured data and weather information was proved to be valid and able to identify the ship's resistance propulsion performance. Even with little difference in the air-resistance coefficient value, both methods provide sufficient accuracy for speed-power analysis. The differences were unnoticeable when the speed-power analysis results using each method were compared. Also, speed-power analysis results of the 8,600 TEU container ship in two draft conditions show acceptable trends when compared with the model test results and are also able to show power increase owing to hull fouling and aging. Thus, results of speed-power analysis of the existing 8,600 TEU container ship using the SPA program appropriately exhibit the characteristics of speed-power performance in deal conditions.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.7
• /
• pp.45-51
• /
• 2012

In this paper, the wireless power transfer system using the magnetic resonance was designed and the effect of resonant coil radius and load resistance to this system was analyzed by the circuit analysis method. As a result, the calculated transmitted-power is similar to measured one, and the coil size has a small effect to the coupling coefficients in the resonant frequency band. In addition, the fact that the calculated transmitted-power according to the source frequency is similar to measured one confirms that the circuit analysis methode in this paper is valid. The input side transmission efficiency ${\eta}_i$ including only the loss in the power transfer circuit is almost 90[%] with the large coil in the 10[cm] transfer distance, and 65[%] with the small coil in 1[cm]. The source side transmission efficiency ${\eta}_s$ is 30~40[%] at both coil when load resistance below 4.7[${\Omega}$] has been connected. Considering that the maximum ${\eta}_s$ is 50[%], this is valid in the practical applications.

• Journal of the Korean Society of Tobacco Science
• /
• v.11 no.2
• /
• pp.149-155
• /
• 1989

This study was conducted to obtain the breeding information for the leaf breakdown, and correlation coefficients between leaf breakdown and some agronomic characters in flue-cured tobacco at Taegu Experiment Station, Korea Ginseng & Tobacco Research Institute. NC 95 and NC 2326 were used as parents. The bulk method procedure was used from the F2 to the F4 generations, 54 plants were selected among F4, and 11 lines were selected among 54 F5 which based on high resistance to bacterial wilt compared with NC2326. The entries were composed of parents and 11 F6 advanced lines, and designed in randomized block with 3 replications. Plant seedlings were transplanted in 16 April. The number of breakdown leaf were investigated at flowering stage, 18 June. There were significant difference between NC 95 and NC 2326 for the number of breakdown leaf, number and weight of ground suckers, days to flower, yield and resistance to bacterial wilt, and similar results were appeared among lines. Estimated heritability in the broad-sense ranged from 59.3% to 87.4% for all characters. Most of genetic correlations were higher than phenotypic coefficients between characters. Number of breakdown leaf was positively correlated with days to flower, the number and weight of ground suckers, while it was negative to yield. One line among 11 had few breakdown leaf, low producted ground suckers and high resistance to bacterial wilt. Above results suggest that the number and weight of ground suckers can be use as a selection criterion for leaf breakdown even under the condition without leaf breakdown.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.43 no.6
• /
• pp.749-762
• /
• 2023

A depth-integrated model with an approximate Riemann solver for flux computation of the shallow water equations was applied to hydraulic jump experiments. Due to the hydraulic jump, different flow regimes occur simultaneously in a single channel. Therefore, the Weisbach resistance coefficient, which reflects flow conditions rather than the Manning roughness coefficient that is independent of depth or flow, has been employed for flow resistance. Simulation results were in good agreement with experimental results, and it was confirmed that Manning coefficients converted from Weisbach coefficients were appropriately set in the supercritical and subcritical flow reaches, respectively. Limitations of the shallow water equations that rely on hydrostatic assumptions have been revealed in comparison with hydraulic jump experiments, highlighting the need for the introduction of a non-hydrostatic shallow-water flow model.

• Wind and Structures
• /
• v.31 no.4
• /
• pp.287-298
• /
• 2020

This paper presents an experimental investigation on the surface pressures on the CAARC standard tall building model concerning the effects of freestream turbulence. Two groups of incidence turbulence are generated in the wind tunnel experiment. The first group has an approximately constant turbulence intensity of 10.3% but different turbulence integral scale varying from 0.141 m to 0.599 m or from 0.93 to 5.88 in terms of scale ratio (turbulence integral scale to building dimension). The second group presents similar turbulence integral scale but different turbulence intensity ranging from 7.2% to 13.5%. The experimental results show that the mean pressure coefficients on about half of the axial length of the side faces near the leading edge slightly decrease as the turbulence integral scale ratio that is larger than 4.25 increases, but respond markedly to the changes in turbulence intensity. The root-mean-square (RMS) and peak pressure coefficients depend on both turbulence integral scale and intensity. The RMS pressure coefficients increase with turbulence integral scale and intensity. As the turbulence integral scale increases from 0.141 m to 0.599 m, the mean peak pressure coefficient increases by 7%, 20% and 32% at most on the windward, side faces and leeward of the building model, respectively. As the turbulence intensity increases from 7.2% to 13.5%, the mean value of peak pressure coefficient increases by 47%, 69% and 23% at most on windward, side faces and leeward, respectively. The values of cross-correlations of fluctuating pressures increase as the turbulence integral scale increases, but decrease as turbulence intensity increases in most cases.

• Proceedings of the KIEE Conference
• /
• 2000.07a
• /
• pp.434-436
• /
• 2000

It is difficult to accurately measure the ground resistance because it varies widely not only with the type of soil but also with the ground parameters; the moisture, the temperature the buried depth of electrodes, and the ground augmentation material and so on. Therefore, in this paper we analyzed the relation between the parameters and the resistance of ground in order to obtain a method of maintaining ground resistance stable. In experiments, the variation coefficients of ground resistance were calculated by the monthly measured data. The ground resistance decreases as the length of the ground rod increases. The variation between the ground resistance and the moisture rate of soil was low in case of using the ground augmentation material. Without the ground augmentation material, the ground resistance decreases as the moisture rate of soil increases. The ground resistance becomes small when the earth temperature becomes low.

• Journal of the Society of Naval Architects of Korea
• /
• v.45 no.5
• /
• pp.513-522
• /
• 2008

In this paper, one of the widely-used ice resistance prediction methods, introduced by Spencer(1992) of the Institute for Ocean Technology, Canada, is reviewed. Spencer's component-based scaling system for ship-ice model tests is analysed to estimate the ice resistance of various types of icebreaking vessels (Canadian MV Arctic, Terry Fox, R-Class icebreaker, US icebreakers Polar Star and Healy, Russian SA-15 cargo ships, Japanese PM Teshio and a model ship). The general form and the non-dimensional coefficients in ice resistance prediction formula are obtained using the published ice model test and full-scale sea trial data. The applicability of Spencer's method on R-Class icebreaker is discussed to estimate ice resistance for the larger icebreaking cargo vessels. Additional parameters to account for the difference in hull forms of icebreakers and cargo vessels are recommended to be included in the Spencer's original ice resistance prediction formula.

• Nuclear Engineering and Technology
• /
• v.54 no.7
• /
• pp.2660-2669
• /
• 2022

The attractiveness for weapons usage of the proposed fuel cycle for the PT-SCWR was evaluated in this study using the Figure-of-Merit methodology. It was compared to the attractiveness of other fuel cycles namely, Low Enriched Uranium (LEU), U/Th, Re-enriched Reprocessed Uranium (RepU), and Pu/Th/U. The optimal content of natural uranium, which can be added to Pu/Th to render the produced U-233 unattractive, was found to be 9%. A ranking system to compare the attractiveness of the various fuel cycles is proposed. RepU was found to be the most proliferation resistant fuel cycle for the first 100 years,while, the least proliferation resistant fuel cycle was the originally proposed Pu/Th one. The reactivity feedback coefficients were calculated for all proposed fuel cycles. All studied reactivity coefficients have the same sign implying that all the fuel cycles will behave neutronically in a similar way. The Pu/Th/U fuel was found to have the most negative value of the Coolant Void Reactivity which will help to restore the core to a safe status faster in case of a loss-of-coolant accident. The fuel and moderator temperature coefficients did not show significant differences between the fuels studied.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.10 no.6
• /
• pp.683-691
• /
• 2018

Numerical simulations of turbulent flows around KCS have been performed to study the sensitivity of ship resistance to wall-adjacent grids and disclose the influence of near-wall treatment on the sensitivity of ship resistance. The resistance coefficients of viscous and pressure forces were compared when using realizable $k-{\varepsilon}$ and SST $k-{\omega}$ turbulence models in structured and unstructured grids, respectively. The calculation of friction velocity was found to be mainly responsible for the reduction of viscous and total resistances when the height of wall-adjacent cells increased. Since the assumption of equilibrium state between turbulent production and dissipation was not met in a bulbous bow, it was more reasonable to iteratively calculate the friction velocity from empirical laws of the wall for near-wall treatment rather than explicitly estimate it from the turbulent kinetic energy.