• Journal of the Korean Wood Science and Technology
• /
• v.32 no.4
• /
• pp.46-51
• /
• 2004

The objective of this study was to evaluate the applicability of high temperature drying to pitch pine (Pinus rigida) lumber, especially intended for use as lamina of structural glued laminated timber (glulam), to enhance the efficient utilization and provide added-value to that species. The high temperature schedule and drying procedures utilized were shown to be reasonable for drying glulam lamina due to the occurrence of small moisture gradients, minimal residual drying stress, and low warpage. Through preliminary tests, it was confirmed that residual resin at lamina surfaces did not adversely affect the gluing process. However, quantitative analysis of resin is required for developing a method to constrain the occurrence of pitch trouble with respect to decreasing long-term adhesive and finish durability of glulam in use after manufacturing. The final moisture content of high temperature dried lamina was much lower than target moisture content and discoloration was more severe than anticipated. In a further study, it will be necessary to determine the optimal drying conditions, such as temperature, humidity, drying time, and top load restraint level, which could best control discoloration, warpage, and moisture content of the lamina, while minimizing fuel expense.

• The Korea Journal of Herbology
• /
• v.27 no.6
• /
• pp.43-48
• /
• 2012

Objectives : This study was investigated to determine the contents of pesticide residues and sulfur dioxide residues in commercial herbal medicines in Korea. Methods : Chromatographic test was performed on 100 samples consisted with 10 kinds of medicinal plants including improted and domestic products. To establish 19 pesticide residues (DDE, DDD, DDT, Dieldrin, Methoxychlor, BHC isomers, Aldrin, Endosulfan isomers, Endrin, Captan, Procymidone, Chlorpyrifos and Imidacloprid) in commercial herbal medicines, chromatographic equipments were used with the gas chromatography-mass detector and gas chromatography-electron capture detector for qualitative analysis. The imidacloprid analysis was performed by high performance liquid chromatograpgy-ultraviolet detector at 270 nm UV wavelength. The contents of sulfur dioxides were analyzed by modified Monnier-Williams method. All methods were based on notification procedure of Korea Food & Drug Administration (KFDA). Results : The residual pesticides were not founded in improted and domestic samples. Among 100 samples, the residues of sulfur dioxide in 73 samples were not detected and 25 samples showed contents in the range of 0~21.90 mg/kg. The excess samples of MRLs were 2 samples (30 mg/kg to medicinal herbs), Asiasari Radix et Rhizoma (Imported product) and the average amount of sulfur dioxide in 2 unsuitable samples were 14.83 mg/kg. These samples were found to transgress KFDA regulatory guidance of residual sulfur dioxide. Conclusion : These results are able to use as basic data to improve the reliability and value of commercial medicinal herbs.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.12
• /
• pp.1919-1925
• /
• 2022

In this paper, we propose an image-to-image translation approach based on the conditional generative adversarial network for semantic segmentation. Semantic segmentation is the task of clustering parts of an image together which belong to the same object class. Unlike the traditional pixel-wise classification approach, the proposed method parses an input RGB image to its corresponding semantic segmentation mask using a pixel regression approach. The proposed method is based on the Pix2Pix image synthesis method. We employ residual connections-based convolutional neural network architectures for both the generator and discriminator architectures, as the residual connections speed up the training process and generate more accurate results. The proposed method has been trained and tested on the NYU-depthV2 dataset and could achieve a good mIOU value (49.5%). We also compare the proposed approach to the current methods in semantic segmentation showing that the proposed method outperforms most of those methods.

• Journal of Advanced Navigation Technology
• /
• v.28 no.5
• /
• pp.732-737
• /
• 2024

We systematically studied the chromatic dispersion and nonlinear distortion compensation characteristics of 24-channel × 40 Gb/s wavelength division multiplexed (WDM) signal in a mid-span spectral inversion (MSSI) system with dispersion-managed link. WDM signals are transmitted over dispersion-managed link consisting of an 80 km × 48 fiber span including erbium-doped fiber amplifier (EDFA). The dispersion map applied to this dispersion-managed link has trapezoidal shape with various structures. The trapezoid-shaped dispersion map examined in this paper are designed with configuration in which the cumulative dispersion profile has positive or negative value in each section before and after the optical phase conjugator. Through simulation, it was confirmed that the proposed trapezoid-shaped dispersion map is effective in compensating for distorted WDM channel signals when the dispersion map is configured with the small RDPS (residual dispersion per span).

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.7
• /
• pp.550-555
• /
• 1999

This paper deals with the effect of lightning impulse current on electrical characteristics of ZnO blocks used in distribution lightning arrester. The electrical characteristics of ZnO blocks are degraded by overtime impulse current, and the degraded ZnO block is brought to a thermal runaway and finally destroyed. It is therefore important to estimate the change of electrical characteristics of ZnO blocks. In this study, an impulse current generator which can produce 8/20$[\mus]$, 3[㎄] and 4/10$[\mus]$, 5[㎄] waveform is designed and fabricated to simulate the lightning impulse current of power systems. Total energy applied to the ZnO blocks at each time is 739[J] in 8/20$[\mus]$, and 523[J] in 4/10$[\mus]$, impulse current, respectively. From the experimental results, the 3rd harmonic of the leakage current increases continuously with the number of applied impulse current, but no significant changes in residual voltage and in reference voltage are observed until the ZnO block is destroyed. Also, it is confirmed that the main factor on degradation of ZnO blocks is rather the total energy applied to ZnO blocks than the peak value of the impulse current.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.7 no.6
• /
• pp.39-48
• /
• 2004

The purpose of this paper was to confirm the application of the equation of the soil-water characteristic curve on an unsaturated soil. To this ends, a series of suction test was conducted on the selected 4 kinds of soil which is located in Korea, using the modified pressure extractor apparatus. And it was carried out to analyze the experimental parameters which can describe the soil-water characteristics, were determined by using the data obtained from the experiment. From the results, it was found that the matric suction was varied according to the grain size distribution, amount of fine grain particle and void ratio. Also it was found that the residual volumetric water content was decreased with the void ratio, but the index related air entry value, the soil parameter related water content and the parameter with residual water content were increased with the void ratio. And the application of equation of the soil-water characteristic curve was confirmed for the various conditions and the various state by the comparison between the volumetric water content measured by the experiment and the predicted values.

• Journal of Korean Society of Forest Science
• /
• v.99 no.5
• /
• pp.706-710
• /
• 2010

Understanding of chemical composition and energy contents in tree is important to develope strategies of renewable energy policy to cope with climate change. Residual biomass as renewable energy source was evaluated and focused on the bark-containing branches. Chemical analysis studies were conducted for different part of yellow poplar (Liriodendron tulipifera), which were partitioned to inner bark, outer bark, small branches, medium branches, big branches and trunk. The variations in hydrophobic extractives, hydrophilic extractives, lignin, carbohydrate compositions, energy contents (higher heating value) and the ash content were determined. The inner and outer bark had higher ash content, hydrophobic and hydrophilic extractives content, and higher energy content than those of tree trunk. Polysaccharides content in inner and outer bark was quite lower than those of stem or branches. Based on the energy content of residual biomass, replacement of fossil fuel and greenhouse gas emission abatement were calculated.

• Analytical Science and Technology
• /
• v.32 no.6
• /
• pp.225-232
• /
• 2019

Traceability establishment in chemical measurements is a like a linkage established through an unbroken chain from the measured results to the international system (SI) of units. The primary process for traceability establishment is the purity assignment of a target material to be measured. In this study, we studied the purity assignment of 17α-hydroxyprogesterone (17-OHP). The presence of 17-OHP is indicative of congenital adrenal hyperplasia (CAH) and it builds up due to the deficiency of 21-hydroxylase and 11β-hydroxylase enzyme in the human blood. The purity assignment of 17-OHP was performed by the mass balance method, in which the impurities are categorized into four classes: total related structural impurities, water, residual organic solvents, and nonvolatiles/inorganics. The total related structural impurities were characterized by HPLC-UV; water content was determined by Karl-Fisher coulometer; and the total residual solvents and nonvolatiles/inorganics were determined by TGA. The purity of 17-OHP from a commercial manufacturer was calculated as 993.30 mg/g, and the expanded uncertainty was 0.58 mg/g. The proposed method was validated by uncertainty evaluation and comparing with the actual value of purity.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.8
• /
• pp.853-859
• /
• 2014

This study presents a technique for extracting all the extrinsic parameters of HEMTs by minimizing the residual errors between a pinch-off cold-FET's gate and drain pad de-embedded Z-parameters and its modeled Z-parameters calculated by the cold-FET's remaining parameters. The presented technique allows us to successfully extract the remaining extrinsic parameter values as well as the gate and drain pad capacitance value without the additional fabrications of the gate and drain dummy pad.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.17 no.5
• /
• pp.26-30
• /
• 2009

In this paper, a robust model based fault detection for varying temperature is proposed, To develop a robust force estimation model, it needs temperature information because the force sensor's output is affected by a temperature variation. If an EPB system does not include a temperature sensor, the model has a much larger error than an EPB system with a built-in temperature sensor. Therefore, the temperature is estimated by using Ohm's law. The force model is applied with a motor current, battery voltage, operation mode, and the estimated temperature to detect a force sensor's abnormal signal fault. The residual is calculated by comparing the value of the measured force and the estimated force. Fault information is collected by using the output of the evaluated residual with the adaptive thresholds. A proposed robust model based fault detection for varying temperature was verified by HILS (Hardware in the Loop Simulation).