• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.2 no.1
• /
• pp.3-9
• /
• 2009

Although Active matrix organic light emitting diode (AMOLED) display has a better image quality in terms of viewing angle, contrast ratio, and response time than liquid crystal displays (LCDs), it still has some critical issues such as lifetime, residual images, and brightness non-uniformity due to non-uniformity in electrical characteristics of driving TFTs and IR drops on supplied power line. Among them, we improved irrecoverable residual images of AMOLED displays which is mainly related to the hysteresis characteristics of driving TFTs. We consider four kinds of surface treatment conditions before gate oxide deposition for improving hysteresis characteristics. We can reduce the hysteresis level of p-channel TFT to 0.23 V, interface trap states between the poly-Si layer and gate insulator to $3.11{\times}10^{11}cm^{-2}$, and output current variation of p-channel TFT to 3.65 % through the surface treatment using ultraviolet light and H2 plasma. Therefore, the recoverable residual image problem of AMOLED displays can be improved by surface treatment using ultraviolet light and $H_2$ plasma.

• Journal of Soil and Groundwater Environment
• /
• v.8 no.3
• /
• pp.45-55
• /
• 2003

This study investigates the fractional composition and the leaching characteristics of heavy metals in polluted soils due to mining activities. The fractionated composition of heavy metals is classified into five fractions; adsorbed, carbonate, reducible, organic and residual fraction. The status of humic substances in mine wastes of most sites are polyhumic except tailing from Sangdong mine. According to the sequential extraction procedures (SEPs), leaching probabilities of Cd in coal wastes and tailing are relatively low due to high percentage of residual fraction. 46.4% of Ni in tailings from Sangdong mine is probably leached under oxidized environment, and 39.4% of Cu in these tailings is readily extracted under strongly oxidized environment by organic fraction. According to leaching condition of pH 3.0 and pH 5.6, the amount of heavy metals leached out of coal wastes and tailing increases to 1/2 hours. At pH 3.0 and pH 5.6, concentration of Ni in tailing increases up three times of the initial value. Heavy metals released from coal wastes and tailing were not influenced significantly by leaching time.

• Journal of Korean Society of Water and Wastewater
• /
• v.29 no.4
• /
• pp.481-491
• /
• 2015

The aim of this study was to evaluate the chemical quenching system for residual ozone and to determine the operating condition for the quenching system. Hydrogen peroxide ($H_2O_2$) and sodium thiosulfate ($Na_2S_2O_3$) were investigated as quenching reagents for ozone removal, and the tendency of each chemical was notably different. In the case of $H_2O_2$, the degradation rate of ozone was increased as the concentration of $H_2O_2$ increase, and temperature and pH value have a significant effect on the degradation rate of ozone. On the other hand, the degradation rate of ozone was not affected by the concentration of $Na_2S_2O_3$, temperature and pH value, due to the high reactivity between the ${S_2O_3}^{2-}$ and ozone. This study evaluates the decomposition mechanism of ozone by $H_2O_2$ and $Na_2S_2O_3$ with consideration for the water quality and reaction time. Furthermore, the removal test for the quenching reagents, which can be remained after reaction with ozone, was conducted by GAC process.

• Journal of Environmental Health Sciences
• /
• v.44 no.5
• /
• pp.444-451
• /
• 2018

Objectives: This study was carried out to provide safe seafood to the public through simultaneous analysis rapid inspections for residual veterinary drugs in 150 fishery products in 2016. Methods: Quinolones (9), Sulfonamides (14), Penicillins (2), Cephalosporins (3), Tetracyclines (4), Macrolides (4), Lincosamides (2), Pleuromutilin (1), Phenicols (4), benzylpyrimidines (2), Others (1) Malachite green (2), and Melamine (1) were analyzed for 49 species using by HPLC and HPLC-MSMS. Results: There were six unsuitable samples, five among fish and one for crustaceans. Within the standard detection were five fish. The antibiotics found were Quinolones (50%), Tetracyclines (33%) and Penicillins (17%). Conclusions: As a result of the experiment, there were six unsuitable samples, five for fish and one for crustaceans. The most prevalent antibiotics were Quinolones. The quinolone antibiotics are highly persistent in fish tissues, so they require more time than the withdrawal period for other common veterinary drugs. Careful attention is required when they are used in fish farms.

• The Korean Journal of Pesticide Science
• /
• v.8 no.2
• /
• pp.112-116
• /
• 2004

Two experiments were carried out in greenhouse under hydrophilic culture facilities and simulation model to provide residual characteristics of ethoprophos treated in sweet pepper's growth. To identify the pattern of absorption-translocation through the plant roots, ethoph 5 % GR were diluted in hydrophilic culture solution and drenched at a time per day for three days. The residue in fruit came closed to 0.02 ppm of MRL at 10 days after treatment(DAT) and reached peaked 0.06 ppm at 30 DAT and remained excess MRL level until around 40 DAT. To confirm the pattern of contamination by volatilization of ethoprophos, ethoph 5%GR was scattered 2 g per cubic meter. At 72 hours after treatment, the residue in sweet pepper fruit was exceed the MRL and the maximum residual amount were 0.62 ppm by volatilization. Consequently the use of ethoprophos during the growth of sweet pepper would be strong possibility to exceed the MRL.

• Korean Journal of Remote Sensing
• /
• v.33 no.1
• /
• pp.25-35
• /
• 2017

Spatial downscaling with fine resolution auxiliary variables has been widely applied to predict precipitation at fine resolution from coarse resolution satellite-based precipitation products. The spatial downscaling framework is usually based on the decomposition of precipitation values into trend and residual components. The fine resolution auxiliary variables contribute to the estimation of the trend components. The main focus of this study is on quantitative analysis of impacts of trend component estimates on predictive performance in spatial downscaling. Two regression models were considered to estimate the trend components: multiple linear regression (MLR) and geographically weighted regression (GWR). After estimating the trend components using the two models,residual components were predicted at fine resolution grids using area-to-point kriging. Finally, the sum of the trend and residual components were considered as downscaling results. From the downscaling experiments with time-series Tropical Rainfall Measuring Mission (TRMM) 3B43 precipitation data, MLR-based downscaling showed the similar or even better predictive performance, compared with GWR-based downscaling with very high explanatory power. Despite very high explanatory power of GWR, the relationships quantified from TRMM precipitation data with errors and the auxiliary variables at coarse resolution may exaggerate the errors in the trend components at fine resolution. As a result, the errors attached to the trend estimates greatly affected the predictive performance. These results indicate that any regression model with high explanatory power does not always improve predictive performance due to intrinsic errors of the input coarse resolution data. Thus, it is suggested that the explanatory power of trend estimation models alone cannot be always used for the selection of an optimal model in spatial downscaling with fine resolution auxiliary variables.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.2
• /
• pp.100-108
• /
• 2014

In this paper, we design SSD(simultaneous single band duplex) system using RF(radio frequency) cancellation and digital cancellation. we analyze characteristic of residual self-interference after RF Cancellation signal when error of phase shifter occur in RF cancellation. When phase shifter error of $0^{\circ}$, $0.5^{\circ}$, $1^{\circ}$ and $2^{\circ}$ occur in RF cancellation, residual self-interference signal power after RF cancellation is bigger than desired signal power of distant station. So, it is impossible to receive transmit data of distant station. but we confirm that it is possible to receive transmit data of distant station by digital cancellation with frame structure. Also, in digital cancellation with frame structure, if residual self-interference signal after RF cancellation is too large then LMS algorithm requires more time to estimate self-interference channel. That is, performance degradation occurs because self-interference channel estimation has not completed in estimation frame.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.8
• /
• pp.659-664
• /
• 2009

This paper describes lightning impulse operating duty performance and temperature dependence of series gap type for transmission line arresters. The ageing parameters of lightning arresters are impulse current, moisture ingress, temperature ageing and so on. Especially it is important to estimate the change of electrical characteristics by lightning impulse current. In the discharge withstand test, total energy applied to the ZnO arrester each time is 4/10 ${\mu}s$, 30 kA. and in the operating duty test, the arrester has passed the test if thermal stability is achieved, if the residual voltage measured before and after the test is not changed by more than 5 %, and after the test reveals no evidence of puncture, flashover or cracking of the ZnO block. As a results, the residual voltage was in the range of 17.2${\sim}$20.3 kV and ZnO block bear up against at 2 shot of series impulse current of 30 kA. Also it was so excellent that the mechanical destruction does not occur at the 2 groups of 5 impulses current of 2/20 ${\mu}s$ 10 kA. According to the tests, it is thought that the ZnO arrester shows good stability with impulse current test. and it was found that the ambient temperature is increased resistive leakage current was increased in the range 47.3${\sim}$167.4 ${\mu}A$.

• Asian Pacific Journal of Cancer Prevention
• /
• v.16 no.17
• /
• pp.7627-7632
• /
• 2015

Background: The present study was conducted to evaluate the technical feasibility, safety and adequacy of surgical margins with salvage transoral robotic surgery (TORS) for recurrent or residual head and neck squamous cell carcinoma patients. Materials and Methods: Thirty patients who underwent salvage TORS using the 'DaVinci' robot were enrolled in the study and data related to their surgical time, complications and functional outcome were recorded. Results: The feasibility of salvage TORS in our study was observed to be 100%. Positive margins were encountered in only 6.7% of patients. Mean blood loss was 23.3 ml with no patient requiring blood transfusion. Postoperative complications in the form of primary haemorrhage requiring active surgical intervention occurred in 13.3%. Oral feeding could be started as early as the 3rd postoperative day in a few patients, with nasogastric tubes being removed on the 12th postoperative day. Long term gastrostomy tube dependency was seen in 10% cases. Median survival of patients was 19 months. Conclusions: Salvage TORS is a safe, effective and feasible option in the management of treatment failure cases. It offers an alternative surgical approach with unexpected benefits in terms of tracheostomy tube use, Ryle's tube and gastrostomy dependence.

• Nuclear Engineering and Technology
• /
• v.48 no.3
• /
• pp.765-772
• /
• 2016

In analyzing residual radiation, researchers generally use a two-step Monte Carlo (MC) simulation. The first step (MC1) simulates neutron transport, and the second step (MC2) transports the decay photons emitted from the activated materials. In this process, the stochastic uncertainty estimated by the MC2 appears only as a final result, but it is underestimated because the stochastic error generated in MC1 cannot be directly included in MC2. Hence, estimating the true stochastic uncertainty requires quantifying the propagation degree of the stochastic error in MC1. The brute force technique is a straightforward method to estimate the true uncertainty. However, it is a costly method to obtain reliable results. Another method, called the adjoint-based method, can reduce the computational time needed to evaluate the true uncertainty; however, there are limitations. To address those limitations, we propose a new strategy to estimate uncertainty propagation without any additional calculations in two-step MC simulations. To verify the proposed method, we applied it to activation benchmark problems and compared the results with those of previous methods. The results show that the proposed method increases the applicability and user-friendliness preserving accuracy in quantifying uncertainty propagation. We expect that the proposed strategy will contribute to efficient and accurate two-step MC calculations.