• 한국지구물리탐사학회:학술대회논문집
• /
• 2005.05a
• /
• pp.261-266
• /
• 2005

According to development of satellite geodesy, gravity potential models which have high accuracy and resolution were released. Using the EIGEN-CG01C model based on low orbit satellite data such as CHAMP and GRACE and the EGM96 model, geoid and gravity anomaly were calculated and compared. The study area is located at $123^{\circ}{\sim}132^{\circ}$ E, $33^{\circ}{\sim}43^{\circ}$ including Korea. Comparing two models, very high correlation more than 0.90 in geoid and gravity anomaly was observed, but in amplitude analysis the EIGEN-CG01C model have higher amplitude in high frequency area. Gravity anomaly calculated with both models shows a little difference in North Korea and some coast area of the Yellow sea. Through power spectrum analysis, residual anomaly that can be used in large scale structure or underground resources survey was calculated.

• Textile Coloration and Finishing
• /
• v.26 no.1
• /
• pp.53-62
• /
• 2014

This study examined the dyeability, color fastness and functionality of cotton fabrics dyed with residual parts of cultivated Pteridium aquilinum. UV-Vis absorption spectrum, TLC and FT-IR spectra analysis showed that colorants of Pteridium aquilinum are a mixture of pyrogallol tannin and catechol tannin. Optimum dyeing conditions was confirmed colorant concentration of 500% at $100^{\circ}C$ for 60 minutes. Color fastness followed to washing, rubbing, perspiration and light as 4-5, 5, 4-5(acidic), 3-4(alkaline) and 2, respectively. Deodorization rates of ammonia($NH_3$) and acetic acid ($CH_3COOH$) were analyzed 88.8% and 78.0%. UV protection rate was 94.2% of UV-A and 96.8% of UV-B. UV protection factor(UPF) was 27. Therefore residual parts of cultivated Pteridium aquilinum could be used for a new functional colorant.

• Speech Sciences
• /
• v.4 no.2
• /
• pp.5-15
• /
• 1998

This paper proposes a speech state-dependent spectral subtraction method to regulate the blind spectral subtraction for improved enhancement. In the proposed method, a modified subtraction rule is applied over the speech selectively contingent to the speech state being voiced or unvoiced, in an effort to incorporate the acoustic characteristics of phonemes. In particular, the objective of the proposed method is to remedy the subtraction induced signal distortion attained by two state-dependent procedures, spectrum sharpening and minimum spectral bound. In order to remove the residual noise, the proposed method employs a procedure utilizing the masking effect. Proposed spectral subtraction including state-dependent subtraction and residual noise reduction using the masking threshold shows effectiveness in compensation of spectral distortion in the unvoiced region and residual noise reduction.

• Clinical and Experimental Pediatrics
• /
• v.59 no.9
• /
• pp.384-385
• /
• 2016

• The KIPS Transactions:PartB
• /
• v.17B no.1
• /
• pp.69-78
• /
• 2010

Spectral modeling synthesis (SMS) has been used as a powerful tool for musical sound modeling. This technique considers a sound as a combination of a deterministic plus a stochastic component. The deterministic component is represented by the series of sinusoids that are described by amplitude, frequency, and phase functions and the stochastic component is represented by a series of magnitude spectrum envelopes that functions as a time varying filter excited by white noise. These representations make it possible for a synthesized sound to attain all the perceptual characteristics of the original sound. However, sometimes considerable phase variations occur in the deterministic component by using the conventional SMS for the complex sound such as whale sounds when the partial frequencies in successive frames differ. This is because it utilizes the calculated phase to synthesize deterministic component of the sound. As a result, it does not provide a good spectrum matching between original and synthesized spectrum in higher frequency region. To overcome this problem, we propose a modified SMS that provides good spectrum matching of original and synthesized sound by calculating complex residual spectrum in frequency domain and utilizing original phase information to synthesize the deterministic component of the sound. Analysis and simulation results for synthesizing whale sounds suggest that the proposed method is comparable to the conventional SMS in both time and frequency domain. However, the proposed method outperforms the SMS in better spectrum matching.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.10
• /
• pp.930-938
• /
• 2004

This paper presents the noise source identification of a car A/V system. There are two different kinds of noise sources noise generated by loading mechanism and rattle noise by externally forced vibration. A dynamometer has been made to produce stationary inertia to the loading mechanism of A/V system. Sound pressure spectra and sound intensity were measured by operating the dynamometer setup as various motor speeds, and the results were analyzed. A dominant rattle noise source about A/V system's components has been found by multi-dimensional spectral analysis. Residual spectrum method was applied for eliminating coherence between the vibration sources. In result, the dominant rattle noise source was identified by partial coherent output spectrum of individual vibration component.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.2
• /
• pp.333-339
• /
• 1996

In this paper, an effiicent quatization method of line spectrum pairs(LSP) with cascaded structure of vector quantizer and scalar quantizer is proposed. First, input LSP parameters is vector-quantized using a codebook with a moderate number of entries. In the second stage of quantization, the components of residual vector are individution improve the quantizer by the scalar quantizer. The utilization of ordering property and the inclusion of interframe prediction improve the quantizer performance and remove the stability check routine. The new vector-scalar cascaded quantizer using 27 bits/frame shows a transparent quality that an average specytural distortion is 1 dB and the frame proportion with above 2 dB spectral distion is less than 2%.

• Journal of the Optical Society of Korea
• /
• v.12 no.4
• /
• pp.337-345
• /
• 2008

This article presents the RSOA-based re-modulation schemes for practical application to the WDM-PON link. Emphasis is put on the three methods for reducing the residual downstream signal in the upstream transmission; the simplest one is to use the RSOA gain-saturation property, the second uses selective filtering of the adiabatic-chirped DFB-LD output spectrum, and the last uses a dynamic RSOA gain control by varying its driving current according to the incident binary signal. The reflection sensitivity in the proposed re-modulation link is also qualitatively presented in the cases of using two different types of seed light: coherent light from DFB-LD array and spectrum-sliced incoherent ASE light. We show experimental results of an error-free bidirectional gigabit transmission over 20 km at -30 dB reflection with the spectrum-sliced ASE seed light.

• Nuclear Engineering and Technology
• /
• v.55 no.6
• /
• pp.2276-2282
• /
• 2023

We deploy artificial neural networks to unfold neutron spectra from measured energy-integrated quantities. These neutron spectra represent an important parameter allowing to compute the absorbed dose and the kerma to serve radiation protection in addition to nuclear safety. The built architectures are inspired from convolutional neural networks. The first architecture is made up of residual transposed convolution's blocks while the second is a modified version of the U-net architecture. A large and balanced dataset is simulated following "realistic" physical constraints to train the architectures in an efficient way. Results show a high accuracy prediction of neutron spectra ranging from thermal up to fast spectrum. The dataset processing, the attention paid to performances' metrics and the hyper-optimization are behind the architectures' robustness.

• Composites Research
• /
• v.23 no.6
• /
• pp.26-31
• /
• 2010

This research work contributes to a study for the procedure and methodology to assess the fatigue durability for a composite torque link for helicopter landing gear, which was newly developed and fabricated by the resin transfer moulding technique to interchange with metal component. The simulated load spectrum anticipated to be applied to the torque link during its operation life was generated using an advanced method of probabilistic random process, and the fatigue durability was evaluated by the residual strength degradation approach on the basis of material test data. The full scale fatigue test was performed and compared with the analysis results.