• Journal of the Korean Wood Science and Technology
• /
• 제49권6호
• /
• pp.541-549
• /
• 2021

This paper reports a method to evaluate the residual strength of insect-damaged radiata pine lumber, such as the screw withdrawal strength as a semi-destructive method and a compression parallel to the grain test to assess the density changes after exposure to outdoor conditions. The screw withdrawal strength test was used as a semi-destructive method to estimate the residual density of decayed lumber. A compression parallel to the grain test was applied to evaluate the residual density. Three variables, such as the screw withdrawal strength, compression parallel to the grain, and residual density, were analyzed statistically to evaluate their relationships. The relationship between the residual density and screw withdrawal strength showed a good correlation, in which the screw withdrawal strength decreased with decreasing density. The other relationship between the residual density and compression parallel to the grain was also positively correlated; the compression parallel to the grain strength decreased with decreasing density. Finally, the correlation between the three variables was statistically significant, and the mutual correlation coefficients showed a strong correlation between the three variables. Hence, these variables are closely correlated. The test results showed that the screw withdrawal strength could be used as a semi-destructive method for an in situ estimation of an existing wood structure. Moreover, the method might approximate the residual density and compression parallel to the grain if supplemented with additional data.

• 한국환경과학회지
• /
• 제11권1호
• /
• pp.41-56
• /
• 2002

In order to estimate the quantitative roles of the tide induced residual currents, density currents and wind driven currents on the residual currents in Kwangynag Bay Korea, numerical experiments with a diagnostic multi-level model were carried out. Density currents were calculated from the temperature and salinity data observed in January, May, August and November 1998. Anti-clockwise circulations are formed at the western inner part of the bay, the location from the east of Myodo Is. to the south of POSCO Co. and the place between Yeosu peninsula and Namhae Is. from the calculation results of the tide induced residual currents. Velocities of the density currents are less than 3cm/s at the western inner part of the bay and about 5cm/s at the southern entrance of the bay. Density currents get strong in summer and weak in autumn. Wind driven currents at the surface layer flow in the directions of the given winds which are the daily mean winds when the temperature and salinity observations are carried out. In the middle and lower layers, however the wind driven currents flow in the opposite direction to the surface currents as supplementary currents. The surface wind driven currents are greater than the tide induced residual currents or the density currents. The calculated residual currents including the tide induced residual currents, density currents and wind driven currents agree with the results of the current observations approximately. In the Bay, the wind driven currents affect on the residual currents greatestly and tide induced residual currents and density currents do in the second place and the third place.

• 임산에너지
• /
• 제20권2호
• /
• pp.46-57
• /
• 2001

이 연구는 강송, 리기다소나무, 낙엽송 인공조림지를 대상으로 간벌 시업후 잔존임분밀도에 따른 임목생장 비교를 퉁해 침엽수 인공림을 적절히 관리하기 위한 보육 정보를 제공하고자 수행되었다. 연구결과를 요약하면 다음과 같다. 1. 잔존임분밀도별 임목의 직경생장은 강송림과 리기다소나무림, 낙엽송림 (가), (나)소반의 경우, 임분밀도가 감소할수록 직경생장이 증가하는 것으로 파악되었으며, 잔존임분밀도에 따른 임목의 생장은 통계적으로 유의적인 차이가 있는 것으로 분석되었다. 2. 잔존임분밀도별 임목의 수고생장 양상에서는 처리구별로 수고생장이 다소 차이가 있는 것으로 나타났으나 간벌의 직접적인 영향보다는 입지조건과 같은 환경요소의 차이에 의한 것으로 나타났다. 3. 각 임분밀도 조절 처리구별로 평균에 해당되는 직경급의 목편을 추출하여 최근 6개년간의 직경생장량을 실측한 결과는 전구간에서 직경급이 클수록, 잔존임분밀도가 낮을수록 직경생장량이 큰 것으로 파악되었다.

• 한국추진공학회지
• /
• 제18권6호
• /
• pp.27-33
• /
• 2014

KSLV-I 나로호 2단은 희박영역에서 킥모터 연소 종료 후 탑재된 나로과학위성과 분리한다. 위성과 분리된 나로호 2단은 킥모터 잔류추력 플룸을 고려하여 위성에 대한 오염 및 충돌 회피 기동(CCAM)을 수행한다. 이때 위성 예상 궤도는 킥모터 잔류추력의 Plume Density가 충분히 낮은 영역을 통과해야만 위성의 성능 보증 및 오염을 피할 수 있다. 이를 확인하기 위해서는 CCAM을 수행하는 나로호 2단 킥모터 잔류추력 Plume Density에 대한 정확한 예측이 필수적이다. 본 연구에서는 희박영역에서 널리 사용되는 DSMC 방법을 이용하여 고고도에서의 킥모터 노즐 내부를 해석하여 연속체방정식의 해와 비교하여 그 타당성을 검증한 후, 커플링 방법을 사용하여 계산 영역을 확장하여 킥모터 잔류추력의 Plume Density를 시뮬레이션 함으로써, 나로호 2단과 분리된 위성의 궤도가 킥모터 잔류추력의 Plume Density로부터 안전하다는 것을 확인하였다.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part 1
• /
• pp.566-567
• /
• 2006

The characteristics of residual stresses occurring in PM steel based nickel (FLN2-4405) was investigated. The measurements of residual stresses were carried out by electrochemical layer removal technique. The values and distributions of residual stresses occurring in PM steel processed under various densities and heat treatment conditions were determined. In most of the experiments, tensile residual stresses were recorded in surface of samples. The residual stress distribution on the surface of the PM steels is affected by the heat treatment conditions and density. Maximum values of residual stresses on the surface were observed sinter hardened condition and $7.4\;g/cm^3$ density. Minimum level of recorded tensile residual stresses are150 MPa and its maximum level is 370 MPa.

• 한국표면공학회지
• /
• 제42권4호
• /
• pp.145-151
• /
• 2009

Nanocrystalline Cu thin films for FCCL were electrodeposited from sulfate baths to investigate systematically the influences of current density, solution pH on current efficiency, residual stress, surface morphology, and microstructure of thin Cu films. Current efficiencies were measured to be approximately 100%, irrespective of the applied current density and solution pH. But these influenced residual stress, surface morphology, XRD pattern, and grain size of electrodeposited Cu thin film. The residual stress decreased with decreasing the surface roughness, but increased with increasing the fcc(111) peak strength of XRD patterns.

• 한국환경과학회지
• /
• 제6권4호
• /
• pp.313-322
• /
• 1997

한국수영만에서 잔차류장의 운동 위치에너지의 계절변화를 연구하기 위하여 우리는 에너지의 수지를 계산하고 조석에너지와 비교했다. 위치에너지는 겨울과 봄철에 크며, 밀도성층이 형성된 여름과 초가을에 작게 나타났다. 잔차류의 운동에너지는 계절적인 변화를 보이고 있으며, 단위면 적당 잔차류의 평균 운동에너지는 6.4$\times$$10^{-4}ergs s^{-1}cm^{-}2$이다. 수영 만에서 잔차류장의 계절변동은 조석잔차류의 운동에너지가 밀도류나 취송류의 운동에너지보다 큰 11월을 제외하고는 밀도류가 지배하고 있다. 잔차류의 주성분인 조석잔차류, 취송류 및 밀도류의 운동에너지의 평균백분율은 잔차류의 운동에너지에 대하여 각각 29.1%, 3.4%, 67.5% 이다. 단위면적당 잔차류의 운동에너지, 위치에너지 및 조석에너지의 비는 각각 1.0 : 6.7$\times$$10^3$ : 8.2$\times$$10^4$ 이다.

• 수산해양기술연구
• /
• 제58권2호
• /
• pp.159-174
• /
• 2022

Flow prediction was carried out through observational survey and three dimensional multi-layered numerical diagnostic model experiment to clarify the time and spatial structure of tidal current and residual flow dominant in the sea exchange and material circulation of the waters around Geumo Islands in the southern waters of Korea. The horizontal variation of tidal current is so large that it causes asymmetric tidal mixing due to horizontal eddies and the topographical effect creating convergence and dispersion of flow direction and velocity. Due to strong tidal currents flowing northwest-southeast, counterclockwise and clockwise eddies are formed on the left and right sides of the south of Sori Island. These topographical eddies are created by horizontal turbulence and bottom friction causing nonlinear effects. Baroclinic density flows are less than 5 cm/s at coastal area in summer and the entire sea area in winter. The wind driven currents assuming summer and winter seasonal winds are also less than 5 cm/s and the current flow rate is high in winter. Density current in summer and wind driven current in winter have a relatively greater effect on the net residual flows (tidal residual current + density current + density driven current) around Geumo Islands Sea area.

• 상하수도학회지
• /
• 제27권5호
• /
• pp.547-554
• /
• 2013

Chlorine has strong oxidizing power, also it is many advantages over other disinfectants such as the residual characteristic and economic feasibility. However, chlorine also has disadvantages such as creating disinfection by-products of chlorine as THMs. In particular, the most deadly disadvantage of chlorine is that it is extremely poisonous toxins about all alive lives. Disinfection with electrolysis water can be a very useful way Because you do not have to worry about chlorine's dangerous. In this study, we evaluated the potential as a disinfectant, across the evaluating disinfection effect and generating characteristic of by-products. The electrolyzed water could be obtained removal efficiencies of over 99.9 % the coliform by operating condition such as residence time, current density (voltage), the electrode gap. The residual chlorine be generated 10,000 mg/L in current density $1.0A/dm^2$ and residence time of 10 minutes. The residual chlorine concentration was possible to maintain a stable. The by-products generated by high concentration residual chlorine in the reactor such as trihalomethanes, haloaceticacid, chloralhydrate, haloacetonitrile were detected in less than a water quality standards. At the concentration of less than residual chlorine of 1 ppm, the chlorine disinfection by-products be generated most below the detection limit.

• 한국결정성장학회지
• /
• 제9권6호
• /
• pp.535-541
• /
• 1999

Low-dislocation-density large-diameter GaAs single crystals with low-residual-strain have been strongly required. We have developed dislocation-free 3-inch Si doped GaAs crystals for photonic devices, and low-dislocation-density low-residual-strain 4-inch to 6-inch semi-insulating GaAs crystals for electronic devices by Vertical Bridgman(VB) technique. We confirmed that VB substrates with low-residual-strain have higher resistance against slip-line generation during MBE process. VB-GaAs single crystals show uniform radial profile of resistivity reflecting to the flat solid-liquid interface during the crystal growth. Uniformity of micro-resistivity of VB-GaAs substrate is much better than of the LEC-GaAs substrate, which is due to the low-dislocation-density of VB-GaAs single crystals.