• The Korean Journal of Petroleum Geology
• /
• v.14 no.1
• /
• pp.36-44
• /
• 2008

Natural gas in tight reservoirs, one of unconventional hydrocarbon resources, has become a significant exploration and exploitation targets. Tight gas reservoirs are the gas-bearing rocks that commonly have a permeability of less than 0.1 millidarcy (mD). Tight gas reservoirs are characterized by extensive and deep locations as well as abnormal pressure such as over- or under-pressure. The tight gas reservoirs are independent of structural or stratigraphic traps, whereas conventional gases normally occur at these traps. Tight gas reservoirs can be productive when stimulated by hydraulic fracturing. Better production areas within the tight reservoir beds are referred to as sweet spots that are commonly caused by natural fractures, which should be understood and identified to enhance the recovery of the gas from tight reservoirs. The exploration and production techniques allow the commercial production of tight gas, one of environmentally friendly resources. Slant and horizontal wells have best production when they intersect the fractures. Gas production from the tight reservoirs has rapidly grown in U.S. and Canada. Indeed, the U.S. gas production of tight sandstones increases from 11.1% in 1990 to 24.1% in 2005. The presence of tight gas reservoirs has been suggested on the Korean offshore block 6-1. Paradigm shift from conventional to unconventional tight reservoir is required to develop the tight gas from the block.

• Geophysics and Geophysical Exploration
• /
• v.14 no.3
• /
• pp.203-213
• /
• 2011

Time-lapse seismic surveys make repeated seismic surveys at different stages of oil production of a hydrocarbon reservoir to monitor changes in reservoir like fluid saturation. Since the repeatable surface seismic measurements can identify fluid types and map fluid saturations, oil and gas companies can make much more informed decision during not only production but also drilling and development. If time-lapse seismic surveys compare 3D seismic surveys, the time-lapse surveys are widely called as 4D seismic. A meaningful time-lapse interpretation is based on the repeatability of seismic surveys, which mainly depends on improved positioning and reduced noise (if surveys were designed properly through a feasibility study). The time-lapse interpretation can help oil and gas companies to maximize oil and gas recovery. This paper discusses about time-lapse seismic surveys mainly focused on feasibility, repeatability, data processing and interpretation.

• Geophysics and Geophysical Exploration
• /
• v.15 no.1
• /
• pp.39-46
• /
• 2012

Recently, stratigraphic reservoirs are getting more attention than structural reservoirs which have mostly developed. However, recognizing stratigraphic thin gas reservoirs in a stacked section is usually difficult because of tuning effects. Moreover, if the reflections from the brine-saturated region of a thin layer have the same polarity with those from the gas-saturated region, we could not easily identify the gas reservoir with conventional data processing technique. In this study, we introduced a way to delineate the gas-saturated region in a thin layer reservoir using a spectral decomposition method. First of all, amplitude spectrum with the variation of the frequency and the incident angle was investigated for the medium which represents property of Class 3, Class 1 or Class 4 AVO response. The results show that the maximum difference in the amplitude spectra between brine and gas-saturated thin layers occurs around the peak frequency independent of the incident angle and the type of AVO responses. In addition, the amplitude spectra of the gas-saturated zone are greater than those of brine-saturated one in Class 3 and Class 4 at the peak frequency while those of phenomenon occur oppositely in Class 1. Based on the results, we applied spectral decomposition method to the stacked section in order to distinguish the gas-saturated zone from the brine-saturated zone in a thin layer reservoir. To verify our new method, we constructed a thin-layer velocity model which contains both gas and brine-saturated zones which have the same reflection polarities. As a result, in the spectral decomposed sections near the peak frequency obtained by Wigner-Ville Distribution (WVD), we could identify the difference between reflections from gas- and brinesaturated region in the thin layer reservoir, which was hardly distinguishable in the stacked section.

• Tunnel and Underground Space
• /
• v.23 no.6
• /
• pp.538-546
• /
• 2013

This paper deals with a hydraulic fracturing technique, which is one of the methods to maximize the recovery rate and productivity of oil and gas in the petroleum industry. In the hydraulic fracturing, typically water mixed with sand and chemicals is injected into a wellbore in order to create artificial fractures along which formation fluids migrate to the well. In recent years, it is widely used in non-conventional oil and gas such as oil shale and shale gas. Three main stages of the hydraulic fracturing process, the proposed design models for the effective hydraulic fracturing and diagnostics after fracturing treatment are introduced. In addition, this paper introduces reservoir geomechanics to solve various problems in the process of hydraulic fracturing.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.1
• /
• pp.61.2-61.2
• /
• 2011

HI gas disks are known to be the largest ISM reservoir in most late type galaxies. When the HI properties of galaxies such as total mass, density, and distribution change, the galaxies may evolve quite differently. In this talk, I will present two groups of galaxies, one undergoing HI stripping and one accreting more gas. I will discuss causes of gas stripping and accretion, and possible consequences in galaxy evolution.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.547-547
• /
• 2013

This paper presents the understandings carried out for the installation of the hydrogen reservoir of the multi-gap pseudospark switch under developing for the accelerator applications. As a cold cold cathode switch, the pseudospark switch could replace the thyratron switch which has hot cathode and being used well currently in the high power field such as laser and accelerator applications. Especially in the klystron modulator, the key component is a switch which mostly defines the jitter and the instability of the modulator system. To get the less jitter and the instability, we need to find proper range of the pressure for the gas discharge inside gas switch. This could be achieved by the understanding of the characteristic of the nonevaporable getter (NEG) which is used as a hydrogen reservoir for the switch. Therefore we verified the characteristics of the NEG (St 172, Saes) and its installation in the switch. Finally we controlled the getter to find best pressure point for the pseudospark switch.

• Journal of the Korean Institute of Gas
• /
• v.27 no.2
• /
• pp.39-48
• /
• 2023

This study presents the experimental results to measure the adsorption amount of methane gas by coal according to the conditions of a coalbed methane (CBM) reservoir. Adsorbed gas to coal seam particles was measured under reservoir conditions (normal pressure ~ 1,200 psi pressure range, temperature range15 ~ 45℃) using coal samples obtained from random mines in Kalimantan Island, North Indonesia. The obtained amount of absolute adsorbed gas was applied to triangular with linear interpolation to calculate the maximum amount of adsorbed gas according to temperature and pressure change, at which no experiment was performed. As a result, it was revealed that the amount of adsorbed gas to coal particles increased as the pressure increased and temperature decreased, but the increase of the amount of adsorbed gas decreased at more than an appropriate depth(1,000 ft). In the cleat permeability and cleat porosity for each depth of the coal bed considering the effective stress, the cleat permeability was 28.86 ~ 46.81 md, and the cleat porosity was 0.83 ~ 0.98%. This means that the gas productivity varies significantly with the depth because the reduction of the permeability according to the depth in the coal seam is significant. Therefore, a coalbed depth should be considered essential when designing the spacing of production wells in a coalbed methane reservoir in further study.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.26 no.4
• /
• pp.387-394
• /
• 2017

This paper develops a pump system for patient with chronic pain or cancer. The pump module is consists of two micro-valve and membrane. The micro-valve is operated by a solenoid. With two solenoid valves which are connected via a drug transport line, the inlet and outlet are completely blocked. A silicon rubber membrane located between the two valves makes the flow-rate constant without any backflow. This pump module can control the flow-rate of drugs by controlling the time that the valves are opened and closed. The reservoir consists of a drug chamber and a gas chamber. As the gas chamber encloses the drug chamber, propellant gas which is injected into the gas chamber pressurizes the drug chamber regardless of volume of the drug chamber. To design the pump module, analysis a constant efficiency test, and accuracy test for the pump module were conducted.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.57 no.5
• /
• pp.113-122
• /
• 2015

This study aims to evaluate future stream flow by the operation of agricultural reservoir group at the upper stream of the Miho River. Four agricultural reservoirs with storage capacities greater than one million cubic meters within the watershed were selected, and the RCP 8.5 climate change scenario was applied to simulate reservoir water storage and stream flow assuming that there are no changes in greenhouse gas reduction. Reservoir operation scenarios were classified into four types depending on the supply of instream flow, and the water supply reliability of each reservoir in terms of water supply under different reservoir operation scenarios was analyzed. In addition, flow duration at the watershed outlet was evaluated. The results showed that the overall run-off ratio of the upper stream watershed of the Miho River will decrease in the future. The future water supply reliability of the reservoirs decreased even when they did not supply instream flow during their operation. It would also be difficult to supply instream flow during non-irrigation periods or throughout the year (January-December); however, operating the reservoir based on the operating rule curve should improve the water supply reliability. In particular, when instream flow was not supplied, high flow increased, and when it was supplied, abundant flow, ordinary flow, and low flow increased. Drought flow increased when instream flow was supplied throughout the year. Therefore, the operation of the agricultural reservoirs in accordance with the operating rule curve is expected to increase stream flow by controlling the water supply to cope with climate change.

• Earthquakes and Structures
• /
• v.16 no.5
• /
• pp.523-532
• /
• 2019

Different types of gas reservoir such as Liquid Natural Gas (LNG) are among the strategic infrastructures, and have great importance for any government or their private owners. To keep the tank and its contents safe during earthquakes especially if the contents are of hazardous or flammable materials; using seismic protection systems such as base isolator can be considered as an effective solution. However, the major deficiency of this system can be the large deformation in the isolation level which may lead to the failure of bearing system. In this paper, as a solution, the efficacy of an optimally designed combined vibration control system, the combined laminated rubber isolator and rotational friction damper, is investigated to evaluate the enhancement of an existing metal tank response under both far- and near-field earthquakes. Responses like impulsive and convective accelerations, base shear, and sloshing height are studied herein. The probabilistic framework is used to consider the uncertainties in the structural modeling, as well as record-to-record variability. Due to the high calculation cost of probabilistic methods, a simplified structural model is used. By using the Mont-Carlo simulation approach, it is revealed that this combined isolation system is a highly reliable system which provides considerable enhancement in the performance of reservoir, not only leads to the reduction of probability of catastrophic failure of the tank but also decrease the reservoir damage during the earthquake. Moreover, the relative displacement of the isolation level is controlled very well by this combined system.