• Earthquakes and Structures
• /
• 제15권2호
• /
• pp.165-178
• /
• 2018

The aim of this study is to investigate the efficiency of using threaded rods and steel profiles to produce a steel confining system for rehabilitation of damaged concrete corbels for the first time in literature. Some of the specimens were repaired by crack repair epoxy before being confined for further enhancement. A total of 19 two sided damaged corbels were used in the study with different mechanical properties and parameters but similar dimensions. The differences were in rehabilitation style, shear span, fiber percentage, reinforcement steel diameter, and concrete strength. The rehabilitated specimens were loaded with vertical load until failure. Four different configurations were used in the investigation. Test results show that the proposed rehabilitation technique is effective to enhance the load capacity of the corbels and to improve their ductility. Moreover, new formulations were proposed to calculate the load capacity of the rehabilitated corbels. A good fit was observed between numerical and experimental results.

• International Journal of Contents
• /
• 제10권3호
• /
• pp.90-95
• /
• 2014

The purpose of this study was to analyze the changes in muscle fatigue by using electromyography (EMG) measurements of the median frequency of shoulder muscles of patients who underwent rotator cuff repair, and to provide basic data for efficient exercise methods during rehabilitation after the repair. In the study, 24 male and 8 female patients who underwent rotator cuff repair performed continuous passive shoulder joint motion for 3 weeks and the median frequency of their shoulder muscles before and after the repair were compared using measurements by EMG. The infraspinatus, supraspinatus, and serratus anterior muscles showed significant differences in the changes in the median frequency before and after the repair. Significant differences were also found in the median frequency of the three muscles both before and after the repair. Additionally, the middle deltoid muscle had a lower median frequency than the supraspinatus muscle before the repair and the infraspinatus muscle had a lower median frequency than the middle deltoid muscle after the repair. It is expected that these results will serve as important data in developing rehabilitation exercise programs for the infraspinatus, supraspinatus, and serratus anterior muscles by compensating the middle deltoid muscle with the lowest muscle fatigue after the rotator cuff repair erase.

• 한방재활의학과학회지
• /
• 제28권1호
• /
• pp.109-120
• /
• 2018

Objectives This is one of the manuals of East-west integrative medicine which was created by the Committee on integrative medicine of Chung-Yeon Korean Medicine Hospital. The purpose of this manual is to support clinical decision making and communication during the rehabilitation of patients after shoulder surgery. Methods The drafting was done by two rehabilitation specialists in Korean medicine. After a rehabilitation specialist in western medicine reviewed the draft and exchanged their ideas, a revised version that reflects the goal of consultation was made. Then the Committee agreed to adopt the manuals through the process of review and feedback in addition to face-to-face discussions. Results This manual describes clinical decision making for rehabilitation after arthroscopic rotator cuff repair, SLAP repair, and arthrolysis. Therefore it contains the schedule of rehabilitation treatment through the surgical technique, general goal of the rehabilitation by phase, guide for patients and postoperative infection management. Conclusions The proposal of this manual has a significance for it provides information about decision making process and contents of treatment in one medical institution for East-west integrative rehabilitation treatment after shoulder surgery.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1997년도 가을 학술발표회 논문집
• /
• pp.647-652
• /
• 1997

Repair and rehabilitation of existing structures is becoming a major part of construction, both in the industrially developed and developing countries. Advanced high strength composites are being utilized more and more for these applications because they are much stronger than steel, non-corrosive, and light. The light weight reduces the construction cost and time sustantially. The fibers are normally made of aramid, carbon, or glass and the binders are typically epoxies or esters. One major disadvantage of these composites is the vulnerability to fire. In most instance, the temperature cannot exceed $300^{\cire}C$. Since carbon and glass can substain high temperatures, an inorganic polymer is being evaluated for use as a matrix. The matrix can sustain more than $1000^{\cire}C$. The results reported in this paper deal with the mechanical properties of carbon composites made with the inorganic polymer and the behavior strengthened reinforced concrete beams. The results indicate that the new matrix can be successfully utilized for a number of applications.

• Architectural research
• /
• 제7권2호
• /
• pp.81-89
• /
• 2005

Over the years, existing bridges have had various degrees of maintenance to extend the service life. As the existing bridges continue to deteriorate, however, each Department of Transportation (DOT) of the United States of America faces increasing demands on the limited funds available for bridge maintenance. Therefore, it is very important for State Department of Transportations to establish Maintenance, Repair, and Rehabilitation (MR&R) strategies for bridge structures such that funds get allocated for appropriate maintenance over the service life. This paper identifies the state-of-art and the state-of-practice of MR&R actions and the use of MR&R strategies in concrete bridge decks. In addition, a questionnaire survey was conducted to identify the type and timing for MR&R actions as well as existing MR&R strategies taken in concrete bridge deck by each DOT. This paper also presents the results of the survey.

• Steel and Composite Structures
• /
• 제9권2호
• /
• pp.103-118
• /
• 2009

It has been reported that more than thirty five percent of steel bridges in the USA are structurally deficient because of structural degradations. The degraded structures need either full replacement or rehabilitation such that they are able to provide the required services for a longer period of time. The cost for repair in most cases is far less than the cost of replacement. Moreover, repair method generally takes less time than replacement and also reduces service interruption time. Modern advanced composites have been used in aerospace and automotive fields since World War II. In the recent past, because of the high strength-to-weight ratio and high stiffness-to-weight ratio, these composite materials have been introduced to civil engineering infrastructures primarily for repair and rehabilitation of concrete structures. However, only a few preliminary studies on repair of corroded steel structures using theses composite materials are reported in the literature available in the public domain. Thus, in this study, a series of laboratory tests was undertaken to evaluate the effectiveness of this repair method using carbon fiber reinforced polymer composite. The paper discusses the test method and test results obtained from these tests.

• 대한물리의학회지
• /
• 제9권4호
• /
• pp.485-492
• /
• 2014

PURPOSE: This study aimed to examine the pain, range of motion (ROM), upper extremity task performance, and functional levels of patients after rotator cuff repair according to the timing of a closed chain exercise thereby presenting basic data for an effective rehabilitation program. METHODS: The intervention was applied three times per week, one hour per day, for four weeks to 40 participants, 78 of whom had undergone rotator cuff repair. The participants were divided into four groups and assigned to usual general physical therapy and an open chain exercise. Group I consisted of the open chain exercise only. The closed chain exercise was applied to group II after the 4 times, group III after the 7 times, group IV after the 10 times. Measurement were used ROM, visual analogue scale (VAS), box and block test (BBT), and shoulder pain and disability index (SPADI). A one-way analysis of variance was conducted to test differences. RESULTS: There were significant differences in the internal/external rotation between group I and group II. The VAS significantly differed between group II and group I, group III, and group IV. The BBT results of group II and group I were significantly different compared to those of group IV. The SPADI significantly differed between group II and group I and between group II and group IV. CONCLUSION: The closed chain exercise was effective for patients following rotator cuff repair from the second week after active exercise was prescribed, verifying its applicability in rehabilitation programs.

• Clinics in Shoulder and Elbow
• /
• 제25권4호
• /
• pp.334-338
• /
• 2022

Currently, the literature contains few studies that describe any potential complications following arthroscopic acromioplasty. Because part of the anterior deltoid originates from the anterior acromion, there is a risk for violation and subsequent iatrogenic rupture or avulsion during this procedure. This type of injury can be a devastating problem for patients that may lead to poor function and debilitating pain. We present a patient with deltoid insufficiency following arthroscopic acromioplasty who elected to proceed with operative management with a planned arthroscopic evaluation of the shoulder followed by an open deltoid repair. At the final follow-up visit 2.5 years postoperatively, the patient reported improved pain from baseline and no residual disability and was able to perform most activities of daily living without difficulty. This case serves as an example of a surgical repair for a deltoid avulsion following arthroscopic acromioplasty. As there is still a lack of standard guidelines, our suture repair technique can be considered one method of treatment for this type of injury.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1996년도 가을 학술발표회 논문집
• /
• pp.416-424
• /
• 1996

Reinforced Concrete structures need repair and rehabilitation due to the deterioration such as crack, spalling and disintegration. Numerous repair materials which are currently used in cinstruction fields witdout any specifications are examined in terms of their serviceabilities and effectiveness. In this paper sections of R/C beams are enlarged with repari material(epoxy, latex, premix), and then they are strengthened with rebar, steel plate of CFRP sheet on the tension side. Structural behaivior of strengthened beams are investigated under stactic tests and compared with each parameters.

• 산업기술연구
• /
• 제26권B호
• /
• pp.101-110
• /
• 2006

The purpose of this study was to investigate the flexural, interfacial behavior, crack propagation, nonlinear behavior, effect repaired and rehabilitated with VES-LMC using RC beam with 4-point-loading test. The results were following: The test result showed that repair and rehabilitation effect increased as its depth increased, which was verified by the increase of flexural stiffness. More than 40% of stiffness was improved when the depth of repair was up to steel position. However, there was a little difference between 8cm and 12cm repaired beam. This means the repair depth must be considered. The interfacial behavior data showed that the repaired or rehabilitated beams had a little relative displacement. This means that two materials behave comparatively acting together. This suggested that interface treatment were one of the most important jobs in composite beams.