• Journal of Pharmaceutical Investigation
• /
• v.21 no.2
• /
• pp.91-95
• /
• 1991

Polyethylene glycol, polypropylene glycol and block copolymer of ethylene glycol and propylene glycol were crosslinked by triisocyanate to form water swellable, rubbery polymer. The equilibrium swelling of the hydrogels ranged from 3% to 60% according to the hydrophobic-hydrophilic properties of the prepolymers. Model drugs, sodium salicylate and prednisolone were incorporated in the polymer matrices by swelling loading. Physical properties of the drugs affected the drug release mechanisms due to the change in the swelling behaviors of the polymeric devices. Zero order release was observed in the case of relatively hydrophobic polymer matrices.

• Journal of Pharmacopuncture
• /
• v.19 no.3
• /
• pp.239-245
• /
• 2016

Objectives: This study was conducted to clarify the effects of agarwood on histamine release from mast cells in rats and on the scratching behaviors in mice. Methods: Histamine release from rat mast cells induced by compound 48/80 or concanavalin A (Con A) and compound 48/80-induced scratching behavior in mice were examined to investigate the effects of agarwood. The hyaluronidase activity and the 3',5'-cyclic adenosine monophosphate (cAMP) levels in mast cells were examined to investigate the mechanisms for the inhibition of histamine release. The correlation between the inhibitory effects of agarwood on histamine release and the content of its typical ingredients, a 2-(2-phenylethyl)chromone derivatives, was analyzed using thin-layer chromatography. Results: Agarwood showed an inhibitory effect on mast-cell histamine release induced by compound 48/80 or Con A without any effect on hyaluronidase activity; this effect involves an increase in the cAMP levels in mast cells. Oral administration of agarwood showed an inhibitory effect on compound 48/80-induced scratching behavior in mice. The inhibitory effects of agarwood on histamine release were quite different, depending on the area where the agarwood was produced, its quality, and its market price. No correlation was found between the inhibitory effects of agarwood on histamine release and the typical ingredients of agarwood, which are 2-(2-phenylethyl)chromone derivatives. Conclusion: These results show that agarwood inhibits histamine release from mast cells partially through an increase in the cAMP levels in cells. We suggest that some active ingredients of agarwood must be effective on oral intake and that agarwood can be used to treat patients with a number of conditions, including urticaria, atopic dermatitis, and bronchial asthma, in which an increase in histamine release occurs. Differences in the pharmacological effects of this crude drug among markets may provide important information for the quality control of this herbal medicine.

• Korean Chemical Engineering Research
• /
• v.43 no.4
• /
• pp.482-486
• /
• 2005

The biodegradable poly(${\varepsilon}$-caprolactone)(PCL)/poly(ethylene imine)(PEI) microcapsules containing $Al_2O_3$ and fragrant oil were prepared with different PEI contents. The effects of stirring rate and concentration of the surfactant on the diameter and morphologies of microcapsules were investigated by using scanning electron microscope (SEM). Thermal behaviors were studied by using a differential scanning calorimetry(DSC), and the release behaviors of fragrant oil from microcapsule were characterized by UV/vis. spectrophotometer. As a result, the average particle size of the microcapsules decreased with increasing the stirring rate or concentration of the surfactant. The surface morphologies of the microcapsules were changed from smooth surfaces to skin-like rough surfaces as increasing the PEI content. These results were mainly due to the increased hydrophilic groups at the microcapsule surfaces, resulting in increasing the release rate of fragrant oil in the microcapsules studied.

• Polymer(Korea)
• /
• v.31 no.3
• /
• pp.177-183
• /
• 2007

In this study, nano-sized poly(vinyl acetate) (PVAc) particles containing lavender oil as a core material were prepared by using emulsification-diffusion method. Effects of experimental parameters on the characteristics and the release behavior were examined with a field emission- scanning electron microscope, an electrophoretic light scattering spectrophotometer, a visible spectrophotometer and a high performance liquid chromatography The resulting aromatic particles could be prepared in nano-sized globular shapes with the mean particle size of 224 nm by controlling the experimental conditions. From the evaluation of release properties of aromatic PVAc nanoparticles with or without PVA coating, it was found that the aromatic particles coated with PVA show more sustaining and stable release behaviors. Our research on aromatic PVAc nanoparticles could be applied for durable fragrant finishing for textiles, leather products and so on.

• Child Health Nursing Research
• /
• v.8 no.4
• /
• pp.458-468
• /
• 2002

The purpose of this study was to identify metacommunicative behaviors between nurses and patients in a pediatric unit. The research method included observation using videotaping. Data were collected from December, 2001 to February, 2002. Total six nurses, and eight patients and their mothers in a pediatric unit participated in this study. The interactions were videotaped under the participants' consent. The participants were observed for total 8 hours over 2-day period. Special episodes which were identified as metacommunicative behaviors in the taped interactions were transcribed. Transcription included verbal and nonverbal interactions. Selected episodes were classified using Mitchell's definition. Each classified definitions were named, and categorized by its purpose. The results were as follows: Nineteen metacommunicative behaviors which used frequently by nurses-approaching, mediating eye level, eye contact, touching, encouraging, turnabout, mimic voice, giving choices, friendly demand, expansion, tagging, repeating and confirming, identification, reflection, baby talk, symbolization, description of acts, relaxed posture, turning away- were identified and organized into four categories. They were call for attention, facilitating response, empathy, and tension release. In conclusion, nurses in this study used metacommunicative behaviors frequently and these behaviors were effective in interacting with children. It is suggested that any educational programs to teach communication skills to nurses need to include techniques on metacommunicative behaviors. This will help nurses to be more sensitive to different characteristics of their patients.

• Nuclear Engineering and Technology
• /
• v.55 no.8
• /
• pp.2977-2983
• /
• 2023

During normal operation, some parts of the fission product in the defective fuel rods can release into the primary loops in PWR and the escape rate coefficients are widely used to assess quantitatively the release behaviors of fission products in the industry. The escape rate coefficients have been standardized and have been validated by some drilling experiments before the 1970s. In the paper, the model to determine the escape rate coefficients of fission products has been established and the typical escape rate coefficients of noble gas and iodine have been deduced based on the measured radiochemical data in one operating PWR. The result shows that the apparent escape rate coefficients vary with the release-to-birth and decay constants for different fission products of the same element. In addition, it is found that the escape rate coefficients from the defective rod with large defects are much higher than the standard escape rate coefficients, i.e., averagely 4.4 times and 1.8 times for noble gas and iodine respectively. The enhanced release of fission products from the severe secondary hydriding of several defective fuel rods in one cycle may lead to the potential risk of the temporary shutdown of the operating reactors.

• Journal of Radiation Protection and Research
• /
• v.42 no.2
• /
• pp.114-129
• /
• 2017

Background: The purpose of this paper is to confirm the event timings and the magnitude of fission product aerosol release from the Fukushima accident. Over a few hundreds of technical papers have been published on the environmental impact of Fukushima Daiichi accident since the accident occurred on March 11, 2011. However, most of the research used reverse or inverse method based on the monitoring of activities in the remote places and only few papers attempted to estimate the release of fission products from individual reactor core or from individual spent fuel pool. Severe accident analysis code can be used to estimate the radioactive release from which reactor core and from which radionuclide the peaks in monitoring points can be generated. Materials and Methods: The basic material used for this study are the initial core inventory obtained from the report JAEA-Data/Code 2012-018 and the given accident scenarios provided by Japanese Government or Tokyo Electric Power Company (TEPCO) in official reports. In this research a forward method using severe accident progression code is used as it might be useful for justifying the results of reverse or inverse method or vice versa. Results and Discussion: The release timing and amounts to the environment are estimated for volatile radioactive fission products such as noble gases, cesium, iodine, and tellurium up to 184 hours (about 7.7 days) after earthquake occurs. The in-plant fission product behaviors and release characteristics to environment are estimated using the severe accident progression analysis code, MELCOR, for Fukushima Daiichi accident. These results are compared with other research results which are summarized in UNSCEAR 2013 Report and other technical papers. Also it may provide the physically based arguments for justifying or suspecting the rationale for the scenarios provided in open literature. Conclusion: The estimated results by MELCOR code simulation of this study indicate that the release amount of volatile fission products to environment from Units 1, 2, and 3 cores is well within the range estimated by the reverse or inverse method, which are summarized in UNSCEAR 2013 report. But this does not necessarily mean that these two approaches are consistent.

• International Journal of Concrete Structures and Materials
• /
• v.19 no.1E
• /
• pp.25-32
• /
• 2007

The fracture energy evaluated from the previous experimental results can be simulated by using the modified singular fracture process zone (S-FPZ) model. The fracture model has two fracture properties of strain energy release rate for crack extension and crack close stress versus crack width relationship $f_{ccs}(w)$ for fracture process zone (FPZ) development. The $f_{ccs}(w)$ relationship is not sensitive to specimen geometry and crack velocity. The fracture energy rate in the FPZ increases linearly with crack extension until the FPZ is fully developed. The fracture criterion of the strain energy release rate depends on specimen geometry and crack velocity as a function of crack extension. The behaviors of micro-cracking, micro-crack localization and full development of the FPZ in concrete can be explained theoretically with the variation of strain energy release rate with crack extension.

• The Korean Journal of Physiology and Pharmacology
• /
• v.26 no.5
• /
• pp.307-312
• /
• 2022

It is well known that dopamine transmission from the ventral tegmental area (VTA) modulates motivated behavior and reinforcement learning. Although dopaminergic neurons are the major type of VTA neurons, recent studies show that a significant proportion of the VTA contains GABAergic and type 2 vesicular glutamate transporter (VGLUT2)-positive neurons. The non-dopaminergic neurons are also critically involved in regulating motivated behaviors. Some VTA neurons appear to co-release two different types of neurotransmitters. They are VGLUT2-DA neurons, VGLUT2-GABA neurons and GABA-DA neurons. These co-releasing neurons show distinct features compared to the neurons that release a single neurotransmitter. Here, we review how VTA cell populations wire to the other brain regions and how these projections differentially contribute to motivated behavior through the distinct molecular mechanism. We summarize the activities, projections and functions of VTA neurons concerning motivated behavior. This review article discriminates VTA cell populations related to the motivated behavior based on the neurotransmitters they release and extends the classical view of the dopamine-mediated reward system.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.9 no.6
• /
• pp.476-481
• /
• 2004

The aim of this study was to formulate a sustained release system for indomethacin (IND) with rosin gum obtained from a pine tree. Rosin microparticles were prepared by a disper­sion and dialysis method without the addition of surfactant. In order to investigate the influence of solvents on the formation of colloidal microparitcles, various solvents like ethanol, DMF, DMAc, and acetone were used. The rosin microparticles containing IND were characterized by X­ray differactometry (XRD) and differential scanning calorimetry (DSC). The morphologies of rosin microparticles observed by scanning electron microscopy (SEM) were spherical. The solvents used to dissolve rosin significantly affected the drug content and drug release rate of IND. The release behaviors of IND from the rosin microparticles were dependent on the drug content and size of the particles. Rosin micorparticles with a higher drug content and of a larger particle size had a slower drug release rate. Also, the IND release rate from the rosin microparticles could be regulated by the rosin content in the microparticles. From these results, rosin microparticles have the potential of being used as a sustained release system of IND.