• Korean Journal of Materials Research
• /
• v.8 no.10
• /
• pp.961-968
• /
• 1998

In order to investigate the effects of substrate bias voltage on the formation of$ZnS-SiO_2$ protective film in phase change optical disk by R.F. magnetron sputtering method, thin dielectric film was formed on Si wafer and Corning glass by using ZnS(80mol%)-$SiO_2$(20mol%)t arget under argon gas. In this study, the Taguchi experimental method was applied in order to obtain optimum conditions with reduced number of experiments and to control numerous variables effectively. At the same time this method can assure the reproducibility of experiments. Optimum conditions for film formation obtained by above method were target RF power of 200 W. substrate RF power of 20 W, Ar pressure of 5 mTorr. sputtering time of 20 min.. respectively. The phase of specimen was determined by using XRD and TEM. The compositional analysis of specimen was performed by XPS test. In order to measure the thermal resistivity of deposited specimen, annealing test was carried out at $300^{\circ}C$ and $600^{\circ}C$. For the account of void fraction in thin film, the Bruggeman EMA(Effective Medium Approximation) method was applied using the optical data obtained by Spectroscopic Ellipsometry. According to the results of this work, the existence of strong interaction between bias voltage and sputtering time was confirmed for refractive index value. According to XRD and TEM analysis of specimen, the film structure formed in bias voltage resulted in more refined structures than that formed without bias voltage. But excess bias voltage resulted in grain growth in thin film. It was confirmed that the application of optimum bias voltage increased film density by reduction of void fraction of about 3.7%.

• Korean Journal of Materials Research
• /
• v.9 no.12
• /
• pp.1245-1251
• /
• 1999

Phase-change optical disk very rapid recording, high densification of data, resulting in high feedback rate and good C/N(carrier to noise) ratio of a feedback signal. However, repetitive thermal energy may cause the deformation of a disk or the lowering of an eliminability and a cyclability of the recording. The lowering of the cyclability can be reduced by insertion of thin layer of ZnS-$SiO_2$ dielectric thin film in appropriate disk structure between the upper and lower part of the recording film. Using the Taguchi method, optimum conditions satisfying both the optimized quality characteristic values and the scattering values for film formation were found to be the target R.F. power of 200W, the substrate R.F. power of 20W, the Ar pressure of 6mTorr, and the electrode distance of 6cm. From the refractive index data, the existence of the strong interaction between the electrode distance and Ar pressure was confirmed, and so was the large effect of the electrode distance on transmittance. According to the analysis of TEM and XRD, the closer the electrode distance was, the finer was the grain size due to the high deposition rate. However, the closer electrode distance brought the negative effect on the morphology of the film and caused the reduction of transmittance. AFM and SEM analyses showed that the closer the electrode distance was, the worse was the morphology due to the high rate of the deposition. Under optimum condition, the deposited thin film showed a good morphology and dense microstructure with less defects.

• Journal of the Korean Applied Science and Technology
• /
• v.35 no.1
• /
• pp.99-110
• /
• 2018

In this study, oil of Platycodon grandiflorum seeds was prepared using supercritical carbon dioxide extraction (SCE) and its physicochemical indices as a new edible oil were investigated. Compared to Soxhlet solvent extraction, SCE under the condition of 6,000 psi at $40^{\circ}C$ produced more oil, especially from the roasted seeds to 32.7%. TLC analysis showed triacylglycerols accounted for most of the oil obtained from roasted Platycodon grandiflorum seeds by SCE similarly to commercial soybean oil or perilla seeds oil. The oil had highly unsaturated lipid with considerable amount of linoleic acid(73.27%) much more than two commercial oils followed by oleic acid(13.16%). Physicochemical properties of the oil were as follows; specific gravity, 0.92; dynamic viscosity, 45.37 cP; refractive index, 1.48; color, L=47.30, a=-3.69, b=25.72; iodine value, 141.57 g $I_2/100g$ oil; saponification value, 191.21 mg of KOH/g of oil; acid value, 2.60 mg of KOH/g of oil. Among those, refractive index, viscosity and iodine value, which were related to unsaturation degree of lipid, were ranged between those of two commercial oils. The oxidation stability of oil(2.03 hr) was also ranged between less stable perilla seeds oil(1.79 hr) and more stable soybean oil(2.94 hr) based on the induction time measured by Rancimat assay. In addition to extraction yield increase, seeds roasting provided further benefits such as reductions of cholesterol ester content and acid value without change in fatty acid composition. In conclusion, oil was extracted from the roasted Platycodon grandiflorum seeds at high yield by supercritical carbon dioxide and it seemed to have proper characteristics as a edible oil.

• Korean Journal of Optics and Photonics
• /
• v.13 no.3
• /
• pp.197-203
• /
• 2002

The TiO$_2$ coating solutions were synthesized with different concentrations (T1-0.7N, T2-2.0N) of hydrochloric acid used as catalyst. and TiO$_2$ thin films were prepared by sol-gel dip coating. Their structural and optical properties were examined as a function of calcination temperature. XRD results showed that T1 thin films calcined at 400~80$0^{\circ}C$ had the anatase phase, while those calcined at 100$0^{\circ}C$ had the rutile phase. T2 thin films calcined at 40$0^{\circ}C$ and $600^{\circ}C$ had the anatase phase, with the rutile phase for calcination at 80$0^{\circ}C$. Crystallinity of T2 thin films was superior to that of T1 thin films. The crystallite size of TiO$_2$ thin films increased with increasing calcination temperature, and the crystallite size of anatase phase in T2 thin films was larger than that in T1 thin films, but the crystallite size of rutile phase in T2 thin films was smaller. The surface morphology of the films showed that the films were formed more densely in the rutile phase than in the anatase phase, this phenomenon appeared conspicuously in T2 thin films. The transmittance of the samples with thin films on quartz glass calcined at 100$0^{\circ}C$ was significantly reduced at wavelength range about 300-700 nm due to the increased absorption originating from the change of crystallite phase and composition of the films and the scattering effect originating from increasing crystallite size. The refractive index of TiO$_2$ thin films increased, and hence the film thickness as well as the porosity of TiO$_2$ thin films decreased with increasing calcination temperature. Furthermore, the refractive index of T2 thin films was higher than T1 thin films, and porosity of T2 films was lower.

• Journal of the Korean Chemical Society
• /
• v.12 no.2
• /
• pp.65-80
• /
• 1968

The physico-chemical properties of nine selected thallium borosilicate glasses and other 21 supplementary compositions were investigated. Their composition-property curves are found to be in many respects analogous to those of other borosilicate glasses containing lithia, soda, and lead oxide. It is indicated that certain minima found in the composition-property curves of thallium borosilicate glasses might be caused by a change in boron coordination as has been observed to occur in the $Na_2O-B_2O_3-SiO_2$ glasses. Typical effects of thallium ions on the borosilicate glass are summarized as follows: 1) Addition of thallium ions increased density, refractive index, water solubility, linear coefficient of thermal expansion, and dielectric constant. 2) Increased concentration of thallium decreased the softening point of the glasses, caused fluorescence under ultraviolet radiation and smeared out the absorption edges up to $15{\mu}$ in the infrared region. An extensive liquid immiscibility was found by replication electron microscope technique in the $Tl_2O-B_2O_3-SiO_2$ system. The immiscibility covers a composition range roughly from 55 wt. % Tl2O to the binary system $B_2O_3-SiO_2.$ By acid treatment, it was found that the immiscible glass consists of separate silica-rich and boron-rich phases.

• Food Science and Preservation
• /
• v.19 no.3
• /
• pp.368-375
• /
• 2012

To decrease the intake of animal fat and cholesterol, the changes in the physicochemical characteristics of beef loin cooked through different methods (boiling, steaming, baking, and frying) were investigated. The cooking weight loss, moisture drain rate, and cholesterol drain rate were highest during frying, whereas the lipid drain rate was highest during boiling. The pH value increased markedly during steaming, the acid value of meat fat increased remarkedly during boiling, and the refractive index of meat fat increased notably upon frying. The hardness of meat was remarkedly increased by steaming. The gumminess and chewiness of meat were notably increased by frying. The springiness slightly decreased during all the cooking methods, and the cohesiveness was not significantly affected by any cooking process. The CIE $L^*$ (lightness) value increased markedly during boiling, the CIE $a^*$ (redness) value decreased markedly during both boiling and steaming, and the CIE $b^*$ (yellowness) value decreased notably during all the cooking methods. The fatty acid composition did not significantly change after cooking, except when the meat was fried. Therefore, boiling is an effective cooking method for beef loin to decrease the intake of animal fat.

• Journal of the Korean Society of Radiology
• /
• v.13 no.6
• /
• pp.825-830
• /
• 2019

A detector module measuring a depth of interaction was developed using silicon photomultiplier (SiPM) and two layers of scintillation crystal array treated with multiple reflectors. When reconstructing an image based on a signal obtained by using different types of reflector of each layer, the interaction positions of scintillation pixels and gamma rays could be tracked by utilizing the feature that all scintillation pixels were recorded at different positions. The bottom layer uses a specular reflector, and the top layer uses a diffuse reflector to differently process the size of the signal obtained from the SiPM. The optical grease was used to recude the sharp refractive index change between the layers of scintillator and the SiPM. The signals obtained from the 16 SiPMs were reduced to four signals using the Anger equations, and the images were reconstructed using them. All the scintillation pixels composed of the two layers appeared in the reconstructed image, which distinguished the layer where the scintillation pixels and gamma rays interacted. If the detectors, which measure the interaction depth of two layers using different reflectors, will be applied to preclinical positron emission tomography, the degradation of spatial resolution appearing outside the field of interest could be solved.