• 한국추진공학회지
• /
• 제3권2호
• /
• pp.18-24
• /
• 1999

액체 램제트 연소기는 흡입공기와 분무, 혼합 그리고 이에 따른 연소 등 일련의 과정에 따라 다수의 복잡한 현상들이 상호 밀접하게 관련되어 있으며, 이러한 반응 및 비반응 유동 특성을 파악하기 위해서 2차원 및 3차원 연소기 형상에 대해서 수치적 실험을 수행하였다 격자구성은 연소기에 공기를 공급하고 연료를 분무하는 공기 유입관 영역과 연소실 영역, 그리고 출구 대기 영역으로 나누어 격자를 생성시켰다. 비반응 유동해석을 통해서 연소실내의 선회영역 유동특성은 2차원과 3차원이 크게 차이가 남을 알 수 있었다. 반응 유동 해석에서는 분무 모델의 적용 유무에 따라 연소 형태가 크게 변화하였다. 연료의 분사위치를 유입관의 위쪽에 준 경우와 아래쪽에 준 두 가지 경우를 비교하였으며, 유입관의 아래쪽에 연료의 분사위치를 준 경우가 연소의 안정화에 필요한 재순환 영역으로의 연료의 유입이 잘 되어 유입관 위쪽에 연료를 분사시키는 것보다 좋은 분사위치임을 알 수 있었다.

• 한국대기환경학회:학술대회논문집
• /
• 한국대기환경학회 2010년도 춘계학술대회 논문집
• /
• pp.551-552
• /
• 2010

• 대한기계학회논문집B
• /
• 제23권6호
• /
• pp.788-794
• /
• 1999

The swirl flame is mostly used to stabilize the flame on the burner nozzle in the industrial combustor. In the case of the weak swirl flame(S<0.4), the recirculation zone could not be formed, but in the strong swirl(S>0.6) flame, it could be formed in the center of the swirl flame. In this study, the measurement and analysis of emission species, temperature, radicals of premixed swirl flame in the combustor were performed to understand the NO formation and emission characteristics of the swirl flame of natural gas. The result of NO emission in the swirl flame is that the amount of NO emission in the strong swirl flame decreased about 60% compared with that of the weak swirl flame. The main region of NO formation of the weak swirl flame is positioned in the down stream(z=100~200mm) of the flame, but that of the strong swirl flame is positioned in the up stream(z=40mm) where the recirculation zone seems to be formed. It is supposed that the increase of flame surface and the formation of inversed flame cause the reduction of the high temperature region on the production of NO in the strong swirl flame. The result of NO-temperature relation revealed that the factor of NO formation is not only temperature but also another parameters in the weak swirl flame, but in the strong swirl flame, NO is proportional to the temperature of higher than 1200K.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.447-448
• /
• 2008

The goal of this study is to find flame dynamic behavior using a transverse fuel injection in a model combustor, and is to investigate main causes of unstable combustion in a liquid-fueled combustor. For transverse fuel injection into air cross flow, spray result shows similar tendency with Wu et al.[1998] until spray arrives at flame-holder. However, passing through flame-holder, fuel inflow into recirculation region of flameholder is not sufficient so it makes large difference between shear flame and recirculation flame behind flameholder. In combustion tests, the stable flame shows a kind of shear flames and low peaks of dynamic pressure frequencies. On the other hand, unstable flame shows periodic detached flame in recirculation zone and a strong peak of dynamic pressure frequency. The instability frequency is highly affected by influx air velocity, air temperature, equivalence ratio and wake or vortex shedding frequency behind the flameholder.

• 한국가시화정보학회:학술대회논문집
• /
• 한국가시화정보학회 2005년도 추계학술대회 논문집
• /
• pp.58-63
• /
• 2005

Three-dimensional vortical structures in the wake behind a road vehicle has been visualized with the help of two-dimensional PIV measurement data. A three-dimensional velocity field has been reconstructed from several sectional measurement data in the x-y, y-z and z-x planes. Isovorticity surface observed by stacking only the sectional data in each plane, does not show the vortical structures within the recirculation region but represents only the strong shear flows. Thus, in the present study, the velocity component normal to the x-y plane is obtained by interpolating those velocities in the z-x plane. Then, a $\lambda_{2}$-definition which captures the local pressure minimum or vortex core, is applied to visualize the vortices in the recirculation region. The final results represent a successful configuration for the three-dimensional vortices.

• 대한기계학회논문집B
• /
• 제31권9호
• /
• pp.780-789
• /
• 2007

Lock-on phenomenon in the wake of a circular cylinder is investigated at the Reynolds number of 360 using direct numerical simulation (DNS). To induce lock-on, a streamwise velocity perturbation with a frequency of twice the natural shedding frequency is superimposed on the free stream velocity. The Reynolds stress distributions are investigated to analyze the streamwise force balance acting on the recirculation region and the results are compared with the previous experimental result. When the lock-on occurs, the pressure force on the recirculation region is shown to increase mainly due to the reversal of the Reynolds shear stress distribution, which is consistent with our previous results using PIV measurement. It is also shown that, with the lock-on, the strength of the primary vortices increases whereas that of the secondary vortices decreases significantly. Further, under the lock-on condition the wavelength of the secondary vortices increases by as much as 2.5 times.

• 한국추진공학회지
• /
• 제8권2호
• /
• pp.95-101
• /
• 2004

보론 카바이드를 함유한 고체연료 그레인을 사용하여 당량비와 공기 질량 유속에 따라 연소 효율이 어떻게 변하는가를 조사하였다. 연소 효율은 당량비의 증가 방향과 질량유속 감소 방향에 따라서 증가하였다. 높은 흡입온도가 높은 연소 효율을 보이는데 이는 확산 영역에서 큰 보론 입자들의 연소 증진 결과이다. 재순환 영역으로 주로 이루어진 짧은 그레인에서는 큰 보론 입자의 형성으로 연소 효율은 감소하고 있다. 흡입 온도에 따라 증가하는 연소 효율은 흡입온도 증가에 따라 일반적으로 열역학적 사이클의 효율이 감소하는 것과는 상반되는 방향이나 실험적 결과를 해석할 때 합당한 결과로 나타나고 있다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2006년도 제26회 춘계학술대회논문집
• /
• pp.197-201
• /
• 2006

액체산소와 케로신을 사용하여 연료 과농 조건에서 작동하는 30 ton급 로켓엔진용 가스발생기를 개발하는 과정에서 사용된 동축 와류형 분사기의 산화제 post에 발생한 열손상에 대한 연구가 진행되었다. 분사기의 열손상을 방지하기 위해 분사기는 내부 혼합 방식을 유지하면서 recess를 증가시키고 재순환영역을 최소화하여 재순환영역에서의 화염형성을 억제하는 방향으로 재설계 되었다. 축소형 규모의 연소시험에서 이러한 재설계를 통해 연료 과농 가스발생기용 동축 와류형 분사기의 산화제 post 열손상을 방지할 수 있음을 확인할 수 있었다.

• 한국환경과학회지
• /
• 제22권8호
• /
• pp.1029-1041
• /
• 2013

In this study, eight episode days of high-concentration $PM_{10}$ occurrences in the Gimhae region between 2006 and 2011 were analyzed. Most of them appeared in winter and the highest concentration was observed around 12 LST. Furthermore, the wind direction, wind velocity, and temperature elements were compared with observed values to verify the WRF numerical simulation results used in this study, and they simulated well in accordance with the trend of the observed values. The wind was generally weak in the high-concentration episode days that were chosen through surface weather chart and the numerical simulation results for wind field, and the air pollutants were congested due to the effects of the resulting local winds, thereby causing a high concentration of air pollutants. Furthermore, the HYSPLIT model was performed with the WRF numerical simulation results as input data. As a result, they originated from China and flowed into Gimhae in all eight days, and the lowest concentration appeared on the days when recirculation occurred.

• 한국유체기계학회 논문집
• /
• 제15권6호
• /
• pp.85-91
• /
• 2012

Numerical simulations on a single stage transonic compressor which is developed by Korea Aerospace Research Institute are carried out and their results are compared with experimental data for cross validations. Comparisons between experimental data and numerical simulation results show good agreements on a performance curve, static pressure and total pressure distributions. CFD results show that there is a clear interaction between tip leakage flow and normal shock in the rotor passage. Tip leakage flows are almost dissipated after the strong normal shock and it forms a strong recirculation near the blade tip. Also a large separation region grows on the suction surface just after the normal shock. As the pressure ratio and blade loading increase, the normal shock line moves upstream and it starts to deviate from the blade leading edge. Then the tip leakage flow does not overcome the strong adverse pressure gradient and flow blockage originated from the tip recirculation region. As a result, the tip leakage flow heads for the neighboring blade leading edge, which results in a compressor stall.