• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.6
• /
• pp.1064-1071
• /
• 2006

In electric motor coaches, the rolling stocks move by the adhesive effort between rail and driving wheel. Generally, the adhesive effort is defined by the function of both the weight of electric motor coach and the adhesive effort between rails and driving wheel. The characteristics of adhesive effort is strongly affected by the conditions between rails and driving wheel. When the adhesive effort decreases suddenly, the electric motor coach has slip phenomena. This paper proposes a re-adhesion control based on disturbance observer and sensor-less vector control. The numerical simulation and experimental results point out that the proposed readhesion control system has the desired driving wheel torque response for the tested bogie system of electric coach. Based on this estimated adhesive effort, the re-adhesion control is performed to obtain the maximum transfer of the tractive effort.

• Korean Journal of Materials Research
• /
• v.19 no.2
• /
• pp.61-67
• /
• 2009

Electrolessly deposited Co (Re,P) was investigated as a possible capping layer for Cu wires. 50 nm Co (Re,P) films were deposited on Cu/Ti-coated silicon wafers which acted as a catalytic seed and an adhesion layer, respectively. To obtain the optimized bath composition, electroless deposition was studied through an electrochemical approach via a linear sweep voltammetry analysis. The results of using this method showed that the best deposition conditions were a $CoSO_4$ concentration of 0.082 mol/l, a solution pH of 9, a $KReO_4$ concentration of 0.0003 mol/l and sodium hypophosphite concentration of 0.1 mol/L at $80^{\circ}C$. The thermal stability of the Co (Re,P) layer as a barrier preventing Cu was evaluated using Auger electron spectroscopy and a Scanning calorimeter. The measurement results showed that Re impurities stabilized the h.c.p. phase up to $550^{\circ}C$ and that the Co (Re,P) film efficiently blocked Cu diffusion under an annealing temperature of $400^{\circ}C$ for 1hr. The good barrier properties that were observed can be explained by the nano-sized grains along with the blocking effect of the impurities at the fast diffusion path of the grain boundaries. The transformation temperature from the amorphous to crystal structure is increased by doping the Re.

• Journal of Adhesion and Interface
• /
• v.14 no.4
• /
• pp.197-211
• /
• 2013

Surfactants which have ability to decrease surface tension through surface activation between the interfaces are used as essential major raw materials for detergents and cosmetics. Typical synthetic detergents such as EO (ethylene oxide), LAB (linear alkylbenzene) are made from chemical surfactant derived from petrochemicals, therefore, they are responsible for major environment contaminations and ecosystem destruction, especially of rivers and also cause atopic dermatitis through strong skin stimulus of these small molecular's powerful permeability and lead to cancers if they get into organs through capillary. Now worldwide interest is increasing to develop new natural surfactants and biosurfactants as ecological, biodegradabl, harmless and multi-functional new amphiphillic materials which replace these synthetic surfactants.

• Tribology and Lubricants
• /
• v.35 no.2
• /
• pp.106-113
• /
• 2019

We investigated the application of tetrahedral amorphous carbon (ta-C) coatings to fabricate a glass lens manufactured using a glass molding process (GMP). In this work, ta-C coatings with different thickness (50, 100, 150 and 200 nm) were deposited on a tungsten carbide (WC-Co) mold using the X-bend filter of a filtered cathode vacuum arc. The effects of thickness on mechanical and tribological properties of the coating were studied. These ta-C coatings were characterized by atomic force microscopy, scanning electron microscopy, nano-indentation measurements, Raman spectrometry, Rockwell-C tests, scratch tests and ball on disc tribometer tests. The nano-indentation measurements showed that hardness increased with an increase in coating thickness. In addition, the G-peak position in the Raman spectra analysis was right shifted from 1520 to $1586cm^{-1}$, indicating that the $sp^3$ content increased with increasing thickness of ta-C coatings. The scratch test showed that, compared to other coatings, the 100-nm-thick ta-C coating displayed excellent adhesion strength without delamination. The friction test was carried out in a nitrogen environment using a ball-on-disk tribometer. The 100-nm-thick ta-C coating showed a low friction coefficient of 0.078. When this coating was applied to a GMP, the life time, i.e., shot counts, dramatically increased up to 2,500 counts, in comparison with Ir-Re coating.

• YAKHAK HOEJI
• /
• v.51 no.1
• /
• pp.35-43
• /
• 2007

To investigate the immunomodulatory roles of cyclic AMP (CAMP) on macrophage- and T lymphocyte-mediated immune responses, CAMP elevating agents were employed and carefully re-examined under the activation conditions of the cells. Various inhibitors tested dose-dependently blocked tumor necrosis factor (TNF)-${\alpha}$ production with IC$_{50}$ values ranged from 0.04 to 300 ${\mu}$M. Of the inhibitors, cAMP-elevating agents showed lower cytotoxicity assessed by lactate dehydrogenase (LDH) release, suggesting less toxic and more selective. In particular co-treatment of dbcAMP with a protein kinase C inhibitor staurosporine displayed the synergistic inhibition of TNF-${\alpha}$ production. The modulatory effect of dbcAMP on TNF-${\alpha}$ and nitric oxide (NO) was significantly affected by treatment time of dbcAMP. Thus, post-treatment of dbcAMP (three hours before LPS) abrogated dbcAMP's inhibitory activity and rather enhanced TNF-${\alpha}$ level up to 60%. In contrast, additional NO production was shown at the co-treatment of dbcAMP with LPS. Unlike simultaneous treatment of phorbol 12-myristate 13-acetate (PMA) and interferon (IFN)-${\gamma}$co-treatment, the combination of dbcAMP with other NO-inducing stimuli did not show drastic overproduction of NO. cAMP elevating agents also diminished splenocyte proliferation stimulated by concanavalin (Con) A, phytohemaglutinin A (PHA) and lipopolysaccharide (LPS). In addition, dbcAMP but not rolipram strongly suppressed CD8$^+$ T cells (CTLL-2). Finally, cAMP elevating agents were differentially involved in regulating CD98-mediated cell-cell adhesion. Thus, dbcAMP and rolipram significantly enhanced the cell-cell adhesion, whereas forskolin blocked. Therefore, our results suggest that CAMP elevating agents participate in various immune responses mediated by macrophages and T cells with a different fashion depending on cellular environments and activation signals.

• KSBB Journal
• /
• v.19 no.5
• /
• pp.399-405
• /
• 2004

A reticulated PU-g-PAAc foam was modified through the surface treatment of PU foam by one atmospheric pressure plasma. The synthesized PU-g-PAAc foam was prepared for the purpose of immobilizing microbial organisms. We also attempted different plasma treatment methods including simple plasma treatment, plasma induced grafting and plasma induced grafting followed by plasma re-treatment. The effect of grafting on equilibrium water content (EWC) of PU forms was examined by swelling measurements. Adhesion test was performed to investigate the effect of different plasma treatment methods on the improvement of microbial immobilization. Two foams modified by plasma induced grafting and plasma re-treatment after grafting showed 2.7 and 3.0 fold higher microbial immobilization than unmodified one, respectively. Meanwhile, simple plasma treatment showed a little enhancement. FT-IR analysis of each sample verified the contribution of surface functional groups on the enhancement of microbial immobilization. SEM observation confirmed microbial adherence.

• Journal of Gastric Cancer
• /
• v.13 no.4
• /
• pp.263-265
• /
• 2013

Intussusception is a rare cause of postoperative intestinal obstruction in adults. Many retrograde intussusceptions occur during the period following gastrectomy. A 77-year-old woman visited our hospital because of detected gastric adenocarcinoma. She received radical total gastrectomy with Roux-en-Y esophagojejunostomy. On the fifth postoperative day, she complained of abdominal pain, and we found leakage at the esophagojejunostomy site and dilatation of the Roux limb and the afferent limb of the jejunojejunostomy. Emergency surgery was performed. Retrograde jejunojejunal intussusception accompanied with a nasojejunal feeding tube was found at the efferent loop of the jejunojejunostomy. No ischemic change was found; therefore, manual reduction and primary repair of esophagojejunostomy was performed. She was discharged without complications on the 23rd re-postoperativeday. We suggest that the nasojejunal feeding tube acted as a trigger of intussusception because there was no definitive small bowel mass or postoperative adhesion. We present our findings here along with a brief review of the literature.

• Proceedings of the KIPE Conference
• /
• 2003.07b
• /
• pp.876-879
• /
• 2003

본 논문은 전동차용 추진제어장치의 재점착제어에 관한 것이다. 본 연구에서는 공전검지 방법에 대하여 기술하고, 등가 관성량을 이용한 추정재점착제어에 관하여 제시한다. 서울시 6호선 국산화 전동차(609편성)와 광주도시철도 1호선 전동차에 적용하여 재점착 제어성의 우수함과 안정성을 검증 하고자 한다.

• Proceedings of the KIEE Conference
• /
• 1999.11b
• /
• pp.420-422
• /
• 1999

To improve traction effort performance and stability of Korean High-Speed Railway Train, a practical re-adhesion controller including a novel wheel slip protection control scheme is proposed. The presented method is verified by various train running simulations by induction motor vector control with PWM inverter.

• Elastomers and Composites
• /
• v.39 no.4
• /
• pp.294-300
• /
• 2004

Mechanical properties of the commingled waste plastics filled with ground rubber tire were studied. To improve adhesion at the interface, trans-octylene rubber(TOR) was added. With increasing the rubber level, first, due to their inherent incompatibility, the tensile and the compressive strength decreased but tensile strain and impact strength increased. Then, as TOR added, the samples showed still the same strain but the tensile, impact, and compressive strength as well increased markedly Variation of the properties by addition of TOR seemed to be attributed to the dual character of TOR.