• Journal of the Korean Geotechnical Society
• /
• v.33 no.12
• /
• pp.81-92
• /
• 2017

According to the revision of the Housing Act in 2013, it has been possible to carry out an apartment remodeling project involving two to three floor vertical extension. The remodeling project with vertical extension requires foundation reinforcement because structural safety due to additional load and enhanced seismic criteria must be met. In this case, structural analysis is performed to analyze the load distributed to existing PC pile and reinforced additional pile. The vertical stiffness ($K_v$) of the pile is required for structural analysis, but the research on the 20~30 year old PC pile stiffness is very limited. In this paper, the stiffness of the PC pile in accordance with the change of diameter and length was analyzed by examining the results of 38 field pile load tests performed during the construction of the apartments in the 1990's. As a result of the analysis, the pile stiffness decreases with the increase of the length-diameter ratio (L/D). In addition, the results of on-site pile load test are compared with the coefficient 'a' for estimating pile stiffness proposed in Korea Highway Bridge Design Standard (2008) and the Pile Foundation Design Guideline of Korea Railroad Corporation (2012). It shows that 'a' obtained through the estimation of the literature is very similar to the field test results in the range of 10

• Journal of Radiation Protection and Research
• /
• v.38 no.4
• /
• pp.208-213
• /
• 2013

The suitability of the site criteria is a basic requirement for securing safety of nuclear power plants. The suitability should be confirmed through the estimation of environmental radiation effects at the exclusion area boundary under the severe weather conditions. In this study, field tracer experiments over short range of 1 km radius under severe weather conditions were conducted at flat area in Daejeon. Severe weather conditions are represented with stable atmospheric condition and low wind speed. In general, the condition is appeared at clean night time with weak wind. The analysis of the measured distribution of the released tracer gas shows two big differences between the results of the past experiments conducted under the favorable weather conditions. One is the difficulty of finding the typical distribution of the released tracer gas with peak concentration in the downwind direction. The other one is the appearance of the contour of the concentration of tracer gas at several hundred meters even though the gas released at 10 m height over the ground.

• Journal of Radiation Protection and Research
• /
• v.42 no.2
• /
• pp.114-129
• /
• 2017

Background: The purpose of this paper is to confirm the event timings and the magnitude of fission product aerosol release from the Fukushima accident. Over a few hundreds of technical papers have been published on the environmental impact of Fukushima Daiichi accident since the accident occurred on March 11, 2011. However, most of the research used reverse or inverse method based on the monitoring of activities in the remote places and only few papers attempted to estimate the release of fission products from individual reactor core or from individual spent fuel pool. Severe accident analysis code can be used to estimate the radioactive release from which reactor core and from which radionuclide the peaks in monitoring points can be generated. Materials and Methods: The basic material used for this study are the initial core inventory obtained from the report JAEA-Data/Code 2012-018 and the given accident scenarios provided by Japanese Government or Tokyo Electric Power Company (TEPCO) in official reports. In this research a forward method using severe accident progression code is used as it might be useful for justifying the results of reverse or inverse method or vice versa. Results and Discussion: The release timing and amounts to the environment are estimated for volatile radioactive fission products such as noble gases, cesium, iodine, and tellurium up to 184 hours (about 7.7 days) after earthquake occurs. The in-plant fission product behaviors and release characteristics to environment are estimated using the severe accident progression analysis code, MELCOR, for Fukushima Daiichi accident. These results are compared with other research results which are summarized in UNSCEAR 2013 Report and other technical papers. Also it may provide the physically based arguments for justifying or suspecting the rationale for the scenarios provided in open literature. Conclusion: The estimated results by MELCOR code simulation of this study indicate that the release amount of volatile fission products to environment from Units 1, 2, and 3 cores is well within the range estimated by the reverse or inverse method, which are summarized in UNSCEAR 2013 report. But this does not necessarily mean that these two approaches are consistent.

• Korean Chemical Engineering Research
• /
• v.48 no.6
• /
• pp.717-724
• /
• 2010

The flash point is one of the most important physical properties used to determine the potential for fire and explosion hazards of flammable liquids. Despite the needs of the experimental flash point data for the design and construction of chemical plants, there is often a significant gap between the demands for the data and their availability. This study have built and compared two models of partial least squares(PLS) and support vector machine(SVM) to predict the experimental flash points of 893 organic compounds out of DIPPR 801. As the independent variables of the models, 65 functional groups were chosen based on the group contribution method that was oriented from the assumption that each fragment of a molecule contributes a certain amount to the value of its physical property, and the logarithm of molecular weight was added. The prediction errors calculated from cross-validation were employed to determine the optimal parameters of two models. And, an optimization technique should be used to get three parameters of SVM model. This work adopted particle swarm optimization that is one of heuristic optimization methods. As the selection of training data can affect the prediction performance, 100 data sets of randomly selected data were generated and tested. The PLS and SVM results of the average absolute errors for the whole data range from 13.86 K to 14.55 K and 7.44 K to 10.26 K, respectively, indicating that the predictive ability of the SVM is much superior than PLS.

• Progress in Medical Physics
• /
• v.13 no.4
• /
• pp.224-228
• /
• 2002

Myocardial tagging technique such as spatial modulation of magnetization (SPAMM) allows the study of myocardial motion with high accuracy. However, the accuracy of the estimation of tag intersection can be affected by tagline spacing. The aim of this study was to investigate the relationship between tagline spacing of SPAMM image and tagging contrast-to-noise ratio (CNR) in in-vivo study. Two healthy volunteers were undergone electrocardiographically triggered MR imaging with SPAMM-based tagging pulse sequence at a 1.5T MR scanner. Horizontally modulated stripe patterns were imposed with a range from 3.6 to 9.6 mm of tagline spacing. Images of the left ventricle(LV) wall were acquired at the mid-ventricle level during cardiac cycle with FE-EPI (TR/TE = 5.8/2.2 msec, FA= 10$^{\circ}$. Tagging CNR for each image was calculated with a software which developed in our group. During contraction, tagging CNR was more rapidly decreased in case of narrow tagline spacing than in case of wide tagline spacing. In the same heart phase, CNR was increased corresponding with tagline spacing. Especially, at the fully contracted heart phase, CNR was more rapidly increased than the other heart phases as a function of tagline spacing. The results indicated that the optimization of tagline spacing provides better tagging CNR in order to analyze the myocardial motion more accurately.

• Journal of Korean Society on Water Environment
• /
• v.30 no.2
• /
• pp.175-183
• /
• 2014

The influence of temperature on the treatment efficiency of chlorinated organic substances contained in groundwater by permeable reactive barrier which is composed of $Fe^{\circ}$ has been investigated by constructing the Pourbaix diagrams for Fe-$H_2O$ system at different temperatures based on thermodynamic estimation. In aerobic condition, the equilibrium potentials for $Fe^{\circ}/Fe^{2+}$ and $Fe^{2+}/Fe^{3+}$ were observed to increase, therefore, the dechlorination reaction for organic pollutants by $Fe^{\circ}$ was considered to decline with temperature due to the diminished oxidation of reactive barrier. The result for the variations of the ionization fraction of $Fe^{2+}$ and $Fe^{3+}$ ion in the pH range of 0 ~ 2.5 obtained by employing Visual MINTEQ program showed that the ionization fraction of $Fe^{2+}$ increased with pH, however, that of $Fe^{3+}$ decreased symmetrically and the extent of the variation of ionization fraction for both ions was raised as temperature rises. The equilibrium pH for $Fe^{3+}/Fe(OH)_3$ was examined to decrease with temperature so that the treatment efficiency of chlorinated organic substance was expected to decrease with temperature due to the enhanced formation of passivating film in aerobic condition. The change of the reactivity of a specific chemical species with temperature was defined quantitatively based on the area of its stable region in Pourbaix diagram and depending on this the reactivity of $Fe^{3+}$ was shown to decrease with temperature, however, that of $Fe(OH)_3$ was decreased monotonously as temperature is raised for $Fe^{3+}/Fe(OH)_3$ equilibrium system. In anaerobic condition, the equilibrium potential for $Fe^{\circ}/Fe^{2+}$ was observed to rise and the equilibrium pH for $Fe^{2+}/Fe(OH)_2$ were examined to decrease as temperature increases, therefore, similar to that for aerobic condition the efficiency of the dechlorination reaction for organic substances was considered to be diminished when temperature rises because of the reduced oxidation of $Fe^{\circ}$ and increased formation of $Fe(OH)_2$ passivating film.

• Journal of Conservation Science
• /
• v.32 no.4
• /
• pp.511-520
• /
• 2016

The purpose of this study was to estimate the firing temperature of fired clay brick by applying high temperature X-ray diffraction(XRD) analysis. The clay bricks, which were excavated from a Buddhist temple in Karatepa, Uzbekistan were composed of quartz, plagioclase, alkali feldspar, mica, chlorite, limestone, hornblende, etc. Some clay bricks contained gypsum, which was presumed to have been used to improve the adhesive strength of the brick. Estimating the firing temperature using a geologic thermometer, the UZ-1 sample was identified as being in the quartz, plagioclase, pyroxene series, and the firing temperature was estimated to be $900-1200^{\circ}C$. On the other hand, applying the high temperature XRD method to the UZ-5 sample, it was found that the limestone was destroyed at $1000^{\circ}C$ and the diffraction peak of chlorite was weakened at $1050^{\circ}C$. Moreover, pyroxene series minerals developed at $1050^{\circ}C$ in the reproduction experiment. These results indicate that the clay bricks used in the temple were produced in a kiln that reached a temperature of more than $1000^{\circ}C$. Thus, high temperature XRD analysis can more accurately estimate firing temperatures as compared to the firing temperature mineral identification method and it can be used to determine the creation and extinction temperature range of minerals.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.7
• /
• pp.697-703
• /
• 2006

Endocrine disruptors were measured with GC/MS in effluents discharged from sewage treatment processes in pilot scale for the purpose of water reuse. From that analysis, we compared the removal rate of them by treatment processes. Nonylphenol was mainly detected in effluents and high concentration from 0.36 to 0.94 ${\mu}g/L$. $17{\beta}$-estradiol(E2) and $17{\alpha}$-ethynylestradiol(EE2) were detected as below the limit of detection in effluent. Endocrine disruptors were removed effectively in the range from 50 to 100% by treatment process. EC50 value($9.0{\times}10^{-3}$ M) of $17{\beta}$-estradiol(E2) by dose response curve of E-screen assay has higher than that of bisphenol A($2.736{\times}10^{-5}M$) and p-octylphenol($9.760{\times}10^{-6}$ M). These results showed that alkylphenols have lower relative estrogen potency than other estrogens such as $17{\beta}$-estradiol(E2). Calculated estrogenic activity(ng-EEQ/L) was 2 times higher than measured total estrogenic activity which estimated by E-screen assay. Moreover estrogenic activity of effluent by treatment process showed very low as below 1 ng-EEQ/L.

• Journal of the East Asian Society of Dietary Life
• /
• v.26 no.4
• /
• pp.346-358
• /
• 2016

Local food reflects the identity and image of a specific region. It is also a core element for determining tourists' experience of a region. The purpose of the present study was to develop a Jeju food tour package using local foods and estimate the economic value of the suggested tour package using Contingent Valuation Method (CVM). Five food tour packages were developed by researchers. In order to modify and measure the value of each package, an expert panel survey was conducted, and 'package 5' was selected as a food tour scenario for the tourist survey. A survey was conducted on 295 domestic tourists who visited Jeju within the past 10 years in order to evaluate the economic value and feasibility of the Jeju food tour package. A total fo 72.9% of respondents answered that they were willing to pay for the Jeju local food tour, and the willingness to pay (WTP) range was between ￦45,000 and ￦105,000. The primary factors correlated with WTP was food expenses, followed by leisure experience expenses, interest in local foods, education level, visit frequency and age. The WTP of the Jeju local food tour was calculated with the significantly affected factors using stepwise regression model. The result of the present study reveal that tourists' WTP increased with higher food expenses, education level, and age group. The average value of food expenses, education level, and age were substituted into the formula derived from the regression analysis, yielding 58,385.752 KRW as the WTP. The expected economic value created by exploiting the Jeju local food tour was shown to be 700 billion KRW per year, calculated by multiplying WTP of the food tour packages by the number of tourists. This study examined the feasibility and plan of the food tour package to increase the economic value of Jeju local food. In the case of the culinary tour program based on Jeju local food launching, the estimated economic effect was great. Therefore, in-depth research to merchandise the Jeju local food tour program is needed.

• Journal of Korea Water Resources Association
• /
• v.46 no.11
• /
• pp.1115-1128
• /
• 2013

The purpose of this study is to evaluate the suspended solids and eutrophication processes relationships in Chungju lake using CE-QUAL-W2, two-dimensional (2D) longitudinal/vertical hydrodynamic and water quality model. For water quality modeling, the lake segmentation was configured as 7 branches system according to their shape and tributary distribution. The model was calibrated (2010) and validated (2008) using 2 years of field data of water temperature, suspended solids (SS), total nitrogen (TN), total phosphorus (TP) and algae (Chl-a). The water temperature began to increase in depth from April and the stratification occurred at about 10 m early July heavy rain. The high SS concentration of the interflow density currents entering from the watershed was well simulated especially for July 2008 heavy rainfall event. The simulated concentration range of TN and TP was acceptable, but the errors might occur form the poor reflection for sedimentation velocity of nitrogen component and adsorption-sediment of phosphorus in model. The concentration of Chl-a was simulated well with the algal growth patterns in summer of 2010 and 2008, but the error of under estimation may come from the use of width-averaged velocity and concentration, not considering the actual to one side inclination by wind effect.