• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1204-1211
• /
• 2012

Measurement and analysis results of the extracted radiation-patterns from the field-experiments which were conducted to acquire the generic technology for calibration and validation of the satellite SAR system(Synthetic Aperture Radar) are presented in this study. Prototype of active transponder is adjustable within maximum 63.1 dBsm of RCS (Radar Cross Section) and includes the receiving-function with external receiver. To increase an accuracy of these field experiments, we repetitively measured satellite SAR systems of the same operating mode(i.e., COSMO-SkyMed No. 2 & 3, hh-pol., strip-map himage mode, 3 m resolution). Then, the reliability of experimental results was cross-checked through analysis of the RCS of active transponder on SAR image. The property of azimuth radiation patterns of satellite SAR system extracted from them has $0.352^{\circ}$ of HPBW(half-power beamwidth), $0.691^{\circ}$ of FNBW(first-null beamwidth), and 11.17 dB of PSLR(peak to side lobe ratio), respectively.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.776-779
• /
• 2006

KOMPSAT-5 that will be launched at the end of 2008 has a SAR (Synthetic Aperture Radar) payload. Since the Calibration and Validation of a satellite SAR is different from a passive optical camera as KOMPSAT-2 MSC and KOMPSAT-3 payload, we have started from the basis of SAR system. Firstly, the general SAR Cal/Val parameters have been gathered and defined. Secondly, we have been choosing the Cal/Val parameters suitable to KOMPSAT-5. Thirdly, the methods of SAR Cal/Val with the parameters have been studied. Fourthly, the requirement of Cal/Val devices and Cal/Val site has been studied.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.64-71
• /
• 2017

In this paper, Kalman filter and RRWA algorithm are used to estimate the accurate target in IR-UWB (Impulse-Radio Ultra Wideband) radar system, which enables accurate location recognition of indoors and outdoors with low cost and low power consumption. In the signal reflected by the target, unnecessary signals exist in addition to the target signal. We have tried to remove unnecessary signals and to derive accurate target signals and improve performance. The location of the targets is estimated in real time with one transmitting antenna and one receiving antenna. The Kalman filter was used to remove the background noise and the RRWA algorithm was used to remove the reflected signal. In this paper, we think that it will be useful to study the accurate distance estimation and tracking in future target estimation.

• Journal of Satellite, Information and Communications
• /
• v.12 no.2
• /
• pp.1-10
• /
• 2017

In this paper we propose three existing reflection removal algorithms and one proposed algorithm to estimate accurate targets in near field using IR-UWB (Impulse-Radio Ultra Wideband) radar. The received signal includes unnecessary reflected wave signals to the target signal. A reflective cancellation algorithm was used to remove unnecessary signals and estimate only the correct target signal. The location of the targets is estimated in real time with one transmitting antenna and one receiving antenna. In order to overcome the disadvantages of the existing three reflection removal algorithms, we propose a new reflection removal algorithm and estimate the most accurate target. Also we used DSP(Digital Signal Processor) to install the external mounting of vehicles. This paper will contribute to the study of the future reflections.

• Journal of Satellite, Information and Communications
• /
• v.12 no.3
• /
• pp.63-68
• /
• 2017

SAR(Synthetic Aperture Radar) uses electromagnetic signals to acquire ground information and has been used for wide coverage reconnaissance missions regardless of weather conditions. However SAR is known to be vulnerable to interference signals by other communication devices or radar instruments and may suffer from undesirable performance degradations and image quality. In this paper, a modified Eigen-subspace based filter is proposed that can be easily applied to SAR images affected by interference signals. The method of constructing Eigen-subspace based filter is briefly described and various simulations are performed to show the performance of the interference mitigation process. The suppression filter is applied to a ALOS PALSAR raw data affected by interfering signals in order to verify its superiority over the Notch filter.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.2
• /
• pp.144-150
• /
• 2022

The on-board processor of satellite synthetic aperture radar(SAR) generates transmission signal by digital signal processing, converts it into an analog signal. At this time, the transmission signal generated from the baseband requires the frequency modulation to convert it to the high-frequency band in order to improve the stability. General frequency modulation method using local oscillator(LO) causes IQ imbalance due to phase error/magnitude error and these error reduce performance of SAR. To generate transmission signal without phase/magnitude error, this paper suggests design method of the frequency modulation method using digital to analog converter(DAC) at on-board SAR. For design, this paper analyzes the characteristic of DAC mode and uses pre-compensation filter. To analyze the proposed method performance, performance index are compared with IQ imbalance signals. This method is suitable for on-board SAR using fast sampling DAC and has the advantage of being able to solve IQ imbalances.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2023.05a
• /
• pp.152-153
• /
• 2023

AIS has been widely used for maritime traffic assessment for its convenience. However, AIS has problems with position missing due to radio interference and transmission distance limit. On the other hand, satellite radar determines the location of ships over a wide sea regardless of the problems. This study proposes a noble method of stepwise threshold determination to detect ships from Sentinel-1. The proposed method is up to 25 times faster than the existing moving window-based threshold determination method, and the detection accuracy is similar.

• Korean Journal of Remote Sensing
• /
• v.38 no.6_3
• /
• pp.1761-1775
• /
• 2022

Due to unpredictable climate change, the frequency of occurrence of water-related disasters and the scale of damage are also continuously increasing. In terms of disaster management, it is essential to identify the damaged area in a wide area and monitor for mid-term and long-term forecasting. In the field of water disasters, research on remote sensing technology using Synthetic Aperture Radar (SAR) satellite images for wide-area monitoring is being actively conducted. Time-series analysis for monitoring requires a complex preprocessing process that collects a large amount of images and considers the noisy radar characteristics, and for this, a considerable amount of time is required. With the recent development of cloud computing technology, many platforms capable of performing spatiotemporal analysis using satellite big data have been proposed. Google Earth Engine (GEE)is a representative platform that provides about 600 satellite data for free and enables semi real time space time analysis based on the analysis preparation data of satellite images. Therefore, in this study, immediate water disaster damage detection and mid to long term time series observation studies were conducted using GEE. Through the Otsu technique, which is mainly used for change detection, changes in river width and flood area due to river flooding were confirmed, centered on the torrential rains that occurred in 2020. In addition, in terms of disaster management, the change trend of the time series waterbody from 2018 to 2022 was confirmed. The short processing time through javascript based coding, and the strength of spatiotemporal analysis and result expression, are expected to enable use in the field of water disasters. In addition, it is expected that the field of application will be expanded through connection with various satellite bigdata in the future.

• Journal of Satellite, Information and Communications
• /
• v.4 no.2
• /
• pp.12-19
• /
• 2009

In the modern UAV systems, the role of radar payload has been increasing with its unique performance of day-and-night operation and see-through capability over hidden obstacles. Contrary to the satellite reconnaissance, UAV is expected to provide high resolution target detection and recognition capability while frequent flight missions would deliver enhanced SAR image and local information over the target area. STK(Satellite Tool Kit) is a professional space-analysis software widely used in all phases of a space system's life cycle. The simulation of STK is efficient and accurate relatively. In this paper, the author attempt to model the UAV operation and measure the expected SAR image quality. STK(Satellite Tool Kit) is employed to analyze UAV operation and produce SAR raw data. A SAR simulator is developed to produce high resolution SAR image for various ground targets.

• Atmosphere
• /
• v.31 no.5
• /
• pp.489-510
• /
• 2021

In this paper, we propose an algorithm for detecting convective initiation (CI) using GEO-KOMPSAT-2A/advanced meteorological imager data. The algorithm identifies clouds that are likely to grow into convective clouds with radar reflectivity greater than 35 dBZ within the next two hours. This algorithm is developed using statistical and qualitative analysis of cloud characteristics, such as atmospheric instability, cloud top height, and phase, for convective clouds that occurred on the Korean Peninsula from June to September 2019. The CI algorithm consists of four steps: 1) convective cloud mask, 2) cloud object clustering and tracking, 3) interest field tests, and 4) post-processing tests to remove non-convective objects. Validation, performed using 14 CI events that occurred in the summer of 2020 in Korean Peninsula, shows a total probability of detection of 0.89, false-alarm ratio of 0.46, and mean lead-time of 39 minutes. This algorithm can be useful warnings of rapidly developing convective clouds in future by providing information about CI that is otherwise difficult to predict from radar or a numerical prediction model. This CI information will be provided in short-term forecasts to help predict severe weather events such as localized torrential rainfall and hail.