• 동력기계공학회지
• /
• 제14권4호
• /
• pp.11-16
• /
• 2010

The evaporation heat transfer characteristics of propane(R-290) in horizontal small diameter tubes were investigated experimentally. The test tubes have inner diameters of 1 mm and 4 mm. Local heat transfer coefficients were measured at heat fluxes of 12, $24\;kW/m^2$, mass fluxes of 150, $300\;kg/m^2s$, and evaporation temperature of $15^{\circ}C$. The experimental results showed that the evaporation heat transfer coefficient of R-290 has an effect on heat flux, mass flux, tube diameter, and vapor quality. The evaporation heat transfer of R-290 has an influenced on nucleate boiling at low quality and convective boiling at high quality. The evaporation heat transfer coefficient of R-290 increases with decreasing inner tube diameter. And the evaporation heat transfer coefficient of R-290 is about 1~3 times higher than that of R-134a.

• 대한전기학회논문지
• /
• 제45권1호
• /
• pp.81-85
• /
• 1996

Microwave dielectric properties of 0.15(B $a_{x}$S $r_{0.05}$)O-0.15(S $m_{2}$(1-y)N $d_{2y}$) $O_{3}$-0.7Ti $o_{2}$(x=o.9~0.1[mol.], y=6[m/o]) ceramics were investigated with BaO compositional ratio. Sintered density and resistivity of specimens were independent on the BaO compositional ratio. In the specimen with x=0.975[mol.], dielectric constant, quality factor and temperature coefficient of resonant frequency had good values of 76.52, 3001(at 3[GHz]) and +0.71[ppm/.ceg. C], respectively. By comparing with the stoichiometric compositions of 78.14, 2938(at 3[GHz])+14.19[ppm/.ceg. C], dielectric constant and quality factor showed similar properties, but the temperature coefficient of resonant frequency was highly improved. (author). refs., figs., tabs.s.s.

• ETRI Journal
• /
• 제43권5호
• /
• pp.923-931
• /
• 2021

We studied the influence of GaAs top-layer thickness on the small-signal modulation response and 56 Gb/s four-level pulse-amplitude modulation eye quality of 850 nm vertical-cavity surface-emitting lasers (VCSELs). We considered the proportionality of the gain-saturation coefficient to the photon lifetime. The simulation results that employed the transfer-matrix method and laser rate equations led to the conclusion that the proportionality should be considered for proper explanation of the experimental results. From the obtained optical eyes, we could determine an optimum thickness of the GaAs top layer that rendered the best eye quality of VCSEL. We also compared two results: one result with a fixed gain-saturation coefficient and the other that considered the proportionality. The former result with the constant gain-saturation coefficient demonstrated a better eye quality and a wider optimum range of the GaAs top-layer thickness because the resultant higher damping reduced the relaxation oscillation.

• 한국수자원학회논문집
• /
• 제33권1호
• /
• pp.73-85
• /
• 2000

농촌 소하천의 수리학적 및 수질특성을 반영한 모형을 개발하였다. 모형구조 설계시 제어체적 기법을 활용하여 하천 형상, 수질 및 유량의 변화가 심한 농촌 유역의 소하천에 대한 수질의 모의하였다. 개발한 모형에 난수발생기법을 도입하여 최적 반응계수와 모형구조를 추정하였다. 또한 모형 보정기준의 일반화를 위해 동의지표와 효율계수를 도입하여 매개변수추정의 신뢰성 향상을 도모했다. 모형의 적용성을 검증하기 위해 경남 김해시 한림면 용덕천에서 수질을 채취하여 분석하였다. 관측된 자료와 개발된 모형의 비교연구를 통해 대상유역의 소하천에서 일어나는 수질 반응계수들과 그 변동성을 추정하였다.

• 한국물환경학회지
• /
• 제31권2호
• /
• pp.103-109
• /
• 2015

The characteristics of drinking groundwater at west Gyeong-nam were analyzed by investigating 3,698 cases which were carried out from January 2008 to september 2013. 24.5% of the observed data exceeded the drinking water quality standards. Among the drinking water quality standards, 40 parameters were found to exceed. and most problematic were total coliform and HPC(Heterotrophic Plate Count). The unfit ratio of each region for drinking water were 23.1% at Geoje, 18.7% at Geochang, 28.5% at Goseong, 24.1% at Namhae, 32.8% at Sacheon, 20.5% at Sancheong, 36.9% at Uiryeong, 29.2% at Jinju, 40.9% at Tongyeong, 24.7% at Hadong, 20.6.% at Hamyang, 20.1% at Hapcheon. The result of correlation showed that rainfall and unfit ratio of HPC may be associated with the hydrologic durability and season. The coefficient of correlation between them was 0.304. During the summer, the coefficient of correlation was 0.699. But the significant correlation between total coliform and rainfall was not found.

• 품질경영학회지
• /
• 제51권1호
• /
• pp.37-54
• /
• 2023

Purpose: A main aims are to check the level of satisfaction of service quality and derive service quality factors in the field of defense quality assurance activities that need improvement. Furthermore, the paper presents a basic data for identifying future development directions. Methods: Classify the level of service perceived by customers and calculate the customer satisfaction coefficient and PCSI index. In addition, the direction of future research is established by empirically comparing and analyzing the data of this study and the past data. Results: The paper derive the service quality factors to be provided to small businesses in the current state. Moreover, It shows the increasing trend of new companies using comparative analysis with past data Conclusion: Since the new company consists of small businesses with less than 50 employees, further research on small businesses is needed in the future.

• Steel and Composite Structures
• /
• 제14권4호
• /
• pp.349-365
• /
• 2013

Structures consisting of concrete and steel parts, which are irregular in damping ratios are investigated. This investigation is a code-based seismic design of such structures. Several practical difficulties encountered, due to inherent differences in the nature of dynamic response of each part, and the different damping ratios of the two parts. These structures are irregular in damping ratios and have complex modes of vibration so that their analysis cannot be handled with the readily available commercial software. Therefore, this work aims to provide simple yet sufficiently accurate constant values of equivalent damping ratios applied to the whole structure for handling the damping irregularity of such structures. The results show that the equivalent damping ratio changes with the height of the building and the kind of the structural system, but it is constant for all accelerations values. Thus, available software SAP2000 applied for seismic analysis, design and the provisions of existing seismic codes. Finally, evaluation of different kinds of structural system used in this research to find the most energy dissipating one found by finding the best value of quality coefficient.

• 품질경영학회지
• /
• 제34권3호
• /
• pp.19-30
• /
• 2006

For highly reliable products, it is difficult to assess the lifetime of the products with traditional life tests. Accordingly, a recent approach is to observe the performance degradation of product during the test rather than regular failure time. This study compares performances of three methods(i.e. the approximation, analytical and numerical methods) to estimate the parameters and quantiles of the lifetime when the time-to-failure distribution follows Weibull and lognormal distributions under a random coefficient degradation rate model. Numerical experiments are also conducted to investigate the effects of model error such as measurements in a random coefficient model.

• 한국품질경영학회:학술대회논문집
• /
• 한국품질경영학회 2010년도 춘계학술대회
• /
• pp.291-309
• /
• 2010

Customer satisfaction is an ever-growing concern of management throughout the world. To find the way to increase customer satisfaction, we must understand customer requirements. Kano distinguishes between three types of product requirements(must-be, one-dimensional, attractive requirement) which influence customer satisfaction in different ways when met. Timko has developed customer satisfaction(CS) coefficient based on Kano model. The CS coefficient is indicative of how strongly a product feature may influence satisfaction. In this paper, potential customer satisfaction improvement(PCSI) index was developed using Kano model and CS coefficient. The PCSI index represents how much a product feature can increase the degree of customer satisfaction when the product feature is fully fulfilled. In order to explain the meaning of PCSI index, a case study for cellular phones is done. It is also discussed how to use the index strategically.

• 한국방송∙미디어공학회:학술대회논문집
• /
• 한국방송공학회 2009년도 IWAIT
• /
• pp.492-497
• /
• 2009

Computer-Generated Hologram (CGH) is made for three dimensional image of a virtual object. Error diffusion method is used for the phase quantization of CGH, and it is known to be effective to the image quality improvement of the reconstructed image. However, the image quality of the reconstructed image from the CGH using error diffusion method depends on the selection of error diffusion coefficient. In this paper, we derived the relational expression to obtain the error diffusion coefficient from the position of the input object and size of the input object for CGH. As a result, the method of this thesis was able to obtain an excellent reconstructed image compared with the case to derive the error diffusion coefficient from only the position of the input image.