• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집
• /
• pp.501-504
• /
• 2001

We used time-of-flight method to analyse transport properties of charge carrier which is produced by X-ray exposure. It is the research of charge transport and specific property of trap that is performed in direct digital x-ray image receptor. But the results shows us different measurement value of electron and charge drift mobility and it is difficult to precise analysis about charge transport properties and trap mechanism. We measured transit time and drift mobility of charge carriers using time-of-fight method to evaluate the correlation of a-Se thickness change and electric field. We made a testing glass with a-Se of 470 ${\mu}{\textrm}{m}$ thickness on corning glass using thermoevaporation method and built Au electrode with 300nm, 2$\phi$ on both sides of a-Se. As a result of this experiment, electron and hole transit time was each 229.17 $\mu$s and 8.737 $\mu$s at 10V/${\mu}{\textrm}{m}$ electric field and Drift mobility was each 0.00174 $\textrm{cm}^2$/V.s, 0.04584 $\textrm{cm}^2$/V.s.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.1
• /
• pp.357-360
• /
• 2004

Al doped ZnO thin films have been were properties of excellent optical transmittance, low resistivity and wide bandgap where be widely used transparent electrode on solar cell. In this paper, ZnO:Al thin films on PC substrate were prepared by RF magnetron sputtering method using ceramic taget with diffrent deposition conditions. In addition, the electrical, structural, optical properties were investigated. we investigated sample properties of Sputter powers and pressures change in $25{\sim}125W,\;2{\times}10^{-2}{\sim}2{\times}10^{-3}Torr$.

• Nuclear Engineering and Technology
• /
• 제50권8호
• /
• pp.1330-1338
• /
• 2018

High-density UMo/Zr monolithic nuclear fuel plates have a promising application prospect in high flux research and test reactors. The solid state welding method called co-rolling is used for their fabrication. Hot co-rolling simulations for the composite blanks of UMo/Zr monolithic nuclear fuel plates are performed. The effects of coupon sizes and mechanical property parameters on the contact pressures between the to-be-bonded surfaces are investigated and analyzed. The numerical simulation results indicate that 1) the maximum contact pressures between the fuel coupon and the Zircaloy cover exist near the central line along the plate length direction; as a whole the contact pressures decrease toward the edges in the plate width direction; and lower contact pressures appear at a large zone near the coupon corner, where de-bonding is easy to take place in the in-pile irradiation environments; 2) the maximum contact pressures between the fuel coupon and the Zircaloy parts increase with the initial coupon thickness; after reaching a certain thickness value, the contact pressures hardly change, which was mainly induced by the complex deformation mechanism and special mechanical constitutive relation of fuel coupon; 3) softer fuel coupon will result in lower contact pressures and form interfaces being more out-of-flatness.

• 농업과학연구
• /
• 제49권4호
• /
• pp.667-676
• /
• 2022

The soil physical and chemical properties are the main factors that influence plant productivity and soil fertility. Since 1999, South Korea has been conducting a survey on changes in the agricultural environment survey every four years. The purpose of the present study is to monitor the physical and chemical properties of soil in Chungcheongbuk-do. Soil samples were collected from the exact sites of the aforementioned environment survey, and land use and cultivated crops were also investigated. From a Pearson correlation analysis, it was found that the total carbon contents were most negatively affected by the soil depth. The bulk density of soil increased up to a depth of 40 cm but decreased to a depth of 60 cm. The porosity and moisture of soil generally decreased, but the porosity increased at a depth of 50 - 60 cm. Chemical properties of soil gradually decreased with an increase of the soil depth from 0 to 70 cm, but little change was observed in soil pH with soil depth. In addition, the organic matter contents of the soil at a depth of 30 cm or more were below the optimal range. The soil of Chungcheongbuk-do thus requires organic matter application as a whole, and correction of items that are partially out of the optimal range is necessary.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2020년도 가을 학술논문 발표대회
• /
• pp.98-99
• /
• 2020

This study is aim to assess mechanical properties which is highly related to structural safe and durability of 100MPa high strength concrete mixed with amorphous metallic fiber. All specimens were heated with low velocity heating rate(1℃/min.), residual compressive strength and residual flexural strength was evaluated. The specimens were cooled down to room temperature after heating. As a result, in the case of 100MPa high-strength concrete, the residual compressive strength enhancing effect of amorphous metallic fiber has showed with the mix proportion of fiber. In addition, residual flexural strength showed more regular pattern before 300℃ then residual compressive strength, but simillar decreasing behavior was shown after 300℃ like residual compressive strength. Further study about fiber pull-out behavior and fiber mechanical, chemical property change due to temperature is needed.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2023년도 봄 학술논문 발표대회
• /
• pp.207-208
• /
• 2023

The procedure of predicting the construction cost and selecting the best alternative is performed based on comparative review of each building case. In the case of office building, it is required continuously until design is complete, since the owner requirements are various and likely to change during the design process compared to a standardized apartment. However, since the comparison work for each alternative in practice uses only the unit construction cost, there is no correlation between the alternative and the final result, and it is difficult to quantitatively determine the effect of the determined design factor on the total construction cost. It is needed that a means to support the generation of design alternatives using similar building cases during the design phase. This paper proposes a BIM-based data replacing process to support creating and comparison of design alternatives of internal finishing for office building. When design alternatives are created through the proposed process, it is possible to compare several similar cases with current project under equivalent design circumstance. Because only some finishing properties are replaced while maintaining the shape information such as the length, height, and base constraint of the object to be replaced.

• 한국음향학회지
• /
• 제25권3호
• /
• pp.101-106
• /
• 2006

본 연구에서는 그릴에 뚫려 있는 구멍이 마이크로스피커의 전체 임피던스에 미치는 영향에 대하여 조사하였다 이들에 대한 영향을 이론적으로 접근하기 위하여 그릴의 구멍을 열린 짧은 길이를 갖는 파이프시스템의 일종인 올피스로 취급하였다. 이에 대한 결과는 실험적으로 얻어진 특성과 매우 잘 일치하였다. 다시 말하면, 이들의 구멍크기가 작아지게 되면 구멍에 의한 음향임피던스가 매우 커지게 된다. 그 결과로써, 마이크로스피커의 전체 음향임피던스에 미치는 영향이 커지는 것을 알 수 있었다. 이처럼 그릴의 구멍크기가 작을수록 전체 임피던스에 미치는 영향이 커져서 마이크로 스피커 유닛에서 발생한 음향특성이 그릴의 사용으로 인하여 달라질 수 있게 된다.

• 한국환경과학회지
• /
• 제16권9호
• /
• pp.1051-1061
• /
• 2007

The impact of midlatitude synoptic system (upper-level trough) on typhoon intensity change was investigated by analyzing the spatial and temporal characteristics of vertical wind shear (VWS), relative eddy momentum flux convergence (REFC), and potential vorticity (PV). These variables were computed over the radial mean $300{\sim}1,000km$ from the typhoon center by using GDAPS (Global Data Assimilation and Prediction System) data provided by the Korea Meteorological Administration (KMA). The selected cases in this study are typhoons Rusa (0215) and Maemi (0314), causing much damage in life and property in Korea. Results show that the threshold value of VWS indicating typhoon intensity change (typhoon to severe tropical storm) is approximately 15 m/s and of REFC ranges 6 to 6.5 $ms^{-1}day^{-1}$ in both cases, respectively. During the period with the intensity of typhoon class, PVs with 3 to 3.5 PVU are present in 360K surface-PV field in the cases. In addition, there is a time-lag of 24 hours between central pressure of typhoon and minimum value of VWS, meaning that the midlatitude upper-level trough interacts with the edge of typhoon with a horizontal distance less than 2,000 km between trough and typhoon. That is, strong midlatitude upper-level divergence above the edge of the typhoon provides a good condition for strengthening the vertical circulation associated with the typhoons. In particular, when the distance between typhoon and midlatitude upper-level trough is less than 1,000 km, the typhoons tend to weaken to STS (Severe Tropical Storm). It might be mentioned that midlatitude synoptic system affects the intensity change of typhoons Rusa (0215) and Maemi (0314) while they moves northward. Thus, these variables are useful for diagnosing the intensity change of typhoon approaching to the Korean peninsula.

• 한국측량학회지
• /
• 제22권1호
• /
• pp.81-90
• /
• 2004

인공위성 영상자료들은 촬영조건 및 센서의 특성에 따라 다른 기하학적인 왜곡을 포함하고 있을 뿐만 아니라 공간, 방사 및 분광 해상도가 상이하기 때문에 정밀한 분석 결과 산출에 어려움이 있다. 즉, 두 개 이상의 영상을 비교 분석하기 위해 기본적인 센서 정보의 차이에서 발생하는 정오차를 소거하고 지형기복에 의해 발생하는 부정오차를 제거하기 위한 정밀 기하보정은 반드시 선행되어야 한다. 본 연구에서는 인공지형지물 변화탐지 기본도 를 구축하기 위해 위성의 센서정보를 이용한 센서모델링을 실시하였고 지상기준점과DEM자료를 가지고 정밀편위수정함으로써 다른 센서 및 촬영조건에 따라 발생하는 정오차를 소거하였다. 즉, 정밀편위수정법에 의해 Kompsat EOC 영상의 기복변위량을 감소시킬 수 있었고, 변화탐지를 위해 사용된 영상의 정합성과를 도심지역, 산림지역 및 혼합지역으로 나누어 시험 지역을 선정하여 검토한 결과 모든 지역에서 약 10% 정도의 정합률이 향상됨으로써 영상의 위치정확도를 향상시킬 수 있었다. 이러한 기본도를 가지고 이루어지는 변화탐지 결과는 지형지물의 갱신이나 다양한 GIS 응용의 기본 자료로서 효율적으로 사용할 수 있을 것으로 기대된다.

• 한국습지학회지
• /
• 제13권3호
• /
• pp.623-631
• /
• 2011

최근 기후변화에 따른 전지구적인 지구온난화는 대형 태풍의 발생, 집중호우의 증가 등 기존의 기후 특성을 변화시키고 있다. 이로 말미암아 자연재해의 강도가 강해지고 있고, 인명과 재산피해가 대규모화되고 있다. 따라서 본 연구에서는 기후변화로 인한 자연재해에 대비하기 위하여 미래 기후변화를 예측하고 도심지에 미치는 영향을 파악하고자 하였으며, 대상지역으로는 배수 관거의 용량 초과로 인해 상습적으로 침수가 발생하는 인천광역시 계양구 일대를 선정하였다. 먼저, 기후변화 시나리오 및 기후모형들을 검토하여 적정 기후시나리오와 기후모형을 선정하고, 수집한 강우자료를 시간단위로 축소한 뒤 미래 기후변화의 영향으로 인해 발생할 수 있는 확률강우량을 구하였다. 미래 증가하는 확률강우량을 XP-SWMM모형에 적용해 도시배수시스템의 홍수유출량을 산정 하였는데, 대상지역에 월류가 발생할 것으로 예상되었다. 따라서 이에 대한 적절한 대책 마련이 필요할 것으로 사료된다.