• Journal of Korean Society for Atmospheric Environment
• /
• v.27 no.1
• /
• pp.1-15
• /
• 2011

Korea Global Atmosphere Watch Center (KGAWC), which is located in Anmyeondo and, belongs to the Korea Meteorological Administration (KMA), measures sulfur hexafluoride ($SF_6$) in every hour since 2007. In this study, $SF_6$ observed in 2007 are discussed. A gas chromatograph-electron capture detector (GC-ECD) with pre-cooled device is applied during the observation, and produced data are qualified by means of periodic calibration with $SF_6$ standard gas made by Korea Research Institute of Standard and Science (KRISS). $SF_6$ has been greatly paid attention since Kyoto protocol because of its high global warming potential(GWP) with 22,200 times of $CO_2$ in the period of 100 years. It is a man-made compound and has been usually used for gas insulation since 1970s and for etching process in the information technology-based industry since 1990. Average mixing ratio of $SF_6$ in 2007 was 6.65 pmol/mol at Anmyeondo. According to the GAW report published in 2008, average mixing ratio of $SF_6$ in the atmosphere is continuously growing. At present, the average mixing ratio of $SF_6$ in the atmosphere is known to be approximately 6.25 pmol/mol at global observatory. $SF_6$ value in Anmyeondo shows 0.40 pmol/mol greater than that of the Mauna Loa observatory in 2007.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.11
• /
• pp.2480-2486
• /
• 2012

The design of low voltage LC-VCO(LC Voltage Controlled Oscillator) has been presented to optimize the phase noise and power consumption for the block of frequency synthesis to satisfy WCDMA system specification in this paper. The parameters for minimum phase noise has been obtained in the region of design, using the lines of the tuning range and the excess gain in the plane of the inductance and the transconductance of MOS transistor to compensate the loss of LC-tank. As a result of simulation, the phase noise characteristics is -113dBc/Hz for offset of 1MHz. The optimum designed LC-VCO has been fabricated using the process of 0.25um CMOS. As a result of measurement for fabricated chip, the phase noise characteristics is -116dBc/Hz for offset of 1MHz. The power consumption is 15mW, and Kvco is 370MHz/V.

• Journal of Information Display
• /
• v.9 no.4
• /
• pp.21-29
• /
• 2008

We studied both the wavelength and intensity dependent photo-responses (photofield-effect) in amorphous In-Ga-Zn-O (a-IGZO) thin-film transistors (TFTs). During the a-IGZO TFT illumination with the wavelength range from $460\sim660$ nm (visible range), the off-state drain current $(I_{DS_off})$ only slightly increased while a large increase was observed for the wavelength below 400 nm. The observed results are consistent with the optical gap of $\sim$3.05eV extracted from the absorption measurement. The a-IGZO TFT properties under monochromatic illumination ($\lambda$=420nm) with different intensity was also investigated and $I_{DS_off}$ was found to increase with the light intensity. Throughout the study, the field-effect mobility $(\mu_{eff})$ is almost unchanged. But due to photo-generated charge trapping, a negative threshold voltage $(V_{th})$ shift is observed. The mathematical analysis of the photofield-effect suggests that a highly efficient UV photocurrent conversion process in TFT off-region takes place. Finally, a-IGZO mid-gap density-of-states (DOS) was extracted and is more than an order of magnitude lower than reported value for hydrogenated amorphous silicon (a-Si:H), which can explain a good switching properties observed for a-IGZO TFTs.

• Electrical & Electronic Materials
• /
• v.9 no.3
• /
• pp.251-258
• /
• 1996

Sol-Gel derived ferroelectric Pb(Z $r_{0.52}$ $Ti_{0.48}$) $O_{3}$ thin films have been fabricated on Pt/Ti/ $SiO_{2}$/Si substrate. Two kinds of fast annealing methods, F-I (six times of intermediate and final annealing) and F-II(one final annealing after six times of intermediate annealing) were used for preparation of multi-coated PZT thin films. As the annealing temperature was increased, high capacitance could be obtained, for instance, 2700.angs.-thick PZT thin film annealed at 680.deg. C had a capacitance value of approximately 20nF at 1kHz. In addition, it is found that the dielectric constant is a function of the perovskite phase fraction. In case of F-I method, PZT thin film had a remanent polarization(Pr) of 8-15.mu.C/c $m^{2}$ and a coercive field( $E_{c}$) of 35-44kV/cm according to annealing temperature, whereas PZT film fabricated by F-II method had as high as 24-25.mu.C/c $m^{2}$ and 48-59kV/cm, respectively. As a result of measuring Curie temperature, PZT thin film had a range of 460-480.deg. C by F-I method and more or less higher range of 525-530.deg. C by F-II method, which implied that different microstructures could cause the different Curie temperature. Through I-V measurement, leakage current of PZT thin film fabricated by F-I and F-II methods was 64nA/c $m^{2}$ and 2.2.mu.A/c $m^{2}$ in the electric field of 100kV/cm, respectively.y.y.y.

• Journal of Korean Library and Information Science Society
• /
• v.36 no.2
• /
• pp.283-305
• /
• 2005

Data produced during scientific and technical activities usually have value as standard reference data (SRD) which is a well-documented numeric value assessed for reliability and accuracy. The main criteria in the evaluation for SRD is how well their production is documented including a sample preparation, measurement method, data processing and so on, other than reference data. SRD is represented as a certified numeric value with uncertainty. In this study, the SRD in the area of material properties was introduced to provide understanding of SRD and its evaluation method. Also the national SRD system was studied. The national SRD system is composed of the center for the SRD, the data centers, and the committee. The role and task of those components were studied. The legislational and systematic supports for the system were proposed in this study.

• Journal of the Korea Society for Simulation
• /
• v.27 no.2
• /
• pp.49-59
• /
• 2018

The simulation-based weapon system effectiveness analysis is to support the decision making in the acquisition process of the defense domain. The effectiveness of the weapon system is a complexly influenced indicator from various factors such as environment, doctrine and so on. And the measurement of effectiveness can be defined differently in compliance with major issues in the weapon system. Because of this, the weapon system effectiveness analysis requires the comparative experiment of various alternatives based on the underlying assumption. This paper presents the efficient approach to reconfigure the simulation using the reflection technique. The proposed method contains the recoupling and resetting the simulation entity using DEVS(Discrete EVent System specification) formalism-based dynamic plug-in method. With the proposed method, this paper designs the effectiveness analysis environment that can efficiently handle the various alternatives of the weapon system.

• Journal of Convergence for Information Technology
• /
• v.8 no.1
• /
• pp.275-280
• /
• 2018

Companies are now rapidly entering the realm of the realtime economy named 'Now Economy'. 'Now Economy' features the measurement and assessment, accelerating speed of decision making about business. According to this, companies intend to change their disposition to be able to make quick and accurate decision by gathering informations rapidly and correctly, and then by processing that. Applications of ICT can be possible to change the new decision system of companies. In this thesis, the new decision system through amalgamations of BPMS, Mobile, Cloud Service, Hadoop, BI and AI is presented. It will be able to make decision quickly and accurately by collecting all information between the most efficiently managed process and formal and informal data inside company through this, and then by combining changes with situations outside company.

• Journal of Cadastre & Land InformatiX
• /
• v.47 no.1
• /
• pp.95-110
• /
• 2017

The network RTK surveying has been widely used in the field of cadastral surveys in recent years, and its use is gradually expanding. As a result of the implementation of GPS static surveys by civilian companies in accordance with the progress of the cadastral surveys and gradual civilian transfer plans and cadastral surveys, there has been an increase in the number of civilian companies performing surveys. In this paper, we describe the process of applying the results of analysis of conformity using the network RTK site calibration function on the local coordinate system to the GPS static surveying of the cadastral reference points in Anyang city. In addition, the measurement results of the network RTK site calibration function and the results of the GPS static surveying network reconciliation in the local coordinate system were compared, and the performance was determined within 0.04m maximum of RMSE(Root Mean Square Error), and further study on the application method is needed.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.1 s.343
• /
• pp.1-6
• /
• 2006

This paper proposes substrate-bias voltage generator to reduce leakage power consumption of digital logic circuits operating at supply voltage of 0.5V. Proposed substrate-bias voltage generator is composed of VSS and VBB generator. The former circuit produces negative voltage and supplies its output voltage for VBB generator. As a result VBB generator develops much lower negative voltage than that of conventional one. Proposed circuit is fabricated using 0.18um 1Poly-6Metal CMOS process and measurement result demonstrated stable operation with substrate-bias voltage of -0.95V.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.3
• /
• pp.211-219
• /
• 2001

This paper describes a read-only CMOS transponder IC for RFID applications. A full-wave rectifier implemented using NMOS transistors supplies the transponder with a dc supply voltage using the magnetic field generated from a reader. A 64-bit ROM has been designed for a data memory. Front-end impedance modulation and Manchester coding are used for transmitting the data from the transponder memory to the reader. A new damping circuit which has almost constant damping rate under the variations of the distance between the transponder and the reader has been employed for impedance modulation. The designed circuit has been fabricated using a 0.65${\mu}{\textrm}{m}$2-poly, 2-metal CMOS process. Die area is 0.9mm$\times$0.4mm. Measurement results show that it has a constant damping rate of around 20~25% and a data transmission rate of 3.9kbps at a 125KHz RF carrier. The power required for reading operation is about 100㎼. The measured reading distance is around 7cm.