• 해양환경안전학회지
• /
• 제25권6호
• /
• pp.765-771
• /
• 2019

선박 및 수중구조물의 고속, 대형화 및 요구조건 강화의 추세에 따라 유동소음 예측기술의 중요성이 강조되고 있다. 항공, 철도 등의 공력소음 분야에서는 음향상사법을 이용하여 순음 및 광대역 유동소음에 대해 활발히 연구되고 있는 반면 조선해양분야에서는 수중추진기의 날개주파수소음에 대해서만 일부 고려되고 있다. 본 논문에서는 날개면 형상의 주요 유동소음발생 메커니즘 뒷날소음을 고려 가능한 FW-H Formulation 1B를 이용하여 수중추진기 및 선저부가물의 기초요소인 수중익에 대해 광대역소음 예측기법을 연구하였다. 기존의 FW-H Formulation 1B는 공기 중의 압력상관관계 모델에 기반하여 구성되어 있어 매질에 대한 일반성 및 정확도의 한계를 가지므로 수중환경에 대해 일반성을 가지는 벽면변동압력 모델로 확장하는 방법론을 제시하였다. 공기 중 날개면의 소음계측결과와 비교해 벽면변동압력 모델을 이용할 경우 기존모델의 해석결과 대비 5 dB 이내의 오차로 정확도 관점에서의 유용성을 확인할 수 있었으며 전산유체역학과 벽면변동압력을 이용한 수중환경의 광대역소음해석 절차를 확립하고 수중익의 광대역소음 예측을 수행하였다.

• Journal of Oral Medicine and Pain
• /
• 제23권4호
• /
• pp.433-445
• /
• 1998

본 연구는 정상인의 저작근에서 지속적인 등척성 수축후 근전도 power spectrum과 압력통각 역치의 회복 특성을 구명하기위해 시행되었다. 악안면 영역의 동통과 긴으장애의 벙력 및 현증이 ㅇ벗고 정상적인 교합관계를 가진 26명의 정상인(남자 14명, 여자 12명) 을 대상으로 최대근활성도의 70% 수준에서 인내가능 할 때까지의 등척성 수축과 수축후 회복기 동안의 근전도 power spectrum과 압력통각 역치를 컴퓨터를 이용한 근전도 시스텀과 전자식 압력통각계를 사용하여 분석한 결과 다음과 같은 결론을 얻었다. 1. 지속적인 등척성 수축 시작 시점의 중간주파수에서 남녀간에는 통계적으로 유의한 차이가 관철되지 않았지만, 근육간 비교에서는 전측두근에서 교근보다 유의하게 높게 나타났다(p<0.05). 2. 지속적인 등척성 수축전 암력통각 역치는 전축두근에서 교근보다 유의하게 높았고(p<0.001), 남성에서 여성보다 유의하게 높게 나타났다(p<0.05). 3. 지속적인 등척성 수축시 중간주파수와 압력통각 역치의 변화량은 성별간, 근육간에 우의한 차이가 관찰되지 않았다. 4. 지속적인 등척성 수축말기 중간주파수는 수축초기에 비하여 유의하게 감소하였으며(p<0.001), 이의 회복은 모든 근육에서 60초와 120초 사이에서 이루어 졌다. 5. 지속적인 등척성 수축후 압력통각역치는 수축전에 비해 유의하게 감소하였으며(p<0.001), 수축전 수준으로의 회복은 여자군의 전측두근과 교근에서는 30분후에 남자구느이 전측두근과 교근에서는 50분 후에 이루어졌다. 6. 지속적인 등척성 수축후 주관적인 동통이 소실된 시각은 여자군의 전축두근에서는 28분, 교근에서는 42분으로 남자군의 전측두근에서는 30분, 교근에서는 40분으로 나타났다.

• Bulletin of the Korean Chemical Society
• /
• 제27권3호
• /
• pp.373-375
• /
• 2006

$CF_4$ gas is one of the most common chemicals used for dry etching in semiconductor manufacturing processes. For application to the etching process and environmental control, the low-pressure inductively coupled plasma (LP-ICP) was employed to obtain the spectrum of $CF_4$ gas. In terms of the analysis of the spectra, trace CF radical by A-X and B-X transitions was detected. The other $CF_x$ radicals, such as $CF_2$ and $CF_3$, were not seen in this experiment whereas strong C and $C_2$ emissions, dissociation products of $CF_4$ gas, were observed.

• 한국생산제조학회지
• /
• 제8권2호
• /
• pp.35-43
• /
• 1999

The paper describes an approach for measuring delivery flow ripple generated by oil hydraulic axial piston pumps. In order to reduce pressure ripple which cause to undesirable noise. vibration and fatigue in hydraulic systems it is indispensible measure a delivery flow ripple from pumps. Since the flow ripple measurement of flow pumps is independent of the dynamic characteristics of the connected hydraulic circuit the measurement of flow ripple is most suitable for pump fluid-borne noise rating. The measurement of flow ripple with high frequencies from axial piston pumps is made by applying the remote instantaneous flow rate measurement method which is based on the dynamic characteristics between pressure and flow rate in hydraulic pipeline. The measured flow ripple waveforms are influenced by the configuration of V-shaped triangular relief groove in the valve plate. It can be seen that the appropriate relief groove in valve plate reduces the pressure and flow ripple amplitude and frequency spectrum for high harmonics.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 춘계학술대회 논문집 유기절연재료 방전 플라즈마연구회
• /
• pp.92-95
• /
• 2003

In this paper, the emission properties of electrodeless fluorescent lamp were discussed using the inductively coupled plasma. To transmit the electromagnetic energy into the chamber, a RF power of 13.56MHz was applied to the antenna and considering the Ar gas pressure and the RF electric power change, the emission spectrum, Ar-I line, luminance were investigated. At this time the input parameter for ICP RF plasma, Ar gas pressure and RF power were applied in the range of 10~60m Torr, 10~300W respectively.

• 한국자동차공학회논문집
• /
• 제6권1호
• /
• pp.205-212
• /
• 1998

In this study, the effects of water vapor in inlet air on combustion efficiency, general performance, knock characteristics and emission gas concentration were investig- ated through the experiments of combustion and vibration analyses, emission gas analysis by changing water vapor quantity in inlet air with temperature and humidity auto control unit. With partial vapor pressure increase, the brake torque at wide open throttle status decreased and the average ignition delay angle increased, IMEP (indicated mean effective pressured using the integral and 3rd derivatives of filtered cylinder pressure as knock intensity, which matched well with the method of frequency power spectrum of block vibration signal. Water vapor in intake air had influence on the spark knock sensitivity. With the increase of water vapor content in intake air NOx emission was decreased and HC emission was increased.

• 전기학회논문지
• /
• 제56권10호
• /
• pp.1802-1806
• /
• 2007

Nowadays, many configurations and applications of small atmospheric plasma source have been investigated with growing interest, as it provides the bacteria inactivation, the surface modification and removal of unwanted small regions, and so on. In this paper, the non-thermal micro plasma source under atmospheric pressure by means of submicrosecond pulse voltage waveforms is suggested. Plasma operates in helium is appears as a small (sub-mm) glow at the tip of a plasma gun. Electrical measurements show that the plasma source operates at low voltage (about 500V) and the power consumption is about 1W at 25kHz. Moreover, the emission spectrum shows the relatively higher emission intensity of oxygen particles than those of helium and nitrogen.

• Journal of Advanced Marine Engineering and Technology
• /
• 제31권6호
• /
• pp.761-767
• /
• 2007

We have developed novel optical-fiber sensors based on strain-induced long-period fiber gratings for monitoring the deformation of a hull. They have no external pressure for sustaining the mechanical formed gratings. The pressure, which provides a force to form the periodic grating along the single mode fiber, was realized by the bonding strength of a photopolymer. To reduce the polarization dependency of the sensors caused by the asymmetry structure of gratings, a Faraday Rotator Mirror (FRM) was utilized in this experiment. We have realized the polarization-insensitive function of the proposed sensors. The change of an external strain are measured by an optical spectrum analyzer. When the external stain increases. the attenuation at the resonant wavelength decreases and the loss peak was slightly shifted to the shorter wavelength.

• 소음진동
• /
• 제9권5호
• /
• pp.922-927
• /
• 1999

The objective of this paper is to obtain the contribution of each source to the spectrum of pressure, when there are multiple incoherent sources in near-field acoustic holography. For this objective, we have to obtain signals very coherent to the input signals of the sources. To obtain the very coherent signals, many people have measured pressure signals in the vincinity of the sources. However, it is sometimes difficult to locate microphones near to the sources so that the signals are very coherent to the input signals. This paper proposed a method to obtain the very coherent signals by near-field acoustic holography. Therefore, the proposed method does not require the measurement of pressure near to each source. Simulation results for two incoherent monopole sources showed the possibility of the proposed method.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제53권1호
• /
• pp.20-23
• /
• 2004

In this paper, the emission properties of electrodeless fluorescent lamp were discussed using the inductively coupled plasma. To transmit the electromagnetic energy into the chamber, a RF power of 13.56 [MHz] was applied to the antenna and considering the Ar gas pressure and the RF electric power change, the emission spectrum, Ar I line, luminance were investigated. At this time, the input parameter for ICP RF plasma, Ar gas pressure and RF power were applied in the range of 10∼60 [mTorr], 10∼300 [W], respectively. From emission intensity and lumnance intensity results, the mode transition from E-mode to H-mode was observed. This implies that this method can be used to find an optimal RF power for efficient light illumination in an electrodeless fluorescent lamp.