• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2002.04a
• /
• pp.217-218
• /
• 2002

대기환경 중의 오존은 유기용제의 사용 및 차량에서 배출되는 휘발성 방향족 화합물과 오존전구물질(ozone precursors)이 대기 중에서 광화학반응을 통하여 만들어지는 것으로 알려져 있다. 오존은 호흡기계통의 기관지염 및 감기, 현기증과 같은 인체의 건강상에도 매우 나쁜 영향을 초래하고 있어 이에 대한 모니터링이 중요한 과제로 대두되고 있다. 본 연구에서는 고가의 장비가 소요되는 기존의 분석법인 저온농축법과 흡착법을 이용하는 대신에 고체상 미량추출방법 (Solid-Phase Microextraction, 이하 SPME)을 이용하여 GC/MS로 대기 중 오존 VOC를 ppt 수준까지 빠르고 신속하게 분석하는 방법을 확립하였다. (중략)

• Journal of Microbiology and Biotechnology
• /
• v.3 no.4
• /
• pp.244-251
• /
• 1993

A novel system has been developed to produce ${\delta}-aminolevulinic$ acid (ALA) using the intact cells of late logarithmic phase of Rhodocyclus gelatinosus KUP-74. The system was shown optimum yield of extracellular ALA under a condition of anaerobic light irradiation (4 Klux) at $30^{\circ}C$ with no variation in cell mass. The rate of extracellular ALA formation was stimulated by low doses of either $C_4\;or\;C_5$ ALA biosynthetic precursors, where 5 mM ($C_4) and 3 mM ($C_5) of each precursors were appeared to generate the maximum rates of 3.3 and 4.0 nmoles of ALA per 0.35 mg cells per hr, respectively. Half-life of the system was 10 hr in a sense of an ability of portage transport of L-glutamate, and sequential dose of this compound was resulted in promising recovery of the ALA.

• Journal of the Korean Society of Combustion
• /
• v.7 no.2
• /
• pp.24-33
• /
• 2002

The morphology of deposits on $15-{\mu}m$ thin SiC filaments has been investigated with SEM in a co-flowing, propane/air laminar diffusion flame. The average size of mature soot particles deposited in the luminous flame edge is strongly dependent on their axial position in a typical heavily sooting flame. The surface growth of liquid-phase PAHs molecules and the transition to soots from fully-developed precursors could be observed in the radial deposition of the flame. Two sooting regimes were found: one is the transition from the condensed-phase precursors; the other is the aggregation of smaller soot particles (or chains of them) to be carried along particle path lines. In the high temperature flame edge outside the soot luminous flame surface, the very thin fiber-like structures, which are about 10 nm thick, were found.

• Plant Biotechnology Reports
• /
• v.2 no.2
• /
• pp.133-136
• /
• 2008

Cell cultures of Commiphora wightii (Arnott.) Bhandari were grown in shake flasks and a bioreactor and an increase in guggulsterone accumulation up to $18{\mu}g\;l^{-1}$ was recorded in cells grown in the production medium containing a combination of sucrose:glucose (4% total), precursors (phenylalanine, pyruvic acid, xylose, and sodium acetate), morphactin, and 2iP. A yield of $10g\;l^{-1}$ biomass and ${\sim}200{\mu}g\;l^{-1}$ guggulsterone was recorded in a 3-l flask and in a 2-l stirred tank bioreactor compared with 6.6 g biomass and $67{\mu}g\;l^{-1}$ guggulsterone in 250-ml flasks. Increased vessel size was correlated with increased biomass and guggulsterone accumulation. 2iP alone was not effective for biomass and guggulsterone accumulation in cell cultures of C. wightii.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.256-256
• /
• 2011

We have deposited Al2O3 thin films on Si substrates at room temperature by UV-enhanced atomic layer deposition using trimethylaluminum (TMA) and H2O as precursors with UV light. The atomic layer deposition relies on alternate pulsing of the precursor gases onto the substrate surface and subsequent chemisorption of the precursors. In many cases, the surface reactions of the atomic layer deposition are not completed at low temperature. In this experiment, the surface reactions were found to be self-limiting and complementary enough to yield uniform Al2O3 thin films by using UV irradiation at room temperature. The UV light was very effective to obtain the high quality Al2O3 thin films with defectless.

• Macromolecular Research
• /
• v.17 no.9
• /
• pp.697-702
• /
• 2009

Mesoporous ethanesilica thin film was prepared using PEO-PLGA-PEO triblock copolymers as structure-directing agents and (1,2-bis(triethoxysilyl) ethane BTESE; bridged organosilicates) as inorganic precursors via one-step sol-gel condensation of ethanesilica precursors. The mesostructure of ethanesilica films is critically dependent on the processing experimental parameters after the hydrolyzed silica sol mixture was spin-cast. This study examined the effects of the block copolymer template/organosilica precursor ratio in the casting solution and aging period before calcination of the mesostructure. It was further demonstrated that mesoscopic ordering of organosilicate thin films is induced by the rearrangement of block copolymer template/organosilica hybrid during thermal decomposition of the PEO-PLGA-PEO triblock copolymer. The mesoporous structure and morphology were characterized by SAXS, TEM and solid-state NMR measurement.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.3
• /
• pp.653-656
• /
• 2009

3-Dimensionally ordered macroporous $LiMn_2O_4$ thin film was prepared by a sol-gel and dip coating method on Pt/Ti/$SiO_2$/Si substrate. An opal structure consisting of mono dispersed polystyrene beads (300 nm) was used as a template. After solution containing Mn and Li precursors was coated on the template-deposited substrate, the template and organic materials in the precursors was removed by calcination at 400 ${^{\circ}C}$. And then the 3-dimensional $LiMn_2O_4$ thin film with spinel structure was fabricated by heat treatment at 700 ${^{\circ}C}$. The structural and electrochemical property was investigated by XRD, SEM and charge-discharge cycler.

• Journal of the Korean Ceramic Society
• /
• v.50 no.4
• /
• pp.257-262
• /
• 2013

A biomimetic approach was applied for the chemical deposition of calcium phosphate (CaP) coatings on 3 mole% yttrium-stabilized zirconia [3YSZ] powders. The solid-state reaction of 3YSZ powders with the addition of CaP was investigated for the development of biodegradable zirconia ceramics. The solid-state interaction between the 3YSZ matrix powders and the CaP additives differed from the behavior of commercial zirconia matrix powders. The 3YSZ powders were chemically reacted with precursors for the CaP formation. 3YSZ powders were mixed in an aqueous solution of Ca-P precursors and the CaP was precipitated on the surface of the 3YSZ matrix powders. The CaP-doped YSZ powders were calcined at $1100^{\circ}C$ and shaped powder blocks were then fired at $1600^{\circ}C$ for 2 h. The CaP phase formation was investigated using FE-SEM and XRD analysis.

• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.09a
• /
• pp.346-347
• /
• 2006

New manufacturing processes, such as thermochemical, mechanochemical and chemical vapor condensation processes have been developed to obtain nanostructured WC/Co materials. Nanoscale size WC/Co composite powders of near 100-150nm can be synthesizes by thermochemical and mechanochemical processes using water soluble precursors. Non-agglomerated and nano sized WC powder can be synthesized by the chemical vapor condensation process using metallorganic precursors as starting materials. In this paper, the scientific and technical issues on synthesis and consolidation of nanostructured WC/Co alloys produced by new chemical processes are introduced.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.401-402
• /
• 2005

The important parts of material science in the film preparation fields and sol-gel technology are presented. For the present work, a series of amorphous films was prepared in air by sol-gel method without using some alkoxide stabilizer, which reduces the reactivity of the metal alkoxides. The choice of precursors can affect the chemical-reaction kinetics, microstructures and properties of the product. In this report author compared the crystallization behavior of oxide functional films derived from the same precursors, stressing the influence of experiment conditions and where it was possible to obtain the uniform amorphous or crystalline dielectric films. A short analysis of sol-gel technology and thin film methods about development of dielectric materials has been given.