• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.2
• /
• pp.397-401
• /
• 2005

In this paper, we have developed a frequency mixer which can be used as a microwave phase conjugator in the retrodirective array antenna. The retrodirective array, which can reflect the incident wave retrodirertively back to the source direction without any priori information, requires phase conjugators to achieve the phase change of 180 degrees for the incoming signal. frequency mixers can efficiently serve as phase conjugators. The circuit topology is of the 2-port structure to avoid the complexity of LO and Rf signal combination and matching circuits, using a pseudomorphic HEU device. The operating frequencies are 4.0 CHz, 2.01 CHz, and 1.99 CHz for LO, RF, and If signals, respectively. Conversion loss is measured to be -ldB and 1-dB compression point -l5 dBm at the LO power of -10 dBm.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.3
• /
• pp.405-417
• /
• 2001

In this paper, since we currently using surveillance system of analog type bring about waste of resource and efficiency deterioration problems, we describe new solution that design and implementation to the digital surveillance system of new type applying compression techniques and encoding techniques of image data using MPEG-2 international standard. Also, we proposed fast motion estimation algorithm requires much less than the convectional digital surveillance camera system. In this paper a fast motion estimation algorithm is proposed the MPEG-2 video encoding. This algorithm is based on a hybrid use of the block matching technique and gradient technique. Also, we describe a method of moving object extraction directly using MPEG-2 video data. Since proposed method is very simple and requires much less computational power than the conventional object detection methods. In this paper we don't use specific H/W and this system is possible only software encoding, decoding and transmission real-time for image data.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.1
• /
• pp.166-172
• /
• 2001

A RF wideband receiver for INMARSAT-B satellite communications system was composed of low noise amplifier and high gain amplifier, The low noise amplifier used to the resistive decoupling circuit for input impedance matching and self-bias circuits for low noise. The high gain amplifier consists of matched amplifier type to improve receiver gain. The active bias circuit can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilization resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 60 dB in gain and less than 1.8:1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio which is input signal level -126.7 dB m at 1537.5 MHz is a 45.23 dB /Hz at a 1.02 kHz.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.42 no.3 s.303
• /
• pp.15-22
• /
• 2005

This paper proposed a object tracking algorithm which can track contour of fast moving object through motion estimation. Since the proposed tracking algorithm is based on the radial representation, the motion estimation of object can be accomplished at the center of object with the low computation complexity. The motion estimation of object makes it possible to track object which move fast more than distance from center point to contour point for each frame. In addition, by introducing both gradient image and difference image into energy functions in the process of energy convergence, object tracking is more robust to the complex background. The results of experiment show that the proposed algorithm can track fast moving object in real-time and is robust under the complex background.

• The Journal of Advanced Prosthodontics
• /
• v.5 no.3
• /
• pp.262-269
• /
• 2013

PURPOSE. Perceived color of ceramics changes by the spectral power distribution of ambient light. This study aimed to quantify the amount of shifts in color and color coordinates of clinically simulated seven all-ceramics due to the switch of three ambient light sources using a human vision simulating spectroradiometer. MATERIALS AND METHODS. CIE color coordinates, such as $L^*$, $a^*$ and $b^*$, of ceramic specimens were measured under three light sources, which simulate the CIE standard illuminant D65 (daylight), A (incandescent lamp), and F9 (fluorescent lamp). Shifts in color and color coordinate by the switch of lights were determined. Influence of the switched light (D65 to A, or D65 to F9), shade of veneer ceramics (A2 or A3), and brand of ceramics on the shifts was analyzed by a three-way ANOVA. RESULTS. Shifts in color and color coordinates were influenced by three factors (P<.05). Color shifts by the switch to A were in the range of 5.9 to 7.7 ${\Delta}E{^*}_{ab}$ units, and those by the switch to F9 were 7.7 to 10.2; all of which were unacceptable (${\Delta}E{^*}_{ab}$ > 5.5). When switched to A, CIE $a^*$ increased (${\Delta}a^*$: 5.6 to 7.6), however, CIE $b^*$ increased (${\Delta}b^*$: 4.9 to 7.8) when switched to F9. CONCLUSION. Clinically simulated ceramics demonstrated clinically unacceptable color shifts according to the switches in ambient lights based on spectroradiometric readings. Therefore, shade matching and compatibility evaluation should be performed considering ambient lighting conditions and should be done under most relevant lighting condition.

• Physical Therapy Korea
• /
• v.8 no.4
• /
• pp.45-61
• /
• 2001

본 연구는 보행주기 동안 정상인과 당뇨병성 족부궤양 환자의 족관절 운동역학적 변수와 족관절 근육들의 근활성도에 차이가 있는지 알아보기 위하여 실시하였다. 본 연구의 대상자는 당뇨병성 족부궤양이 있는 환자 9명(남자: 6명, 여자: 3명)과 성, 연령, 체중으로 짝짓기(matching)시킨 대조군 9명이었다. 3차원 동작분석기, 힘판, 표면 근전도를 이용하여, 보행주기 동안 족관절의 관절가동범위, 모멘트(moment), 일률(power), 그리고 내측가자미근, 전경골근, 비복근의 근수축 개시시간(onset time)과 종료시간(cessation time)을 측정하였다. 정상군과 비교하여 당뇨병성 족부궤양군의 보행속도는 느렸고, 입각기 기간이 길었으며, 족관절의 가동범위가 적었고, 족관절 최대 족저굴곡 모멘트와 일률이 정상군에서보다 유의하게 낮았다. 보행주기에서 당뇨병성 족부궤양군에서 내측 가자미근과 비복근의 근수축 개시시간은 유의하게 빨랐으며, 전경골근과 비복근의 근수축 종료시간은 유의하게 지연되었다. 당뇨병성 족부궤양 환자군의 족관절 근육에서 동시수축(co-contraction)이 증가되고, 보행속도가 느리며, 입각기 기간이 증가하였다. 이러한 보행특성의 차이는 족부 감각손실에 따른 보행의 안정성을 유지하기 위한 보행전략 때문으로 판단된다. 앞으로 이러한 비정상적인 보행특성이 당뇨병성 족부궤양에서 발생하는 비정상적인 족저부 압력분포과 족부궤양 발생과 어떤 관계가 있는지 알아보는 연구가 필요할 것이다.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.11
• /
• pp.77-83
• /
• 2009

In this paper, a selective feedback low-noise amplifier (LNA) has been realized in a $0.18{\mu}m$ CMOS technology to cover a number of wireless multi-standards. By exploiting notch filter, the SF-LNA demonstrates the measured results of the power gain (S21) of 11.5~13dB and the broadband input/output impedance matching of less than -10dB within the frequency bands of 820~960MHz and 1.5~2.5GHz, respectively. The chip dissipates 15mW from a single 1.8V supply, and occupies the area of $1.17\times1.0mm^2$.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.5
• /
• pp.100-105
• /
• 2010

A multi-band low noise amplifier (LNA) is designed in 90 nm RF CMOS process for 3GPP LTE (3rd Generation Partner Project Long Term Evolution) applications. The designed multi-band LNA covers the eight frequency bands between 1.85 and 2.8 GHz. A tunable input matching circuit is realized by adopting a switched capacitor array at the LNA input stage for providing optimum performances across the wide operating band. Current steering technique is adopted for the gain control in three steps. The performances of the LNA are verified through post-layout simulations (PLS). The LNA consumes 17 mA at 1.2 V supply voltage. It shows a power gain of 26 at the normal gain mode, and provides much lower gains of 0 and -6.7 in the bypass-I and -II modes, respectively. It achieves a noise figure of 1.78 dB and a IIP3 of -12.8 dBm over the entire band.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.48 no.6
• /
• pp.56-61
• /
• 2011

A class-D audio amplifier is widely used in coil speaker. This paper presented the technique for applying a class-D audio amplifier to the ceramic flat speaker. This technique can be achieved by employing a matching transmitter in order to replace class-G amplifier that is drven by voltage level to class-D amplifier employing power driving method. Consequently, the presented technique can improve the efficiency by making the voltage driving level a litter larger. We evaluate the sound-level efficiency using the various mediums such as wood, plastic, and paper. From the simulation results, the proposed technique employing a class-D audio amplifier rather than a class-G one showed a 10% improvement. The proposed system can be applicable for the mobile appliances as an external slim speaker.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.39 no.4
• /
• pp.409-412
• /
• 2002

The LNA(Low Noise Amplifier) is designed for use in low cost commercial application covered fully IMT-2000 band(1920~2170MHz, BW=250MHz). It is optimized source inductance for source lead and designed to equivalent etched line. The LNA uses a high pass impedance matching network for noise match and simple structure. The bias circuit designs have been made self-biased with a negative voltage applied to gate. The power supply voltage is 8V, total current is 180mA. The LNA is biased at a Vgs of -0.4, Vds of 4V for first stage and Vds of 5V for second stage. The LNA is designed competitively for commercial product specification. The measured gain and noise figure of the completed amplifier was 20dB and 1dB, respectively. Also, input VSWR, P1dB and gain flatness was measured of 1.14 ~ l.3dB, 22.4dBm and $\pm$0.45dB, respectively. The designed LNA can be used for commercial product.