• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.2
• /
• pp.87.2-87.2
• /
• 2013

We studied a fine-scale half ring-like structure around a pore seen from the high spectral and the high spatial resolution data. Our observations were carried out using the Fast Imaging Solar Spectrograph (FISS) and the InfraRed Imaging Magnetograph (IRIM) installed at the 1.6 meter New Solar Telescope of Big Bear Solar Observatory (BBSO) on 2012 July 19. During the observations, we found a fine-scale half ring-like structure located very close to a pore (~0.4 arcsec apart from the pore). It was seen in the far wing images of the $H{\alpha}$ and Ca II $8542{\AA}$ lines, but it was not seen in the line center images of two lines. The length of the structure is about 4200 km and the width is about 350 km. We determined its line-of-sight velocity using the Doppler shift of the centroid of the Ti II line ($6559.6{\AA}$, close to the $H{\alpha}$ line) and determined horizontal velocity using the NAVE method. we also investigated the magnetic configurations using the Stokes I, Q, U, and V maps of the IRIM. As a results, we found that it has a high blue-shift velocity (~2km) faster than the photospheric features and has a strong horizontal component of the magnetic field. Based on our findings, we suggest that it is associated with small flux emergence, which occurs very close to the pore. Even though it is very small structure, this kind of magnetic configuration can be in chare of the upper chromosphere heating, especially above the pore.

• Journal of Environmental Health Sciences
• /
• v.29 no.1
• /
• pp.34-42
• /
• 2003

The objective of this study is to investigate the waste recycling possibility, practicability, economic efficiency and acid gas sorbent use of the hard-shelled mussel. This study is to investigate the hydration/calcination reaction and fixed bed reactor. The physical-chemical characteristics of the hard-shelled mussel were analyzed by ICP SEM-EDX, BET and pore volume. Thus, the results could be summarized as follows; Hard-shelled mussel can be used as iron-manufacture and chemical sorbents considering more than 53.7% of the mussel is lime content. The SO$_2$removal efficiency of the hard-shelled mussel after calcined hydration increased thirty times as a result of the higher pore size, specific surface area and pore volume. Also, the CaO content, pore volume, pore size distribution and specific surface area greatly influenced the SO$_2$ and NOx removal reactivity. The optimum particle diameter average of hard-shelled mussel was $\pm$100 mesh, which was applied to the sorbent on the medium/small scale waste incinerator and flue gas desulfurization processes.

• Geophysics and Geophysical Exploration
• /
• v.12 no.4
• /
• pp.347-354
• /
• 2009

Physical properties of rocks are strongly dependant on details of pore micro-structures, which can be used for quantifying relations between physical properties of rocks through pore-scale simulation techniques. Recently, high-resolution scan techniques, such as X-ray microtomography and high performance computers make it possible to calculate permeability from pore micro-structures of rocks. We try to extend this simulation methodology to velocity and electrical conductivity. However, the smoothing effect during tomographic inversion creates artifacts in pore micro-structures and causes inaccurate property estimation. To mitigate this artifact, we tried to use sharpening filter and neural network classification techniques. Both methods gave noticeable improvement in pore structure imaging and accurate estimation of permeability and electrical conductivity, which implies that our method effectively removes the smoothing effect in pore structures. However, the calculated velocities showed only incremental improvement. By comparison between thin section images and tomogram, we found that our resolution is not high enough, and it is mainly responsible for the inaccuracy in velocity despite the successful removal of the smoothing effect. In conclusion, our methods can be very useful for pore-scale modeling, since it can create accurate pore structure without the smoothing effect. For accurate velocity estimation, the resolution of pore structure should be at least three times higher than that for permeability simulation.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.7
• /
• pp.1559-1562
• /
• 2009

The influence of hot pressing on the pore structures of Nafion membranes was investigated by observing the Nafion before and after hot pressing with $^1H$ nuclear magnetic resonance (NMR) spectroscopy. The freezing point depression and chemical shift data of water in the Nafion indicated the presence of two different pore size ranges in Nafion. Hot pressing mainly reduced the sizes and number of the big pores. The reduction of water uptake and proton conductivity after hot pressing was explained by this variation of pore size and number. We demonstrated the potential application of chemical shift data and NMR cryoporometry experiments to measure the relative pore sizes, on a nano scale, and numbers.

• The Bulletin of The Korean Astronomical Society
• /
• v.40 no.1
• /
• pp.84.3-85
• /
• 2015

We report a small-scale EUV bright loop associated with the evolution of the fine-scale magnetic discontinuity in the photosphere. Our analysis was carried out by using the high spatial resolution data taken with InfraRed Imaging Magnetograph (IRIM) and the Fast Imaging Solar Spectrograph (FISS). As a result, an extremely narrow dark lane of the intense horizontal magnetic field (width ~ 300 km) is detected parallel to the boundary of the magnetic pore, which is one of the footpoints of the small-scale bright coronal loop. We find that the variation of the net linear polarization inside the dark lane is closely related to the intensity variations of the coronal loop. Based on our results, we suggest that small-scale atmospheric heating such as bright coronal loop seen above the complex pore group may be strongly affected by the evolution of the fine-scale magnetic discontinuity in the photosphere. This is a nice example of solar atmospheric heatings associated with the fine-scale magnetic discontinuity in the photosphere.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.3 no.4
• /
• pp.179-189
• /
• 1999

This study attempts to propose an evaluation considering the property of concrete pore which affects the deterioration of neutralization and the rebar resistance of concrete. Understanding pore property of concrete in using extent, for practical using of concrete manufacturing condition. basic quality property and durability estimation etc, the results of the experiment are as follows. 1) The result of analysis pore property of every specimen with the method of area ratio, in limitation of $10^{-6}{\sim}10^{-5}m$, the pore distribution ratio was maximum. It was high value as W/C was increased and the unit cement content was decreased. 2) In case of using admixture. the volume of pores was some increased as variation of mixing content. In high W/C range, it was very increased compared with plain concrete. 3) Concerned with compressive strength and volume of pores in hardened concrete, it is possible compressive strength estimation using the property of concrete pores. 4) Direct measurement of concrete pore property is difficult. the valuation of the dynamic modulus of elasticity using ultrasonic wave velocity was available. 5) Quantitatively evaluation of concrete structure durability by past result of pore distribution estimation, and it can be estimative scale of property study on the concrete materials.

• Journal of Korean Society of Water and Wastewater
• /
• v.22 no.3
• /
• pp.323-328
• /
• 2008

During the full-scale water treatment operation at "G" Water Treatment Plant in Seoul, we investigated changes in pore volume distribution and specific surface area of GAC with time. The pore volume of the used GAC decreased to the level below 0.6 cc/g while that of the brand new GAC was ranged 0.7~0.9 cc/g. The specific surface area of GAC pores changed within the range between $1100{\sim}1200m^2/g$ and $700{\sim}800m^2/g$. Bacteria attached to the surface of GAC shows a gradual increase ($0.4{\time}10^6{\sim}8.5{\time}10^6CFU/g$) under scanninig electron microscope (SEM). TOC removal was enhanced due to growth of the attached bacteria on GAC. It was found that TOC removal was closely related with physical parameters (pore volume, specific surface area) linearly under the investigated conditions. The used GAC need to be exchanged into new one or re-generated to remove organic matters (TOC) effectively from the finished drinking water.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.5
• /
• pp.103-111
• /
• 2012

In this study, the full-scale laboratory model test on utilization of recycled aggregates and crushed stone as vertical drains to use an alternative material of sand in soft ground is performed. The settlement and pore water pressure were measured to evaluate the discharge capacity and filed application, and the results were compared and analyzed through the finite element method. The measured and estimated settlement in all vertical drain materials decreases gradually with the load increase. The measured settlement 6.55~8.63 mm, and the estimated by the Hyperbolic model was 7.45~7.92 mm. So the model used for the analysis can be applied to the settlement estimation of the actual field. The variations of pore water pressure with time showed constantly regardless of the load in all vertical drainage materials. The pore water pressure was similarity to that of sand after rapid drawdown. Therefore, it was applicable to the field because discharge capacity was enough to be an alternative material to the sand which had been being used as the vertical drains.

• Journal of Hydrogen and New Energy
• /
• v.21 no.4
• /
• pp.328-339
• /
• 2010

A new gasification model for coal char was developed considering the effects of pore structure and solid reaction product (ash) and compared with conventional models. Among various parameters reflecting microscopic pore structure, initial pore surface per unit volume of char was found to have the largest effect on carbon conversions. Reaction studies showed that the proposed model can predict carbon conversion more accurately over a broader range of reaction degree compared to the conventional models. Therefore the model proposed in this study would be useful for the design of pilot or commercial scale gasifiers.

• Environmental Engineering Research
• /
• v.17 no.2
• /
• pp.83-88
• /
• 2012

Currently, the technology of $CO_2$ capture and storage (CCS) has become the main issue for climate change and global warming. Among CCS technologies, the prediction of $CO_2$ behavior underground is very critical for $CO_2$ storage design, especially for its safety. Hence, the purpose of this paper is to model and simulate $CO_2$ flow and its heat transfer characteristics in a storage site, for more accurate evaluation of the safety for $CO_2$ storage process. In the present study, as part of the storage design, a micro pore-scale model was developed to mimic real porous structure, and computational fluid dynamics was applied to calculate the $CO_2$ flow and thermal fields in the micro pore-scale porous structure. Three different configurations of 3-dimensional (3D) micro-pore structures were developed, and compared. In particular, the technique of assigning random pore size in 3D porous media was considered. For the computation, physical conditions such as temperature and pressure were set up, equivalent to the underground condition at which the $CO_2$ fluid was injected. From the results, the characteristics of the flow and thermal fields of $CO_2$ were scrutinized, and the influence of the configuration of the micro-pore structure on the flow and scalar transport was investigated.