• Journal of the Korean Solar Energy Society
• /
• v.29 no.5
• /
• pp.35-44
• /
• 2009

In this study, boiling heat transfer coefficients(HTCs) and critical heat flux(CHF) are measured on a smooth square flat copper heater in a pool of pure water with and without carbon nano tubes(CNTs) dispersed at $60^{\circ}C$. Tested aqueous nanofluids are prepared using multi-walled CNTs whose volume concentrations are 0.0001, 0.001, 0.01, and 0.05%. For dispersion of CNTs, polyvinyl pyrrolidone(PVP) is used in distilled water. Pool boiling HTCs are taken from $10kW/m^2$ to critical heat flux for all nanofluids. Test results show that the pool boiling HTCs of the nanofluids are lower than those of pure water in entire nucleate boiling regime. On the other hand, critical heat flux is enhanced greatly showing up to 200% increase at volume concentration of 0.001% CNTs as compared to that of pure water. This is related to the change of surface characteristics by the deposition of CNTs. This deposition makes a thin CNT layer on the surface and the active nucleation sites of heat transfer surface are decreased due to this layer. The thin layer acts as the thermal resistance and also decreases the bubble generation rate resulting in a decrease in pool boiling HTCs. The same layer, however, maintains the nucleate boiling even at very high heat fluxes and reduces the formation of large vapor canopy at near CHF resulting in a significant increase in CHF.

• Journal of the Korean Solar Energy Society
• /
• v.34 no.5
• /
• pp.65-72
• /
• 2014

In this paper, the water-based Ag nanofluids are synthesized by the chemical reduction method and their extinction coefficients are measured by an in-house developed measurement device. The Ag nanofluids are manufactured by the chemical reduction method with the mixing of silver nitrate ($AgNO_3$) and sodium borohydride ($NaBH_4$) in an aqueous solution of polyvinyl pyrrolidone (PVP). The extinction coefficients of Ag nanofluids are measured by means of the in-house developed apparatus at a wavelength of 632.8nm according to the particle volume fractions. The results show that the extinction coefficient of water-based Ag nanofluids increases with the increase of nanoparticle concentrations. Finally, the temperature field and efficiency of direct absorption solar collector (DASC) are analytically estimated based on the measured extinction coefficient of water-based Ag nanofluids. The results indicate that the direct absorption solar collectors using nanofluids have the feasibility to improve the efficiency of conventional flat-plate solar collectors without using an absorber plate.

• Journal of Pharmaceutical Investigation
• /
• v.37 no.6
• /
• pp.349-354
• /
• 2007

For decades, the various virtues of ${\alpha}-lipoic$ acid (ALA), a natural material synthesized in most cells, have been intensively studied and proved. Recently it was reported that ALA caused significant bodyweight reduction via appetite suppression. Unfortunately, the efficacy requires an administration over 50 mg/kg. The low bioavailability and the short plasma half life of ALA lead us to explore novel pharmaceutical dosage forms using nanoparticles. In this study, the effect of polymeric stabilizers on the bioavailability improvement of ALA nanoparticles was investigated. The reduction of particle size via nano-comminution technology was successful resulting in volume average particle sizes of 320 - 340 nm. The in vitro release rate of ALA did not reflect the decrease of particle size, possibly because of the self polymerization of ALA during nano-comminution. The type of polymeric stabilizers could not affect the release rate either. However, the in vivo food intake results of ALA showed that nano-suspensions were more effective than microparticles or a salt form. The nano-suspension containing polyvinyl pyrrolidone as the primary stabilizer and polyacrylic acid as the secondary stabilizer showed more improved efficacy for 2 hours.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.8
• /
• pp.2005-2014
• /
• 2009

There are several methods to fabricate Polymer Dispersed Liquid Crystal(PDLC) films. One of them, so-called Nematic Curvilinear Aligned Phase(NCAP) film, is based on emulsion technology. To produce NCAP systems various water soluble polymers, such as partially hydrolyzed polyvinylalcohol(PVA) and polyvinyl pyrrolidone(PVP), which can form stable emulsion of liquid crystal(LC) without any stabilizers were used. In this work, we studied the dependence of emulsion stability on nature and composition of copolymers composed of water-soluble and water-insoluble moiety. We found that interfacial surface tension depends on the composition of comonomer, the copolymer concentration in the water, and the nature of hydrophobic chain. The Acrylamide -styrene(AA-ST) copolymer showed the lowest interfacial surface tension among the tested copolymers at the same concentration. Since the interfacial surface tension decreases with increasing the compatibility of copolymer with LC phase the AA-ST copolymer has the best compatibility with LC molecules. It is believed that molecules adsorbing easily on the surface of LC droplets allows the LC emulsion system to be more stable.

• Asian-Australasian Journal of Animal Sciences
• /
• v.20 no.9
• /
• pp.1462-1467
• /
• 2007

This study investigated the effect of chemical treatments on tannins (condensed and hydrolysable) and on the trypsin inhibitor (TI) activity in salseed meal. Triplicate samples of ground salseed meal (1 kg) were mixed with 820 ml of either distilled water (pH 5.3), 0.67 M acetic acid (pH 2.4), 0.67 M sodium bicarbonate (pH 8.2) or 2% polyvinyl-pyrrolidone (PVP) solution. The material was placed in airtight plastic containers and incubated at $37^{\circ}C$ for 0, 3, 6, 12, 24, 48 and 72 h. Samples of untreated salseed meal which had not been subjected to soaking or incubation were run through the analysis to serve as control. Addition of water, acetic acid, sodium bicarbonate and PVP solutions to salseed meal and subsequent anaerobic incubation at $37^{\circ}C$ significantly reduced chemically detectable tannins. At each incubation time, alkali solution was more effective than its counterparts. The effect of acidic solution on hydrolysable tannin was least among the treatments. All the treatments reduced TI activity of salseed meal. The reduction in TI activity by these treatments was similar and ranged between 80-84%. Treatment time effected a decrease in the contents of antinutritional substances. However, the effect of the treatment with the reagents, even for zero incubation time, was quite pronounced. It may be concluded from the present results that the treatment of salseed meal with sodium bicarbonate (0.67 M) is more effective in reducing hydrolysable and condensed tannin contents than PVP, water and acid solutions. Treatment with sodium bicarbonate solution is more economical and easier to handle than acid and PVP treatments. Incubation of the treated material for 12 h is reasonably effective, economical and safe from any mould growth.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.41 no.3
• /
• pp.274-285
• /
• 1996

These experiments were conducted to evaluate the effects of seed coating with ten environmentally acceptable polymers, on germination percentage, water uptake, respiration, emergence and seedling growth characteristics. The water absorption of polymer-coated seeds in saturation condition was highest in klucel and lowest in polyvinyl pyrrolidone(PVP), and that in water was highest in klucel and lowest in maltrin. Respiration rates of polymer-coated seeds in Hwayoungbyeo and Ilpumbyeo were lower than those of none-coated seeds, and those in Daecheongbyeo and Jinmibyeo were higher than that of none-coated seeds, and those of sepiret coated seeds were higher than PVP coated seeds. The germination polimer-coated seed was reduced by one percentage by coating with seed coating machine. Germination percentage was not affected by any of polymer coating in high quality seed, but there were significant effects in low quality seed coating with waterlock, surelease 46 and sepiret significantly reduced germination some cultivars. Germination percentage after accelated ageing treatment were slightly higher most of polymer-coated seeds than in none-coated seeds, but those of sepiret-and klucel-coated seeds were lower significantly. Germination percentage of seeds coated with daran 8600, rnaltrin, sacrust and opadry were enhanced slightly under cold test other polimers reduced germination. The seedling height of polymer-coated seeds were longer than those of none-coated seeds, but those of waterlock, PVP and maltrin coating seeds were shorter, seedling hight was shortened by polimer coating under cold test. Polymer-coated seeds showed higher emergence percentage, shorter emergence time in field condition. The highest emergence percentage and the shortest emergence time was shown at 90% soil moisture content.

• Analytical Science and Technology
• /
• v.28 no.1
• /
• pp.33-39
• /
• 2015

CdS-QD particles are a nano-sized semiconducting crystal that emits light. Their optical properties show great potential in many areas of applications such as disease-diagnostic reagents, optical technologies, media industries and solar cells. The wavelength of emitting light depends on the particle size and thus the quality control of CdS-QD particle requires accurate determination of the size distribution. In this study, CdS-QD particles were synthesized by a simple ${\gamma}$-ray irradiation method. As a particle stabilizer polyvinyl pyrrolidone (PVP) were added. In order to determine the size and size distribution of the CdS-QD particles, sedimentation field-flow fractionation (SdFFF) was employed. Effects of carious parameters including the the flow rate, external field strength, and field programming conditions were investigated to optimize SdFFF for analysis of CdS-QD particles. The Transmission electron microscopy (TEM) analysis show the primary single particle size was ~4 nm, TEM images indicate that the primarty particles were aggregated to form secondary particles having the mean size of about 159 nm. As the concentration of the stabilizer increases, the particle size tends to decrease. Mean size determined by SdFFF, TEM, and dynamic light scattering (DLS) were 126, 159, and 152 nm, respectively. Results showed SdFFF may become a useful tool for determination of the size and its distribution of various types of inorganic particles.