• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.8 no.2
• /
• pp.198-207
• /
• 1996

It is well known that drag reduction in single phase liquid flow is affected by polymer material, molecular weight, polymer concentration, pipe diameter, and flow velocity. Drag reduction in two phase flow can be applied to the transport of crude oil, phase change system such as chemical reactor, pool and boiling flow, and to present cavitation which occurs in pump impellers. But the research of drag reduction in two phase flow is not sufficient. The purpose of the present work is to evaluate the drag reduction by measuring pressure drop, void fraction, mean liquid velocity, and turbulent intensity whether polymer is added in the horizontal two phase system or not. Experiment has been conducted in a test section with the inner diameter of 24mm and the length of 1,500mm. The polymer materials used are two kinds of polyacrylamide[PAAM] and co-polymer[A611P]. The polymer concentration was varied with 50, 100 and 200 ppm under the same experimental conditions. Experimental results showed that the drag reduction of co-polymer is higher than that of polyacrylamide. Mean liquid velocities increased as polymer was added, and turbulent intensity decreased inversely near the pipe wall.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.22 no.6
• /
• pp.398-403
• /
• 2010

The drag reduction(DR) of non-ionic surfactant and polymer according to the variation of fluid velocity, temperature and surfactant concentration was investigated experimentally. For this experiment, the kind of surfactant was non ionic amine-oxide and the kinds of polymer were polyacrylamide and xantan gum. An experimental apparatus equipped with one water storage tanks was built and two flow meters, two pressure gauges for data logging system was installed. Results showed that the kinds of polymer, polyacrylamide and xantan gum, had DR of below 20% for below 500 ppm in fluid temperature of $50{\sim}80^{\circ}C$. But the kind of surfactant, amine oxide, had DR of above 40% for 500~1000 ppm in fluid temperature of $50{\sim}80^{\circ}C$. As a result, amin oxide showed better materials to use to the district heating system.

• Korean Journal of Microbiology
• /
• v.23 no.1
• /
• pp.13-19
• /
• 1985

Acc I endonuclease has been isolated from 300g (wet weight) cells of Acinetobacter calcoaceticus. The cells were broken by using French press at 20, 000p.s.i. After ammonium sulfate fractionation, the enzyme was further purified by heparin agarose, DEAE-sephades, Affi.-gel Blue, phosphocellulose, and hydroxylapatite column chromatography. The purified Acc I endonudlease has a single polypeptide species and its subunit molecular weight was 45,000 ${\pm}$ 1,000 daltons as judged by 10% SDS-polyacrylamide gel electrophoresis. The isolated enzyme was essentially free of contaminating nucleases as judged by homochromatography by using a $^{32}P-labeled$ oligonucleotide. The enzyme showed maximum activity at pH values between 8.0 and 11.0 and in the presence of $MgCl_2$. Acc I endonuclease was maximally active in the absence of NaCl and was completely inhibited at 200 mM NaCl.

• Journal of Environmental Health Sciences
• /
• v.17 no.1
• /
• pp.120-128
• /
• 1991

Saccharomyces cerevisiae was immobilized by incubating iron oxides with calcium alginate, and by polyacrylamide entrapment to use repeatedly for the conversion of glucose to ethanol. Magnetic and non-magnetic immobilized yeast and polyacrylamide immobilized yeast were compared with the native yeast a batch-fermentation of ethanol from glucose. Three kinds of immobilized yeast tended almost identically, having ethanol productivity as well as the final yield about the same to what was found for the native yeast. The long-term operational stability of three kinds of immobilized yeast were significant difference according as immobilized yeast activation or non-activation before ethanol fermentation. In the non-activation they lost their activity of fermentation rapidly in the beginning stage an slower at a later stage. On the other hand, in the activation with nutrient media, their activities were increased to some extent and stable in the later stage. The cell count of three kinds of immobilized yeast after activiation by incubating nutrient media, increased by a factor of about 45 to 48, whereas the fermenting capacity increased by a factor of 174 to 178. In the prearation of immobilized biocatalysts, magnetic matter does not seem to have any adverse affect on the properties of the microorganism. The immobilized biocatalysts by utilizing magnetic matter have some advantages, especially in application of viscous media or insoluble particle-containing media, for this work was linked with microbial utilization of environmental wastes and elimination of envirnmental pollutant.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.3 no.2
• /
• pp.29-36
• /
• 1979

In order to control free formaldehyde release from fabric finished with urea-formaldehyde precondensate, the resin finished fabric was padded in urea or acylamide solution, dried and cured at $140^{\circ}C$. The effect of aftertreatment with urea or acrylamide on free formaldehyde release and on characteristics of resin finished fabric were examined. It was shown that aftertreatment with urea was effective to control free formaldehyde release, the free formaldelyde content in aftertreated fabric could be reduced from 900 ppm to 200 ppm and formaldehyde release under accelerated storage condition was also reduced from 8000 ppm to 1000 ppm. Polyacrylamide formed in the fiber during aftertreatment appeared to be a formaldehyde capture. Especially by washing the aftertreated fabric, the ability to control formaldehyde release under accelerated condition was not dimimished in contrast with aftertreated with unea. It suggests that polyacrylamide can be used as a formaldehyde capture which withstand diminution from washing.

• Geomechanics and Engineering
• /
• v.22 no.4
• /
• pp.329-337
• /
• 2020

Polyacrylamide (PAM) possesses high water absorption capacity and a unique pH-dependent behavior that confer large potential to enhance the engineering performance of clays. In this study, calcium bentonite was treated with a nonionic PAM. Flexible-wall permeability test and the consolidation test were performed at different pH values to evaluate the effects of PAM treatment on the hydraulic and consolidation properties. Test results demonstrate that index properties are affected by the adsorbed PAM on clay surface: a decrease in specific gravity, a decrease in net zeta potential, and an increase in liquid limit are observed due to the PAM treatment. At a given pH, the compressibility of the treated clay is greater than that of the untreated clay. However, the compression indices of untreated and treated clays can be expressed as a single function of the initial void ratio, regardless of pH. Hydraulic conductivity is reduced by PAM treatment about 5 times at both neutral and alkaline pH conditions under similar void ratios, because of the reduction in size of the water flow channel by PAM expansion. However, at acidic pH, the hydraulic conductivity of the treated clay is slightly higher than the untreated clay. This reflects that the treated bentonite with PAM can be beneficially used in barrier system for highly alkaline residues.

• Journal of Microbiology and Biotechnology
• /
• v.1 no.2
• /
• pp.102-110
• /
• 1991

Alkalophilic Bacillus sp. YJ-451, which was isolated from soil at several area in Korea, produced a novel type of bacteriolytic enzyme (cell wall peptidoglycan hydrolase) extracellulary. The cell wall hydrolytic activity was identified as a clear zone on sodium dodecyl sulfate polyacrylamide gel electrophoresis containing 0.2% (w/v) cell wall of Bacillus sp. as substrate. This enzyme was successively purified 66 fold with 3.2% yield in culture broth by ammonium sulfate precipitation, CM-cellulose column chromatography, and gel filtration, followed by hydroxylapatite column chromatography. The molecular weight of the purified enzyme was estimated to be 27,000 by sodium dodecyl sulfate polyacrylamide gel electrophoresis and gel filtration column chromatography. The optimum pH and temperature for the activity of the enzyme were pH 10.0 and $50^{\circ}C$, respectively. The enzyme was stable between pH 5.0 and 10.0 and up to $40^{\circ}C$. Among the microorganisms used in this experiment the enzyme was active against most of gram negative strains and the genus Bacillus such as B. megaterium, B. licheniformis, B. circulans, B. pumilus, B. macerans, B. polymyxa. The release of dinitrophenylglutamic acid but not reducing group from cell wall peptidoglycan digested by the enzyme suggested that the enzyme is a kind of peptidase which hydrolyzes the peptide bond at the amino group of D-glutamic acid in the peptidoglycan.

• Microbiology and Biotechnology Letters
• /
• v.15 no.6
• /
• pp.425-429
• /
• 1987

The extra-cellular hemolysin from Bacillus thuringiensis subsp. israelensis was purified in the process of suiting with (NH$_4$)$_2$SO$_4$, Sephadex G-200 gel filtration, and DEAE-cellulose column chromatography. The purified hemolysin had molecular weight of approximately 47,000 dalton on SDS-polyacrylamide gel electrophoresis. The activity of purified hemolysin on human red blood cells was increased by thiol agents, but that was Inhibited by cholesterol, protease treatment, and metal salts such as CuSO$_4$, and FeSO$_4$, respectively.

• Genomics & Informatics
• /
• v.9 no.4
• /
• pp.197-199
• /
• 2011

The biological interpretation of two-dimensional (2D) gel electrophoresis experiments is a key step toward understanding the functions of biological systems. We here present a web-based integrated database, called 2DSpotDB, for the management of proteome data derived from several pathogens. The 2DSpotDB was established as a part of the management of a pathogen proteome project at the Korea National Institute of Health. The goals of the 2DSpotDB implementation are to store and define important pathogen genes, retrieve information obtained by 2D polyacrylamide gel electrophoresis and mass spectrometry, and create an integrated system to provide pathogen proteome information for biological scientists. This database currently contains 14 gels and information on 387 protein spots, among which 329 proteins were identified and annotated.

• The Korean Journal of Zoology
• /
• v.24 no.1
• /
• pp.27-37
• /
• 1981

Protein patterns at various stages of pre-and post-fertilization in Drosophila melanogaster were analyzed using polyacrylamide gel electrophoresis. Ovaries at various times after hatching, embryos, larvae and pupae were collected and used for protein analysis. The protein patterns were found to vary qualitatively and quantitatively during oogenesis as well as during embryogenesis and metamorphosis. Yolk proteins, which were found to be synthesized in fat body and transferred into the oocytes, appeared in three bands in the gel in the early stages, but these proteins seemded to be converged into a single band in the late stage of oogenesis. The protein patterns in the post fertilization stages seemed to be abruptly changed at two different stages; between embryonic and larval stages and between the second and third instar stages. The pattern in the pupal stages was not very much different from that of the third instar.