• Journal of Power Electronics
• /
• 제18권1호
• /
• pp.70-80
• /
• 2018

A novel strategy based on a zero common mode voltage pulse-width modulation (ZCMV-PWM) technique and zero-sequence circulating current (ZSCC) feedback control is proposed in this study to eliminate ZSCCs between three-level neutral point clamped (NPC) voltage source inverters, with common AC and DC buses, that are operating in parallel. First, an equivalent model of ZSCC in a three-phase three-level NPC inverter paralleled system is developed. Second, on the basis of the analysis of the excitation source of ZSCCs, i.e., the difference in common mode voltages (CMVs) between paralleled inverters, the ZCMV-PWM method is presented to reduce CMVs, and a simple electric circuit is adopted to control ZSCCs and neutral point potential. Finally, simulation and experiment are conducted to illustrate effectiveness of the proposed strategy. Results show that ZSCCs between paralleled inverters can be eliminated effectively under steady and dynamic states. Moreover, the proposed strategy exhibits the advantage of not requiring carrier synchronization. It can be utilized in inverters with different types of filter.

• 한국수자원학회논문집
• /
• 제51권7호
• /
• pp.585-597
• /
• 2018

본 연구는 미래기후변화에 따른 청미천 유역의 향후 수질 변화를 검토하고, 최적관리기법으로의 접근을 이용한 비점오염물질 저감 대책의 유효성을 살펴보는 것을 목적으로 수행되었다. 기후변화에 따른 미래 수문 및 수질변수의 변화를 살펴보기 위하여 Soil and Water Assessment Tool(SWAT) 모형을 이용하였으며, SWAT 모형의 매개변수는 SWAT-CUP을 이용하여 보정하였다. 구축된 Representative Concentration Pathway(RCP) 시나리오 중 RCP 4.5 및 8.5 두 개 시나리오를 이용하여 미래 기후를 고려하였다. 모의 결과로부터 기후 변화가 심화될수록 강우 및 비점오염물질의 유출이 증가하는 것으로 예측되었다. 또한 적절한 최적관리기법을 통해 비점오염물질의 총량뿐만 아니라 시간에 따른 변동성도 함께 효과적으로 저감될 수 있는 것으로 판단된다.

• 한국물환경학회지
• /
• 제27권6호
• /
• pp.905-913
• /
• 2011

This study was conducted to characterize the discharge feature of pollutant load from the upper and lower watershed influencing on the water quality of South Han River using the empirical equation and Factor Analysis. The results of regression analysis between flow rate and pollutant load were as follows. In the streams of the upper watershed of South Han river, $BOD_5$ and $COD_{Mn}$ were increased as the flow rate was increased. Also, steep increases in SS and TP were observed with positive correlation with the flow rate while change in TN was slightly shown. On the other hand, in the streams of the lower watershed of South Han river, $BOD_5$ was negatively correlated with the flow rate, being decreased with the increase in the flow rate. However, changes in $COD_{Mn}$, TN, SS, and TP showed a similar trend with those observed in the upper watershed. With Factor Analysis of the water quality and various components, it was appeared that the flow rate, SS, and TP were significantly correlated each other and they were indicated as the principal component influencing on water quality in the streams of the upper watershed. In contrast, $BOD_5$, $COD_{Mn}$ and TOC were significantly correlated each other and they were included as the principal pollution component of the streams in the lower watershed. From these results, it was conclusive that the upper watershed of South Han River was mainly affected by non point source pollutants while the lower watershed was influenced by point source pollutants from the developed areas.

• Journal of applied mathematics & informatics
• /
• 제16권1_2호
• /
• pp.585-593
• /
• 2004

In this paper we shall discuss the minimal, maximal and primary subautomata. Also the concepts of the totally reachable state and source will be introduced. It is an interesting part that mX＊ is minimal iff the source S(m) is maximal. We shall point out that the characterization of primary subautomaton comes from the properties associated with the sources S(m)'s.

• 한국가스학회지
• /
• 제26권6호
• /
• pp.45-51
• /
• 2022

고정된 점배출원(Point source)에서 배출되는 오염물질을 포집하여 처리하는 기술은 꾸준히 개발되고 있으나, 비산배출원(Non-point source)의 경우 배출원이 다양하고, 일정하지 않아 배출물질 처리기술 및 실효성 있는 배출계수 등을 개발하는 것은 어려운 실정이다. 그렇지만, 비산배출원은 국내 배출량의 약 60%를 차지하고 있기 때문에 배출량 산정방법이 타당하여야 하며 이를 토대로 사업장은 배출저감기술 등을 개발하여야 한다. 이에, 본 연구에서는 배출량이 많은 석유화학업종을 대상으로 현재 사용되고 있는 배출계수의 실효성과 개선 방안 등을 제시하고자 한다. 이를 위하여, 전남 여수 소재 OO회사의 최근 5년간의 LDAR(Leak Detection And Repair)데이터를 분석하여 비산배출원의 배출특성 확인하였다. 그 결과, 유체 성상에 따른 배출 특성의 차이는 없으나 장치의 크기, 제조사별 특성의 차이가 있음을 확인할 수 있었다. 또한, 석유화학 업종에서 적용하는 자체 배출계수가 정유업종에 비해 크게 나타나는 것을 확인하였으며 이에 대한 개선방안 등을 제시하였다. 이러한 연구를 통하여 석유화학업종에 특화된 배출계수를 적용할 수 있으며 사업장 스스로 이를 획기적으로 감할 수 있는 기술을 개발하는데 기여할 것으로 기대한다.

• Journal of Power Electronics
• /
• 제18권5호
• /
• pp.1479-1488
• /
• 2018

Power packet (PP) distribution system distributes power to different loads that share the same distribution cable in a packetized form. When compared with conventional power systems, a PP distribution system (PPDS) can reduce standby power, eliminate Point-of-Load (PoL) power conversion, and intelligently control the load demand from the source side. Due to the absence of PoL conversion, when multiple power sources at different voltage levels and conditioning requirements jointly send power to various loads at different voltage ratings, the generated voltage has an irregular shape. A large filter at each of the load sides is required to reduce such a large voltage ripple. In this paper, a single-inductor, multiple-input-single-output converter structure based multiple-energy-source mixer is proposed. It combines PP generation, maximum power point tracking (MPPT) of renewable energy sources (RESs) and filtering at the source side. To demonstrate the possible renewable energy integration, a PV panel is used as a power source together with other constant voltage sources. The PV power is approximately tracked using the constant voltage method and it is used for each of the PP generations. The proposed PP distribution system is experimentally verified and it is shown that a conventional PI controller is sufficient for stable system operation.

• 한국음향학회지
• /
• 제26권8호
• /
• pp.415-425
• /
• 2007

본 논문에서는 간섭 패턴 정합을 이용한 수중 광대역 음원의 위치 추정법을 제안한다. 두 개의 센서 스펙트로그램에 나타나는 간섭 패턴의 정합을 통해 음원과 두 센서간의 상대적인 거리비를 추정하고 이를 아폴로니오스 원의 방정식에 적용하였다. 아폴로니오스의 원은 두 정점에 이르는 거리비가 일정한 값으로 운동하는 점의 자취로 정의되며, 음원의 위치로 추정 가능한 궤적을 나타낼 수 있다. 그러나 아폴로니오스의 원 하나만으로는 정확한 음원의 위치추정이 어렵다. 그러므로 또 하나의 위치 궤적을 추정 할 수 있는 방정식이 필요하다. 따라서 음원과 두 센서간의 신호도달 시간차이를 이용한 쌍곡선의 방정식을 도입하여 최종적인 음원의 위치는 두 방정식의 교점의 좌표로 추정하였다. 제안된 방법의 성능 평가를 위하여 모의실험을 통해 위치 추정 오차율을 분석하고, 해상실험을 통하여 실제 적용 가능성을 분석하였다. 모의실험 및 해상실험 결과 본 논문에서 제안된 위치 추정 알고리즘이 오차율 10% 이내의 성능을 나타내었다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1997년도 춘계학술대회논문집; 경주코오롱호텔; 22-23 May 1997
• /
• pp.539-544
• /
• 1997

Although the identification of a moving noise source is important in reducing the source power of the transport systems such as airplane or high speed train, the direct measurement of the frequency characteristics is usually difficult due to wind noise when using a microphone running with that noise source. On the other hand the motion of a source causes the frequency characteristics of the pass-by sound measured at a fixed point to be distorted that it is quite difficult to identify the original source characteristics. In this study the relationship between the spectra of the source and the pass-by sound signal is analyzed for a source moving at a constant velocity. The effects of the speed and the frequency characteristics of the source on the pass-by noise spectrum are investigated through numerical simulations.

• Journal of Mechanical Science and Technology
• /
• 제18권9호
• /
• pp.1680-1688
• /
• 2004

The information indicating device plays an important part in the information times. Recently, the classical CRT (Cathod Ray Tube) display is getting transferred to the LCD (Liquid Crystal Display) one which is a kind of the FPDs (Flat Panel Displays). The OLED (Organic Light Emitting Diodes) display of the FPDs has many advantages for the low power consumption, the luminescence in itself, the light weight, the thin thickness, the wide view angle, the fast response and so on as compared with the LCD one. The OLED has lately attracted considerable attention as the next generation device for the information indicators. And also it has already been applied for the outside panel of a mobile phone, and its demand will be gradually increased in the various fields. It is manufactured by the vapor deposition method in the vacuum state, and the uniformity of thin film on the substrate depends on the temperature distribution in the point-cell source. This paper describes the basic concepts that are obtained to design the point-cell source using the computational temperature analysis. The grids are generated using the module of AUTOHEXA in the ICEM CFD program and the temperature distributions are numerically obtained using the STAR-CD program. The temperature profiles are calculated for four cases, i.e., the charge rate for the source in the crucible, the ratio of diameter to height of the crucible, the ratio of interval to height of the heating bands, and the geometry modification for the basic crucible. As a result, the blowout phenomenon can be shown when the charge rate for the source increases. The temperature variation in the radial direction is decreased as the ratio of diameter to height is decreased and it is suggested that the thin film thickness can be uniformed. In case of using one heating band, the blowout can be shown as the higher temperature distribution in the center part of the source, and the clogging can appear in the top end of the crucible in the lower temperature. The phenomena of both the blowout and the clogging in the modified crucible with the nozzle-diffuser can be prevented because the temperature in the upper part of the crucible is higher than that of other parts and the temperature variation in the radial direction becomes small.

• 한국물환경학회지
• /
• 제26권5호
• /
• pp.860-870
• /
• 2010

Long term monthly monitoring data showed that the water quality of streams flowing into Lake Paldang has been improved by various strategy for water. However, the effect of quality on Lake Paldang is still insufficient because of nonpoint source from watershed. In order to evaluate quantifying methods for pollution source and make a suggestion on improvements, Storm Water Management Model (SWMM) was constructed by using data set from the water quality and streamflow monitoring network in the Kyoungan watershed for Total Maximum Daily Loads (TMDLs). Load duration curve (LDC) based on the result of the Kyoungan watershed SWMM indicated that the water quality criterion on $BOD_5$ was often exceeded in up-stream than down-stream. From flowrate-load correlation curve, SS load significantly increased as streamflow increases. 75.3% of streamflow and 62.1% of $BOD_5$ loads is discharged especially in the zone of high flows, but monitoring data set didn't provide proper information about the conditions and the patterns associated with storm events. Therefore, it is necessary to acquire representative data set for comparing hydrograph and pollutograph through monitoring experimental watershed and to establish methods for quantifying point and nonpoint source pollutant loads.