• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37B no.11
• /
• pp.1072-1081
• /
• 2012

For Ka-band satellite communication system, a new flexible payload technologies which can compensate rain attenuation have to be developed. The Ka-band satellite output power control technology enables to adjust downlink output power of satellite payload in Ka-band (19.8 ~ 22.2 GHz). In this paper, we introduce multi-beam antenna with multi-port amplifiers for Ka-band flexible output power allocation system. We have designed multi-beam antenna with array-fed reflector to form 8 beams on the Korean Peninsula. The target EIRP per beam is more than 59 dBW. The system is designed to present 6 dB boost beams for rainfall areas. Individual beams were optimized by the excited amplitude and phase of feed elements of the feed cluster. The multi-port amplifier(MPA) is one of effective approaches for flexible power allocation in combination with multi-beam antenna. In case of using MPA in multi-beam system, the inter-port isolation characteristic of MPA is important parameter to avoid interference among the output ports. In this paper, we propose a new MPA structure that consists of two $4{\times}4$ Buttler matrixes and phase/amplitude controllable power amplifier modules.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.12
• /
• pp.2417-2424
• /
• 2016

Small size and light weight is very important for components used in radar mounted platform such as airborne radar. Recently, the active phased array radar is developed as an array of antennas for thousands of transmit/receive modules to be used as a multi-function radar that can detect and track targets. In this case, the size and weight of the transmit/receive modules are critical factor for developing the radar. In this paper, we developed a compact transmit/receive module using the 10W RF MEMS switch domestically localizing and reduced the circuit area to about 86.5% compared to using a circulator. The developed module satisfies not only electrical requirements but also MIL-STD's environmental specifications. So it can be used in a military device. It can be used at adaptive tunable receivers, reconfigurable smart active antennas and wide band beam electrical steering antennas.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.12
• /
• pp.976-985
• /
• 2018

Modern radars such as the phase array radar can handle various tasks by generating a beam from a phased array antenna. Radar can be used for miscellaneous applications such as surveillance, tracking, missile guidance etc. Previous radar systems could handle only one task at a time. As such, multiple radars were required to perform simultaneous tasks. Multi-function radars can perform many tasks using only one radar system. However, the radar's resources are limited in this instance. To efficiently utilize time, it is necessary to properly schedule tasks in the radar's timeline. In this report, we investigate the efficiency of different scheduling tasks.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.12
• /
• pp.1181-1189
• /
• 2013

In this paper, a retrodirective anatenna array system is proposed and the possibility of actively cancelling electromagnetic waves based on this system is investigated. When a rectrodirective array system receives an electromagnetic wave, it can send waves in the direction of the incoming signal without prior knowledge of the direction. In applications to cancellation of radar signals, the system can generate and send signals to the radar so that it cancels the radar signals that are reflected back to the radar. In such a system, isolation between the input and output ports is a key factor that determines the effectiveness of cancellation. In this work, a dual-conversion mixer system is proposed to maximize the isolation. Since this minimizes the difference between the direction of reflection of radar signals and the transmission of cancellation signals, the effectiveness of cancellation is maximized. Experimental results for a metallic plate and metallic cylinder shows as much as 29-dB reduction in reflection for a $2{\times}2$ retrodirective array based on proposed dual-conversion mixer system, which verifies the proposed method of active cancellation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.5
• /
• pp.694-702
• /
• 2022

This paper shows a small and low-powered wireless communication system based on the ATSC broadcasting system using the ISM frequency band that can be used as a PBS(Personal Broadcasting System). It is designed to demonstrate a channel-adaptive CR(Cognitive Radio) system to provide a better service quality in the unlicensed band where co-channel interference exists. And it achieved very reliable communications by a closed-loop active phased array antenna. This ATSC-based personal broadcasting platform can be modified easily with given flexibility by using GNU Radio as an open-source signal processing platform based on USRP and implementing additional functions in FPGA. In addition, the chosen communication frequency resource can be managed and controlled by the return channel that transmits the channel status and communication parameters between transmission and reception in real-time.

• Journal of electromagnetic engineering and science
• /
• v.12 no.4
• /
• pp.234-239
• /
• 2012

This paper presents a compact K-band Doppler radar sensor for human vital signal detection that uses a radar configuration with only single coupler. The proposed radar front-end configuration can reduce the chip size and the additional RF power loss. The radar front-end IC is composed of a Lange coupler, VCO, and single balanced mixer. The oscillation frequency of the VCO is from 27.3 to 27.8 GHz. The phase noise of the VCO is -91.2 dBc/Hz at a 1 MHz offset frequency, and the output power is -4.8 dBm. The conversion gain of the mixer is about 11 dB. The chip size is $0.89{\times}1.47mm^2$. The compact Ka-band Doppler radar system was developed in order to demonstrate remote human vital signal detection. The radar system consists of a Ka-band Doppler radar module with a $2{\times}2$ patch array antenna, baseband signal conditioning block, DAQ system, and signal processing program. The front-end module size is $2.5{\times}2.5cm^2$. The proposed radar sensor can properly capture a human heartbeat and respiration rate at the distance of 50 cm.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.11
• /
• pp.550-554
• /
• 2001

$(Ba_{0.6}Sr_{0.4}Ca_x)TiO_3 + yAl_2O_3$ wt% (x=0.10, 0.15, 0.20, y=0~3.0) ceramics were fabricated by the mixed-oxide method, and their structural and dielectric properties were investigated with variation of composition ratio and $Al_2O_3$ doping content. As results of the X-ray diffraction and microstructure analysis, all BSCT specimens showed dense and homogeneous structure without presence of the second phase. The sintered density was decreased with an increase of $Al_2O_3$ doping content. The Curie temperature and relative dielectric constant at room temperature were decreased with increasing $Al_2O_3$doping content. The dielectric loss is minimum at BSCT doped with 1.5wt% $Al_2O_3$content. The tunability was decreased with increasing an Ca content and the BSCT(50/40/10) specimen doped with 2.0wt% $Al_2O_3$content showed the maximum value of 4.2%.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.21 no.6
• /
• pp.241-249
• /
• 2022

This paper discusses the design of a ground clutter prevention fence for a radar wind profiler (RWP). The design point of the clutter fence is to improve the quality of the received signal by removing the non-weather clutter coming from the side. In this paper, a clutter prevention fence composed of a metallash mesh around the RWP is proposed, and the phase center of the antenna, the length, and height of the down fence, and the height and slop of the top fence through M&S are designed. The designed ground clutter prevention fence and 256 active phase array antennas were used as basic data. The effectiveness of the design was confirmed by a simulation. The side lobe in the ±90° direction was reduced by more than 30dB depending on the presence or absence of the designed ground clutter prevention fence. The fence was manufactured by 3D modeling, and the clutter shielding performance of approximately 20dB or more on the side of the antenna (±90°) was confirmed by applying it to the currently operated RWP.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.2
• /
• pp.160-168
• /
• 2019

In this study, we propose a verification method for a planar-phased array radar system using a near-field beam focusing(NFBF) test method. We then confirmed the validity of the results. The proposed method can be used to verify a radar system in the near-field range of twice the antenna aperture size, and this is done in the same manner as the field system performance test conducted in a non-outdoor electromagnetic anechoic chamber. The test configuration and procedure for verifying the NFBF using near-field energies were reviewed. In addition, the phase compensation values of additional individual channels were quantified through mathematical verification of the beam-steered NFBF test. Based on a theoretical verification, the actual NFBF test was performed and the validity of the test method was confirmed through comparison with ideal analytical results.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.8
• /
• pp.392-398
• /
• 2006

The properties of tunable dielectric materials on RF frequency band are important high tunability and low loss for RF variable devices, variable capacitor, phased array antenna and other components application. Various composite of BST(barium strontium titanate) ratio combined with other non-electrical active oxide ceramics have been formulated for such uses. We present the tunable properties and Curie temperature on BST thick films. The grain growth of the weight ratio of $BaTiO_3$ increased. This can be explained by the substitute $Sr^{2+}$ ion for $Ba^{2+}$ ion in the $BaTiO_3$ system. The Curie temperature was shifted to lower temperature with increasing $SrTiO_3$in the $BaTiO_3-SrTiO_3$ system, because of decreasing the lattice constant. Also, the dielectric constant, tunability and K-factor of $(Ba_xSr_{1-x})TiO_3$ at over the Curie temperature decreased, at over the $60^{\circ}C$ fixation, maximum dielectric constant at Curie temperature and hence sharper phase transformation occurred at Curie temperature. The result were interpreted as a process of internal stress relaxation resulting form the increase of $90^{\circ}$ domains induced the BST. As a result, It is concluded that over the Curie temperature, frequency response and DC field effect for the tunable properties of BST thick film are suppressed by the transition broadening. For the application of tunable devices, that the curie temperature was investigated to be increased.