• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.1
• /
• pp.97-110
• /
• 2019

Recently, the 4th Industrial Revolution has been emerged and various products are developed and commercialized in preparation of the communication failure. Many solutions are underway in Back-Up Network for IDC Servers, but not in the personal or sensor for low-power system use. Therefore we used the OpenWRT Firmware in Raspberry Pi which can be easily obtained in online market, and it created a low-power load balancer. Therefore, we developed the device that uses LTE Antenna based on USB Interface for communication fault notification and important data. The equipment used in this paper is easy to buy in online shop for anyone. Also, it can be applied in other vendors' boards by using USB. We hope that this paper will contribute to the stability of individual sensor networks.

• The korean journal of orthodontics
• /
• v.51 no.2
• /
• pp.77-85
• /
• 2021

Objective: To evaluate the accuracy of a multi-stage convolutional neural network (CNN) model-based automated identification system for posteroanterior (PA) cephalometric landmarks. Methods: The multi-stage CNN model was implemented with a personal computer. A total of 430 PA-cephalograms synthesized from cone-beam computed tomography scans (CBCT-PA) were selected as samples. Twenty-three landmarks used for Tweemac analysis were manually identified on all CBCT-PA images by a single examiner. Intra-examiner reproducibility was confirmed by repeating the identification on 85 randomly selected images, which were subsequently set as test data, with a two-week interval before training. For initial learning stage of the multi-stage CNN model, the data from 345 of 430 CBCT-PA images were used, after which the multi-stage CNN model was tested with previous 85 images. The first manual identification on these 85 images was set as a truth ground. The mean radial error (MRE) and successful detection rate (SDR) were calculated to evaluate the errors in manual identification and artificial intelligence (AI) prediction. Results: The AI showed an average MRE of 2.23 ± 2.02 mm with an SDR of 60.88% for errors of 2 mm or lower. However, in a comparison of the repetitive task, the AI predicted landmarks at the same position, while the MRE for the repeated manual identification was 1.31 ± 0.94 mm. Conclusions: Automated identification for CBCT-synthesized PA cephalometric landmarks did not sufficiently achieve the clinically favorable error range of less than 2 mm. However, AI landmark identification on PA cephalograms showed better consistency than manual identification.

• Smart Media Journal
• /
• v.10 no.4
• /
• pp.71-79
• /
• 2021

One of the social aspects that changes as the use of the Internet becomes widespread is communication in online space. In the past, only one-on-one conversations were possible remotely, except when they were physically in the same space, but nowadays, technology has been developed to enable communication with a large number of people remotely through bulletin boards, communities, and social network services. Due to the development of such information and communication networks, life becomes more convenient, and at the same time, the damage caused by rapid information exchange is also constantly increasing. Recently, cyber crimes such as sending sexual messages or personal attacks to certain people with recognition on the Internet, such as not only entertainers but also influencers, have occurred, and some of those exposed to these cybercrime have committed suicide. In this paper, in order to reduce the damage caused by malicious comments, research a method for improving the performance of discriminate malicious comments through feature extraction based on parts-of-speech.

• KIPS Transactions on Computer and Communication Systems
• /
• v.11 no.2
• /
• pp.51-58
• /
• 2022

Blockchain technology is a system in which data from users participating in blockchain networks is distributed and stored. Bitcoin and Ethereum are attracting global attention, and the utilization of blockchain is expected to be endless. However, the need for blockchain data privacy protection is emerging in various financial, medical, and real estate sectors that process personal information due to the transparency of disclosing all data in the blockchain to network participants. Although studies using smart contracts, homomorphic encryption, and cryptographic key methods have been mainly conducted to protect existing blockchain data privacy, this paper proposes data privacy using matrix character relocation techniques differentiated from existing papers. The approach proposed in this paper consists largely of two methods: how to relocate the original data to matrix characters, how to return the deployed data to the original. Through qualitative experiments, we evaluate the safety of the approach proposed in this paper, and demonstrate that matrix character relocation will be sufficiently applicable in private blockchain environments by measuring the time it takes to revert applied data to original data.

• Journal of the Korean Society of Industry Convergence
• /
• v.26 no.1
• /
• pp.113-119
• /
• 2023

In this paper, we propose an optimization of a pose estimation deep learning model for recognition of abnormal behavior in unmanned stores using radio frequencies. The radio frequency use millimeter wave in the 30 GHz to 300 GHz band. Due to the short wavelength and strong straightness, it is a frequency with less grayness and less interference due to radio absorption on the object. A millimeter wave radar is used to solve the problem of personal information infringement that may occur in conventional CCTV image-based pose estimation. Deep learning-based pose estimation models generally use convolution neural networks. The convolution neural network is a combination of convolution layers and pooling layers of different types, and there are many cases of convolution filter size, number, and convolution operations, and more cases of combining components. Therefore, it is difficult to find the structure and components of the optimal posture estimation model for input data. Compared with conventional millimeter wave-based posture estimation studies, it is possible to explore the structure and components of the optimal posture estimation model for input data using genetic algorithms, and the performance of optimizing the proposed posture estimation model is excellent. Data are collected for actual unmanned stores, and point cloud data and three-dimensional keypoint information of Kinect Azure are collected using millimeter wave radar for collapse and property damage occurring in unmanned stores. As a result of the experiment, it was confirmed that the error was moored compared to the conventional posture estimation model.

• Journal of Korea Society of Industrial Information Systems
• /
• v.15 no.1
• /
• pp.1-14
• /
• 2010

It is recently issued scalability, mobility and external internet connection on Wire-less sensor network. The low power wireless sensor networks based on IPv6 technology 6LoWPAN technology is being standardized in the IETF. This paper for the 6LoWPAN environment based on the routing protocol LOAD, route cost applied the packet re-transmission rate which follows in Link Qualities price which uses at course expense and packet transmission Minimum route Cost routing protocol where does on the course wherethe smallest packet re-transmission becomes accomplished proposed. The technique which proposes compared and LOAD and AODV that about 13%, about 16% energy consumption is few respectively averagely, Energy of the entire network equally, used and energy effectiveness and improvement of network life time experiment led and confirmed.

• Journal of People, Plants, and Environment
• /
• v.22 no.5
• /
• pp.455-466
• /
• 2019

This study was carried out to analyze trends in floral products and services through the big data analysis of various social networking services (SNSs) and then to provide objective marketing directions for the floricultural industry. To analyze the big data of SNSs, we used four analytical methods: Cotton Trend (Social Matrix), Naver Big Data Lab, Instagram Big Data Analysis, and YouTube Big Data Analysis. The results of the big data analysis showed that SNS users paid positive attention to flower one-day classes that can satisfy their needs for direct experiences. Consumers of floral products and services had their favorite designs in mind and purchased floral products very actively. The demand for flower items such as bouquets, wreaths, flower baskets, large bouquets, orchids, flower boxes, wedding bouquets, and potted plants was very high, and cut flowers such as roses, tulips, and freesia were most popular as of June 1, 2019. By gender of consumers, females (68%) purchased more flower products through SNSs than males (32%). Consumers preferred mobile devices (90%) for online access compared to personal computers (PCs; 10%) and frequently searched flower-related words from February to May for the past three years from 2016 to 2018. In the aspect of design, they preferred natural style to formal style. In conclusion, future marketing activities in the floricultural industry need to be focused on social networks based on the results of big data analysis of popular SNSs. Florists need to provide consumers with the floricultural products and services that meet the trends and to blend them with their own sensitivity. It is also needed to select SNS media suitable for each gender and age group and to apply effective marketing methods to each target.

• Convergence Security Journal
• /
• v.23 no.1
• /
• pp.125-137
• /
• 2023

Companies that handle sensitive information, led by public institutions, establish separate networks for work and the Internet and protect important data through strong access control measures to prevent cyber attacks. Therefore, systems that involve the junction where the Intranet(internal LAN for work purposes only) and the Internet network are connected require the establishment of a safe security environment through both administrative and technical measures. Mobile Device Management(MDM) solutions to control mobile devices used by institutions are one such example. As this system operates by handling sensitive information such as mobile device information and user information on the Internet network, stringent security measures are required during operation. In this study, a model was proposed to manage sensitive information data processing in systems that must operate on the Internet network by managing it on the internal work network, and the function design and implementation were centered on an MDM solution based on a network interconnection solution.

• Convergence Security Journal
• /
• v.22 no.2
• /
• pp.59-66
• /
• 2022

Recently, smart home technology has been developed with a great response due to the convenience of home automation. Smart home technology provides various services by connecting various Internet of Things (IoT) and sensors to a home network through wired/wireless networks. In addition, the smart home service easily and conveniently controls lighting, energy, environment, and door cameras through a wall pad. However, while it has become a social issue due to the recent hacking accident of wall pads, personal information leakage and privacy infringement are expected. Accordingly, it is necessary to prepare preventive and countermeasures against security vulnerability factors of wall pads. Therefore, this study expects that it can be used as basic data for future smart home application and response technology development by examining the weak causes and countermeasures related to wall pads.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2022.11a
• /
• pp.377-379
• /
• 2022

POI refers to the point of Interest in Location-Based Social Networks (LBSNs). With the rapid development of mobile devices, GPS, and the Web (web2.0 and 3.0), LBSNs have attracted many users to share their information, physical location (real-time location), and interesting places. The tremendous demand of the user in LBSNs leads the recommendation systems (RSs) to become more widespread attention. Recommendation systems assist users in discovering interesting local attractions or facilities and help social network service (SNS) providers based on user locations. Therefore, it plays a vital role in LBSNs, namely POI recommendation system. In the machine learning model, most of the training data are stored in the centralized data storage, so information that belongs to the user will store in the centralized storage, and users may face privacy issues. Moreover, sharing the information may have safety concerns because of uploading or sharing their real-time location with others through social network media. According to the privacy concern issue, the paper proposes a recommendation model to prevent user privacy and eliminate traditional RS problems such as cold-start and data sparsity.