• Elastomers and Composites
• /
• v.52 no.3
• /
• pp.194-200
• /
• 2017

After the grafting of methacrylic acid (MA) to ethylene propylene diene monomer (EPDM), a new peak at $1704cm^{-1}$ corresponding to the carboxylic acid group was observed in the infrared (IR) spectrum. This characteristic MA molecule peak grew larger as the MA contents were increased. After casting films were prepared from pure EPDM and MA-grafted EPDM, differential scanning calorimeter (DSC) measurements were made the pure EPDM exhibited a melting point of approximately $45^{\circ}C$ while that of the MA-grafted EPDM was $135{\sim}140^{\circ}C$. As the graft ratio of MA increased, the absorbed heat capacity increased at temperatures near $135{\sim}140^{\circ}C$, indicating that an increased amount of MA reacted. Furthermore, owing to the addition of crystalline MA, it is expected that strength of the elastomer will improve as the graft ratio increases, as a result of the increased number of hard segments.

• Journal of the Korean Ceramic Society
• /
• v.48 no.4
• /
• pp.293-297
• /
• 2011

The thermodynamic behavior of phenolic resin was investigated to verify the relation between the properties of porous ceramics with $ZrO_2$-C system for submerged entry nozzle and the characteristics of phenolic resin with various relative humidity. The green and the sintered density were decreased between 25% and 50% relative humidity, whereas they were gradually enhanced above 50% relative humidity. The highest value of apparent porosity was 20.1% and the minimum compressive strength was 69MPa in the specimen using the powder exposed to 50% relative humidity. As a result of thermal analysis for phenolic resin, the shift of endothermic peak to low temperature and the reduction of exothermic peak were observed, and the peaks corresponded to melting and curing of phenolic resin, respectively. The melting and the curing of phenolic resin generate the change of green density, and it can affect the properties of submerged entry nozzle.

• Atmosphere
• /
• v.17 no.4
• /
• pp.349-364
• /
• 2007

The main purpose of this study is to examine the sensitivity of the WRF (Weather Research and Forecasting) in the wind field to the steepness of mountains in the case with a strong downslope wind occurred in the Yeongdong province. We conducted WRF simulations for February 13 2006. The initial and boundary data are from the NCEP/NCAR $1^{\circ}{\times}1^{\circ}$ GDAS. Arbitrary terrains of the mountains with a symmetric orography and an asymmetric one with steeper leeward slope, were introduced to examine the sensitivity of the shape of the mountains. The simulation with an asymmetric terrain results in stronger maximum surface wind by about $10ms^{-1}$ than with a symmetric terrain, especially in the narrow region from the peak to ~ 4 km away in the downstream. However, the maximum surface wind speed is weaker by $20ms^{-1}$ than with a symmetric terrain away from the narrow peak region. This indicates that the steeper slope leads to the intensification of downslope wind in the narrower region leeward. In addition, for the simulation with an asymmetric terrain, the strength of wave breaking is greater and the Lee wave is more dominant than for that with a symmetric terrain.

• Journal of the Korean Society for Precision Engineering
• /
• v.27 no.11
• /
• pp.17-23
• /
• 2010

Titanium alloy is one of the hard processing materials made by the traditional manufacturing method because of the excellent mechanical strength. Ablation of titanium alloy is investigated by using a femtosecond laser which is a regenerative amplified Ti:sapphire laser with 1kHz repetition rate, 184fs pulse duration time and 785nm wavelength. Experiments are carried out under various ablation conditions with different pulse overlap ratios for the rectangular shape and micro hole. Test results show that the ablation characteristic according to pulse overlap ratio of titanium alloy seems to be as non-linear type at the different zone of energy fluence. The optimal condition of rectangular shape processing is obtained at the laser peak power 1.3mW, pulse overlap ratio of 90%, beam gap of $1\;{\mu}m$. The micro hole has a good quality from the pulse overlap ratio of 99% at the same laser peak power. With the optimal processing condition, the fine rectangular shape and micro hole without burr and thermal damage are achieved.

• Journal of Biomedical Engineering Research
• /
• v.30 no.4
• /
• pp.306-310
• /
• 2009

The purpose of this study is to observe the change in gamma-band cortical activities (GBAs) due to task difficulty. Event-related potential and gamma-band activity were investigated using electroencephalograms recorded during auditory oddball tasks with two difficulty levels. For more difficult task, the amplitude of P300 decreased and the peak latency of P300 was delayed significantly compared to easier task. The induced GBA decreased considerably during the P300 latency period and the peak latency of the induced GBA was delayed for more difficult task. The results imply that the difficulty-related change in cortical information processing may be implemented as a change in the strength of local neuronal association.

• Elastomers and Composites
• /
• v.46 no.2
• /
• pp.158-163
• /
• 2011

Rigid polyurethane foam (PUF) was synthesized with different contents of aliphatic polyester polyol, aromatic polyester polyol and aliphatic polyether polyol to know change of properties under sea water. UTM(universal testing machine), DSC(differential scanning calorimetry), hardness meter and FT-IR(Fourier transform spectroscopy) were used to study the PUF`s physical properties under sea water. Compressive strength and hardness of PUF decreased with increasing the content of aromatic polyester polyol under sea water as aging. According to the results of IR spectral analysis, reduction of urethane and urea peak was found and allophanate and biuret peak increased. Although glass transition temperature of PUF increased, mechanical properties of PUF decreased under sea water, because PUF gets brittle when crosslink density increase.

• Wind and Structures
• /
• v.7 no.3
• /
• pp.145-158
• /
• 2004

The evaluation of the accumulation of permanent set for inelastic structures due to wind action is important in establishing a criterion to select a reduced design wind load and in incorporating the beneficial ductile behaviour in wind engineering. A parametric study of the accumulation of the permanent set as well as the ductility demand for bilinear single-degree-of-freedom (SDOF) systems is presented in the present study. The dynamic analysis of the inelastic SDOF system is carried out using the method of Newmark for artificially generated time history of wind speed. Simulation results indicate that the mean of the normalized damage rate is highly dependent on the natural frequency of vibration. This mean value is relatively insensitive to the damping ratio if the damping ratio is larger than 5%. The scatter associated with the accumulation of the permanent set is very significant. The consideration of the postyield stiffness can significantly reduce the accumulation of the permanent set if the ratio of the yield strength to the expected peak response is small. The results also show that the ductility demand due to the wind action over a period of one hour for flexible structures can be much less than that for rigid structures or structures with larger damping ratio if the SDOF systems are designed with a reduced peak response caused by the fluctuating wind.

• Journal of Korean Academy of Nursing
• /
• v.36 no.3
• /
• pp.571-580
• /
• 2006

Purpose: This study was to compare the effects among Tai-Chi exercise, aquatic Exercise, and a self-help program for knee osteoarthritis patients on symptoms of arthritis, muscle strength, balance, and difficulty of performing activities. Method: There were 50 final subjects50. A non-equivalent pretest-posttest design was used. The collected data was analyzed using SPSS for Window. One-way ANOVA and Scheffe's multiple comparison test were used 8weeks after each program. Result: There were significant differences in joint pain(p=.000), stillness (p=.001), knee extensor peak torque(p=.006), knee flexor(p=.002), and difficult of performing activity (p=.000), but there was no significant difference in balance(p=.648). The Tai-Chi group was significantly different from the self-help group for knee extensor peak torque, knee flexor and stiffness on Scheffe's multiple comparison tests. In addition, the Tai Chi group or aquatic group were significantly different from the self-help group for difficulty of performing activities(p<0.05). Conclusion: There are significant differences in the effects of the nursing intervention among the three groups. The Tai Chi group and aquatic group were significantly different from the self-help group. However, it seems that Tai-chi exercise may be more suitable than aquatic exercise in osteoarthritis exercise programs. Further studies with a longitudinal study are necessary to confirm the longer exercise period.

• Physical Therapy Korea
• /
• v.8 no.3
• /
• pp.27-34
• /
• 2001

Physical therapists have been using biofeedback training to induce improvements in various circumstances. The purpose of this study was to compare the effects of visual and tactile feedback using electrical stimulation on quadriceps strength. Nineteen women without known impairment of the neuromusculoskeletal system volunteered for this study. Subjects were randomly allocated into three groups: visual feedback, tactile feedback, and control group. The torque of isometric knee extension force was measured. Subjects were asked to exert the maximal isometric contraction force of quadriceps over a 30 second period. The resting period of 10 minutes was given after the maximal isometric contraction to avoid the muscle fatigue. In between groups comparison, significant differences of the peak torque and the torque area were found on the performance of the maximal isometric contraction of quadriceps (p<.05). The values peak of torque and torque area were significantly higher during visual feedback than tactile feedback. The results of this study suggest that visual feedback is more powerful than tactile feedback (p<.01).

• The Journal of Korean Physical Therapy
• /
• v.13 no.3
• /
• pp.537-549
• /
• 2001

The isometric torque of the elbow flexor and extensor muscles were measured for 6 seconds at a joint angle of 90$^{\circ}$ , in 10 normal subjects (control group) and 10 hemiplegic subjects(patient group), using the Cybex NORMTM System. The peak torque, the time to peak torque were measured for each exercise. In addition, heart rate and blood pressure were recorded simultaneously at rest and immediately following exercise completion at 1 and 3m mutes. Statistical analysis was performed using SPSS 8.0 for Windows software and mean and standard deviations were calculated. The results are as follows. 1) In the patient involved group. the isometric values for flexors and extensors were significantly lower than in the normal nondominant group(p<.05). 2) The extensor to flexor strength ratio in the isometric mode was 121.0% in the patient involved group compared with 78.7%in the normal nondominant group, a significant difference(p<.05). 3) The mean increment ratio was increased 19.0% for systolic blood pressure and 25.2% for disatolic blood pressure in the patient group. 4) The mean increment ratio was increased 36.0% heart rate in the patient group.