• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.2
• /
• pp.75-79
• /
• 2017

Honeycomb-shaped Ag-grid transparent conductive electrodes (TCEs) were fabricated using two different processes, high density plasma etching and lift-off, and the optical and electrical properties were compared according to the fabrication method. For the fabrication of the Ag-grid TCEs by plasma etching, etch characteristics of the Ag thin film in $10CF_4/5Ar$ inductively coupled plasma (ICP) discharges were studied. The Ag etch rate increased as the power increased at relatively low ICP source power or rf chuck power conditions, and then decreased at higher powers due to either decrease in $Ar^+$ ion energy or $Ar^+$ ion-assisted removal of the reactive F radicals. The Ag-grid TCEs fabricated by the $10CF_4/5Ar$ ICP etching process showed better grid pattern transfer efficiency without any distortion or breakage in the grid pattern and higher optical transmittance values of average 83.3 % (pixel size $30{\mu}m/line$ width $5{\mu}m$) and 71 % (pixel size $26{\mu}m/line$ width $8{\mu}m$) in the visible range of spectrum, respectively. On the other hand, the Ag-grid TCEs fabricated by the lift-off process showed lower sheet resistance values of $2.163{\Omega}/{\square}$ (pixel size $26{\mu}m/line$ width $18{\mu}m$) and $4.932{\Omega}/{\square}$ (pixel size $30{\mu}m/line$ width $5{\mu}m$), respectively.

• Reproductive and Developmental Biology
• /
• v.34 no.3
• /
• pp.181-184
• /
• 2010

Osmolarity of culture media is one of the most important factors affecting in vitro development. This study was conducted to investigate the DNA methylation status of Pre-1 and satellite sequence in pig nuclear transfer (pNT) embryos produced under different osmolarity culture conditions. Control group of pNT embryos was cultured in PZM-3 for six days. Other two treatment groups of pNT embryos were cultured in modified PZM-3 with 138 mM NaG or 0.05M sucrose (mPZM-3, 320 mOsmol) for two days, and then cultured in PZM-3 (270 mOsmol) for four days. Previous our studies have reported that pNT embryos cultured in both hypertonic media showed significantly higher blastocyst formation rate than that of control. The DNA methylation status of the satellite sequences in blastocyst was characterized using bisulfite-sequencing technology. The satellite region had a similar methylation pattern of in vivo blastocyst among two culture groups excepting the control group. Each level of methylation is that the satellite DNA moderately methylated (43.10% of PZM-3; 56.12% of NaCl; 55.06% of sucrose; 60.00% of in vivo embryos). As a result of the sequence of PRE-1, CpG methylation pattern was similar to three groups, including in vivo group. In case of the satellite DNA region, the osmolarity conditions were affected CpG DNA methylation status while PRE-1 sequence was not affected CpG DNA methylation in pNT blastocyst stage. These results indicate that the modification of osmolarity in a culture media may influence to spatially change of DNA methylation of repetitive sequence for pNT embryo development.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.3
• /
• pp.32-39
• /
• 2018

Raman spectra exhibit differences in intensity depending on the measuring equipment and environmental conditions even for the same material. This restricts the pattern recognition approach of Raman spectroscopy and is an issue that must be solved for the sake of its practical application, so as to enable the reusability of the Raman database and interoperability between Raman devices. To this end, previous studies assumed the existence of a transfer function between the measurement devices to obtain a direct spectral correction. However, this method cannot cope with other conditions that cause various intensity distortions. Therefore, we propose a classification method using linear intensity calibration which can deal with various measurement conditions more flexibly. In order to evaluate the performance of the proposed method, a Raman library containing 14033 chemical substances was used for identification. Ten kinds of chemical Raman spectra measured using three different Raman spectroscopes were used as the experimental data. The experimental results show that the proposed method achieves 100% discrimination performance against the intensity-distorted spectra and shows a high correlation score for the identified material, thus making it a useful tool for the identification of chemical substances.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.21 no.6
• /
• pp.323-330
• /
• 1988

The spatial distribution of sea water temperature variation pattern in the South-eastern coastal region of Korea was studied by empirical orthogonal function (E. O. F) analysis in several depths from surface to 300m using the monthly mean water temperature averaged for 23 years, water mass analysis by T. S diagram and sectional diagram of water temperature. Typical type of water temperature variation in this area can be divided into surface (0m-50m), subsurface (100m-150m) and intermediate (200m-300m) layer. The first mode value of water temperature change on the surface layer showed $99\%$ of total variation, and decreased with the increase of the depth. It is deduced to be in the range of $60-70\%$ on the 300m layer. The representative type of water temperature fluctuation by the first mode in each layer is as follows. Water temperature change in the surface layer showed a seasonal variation. In the subsurface layer, it is governed by the interaction of the Tsushima Warm Current water with the cold water and by the heat transfer process from the upper layer. In the intermediate layer, water temperature variation seems to be governed by the advection of the bottom cold water.

• Journal of Bio-Environment Control
• /
• v.12 no.3
• /
• pp.107-113
• /
• 2003

This study was carried out to improve the performance of pre-developed heat recovery devices attached to exhaust-gas flue connected to combustion chamber of greenhouse heating system. Four different units were compared in the aspect of heat recovery performance; A-, B-, and C-types are exactly the same with the old ones reported in previous studies. D-type newly developed in this experiment is mainly different with the old ones in its heat exchange area and tube thickness. But airflow direction(U-turn) and pipe arrangement are similar with previous three types. The results are summarized as follows; 1. System performances in the aspect of heat recovery efficiency were estimated as 42.2% for A-type, 40.6% for B-type, 54.4% for C-type, and 69.2% for D-type. 2. There was not significant improvement of heat recovering efficiency between two different airflow directions inside the heat exchange system. But considering current technical conditions, straight air flow pattern has more advantage than hair-pin How pattern (U-turn f1ow). 3. The main factors influencing on heat recovery efficiency were presumably verified to be the total area of heat exchange surface, the thickness of ail-flow pipes, and the convective heat transfer coefficient influenced by airflow velocity under the conditions of allowable pipe durability and safety. 4. Desirable blower capacity for each type of heat recovery units were significantly different to each other. Therefore, the optimum airflow capacity should be determined by considering in economic aspect of electricity required together with the optimum heat recovery performance of given heat recovery systems.

• Nuclear Engineering and Technology
• /
• v.53 no.1
• /
• pp.61-68
• /
• 2021

Experiments of vertically upward steam-water two-phase flow have been carried out in single-side heated narrow rectangular channel with a gap of 3 mm. Flow patterns were identified and classified through visualization directly. Slug flow was only observed at 0.2 MPa but replaced by block-bubble flow at 1.0 MPa. Flow pattern maps at the pressure of 0.2 MPa and 1.0 MPa were plotted and the difference was analyzed. The experimental data has been compared with other flow pattern maps and transition criteria. The results show reasonable agreement with Hosler's, while a wide discrepancy is observed when compared with air-water two-phase experimental data. Current criteria developed based on air-water experiments poorly predict bubble-slug flow transition due to the different formation and growth of bubbles. This work is significant for researches on heat transfer, bubble dynamics and flow instability.

• Korean Journal of Animal Reproduction
• /
• v.9 no.2
• /
• pp.140-147
• /
• 1985

Seventy four Holstein heifers were randomly assigned over three trials to PRID-7+PG-6 and Synchromate B-9 regimens to synchronize estrus cycle for embryo transfer. Sexual behaviors; moounting, standing, orientation, chin-resting, sniffing, licking, rubbing and butting, vaginal swelling and mucus discharge were observed between 06-08, 12-14 and 18-20 h on 1st day and 00-02, 06-08, 12-14 and 18-20 h on 2nd day after removal of hormones. Synchromate-B treatment (81.6%) showed higher synchronized estrus rate than PRID treatment (77.8%) during observation period. Standing estrus was observed within 74 h after PG injection in PRID and within 52 h after removal of implant in Synchromate-B. About 68% of heifers in PRID and 74% of heifers in Synchromate-B showed standing estrus between 0-14 h on 2nd day after removal of the hormones. Synchromate-B resulted in a tighter synchrony of standing estrus than PRID. Incidence of average mounting and standing per head during observation period was 22.3 and 16.6 in PRID and 28.1 and 13.6 in Synchromate-B. The PRID showed peak in active mounting at 18-20 h on 1st day, however, the Synchromate-B showed at 0-2 h on 2nd day after removal of hormone. Active standing was shown between 18 h on 1st day to 20h on 2nd day in PRID, however, between 0-14 h on 2nd day after removal of hormone is Synchromate-B. There was slight difference in pattern of active mounting and standing during estrus between PRID and Synchromate-B. Conception rate of synchronized heifers transferred with fresh and frozen embryos by non-surgical and surgical methods was higher in synchromate-B (62.5%) than in PRID (38.5%). Chin-resting showed highest incidence among 6 sexual behavioral components in the both treatments. Synchromate-B showed higher incidence of chin-resting (16.6) than PRID (10.7). Synchromate-B group showed also higher incidence of orientation, sniffing and butting than PRID group. Synchromate-B resulted in more active sexual behaviors than PRID. The pattern of incidence of chin-resting, licking and butting was almost symmetrical in PRID with their peak values at 6-8 h on 2nd day, however in Synchromate-B chin-resting and sniffing was symmetrical with their peak values at 12-14 h on 2nd day after removal of hormone. There was tendency to increase vaginal swelling according to time passage of synchronized estrus in the both treatments. Incidence of mucus discharge in Synchromate-B was slightly higher than in PRID. Twenty to 40% was false negative in conception rate by tall painting before re-estrus day as judged by rectal palpation.

• Journal of the Korea Concrete Institute
• /
• v.24 no.6
• /
• pp.737-744
• /
• 2012

Hysteretic steel damper has been applied mainly to steel buildings. However, the usage in RC buildings is rapidly increasing recently. In order to apply the steel hysteretic damper in RC buildings, supporting elements of the damper should have sufficient strength and stiffness suitable for transferring damper forces to beams and walls. But due to the inevitable damage in reinforced concrete elements due to cracking, identification of the load transfer mechanism from damper to supporting element and hysteretic characteristics of the supporting element are extremely important in evaluating the damper behavior. Experiments were carried out on connection details between RC walls and supporting elements of the steel plate typed damper such as EaSy damper. The test results showed that fracture patterns of all specimens were almost identical except in the crack number and pattern associated with shear loading condition. Among the specimens, HD-3 shoed a well distributed cracks patterns along with good performance with respect to energy dissipation capacity, stiffness deterioration, and strength degradation.

• Journal of Digital Contents Society
• /
• v.14 no.4
• /
• pp.573-580
• /
• 2013

With the growth of the smart-devices and information & communication technology, information society has developed and information can be produced, spread and consumed at much faster pace easily. Hence, individuals can utilize wireless communication and smart-devices to create, share and consume information at anytime and anywhere. The growth of technology has allowed the large-scale transfer and sharing of image, sound and video data; it changed the users' data consumption pattern that was mainly consisted of the text. Therefore, the amount of data that an individual consumes increased significantly. The importance of finding and analyzing practical and necessary data among huge amount of data has arisen. In this study, the current status of Big Data is researched and analyzed and the method to utilize Big Data in the electronic trading field is suggested.

• Clean Technology
• /
• v.11 no.2
• /
• pp.69-74
• /
• 2005

A metal ion detector with a submicron size electrode was fabricated by field-induced AFM oxidation. The square frame of the mesa pattern was functionalized by APTES for the metal ion detection, and the remaining portion was used as an electrode by the self-assembly of MPTMS for Au metal deposition. The conductance changed with the quantity of adsorbed copper ions, due to electron tunneling between the mobile and surface electrodes. The smaller electrode has a lower limit of detection due to the enhancement in electron tunneling through metal ions that are adsorbed between the conductive-tip (mobile) and the surface (fixed) electrode. This two-electrode system immobilized with different functional groups was successfully used in the selective adsorption and detection of target materials.