• The Journal of the Acoustical Society of Korea
• /
• v.43 no.4
• /
• pp.445-454
• /
• 2024

To detect underwater targets using sonar, sonar performance analysis that reflects the ocean environment and sonar characteristics must be performed. Sonar performance modeling of passive and monostatic sonar can be performed relatively quickly even considering the ocean environment. However, since bistatic and multistatic sonar performance modeling require higher computational complexity and much more time than passive or monostatic sonar cases, they have been performed by simplifying or not considering the ocean environment. In thisstudy, the effects of reverberation and ocean environment in bistatic sonar performance were analyzed using the bistatic reverberation modeling in the Ulleung Basin of the East Sea. As the sonar operation depth approaches the sound channel axis, the influence of the bathymetry on sound propagation is reduced, and the reverberation limited environment is formed only at short distances. Finally, it was confirmed that similar trends appeared through comparison between the simplified and elaborately calculated sonar performance modeling results.

• The Journal of the Acoustical Society of Korea
• /
• v.43 no.1
• /
• pp.1-8
• /
• 2024

For measuring the performance of passive sonars, we usually consider the maximum Detection Range (DR) under the environment and system parameters in operation. In shallow water, where sound waves inevitably interacts with sea surface or bottom, detection generally maintains up to the maximum range. In deep water, however, sound waves may not interact with sea surface or/and bottom, and thus there may exist shadow zones where sound waves can hardly reach. In this situation, DR alone may not completely define the performance of each sonar. For complete description of sonar performance, we employ the concept 'Robustness Of Detection (ROD)'. In the coastal region of the East Sea, the spatial variations of water masses have close relations with DR and ROD, where the two parameters show reverse spatial variations in general. The spatial and temporal analysis of the temperature by employing the Empirical Orthogonal Function (EOF) shows that the 1-st mode represents typical pattern of seasonal variation and the 2-nd mode represents strength variations of mixed layers and currents. The two modes are estimated to explain about 92 % of the variations. Assuming two types of targets located at the depths of 5 m (shallow) and 100 m (deep), the passive sonar performance (DR) gives high negative correlations (about -0.9) with the first two modes. Most of temporal variations of temperature occur from the surface up to 200 m in the water column so that when we assume a target at 100 m, we can expect detection performance of little seasonal variations with passive sonars below 100 m.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.6
• /
• pp.549-558
• /
• 2020

In this paper, the method is discussed such that the robustness of automatic initiated narrowband target tracking is improved in passive sonar. In the case of automatic tracking initiation as target in passive sonar, due to a number of clutter, the clutter is initiated as target and tracked which prohibits the operation capability. The associated probability and information entropy of measurements, extracted from detection data, is calculated to keep going on automatic target initiation and tracking of true target, but reduce the automatic initiation and tracking of clutter. If the association probability and information entropy of the extracted measurements is satisfied for the predefined conditions, the procedure of automatic initiation begins. Using sea-trial data, simulations are executed and the results from the proposed method indicate that it keeps the automatic target initiation and tracking of true target and suppresses the automatic target initiation and tracking of clutters in contrary to the conventional method.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.2
• /
• pp.110-117
• /
• 2016

Passive sonar systems detect and classify the target by analyzing the radiated noises from vessels. If multiple noise sources exist within the sonar detection range, it gets difficult to classify each noise source because mixture of noise sources are observed. To overcome this problem, a beamforming technique is used to separate noise sources spatially though it has various limitations. In this paper, we propose a new method that uses a FDICA (Frequency Domain Independent Component Analysis) to separate noise sources from the mixture. For experiments, each noise source signal was synthesized by considering the features such as machinery tonal components and propeller tonal components. And the results of before and after separation were compared by using LOFAR (Low Frequency Analysis and Recording), DEMON (Detection Envelope Modulation On Noise) analysis.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.6
• /
• pp.472-483
• /
• 2013

Actual maritime exercise for improving the capability of submarine sonar operator leads to a lot of cost and constraints. Sonar simulator maximizes the capability of sonar operator and training effect by solving these problems and simulating a realistic battlefield environment. In this study, a passive sonar simulator algorithm is suggested, where the simulator is divided into three modules: maneuvering module, noise source module, and sound propagation module. Maneuvering module is implemented in three-dimensional coordinate system and time interval is set as the rate of vessel changing course. Noise source module consists of target noise, ocean ambient noise, and self noise. Target noise is divided into modulated/unmodulated and narrowband/broadband signals as their frequency characteristics, and they are applied to ship radiated noise level depending on the vessel tonnage and velocity. Ocean ambient noise is simulated depending on the wind noise considering the waveguide effect and other ambient noise. Self noise is also simulated for flow noise and insertion loss of sonar-dome. The sound propagation module is based on ray propagation, where summation of amplitude, phase, and time delay for each eigen-ray is multiplied by target noise in the frequency domain. Finally, simulated results based on various scenarios are in good agreement with generated noise in the real ocean.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.177-183
• /
• 2019

In this paper, we proposed an application method of ICA (Independent Component Analysis) to passive line array sonar to separate interferences from target signals in low frequency band and compared performance of three conventional ICA algorithms. Since the low frequency signals are received through larger bearing angles than other frequency bands, neighboring beam signals can be used to perform ICA as measurement signals of the ICA. We use three ICA algorithms such as Fast ICA, NNMF (Non-negative Matrix Factorization) and JADE (Joint Approximation Diagonalization of Eigen-matrices). Through experiments on real data obtained from passive line array sonar, it is verified that the interference can be separable from target signals by the suggested method and the JADE algorithm shows the best separation performance among the three algorithms.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1984.12a
• /
• pp.96-99
• /
• 1984

In this study, the underwater acoustic images were obtained by ultrasonicwave. The experiment was performed in the anechoic watertank, using a passive sonar array for one and two sound source respectively by X-Y scanning technique. The receiving array was consist of 8 disc type transducers with 1.5cm diameter at 25KHz resonance frequency. The scanned data were processed by the FORTRAN IV algorithm for the reconstruction of image, and the image had some noise due to the surface reflected waves. As the result, it was found that the acoustic imaging by electrical deflection and dynamic focusing technique is applicable to SONAR with the suppression of surface reflected wave.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.148-148
• /
• 2000

In this paper the IMM(Interacting Multiple model) algorithm using the MGEKF(Modified Gain Extended Kalman Filter) which modes are variances of the process noises is proposed to enhance the performance of maneuvering target tracking with bearing and frequency measurements. The state are composed of relative position, relative velocity, relative acceleration and doppler frequency. The mode probability is calculated from the bearing and frequency measurements. The proposed algorithm is tested a series of computer simulation runs.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.6
• /
• pp.9-16
• /
• 1999

As a part of target motion analysis(TMA) with highly noisy bearings-only measurements from a passive sonar system, a nonlinear batch estimator is proposed to provide the initial estimates to a sequential estimator called the modified gain extended Kalman filter(MGEKF). Based on the system observability analysis of passive target tracking, a practical and effective method is suggested to determine the observer maneuvers for improved TMA performance through system observability enhancing. Also suggested is a method to determine observer location for enhanced system observability at the initial phase of TMA from various engagement boundaries which represent the relationship between observer-target relative geometrical data and system observability. The proposed TMA methods are tested by a series of computer simulation runs.

• Journal of Ocean Engineering and Technology
• /
• v.34 no.4
• /
• pp.277-284
• /
• 2020

Underwater acoustics, which is the study of phenomena related to sound waves in water, has been applied mainly in research on the use of sound navigation and range (SONAR) systems for communication, target detection, investigation of marine resources and environments, and noise measurement and analysis. The main objective of underwater acoustic remote sensing is to obtain information on a target object indirectly by using acoustic data. Presently, various types of machine learning techniques are being widely used to extract information from acoustic data. The machine learning techniques typically used in underwater acoustics and their applications in passive SONAR systems were reviewed in the first two parts of this work (Yang et al., 2020a; Yang et al., 2020b). As a follow-up, this paper reviews machine learning applications in SONAR signal processing with a focus on active target detection and classification.