• 산업기술연구
• /
• 제28권A호
• /
• pp.113-117
• /
• 2008

Wireless carrier sense multiple access (CSMA) systems are widely used but show extremely different transmission efficiency according to the operation environment. Simulation or prototype deployment is needed to see the transmission efficiency of a wireless CSMA system with the partial packet retransmission scheme. The lower bound for the transmission efficiency of such a system is found mathematically in this work. This shows how much the partial packet retransmission scheme improves the transmission efficiency quantitatively. It also shows that the maximum throughput is obtained at higher offered load compared to the conventional CSMA system without the partial packet transmission. The result of this work can be applied to IEEE 802.11 networks or wireless mesh networks.

• Bulletin of the Korean Chemical Society
• /
• 제28권8호
• /
• pp.1383-1388
• /
• 2007

Recently, the semiconductor and display industries have tried to reduce the emissions of perfluorocompounds (PFCs) from the globally environmental regulation. Total amount of PFC emission can be calculated from the flow rate and the partial pressures of PFCs. For the precise measurement of PFC emission amount, the mass flow controlled helium gas was continuously injected into the equipment of which scrubber efficiency is being measured. The partial pressures of PFCs and helium were accurately measured using a mass spectrometer in each sample extracted from inlet and outlet of the scrubber system. The flow rates are calculated from the partial pressures of helium and also, PFC destruction and removal efficiency (DRE) of the scrubber is calculated from the partial pressure of PFC and the flow rate. Under this method, the relative expanded uncertainties of the flow rate and the partial pressures of PFCs are ± 2% (k = 2) in case the concentrations of NF3 and SF6 are as low as 100 μmol/mol.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 연구회 합동 학술발표회 논문집
• /
• pp.39-43
• /
• 1998

A large number of soft switching topologies included a resonant circuit have been proposed. But these circuits increase number of switch in circuit and complicate sequence of switching operation. In this paper, the authors propose power conversion system, DC-AC inverter of high efficiency and high power factor with soft switching mode by partial resonant method. The switching devices in a proposed circuits are operated with soft switching by the partial resonant method, that is, PRS2MPC (Partial Resonant Soft Switching Mode Power Converter). The result is that the switching loss is very low and the efficiency of system is high. And the snubber condenser used in partial resonant circuit makes charging energy regenerated at input power source for resonant operation.

• 한국화재소방학회논문지
• /
• 제20권2호
• /
• pp.72-79
• /
• 2006

본 연구에서는 부분배연설비의 배연효율을 분석하고, 화재시 운영방안을 제시하기 위하여 수치해석을 실시하였다. 해석결과 선행된 실험을 통하여 얻었던 균일댐퍼의 배연효율 및 연기의 단면분포에 의한 성층화 결과는 서로 일치하는 경향을 얻을 수 있었다. 균일댐퍼의 운영방안은 화재시 화재 근방의 댐퍼만을 개방하였을 경우가 터널내 모든 댐퍼를 개방하였을 경우에 비하여 약 7%의 배연효율이 증가됨을 보였다. 또한, 터널내 차량이 정체시 화재가 발생할 경우 승객의 안전한 대피를 위한 부분배연설비의 정량적인 운전방안을 제안하였다.

• 전자공학회논문지S
• /
• 제34S권9호
• /
• pp.118-125
• /
• 1997

This paper proposed a new partial resonant 3.PHI. AC-DC boost converter of high efficiency using lossless snubber. The proposed converter, DCM (Discontinuous Current Mode) has a merit of simple controlled circuit because the input current control discontinuously. But turned off switching loss and stress of the switching device increase when the switch turned off at the peak of current. Therefore, the paper improves efficiency by adopting the PRS$^{2}$(Partial Resonant Soft Switching) in 3.PHI. AC-DC boost converter and makes the unity power factor. The PRS$^{2}$ is reduced a current/voltage stresses of switching devices. Also, a DCMPRS$^{2}$M(Discontinuous Conduction Mode Partial Resonant Soft Switching Method) appear the current and voltage equation of this circuit. The paepr examine in a 3.PHI. AC-DC boost converter and show the result of that.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제48권4호
• /
• pp.212-218
• /
• 1999

A new partial resonant three phase boost converter with high power factor and high efficiency is proposed. The proposed boost converter is constructed by using a resonant network in parallel with the swithch of the conventional boost converter. The devices are switched at zero voltage or zero current eliminating the switching loss. A new auxiliary partial resonant boost converter achieves zero-voltage switching(ZVS) or zero-current switching(ZCS) for all switch devices without increasing their voltage and current stresses.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.531-532
• /
• 2006

This paper presents our implemented, synthesized and tested on demand and partial reconfiguration approaches for FIR filters using Xilinx Virtex FPGAs. Our scope is to implement a low-power, area-efficient autonomously reconfigurable digital signal processing architecture that is tailored for the realization of arbitrary response FIR filters on Xilinx Virtex4 FPGAs. The implementation of design addresses area efficiency and flexibility allowing dynamically inserting and/or removing the partial modules to implement the partial reconfigurable FIR filters with various taps. This partial reconfigurable FIR filter design shows the configuration time improvement, good area efficiency and flexibility by using the dynamic partial reconfiguration method.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2005년도 International Meeting on Information Displayvol.I
• /
• pp.171-174
• /
• 2005

Experimental measurements are reported and compared with the results of a two-dimensional fluid simulation for the investigation of the discharge characteristics regarding the change of the mixture ratio of Ne-Xe-He noble gases. The increase of Xe contents results in the increases of luminance and luminous efficiency while it also results in the increase of the breakdown voltage and the discharge time lag. The addition of He gas increases the brightness and the luminance efficiency. When Xe partial pressure is low, the luminance efficiency increases with the amount of He at the same total pressure. When Xe partial pressure is high, however, the luminance efficiency has a maximum value when the partial pressure of He is about 10% of the total pressure for a standard AC PDP cell with Xe fraction of $10{\sim}30%$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 B
• /
• pp.1148-1150
• /
• 2003

Power conversion system must be increased switching frequency in order to achieve a small size, a light weight and a low noise. However, the switches of converter are subjected to high switching power losses and switching stresses. As a result of those, the power system brings on a low efficiency. To improved these, a large number of soft switching topologies included a resonant circuit has been prosed. But these circuits increase number of switch in circuit and complicate sequence of switching operation. In this paper, the authors propose a high power factor and high efficiency DC-DC converter using single-pulse soft switching by partial resonant switching node. The switching devices in a prosed circuit are operated with soft switching by the partial resonant method, that is, Partial Resonant Switch Mode Power Converter. The partial resonant circuit makes use of a inductor using step up and a condenser of loss-less snubber. The result is that the switching loss is very low and the efficiency of system is high. Also the proposed converter is deemed the most suitable for high power applications where the power switching devices are used. Some simulative results on computer results are included to confirm the validity of the analytical results.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2014년도 추계학술대회 논문집
• /
• pp.1-2
• /
• 2014

In this paper the partial switching PFC converter which is based on predictive control is proposed. In terms of satisfying the harmonic standard, the predictive control shows a similar performance to the conventional average current mode control PFC in the normal input condition. Moreover, the current harmonic characteristic is insensitive to the distorted input voltage. With predictive control method, novel on-line partial switching strategy is suggested in this paper. Depending on the operating condition, the partial switching PFC converter can boost its output voltage. Also when its efficiency needs to be improved, according to load condition, the partial switching can be achieved. The proposed strategy is proved by the results of FFT and the loss analysis using PSIM 9.0.