• ETRI Journal
• /
• v.31 no.5
• /
• pp.619-621
• /
• 2009

In this letter, we study the influence of receiver imperfections on bit error rate (BER) degradations in detecting low-density parity-check coded multilevel phase-shift keying signals transmitted over a Rician fading channel. Based on the analytical system model which we previously developed using Monte Carlo simulations, we determine the BER degradations caused by the simultaneous influences of stochastic phase error, quadrature error, in-phase-quadrature mismatch, and the fading severity.

• Proceedings of the IEEK Conference
• /
• 2008.06a
• /
• pp.161-162
• /
• 2008

In this paper we design an irregular low-density parity-check (LDPC) code for a multi-input multi-output (MIMO) system. The considered MIMO system is minimum mean square error soft-interference cancellation (MMSE-SIC) detector. The MMSE-SIC detector and the LDPC decoder exchange soft information and consist a turbo iterative detection and decoding receiver. Extrinsic information transfer (EXIT) charts are used to obtain the edge degree distribution of the irregular LDPC code which is optimized for the input-output transfer chart of the MMSE-SIC detector. It is shown that the performance of the designed LDPC code is much better than that of conventional LDPC code optimized for the AWGN channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.7C
• /
• pp.587-593
• /
• 2010

In this paper we design an irregular low-density parity-check (LDPC) code for multiple-input multiple-output (MIMO) system, using a simple extrinsic information transfer (EXIT) chart method. The MIMO systems considered are optimal maximum a posteriori probability (MAP) detector. The MIMO detector and the LDPC decoder exchange soft information and form a turbo iterative receiver. The EXIT charts are used to obtain the edge degree distribution of the irregular LDPC code which is optimized for the MIMO detector. It is shown that the performance of the designed LDPC code is better than that of conventional LDPC code which was optimized for either the Additive White Gaussian Noise (AWGN) channel or the MIMO channel.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.8
• /
• pp.1-11
• /
• 2012

The multi-code spread spectrum communication system, which spreads data bit stream by multiplexing orthogonal codes, can transmit data in high rate. However it needs the high-cost good linear amplifier because of the multi-level output signal. In order to overcome this drawback several systems making the amplitude of output signal constant with Walsh codes have been proposed. Recently constant amplitude pre-coded multi-code spread spectrum systems using extended m-sequence have been proposed. In this paper we consider an extended m-sequence based constant amplitude multi-code spread spectrum system with code set partitioning. By grouping the orthogonal codes into 4 subsets, not only is the computational complexity of the transceiver reduced but BER performance also improves. It has been shown that parity checking on four detected codes at the receiver can correct code detection error and result in BER performance enhancement. In this paper we propose a improved parity check receiver. We carried out computer simulation to verify feasibility of the proposed algorithm.

• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.55-58
• /
• 2004

This this paper, we propose vertical Bell laboratories layered space time (V-BLAST) system based on variable rate Low-Density Parity Check (LDPC) codes to improve performance of receiver when QR decomposition interference suppression combined with interference cancellation is used over independent Rayleigh fading channel. The different rate LDPC codes can be made by puncturing some rows of a given parity check matrix. This allows to implement a single encoder and decoder for different rate LDPC codes. The performance can be improved by assigning stronger LDPC codes in lower layer than upper layer because the poor SNR of first detected data streams makes error propagation. Keeping the same overall code rates, the V-BLAST system with different rate LDPC codes has the better performance (in terms of Bit Error Rate) than with constant rate LDPC code in fast fading channel.

• Journal of IKEEE
• /
• v.24 no.4
• /
• pp.1184-1187
• /
• 2020

This paper proposes an in-vehicle network controller fully exploiting the advantages of UART (Universal Asynchronous Receiver/Transmitter) and CAN (Controller Area Network). UART is used in 1-to-1 communication and it exploits parity bit for data integrity check. The proposed in-vehicle network controller converts UART into CAN, which enables multiple communications along with 1-to-1 communication. Also, the proposed in-vehicle network controller exploits CRC (cyclic redundancy check) for data integrity check, which increases communication reliability. CAN is controlled by microprocessor, but the proposed in-vehicle network controller can be controlled by any devices compliant with RS-232, RS-422, and RS-485.

• Journal of Communications and Networks
• /
• v.11 no.6
• /
• pp.538-543
• /
• 2009

A wiretap channel I is one of the channel models that was proved to achieve unconditional security. However, it has been an open problem in realizing such a channel model in a practical network environment. The paper is committed to solve the open problem by introducing a novel approach for building wiretap channel I in which the eavesdropper sees a binary symmetric channel (BSC) with error probability p while themain channel is error free. By taking advantage of the feedback and low density parity check (LDPC) codes, our scheme adds randomness to the feedback signals from the destination for keeping an eavesdropper ignorant; on the other hand, redundancy is added and encoded by the LDPC codes such that a legitimate receiver can correctly receive and decode the signals. With the proposed approach, unconditionallysecure communication can be achieved through interactive communications, in which the legitimate partner can realize the secret information transmission without a pre-shared secret key even if the eavesdropper has better channel from the beginning.

• Journal of Communications and Networks
• /
• v.16 no.6
• /
• pp.639-644
• /
• 2014

In low-density parity-check (LDPC) coded multiple-input multiple-output (MIMO) communication systems, probabilistic information are exchanged between an LDPC decoder and a MIMO detector. TheMIMO detector has to calculate probabilistic values for each bit which can be very complex. In [1], the authors presented a class of linear block codes named low-density MIMO codes (LDMC) which can reduce the complexity of MIMO detector. However, this code only supports the outer-iterations between the MIMO detector and decoder, but does not support the inner-iterations inside the LDPC decoder. In this paper, a new approach to construct LDMC codes is introduced. The new LDMC codes can be encoded efficiently at the transmitter side and support both of the inner-iterations and outer-iterations at the receiver side. Furthermore they can achieve the design rates and perform very well over MIMO channels.

• ETRI Journal
• /
• v.30 no.6
• /
• pp.807-817
• /
• 2008

We present a low-density parity-check (LDPC)-based, threaded layered space-time-frequency system with emphasis on the iterative receiver design. First, the unbiased minimum mean-squared-error iterative-tree-search (U-MMSE-ITS) detector, which is known to be one of the most efficient multi-input multi-output (MIMO) detectors available, is improved by augmentation of the partial-length paths and by the addition of one-bit complement sequences. Compared with the U-MMSE-ITS detector, the improved detector provides better detection performance with lower complexity. Furthermore, the improved detector is robust to arbitrary MIMO channels and to any antenna configurations. Second, based on the structure of the iterative receiver, we present a low-complexity belief-propagation (BP) decoding algorithm for LDPC-codes. This BP decoder not only has low computing complexity but also converges very fast (5 iterations is sufficient). With the efficient receiver employing the improved detector and the low-complexity BP decoder, the proposed system is a promising solution to high-data-rate transmission over selective-fading channels.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.12
• /
• pp.2791-2797
• /
• 2010

In recent years, the goal of providing high speed wireless data services has generated a great amount of interest among the research community. Several researchers have shown that the capacity of the system, in the presence of flat Rayleigh fading, improves significantly with the use of combined MIMO and LDPC. To feed the soft values to LDPC decoder, the soft values must be calculated from multiple transmitter and receiver antennas in Rayleigh fading channel. It requires high computational complexity to get the soft symbols by increasing number of transmitter and receiver antennas. Therefore, this thesis proposed on effective algorithm for calculation of soft values from multiple antennas based on LLR. As result, This thesis shows that maximum 61% of computational complexity is reduced with a little loss of performance.