• Journal of the Korean Ceramic Society
• /
• v.33 no.4
• /
• pp.379-384
• /
• 1996

The H2S sensing mechanism of CuO-SnO2 was confirmed by analyzing the electrical-resistance variation with temperature under an H2S atmosphere. While the resistance of CuO-SnO2 thick film at N2+H2S atmosphere was almost invariant with change in temperature it increased with increasing temperature for air +H2S atmos-phere. This behavior was analyzed using an equation derived from a basic assumption based on the H2S sensing mechanism proposed before. the experimental results are sufficiently explained with the equation derived which showed that the H2S sensing mechanism was reasonable. The equation also gave a detailed analysis and physical meaning to the behavior of the resistance variation with change in H2S concentration.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.09a
• /
• pp.71-74
• /
• 2001

AMB(Acid Mine Drainage), characterized as high concentration of metal & sulfate ions and low pH(2.0~4.0), is the world-wide problem wherever there is or has been mining activities. Though limestone has been generally used to neutralize AMD, There are metal hydroxide precipitation on the surface of limestone and excessive alkalinity formation which exceeds the regulation. In this research, concrete-recycled fine aggregate is selected for alternative neutralizing agent. Because fine recycled aggregate had more ANP than others in the preliminary research, the purpose of this research is to apply fine aggregate for AMD neutralization. Three columns packed with fine aggregates(2.5mm$O_3$) of it is calculated as 0.09(C-1), approximated 10% purity of limestone. Comparing with values of other columns(C-2: 0.01 and C-3: 0.01), there is variation of porosity and residence time induced from the precipitation of metal hydroxide. Consequently, 8 hours of HRT is enough to create adequate alkalinity and the function which could expect the variation of porosity(n) and residence time( $t_{R}$) should be applied to develop design function.lied to develop design function.

• Journal of Korean Society on Water Environment
• /
• v.22 no.2
• /
• pp.328-332
• /
• 2006

Fe(III)-impregnated activated carbon (Fe-AC) was applied in the treatment of synthetic wastewater containing Cu(II). To investigate the stability of Fe-AC at acidic condition, dissolution of Fe was studied with a variation of solution pH ranging from 2 to 4. Fe-AC was unstable at pH 2, showing a gradual increase of the dissoluted Fe as reaction time increased, while negligible amount of Fe was dissoluted above pH 3. This stability test suggests the applicability of Fe-AC in the treatment of wastewater above pH 3. Adsorption capacity of Cu(II) onto activated carbon (AC) and Fe-AC was investigated in a batch and a column test. In the adsorption kinetics, rapid adsorption of Cu(II) onto AC and Fe-AC was noted at initial reaction time and then reached a near complete equilibrium after 6 hrs. Adsorption trends of Cu(II) onto AC and Fe-AC were similar, showing an increased Cu(II) adsorption at higher pH. Compared with AC, Fe-AC showed a greater Cu(II) adsorption over the entire pH range studied in this research. From the adsorption isotherm obtained with variation of the concentration of Cu(II), the maximum adsorption capacity was identified as 61,700 mg/kg.

• Resources Recycling
• /
• v.21 no.6
• /
• pp.74-81
• /
• 2012

The Influence of temperature on the recovery reaction of silver in aqueous solution was investigated based on Pourbaix diagram constructed by thermodynamic calculation at different temperatures. It was observed that the stability of water is more strongly affected by pH variation and the stable region of ${Ag^+}_{(aq)}$ is diminished at higher temperature. It was shown that the recovery of $Ag_{(aq)}$ in the forms of $Ag_{(s)}$ and $Ag_2O_{3(s)}$ is more advantageous thermodynamically at lower temperature, however, the recovery of $Ag_{(aq)}$ in the forms of $Ag_2O_{(s)}$ 및 $Ag_2O_{2(s)}$ is more advantageous as temperature increases. The rise of temperature is considered to demote the recovery of silver thermodynamically in strong acidic condition ($pH{\leq}2$), but more silver is regarded to be recovered with temperature above pH 2. Finally, The recovery of silver in the elemental state is shown to be more sensitively influenced by temperature variation compared with the recovery of silver in its oxide form.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.10 no.3
• /
• pp.68-73
• /
• 2002

Acidogenic fermentation of primary sludge was investigated for the solution to reduce the sewage sludge and develope external carbon source for BNR process. In a viewpoint to use existing anaerobic digestion tanks, we didn't change environmental factors such as reactor configuration, temperature, pH and investigate the variation of solubilization rates, acidification rates and environmental factors which affected by the variation of HRT. The average solubilization rates were 0.0309 and $0.0204mgSCOD_{prod.}/mgICOD_{inf.}$ at a HRT of 3 and 1.5 days, respectively. The average acidification rates were 0.0068mg HAc/mg $TCOD_{inf.}$ and 0.0652mg HAc/mg $VSS_{destroyed}$ at a HRT of 3day. At a HRT of 1.5 days the average acidification rates were 0.0060mg HAc/mg $TCOD_{inf.}$ and 0.0346mg HAc/mg $VSS_{destroyed}$. For the period of experiments alkalinity and pH were properly maintained without artificial adjusting.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.1288-1291
• /
• 2004

In this study, physical characteristics of alumina slurry on variation of pH value and the effect of non-ionic surfactants on alumina slurry for copper chemical mechanical planarization (CMP) slurry have been investigated. After pH value of the slurry with alumina abrasive was changed by adding various amount of $HNO^3$ or KOH, the differences of settling rate, particle size, and zeta-potential were estimated. Better settling rates were shown in slurries with alumina abrasive at near pH 1. Higher zeta-potential was shown at around pH 2 in alumina slurry and the point of zero charge (PZC) was measured at about pH $9\sim10$. Non-ionic surfactant was added in the slurry with 5wt% alumina abrasive to get its effect on slurry practically. Abrasive size was smaller increased when amount of surfactant increased in slurry with P-4 as abrasive; on the other side, it was smaller when amount of surfactant decreased with AES-12. Variation of zeta-potential has no tendency with adding surfactant; however, values of zeta-potential were between $35\sim50mV$. The proper amount of surfactant was $0.1\sim1.0wt%$ in slurry with P-4 and $0.5\sim1.0wt%$ in slurry with AES-12 respectively. Excellent dispersion stabilization was obtained by addition of non-ionic surfactant

• KSBB Journal
• /
• v.6 no.3
• /
• pp.299-307
• /
• 1991

In this paper the effect of light on non-aerated Baker's Yeast(Saccharomyces cereuisiae) production and the protein excretion to the extracellular fluid is studied. Previous results in our laboratory indicate that at pH=5 and T-32$^{\circ}C$ yeast may be affected by light, but those differences seem to be within statistical variation of the data. In this paper, cell and extracellular protein concentrations along with redox potential are monitored for batch fermentations in the presence and absence of light at pH levels of 3 and 5 and at 31$^{\circ}C$, in order to explore whether possible light effects can be more readily discerned at lower pH values. Yeast particle size distributions are also determined over the course of fermentation using a particle counter in order to add one more measuring tool to our usual cell and total protein measurements. An apparently noticeable difference in the redox potential is observed between the light and the dark runs for early times for the pH=3 runs. The particle size distributions show differences in the particle diameters between light and dark runs at pH=3, but those differences fall within one standard deviation of the mean particle diameters.

• Journal of Ginseng Research
• /
• v.6 no.1
• /
• pp.25-29
• /
• 1982

This investigation was carried out to study the influence of pH and heat treatment on the ginsenosides in the white ginseng extract. Changes in ginsenosides (Rb1, Rb2, ,Rc, Rd) and free sugar were measured by the peak area variation of HPLC chromatogram during 25 hours heat treatment at the various level of pH. It was found that :(1) The peak areas of Rb1. Rb2, Rc and Rd on the HPLC chromatogram were decreased remarkably below pH 4.0 and more decrease was found as the temperature and heating time increased. (2) Those of glucose and arabinose were increased remarkably. It is considrered that the increase of glucose and the formation of arabinose result from the hydrolysis of ginsenoside( Rb1, Rb2, Rc, Rd) linked with sugars.

• Applied Chemistry for Engineering
• /
• v.1 no.2
• /
• pp.154-160
• /
• 1990

Hydroxypropyl methacrylate polymeric membranes having tertiary amine moiety were prepared to control the release rate of insulin in response to the concentration of glucose. Hydroxypropyl methacrylate was copolymerized with N, N'-diethylaminoethylacrylate. Its water content was increased with decreasing the pH of the medium and was reversible with variation of the pH of the medium. The permeation coefficient of insulin through copolymer membrane was also increased with decreasing the pH of the medium. Combining this copolymer membrane and the glucose oxidase immobilized membrane as a sensor for glucose, composite membrane was prepared. The permeability of this composite membrane was increased with addition of glucose.

• Journal of Welding and Joining
• /
• v.17 no.3
• /
• pp.66-70
• /
• 1999

In order to investigate the quantitative behavior of galvanic corrosion in weld joints between stainless std이 and carbon steel, electrochemical polarization experiments were performed at pH4, pH7 and pH10 with boric acid concentration 4000ppm, and water temperature were selected as $35^{\circ}$C and $60^{\circ}$C. As the results, the galvanic corrosion phenomena of carbon steel weld material at $60^{\circ}$C was revealed $2{1\over2}$ times higher corrosion rate than that at $35^{\circ}$C condition. The corrosion rate of stainless steel was almost inedependent of the variation of pH. The significant corrosion rates of carbon steel and the weld joint of carbon-carbon steel were observed at pH 4.