• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.22 no.6
• /
• pp.397-404
• /
• 2010

Laboratory tests of wave overtopping rates for a rubble mound breakwaters armoured Tetrapod were carried out, with varying design waves, crest berm widths and crest freeboards. The objective of this study is to investigate overtopping performance and to examine the characteristics of the widely used overtopping prediction models through the results of laboratory tests. Laboratory tests show that structure slope and wave periods have a considerable influence on overtopping rates, but the difference of overtopping rates related to crest berm widths is slight. Owen(1980)'s prediction considerably overestimates compared to the measured valued. Prediction of Van der Meer et al.(1998) underestimates only for steep slope($cot{\alpha}$=1.5). Besley(1999)'s and Pedersen(1996)'s predictions have a relatively good agreement with the measured results for slopes with a broader crest berm width. In general, best agreement between measured and predicted overtopping rates is observed using modified Pedersen(1996)'s formula for all test conditions.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.1
• /
• pp.1-6
• /
• 2016

The effect of reducing wave overtopping by use of the wave return wall was quantitatively analyzed based on physical experiments. The overtopping discharge for the arc seawall and the inclined seawall was measured and compared with the predictive formula that estimates reduction of overtopping by the wave return wall. When the overtopping discharge was relatively large ($q/{\sqrt{gH^3_s}}>10^{-3}$), the agreement in terms of overtopping reduction rate was fairly good between the prediction and the measurement. For the condition of smaller overtopping than the above criterion, however, the discrepancy was large between the predicted and measured result. In this context, it is required to develop a better formula for estimating reduction of wave overtopping by the wave return wall.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.66 no.5
• /
• pp.41-50
• /
• 2024

An increasing pattern of extreme rainfall recently affected the rural infrastructures with catastrophic damage, especially the overtopping of a fill dam embankment in the Republic of Korea. The overtopping was caused by the sudden increase in reservoir water level over the dam crest level, and it was not easy work to predict a priori because of its non-linear behavior. Fuzzy time series (FTS) is a fuzzy-logic inference procedure and is suited to apply to non-linear prediction methods such as machine learning. This study used the Wangshin reservoir and Goesan-dam cases, which experienced overtopping in 2023 and 2022, respectively. Wangshin Reservoir was a typical agricultural fill dam and needed to stack more available data, with only the daily storage rate (water level) of 7 years, starting on 2 May 2016. Therefore, we used Goesan-dam data to select appropriate variables and compare the analysis result, which was stacked with about 17 years of records. The analyses adapted LSTM to compare with FTS. As a result, the reservoir water level was applied to predict the overtopping water level, and it was shown that the FTS method could predict the actual water levels effectively according to the result of comparison with LSTM. Then, the FTS method was expected to predict reservoir water level a priori to make appropriate countermeasures on overtopping events as one of the alternatives.

• Journal of Ocean Engineering and Technology
• /
• v.22 no.1
• /
• pp.1-5
• /
• 2008

A 2-D Fluent-based numerical wave tank(FBNWT) capable of simulating wave propagating and overtopping is presented. The FBNWT model is based on the Reynolds averaged Naiver-Stokes equations and VOF free surface tracking method. The piston wave maker system is realized by dynamic mesh technology(DMT) and user defined function(UDF). The non-iteration time advancement(NITA) PISO algorithm is employed for the velocity and pressure coupling. The FBNWT numerical solutions of linear wave propagation have been validated by analytical solutions. Several overtopping problems are simulated and the prediction results show good agreements with the experimental data, which demonstrates that the present model can be utilized in the corresponding analysis.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.11 no.1
• /
• pp.35-41
• /
• 2008

Overtopping wave energy convertor is an offshore wave energy convertor for collecting the overtopping waves converting the water pressure head into electric power through the hydro turbines. This paper presents a numerical wave tank based on the commercial CFD code Fluent. The Reynolds Averaged Naiver-Stokes and VOF model is utilized to generate the 2D numerical linear propagating waves, which has been validated by the analytical solutions. Several incident wave conditions and shape parameters are calculated in the optimal designing investigation of the overtopping characteristics and discharge for the overtopping wave energy convertor.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.196-196
• /
• 2016

Landslide dam failure presents as a severe natural disaster due to its adverse impact to people and property. If the landslide dams failed, the discharge of a huge volume of both water and sediment could result in a catastrophic flood in the downstream area. In most of previous studies, breaching process used to be considered as a constructed dam, rather than as a landslide dam. Their erosion rate was assumed to relate to discharge by a sediment transport equation. However, during surface erosion of landslide dam, the sediment transportation regime is greatly dependent on the slope surface and the sediment concentration in the flow. This study aims to accurately simulate the outflow hydrograph caused by landslide dam by overtopping through a 2D surface flow erosion/deposition model. The lateral erosion velocity in this model was presented as a function of the shear stress on the side wall. The simulated results were then compared and it was coherent with the results obtained from the experiments.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.52 no.6
• /
• pp.63-73
• /
• 2010

This study is to develop a downstream flood damage prediction model for efficient confrontation in case of extreme and flash flood by future probable small agricultural dam break situation. For a Changri reservoir (0.419 million $m^3$) located in Yongin city of Gyeonggi province, a dam break scenario was prepared. With the probable maximum flood (PMF) condition calculated from the probable maximum precipitation (PMP), the flood condition by dam break was generated by using the HEC-HMS (Hydrologic Engineering Center - Hydrologic Modeling System) model. The flood propagation to the 1.12 km section of Hwagok downstream was simulated using HEC-RAS (Hydrologic Engineering Center - River Analysis System) model. The flood damaged areas were generated by overtopping from the levees and the boundaries were extracted for flood damage prediction, and the degree of flood damage was evaluated using IDEM (Inundation Damage Estimation Method) by modifying MD-FDA (Multi-Dimensional Flood Damage Analysis) and regression analysis simple method. The result of flood analysis by dam-break was predicted to occurred flood depth of 0.4m in interior floodplain by overtopping under PMF scenario, and maximum flood depth was predicted up to 1.1 m. Moreover, for the downstream of the Changri reservoir, the total amount of the maximum flood damage by dam-break was calculated nearly 1.2 billion won by IDEM.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.2
• /
• pp.113-128
• /
• 1990

In recent years, various types of coastal protection scheme have been studied around the coastal region. Among them, so-called zonal protection systems are being watched with interest from various points of view. In this paper, wave overtopping rate from overflowing the vertical seawall is investigated by conducting two dimensional model on the horizontal bed experiment. Hereafter this system is referred to as a artificial reef system. One is the foundation to control wave height near the surfzone and the other is function to prevent coastal disaster by suppressing net overtopping rate. The main results obtained in this study are summarized as follows. 1) Wave attenuation taken place on the artificial reef can be predicted numerically by using energy dispersion model due to wave breaking proposed by Battjes. 2) To evaluate the wave overtopping rate from a vertical seadike on various coastal constructions by weir model, a numerical procedure for prediction of overtopping is confirmed.

• Ecology and Resilient Infrastructure
• /
• v.7 no.3
• /
• pp.218-226
• /
• 2020

This study investigated that the numerical experiment for analysis on free overtopping flow by a weir of levee type, as the first stage of the development of a numerical technique for prediction methodology based on a numerical model. Using 2-dimensional flow models, Nays2DH, we conducted numerical simulations based on existing experimental data to compare and verify the models. We firstly discussed the numerical reproducibility for the discontinued flow by weir shape, and calibrated the computational flow through preprocessing of channel bed. Further, we carried out and compared the simulations for prediction on the overtopping flow by the number of weir gates. As a result of simulations, we found that the maximum flow velocity of downstream of weir increases when the number of weir gates increases under the same cross sectional area of flow. Through such results, this study could present basic data for hydraulic research to consider the water flow and sediment transport depending on weir operation in the future work.

• Geomechanics and Engineering
• /
• v.31 no.6
• /
• pp.637-651
• /
• 2022

The seismic design of embankment dams requires more comprehensive studies to understand the behaviour of dams. Deformations primarily control this behaviour occur during or after earthquake loading. Dam failures and incidents show that the impacts of deformations should be reviewed for existing and new embankment dams. Overtopping erosion failure can occur if crest deformations exceed the freeboard at the time of the deformations. Therefore, crest settlement is one of the most critical deformations. This study developed empirical formulas using Gene Expression Programming (GEP) based on 88 cases. In the analyses, dam height (H_d), alluvium thickness (H_a), the magnitude-acceleration-factor (MAF) values developed based on earthquake magnitude (Mw) and peak ground acceleration (PGA) within this study have been chosen as variables. Results show that GEP models developed in the paper are remarkably robust and accessible tools to predict earthquake-induced crest settlement of embankment dams and perform superior to the existing formulation. Also, dam engineering professionals can use them practically because the variables of prediction equations are easily accessible after the earthquake.