• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.165.2-165.2
• /
• 2011

Flow with suction to water turbine must be in stable state at small hydraulic power plant. But because of water level fluctuation and water gate effect according to irregular supply of cooling water, it would happen to produce bubble and vortex and finally lead to problems in power-plant system. With utilizing the concept design of double size gate, surface water overflowed the overhead of gate for stable flow at suction. We developed the overflow condition and analyzed the design factor with existed one such as water level(overflow amount) and overhead of water gate(overflow figure). Flow test and CFD simulation say that flow have stable state around suction and 20% of wave reduction effect at surface layer after surface water overflow.

• Proceedings of the KIEE Conference
• /
• 1999.07e
• /
• pp.2143-2145
• /
• 1999

Measurements of wind noise, generated by High-voltage overhead transmission lines placed in a uniform flow are carried out in the Anechoic windtunnel. High-voltage overhead transmission lines generates audible wind noise, which cause a serious environment problem. Accordingly, wind noise has become one of major concerns for design engineers and operations personnel. In the present research, tests were mainly performed with various configuration of transmission line with spiral wires. Remarkable noise reduction was observed for some of the spiral transmission lines, compared with the noise generated without the spiral wire.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.11
• /
• pp.5304-5322
• /
• 2018

Since designing a feedback topology is a practical way to implement interference alignment at reduced cost of channel state information (CSI) feedback, six feedback topologies have been presented in prior works for a K-user multiple-input multiple-output interference channel. To fully reveal the potential benefits of the feedback topology in terms of the saving of CSI overhead, we propose a new feedback topology in this paper. By efficiently performing dimensionality-decreasing at the transmitter side and aligning interference signals at a subset of receivers, we show that the proposed feedback topology obtains substantial reduction of feedback cost over the existing six feedback designs under the same antenna configuration.

• Journal of Bio-Environment Control
• /
• v.15 no.2
• /
• pp.156-161
• /
• 2006

Overhead and sub-irrigation of deep sea water to tomato seedlings reduced the height as 50% and 58% than control plants. In the same treatment with surface sea water and NaCl water, the reduced rate in tomato seedlings' height were 49% and 56% in overhead irrigation, and 47% and 57% in sub-irrigation, respectively. Most effective method for the inhibition of the growth of the seedling was sub-irrigation method, which supplied water through the roots. No significant difference was observed on fresh weight of the upper part of tomato and cucumber seedlings, though the sub-irrigation reduced the fresh weight than the overhead irrigation. The reduced rate of fresh weight of seedlings by overhead irrigation was by 38% and sub-irrigation by 49% as compared to control. Similarly dry weight of upper and under soil parts of seedlings showed same trend of results thereof as fresh weight. This result can be traced to reduction of growth caused by salts in the water. In stem diameter of seedlings no significant difference was observed between two irrigation methods, even though both deep sea and NaCl water reduced stem diameter, as compared to control water. Overhead irrigation can be chosen by seedling producers because of better seedling quality by using TH ratio. Seedling compactness were not noticed in both the overhead and sub-irrigation. Sub-irrigation was found more effective method far the inhibition of height and compactness of tomato seedlings. Higher the concentration of NaCl, deep sea, and surface sea water, lesser the growth in height, fresh and dry weight, stem diameter, and leaf area was obtained. No significant difference was found, though sub-irrigation suppress the growth of seedlings.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.11
• /
• pp.61-68
• /
• 2004

Today almost all chips have IEEE 1149.1 tap controller inside. Recently the circuit is embedded in the chips for other functional objectives. Hence a CED technique for testing and monitoring the IEEE 1149.1 tap controller had been proposed. This paper studies the optimal CED test technique on the IEEE 1149.1 tap controller. There are duplication, parity prediction, and hybrid techniques. The hybrid technique shows the best result on the area overhead. This means that the hybrid technique is perfectly adequate for the IEEE 1149.1 tap controller to be applied to test with the optimal area overhead and can be used widely in the field. Furthermore, we made more reduction from the previous method resulting in less area overhead.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.14 no.2
• /
• pp.87-96
• /
• 2019

Low power issue is one of the most critical problems in the Internet of Things (IoT), which are powered by battery. To solve this problem, various approaches have been presented so far. In this paper, we propose a method to reduce the power consumption by reducing the numbers of accesses into the flash memory consuming a large amount of power for on-chip software execution. Our approach is based on using cooperative logging structure to distribute the sampling overhead in single sensor node to adjacent nodes in case of rare-event applications. The proposed algorithm to identify event occurrence is newly introduced with negative feedback method by observing difference between past data and recent data coming from the sensor. When an event with need of flash access is determined, the proposed approach only allows access to write the sampled data in flash memory. The proposed event detection algorithm (EDA) result in 30% reduction of power consumption compared to the conventional flash write scheme for all cases of event. The sampled data from the sensor is first traced into the random access memory (RAM), and write access to the flash memory is delayed until the page buffer of the on-chip flash memory controller in the micro controller unit (MCU) is full of the numbers of the traced data, thereby reducing the frequency of accessing flash memory. This technique additionally reduces power consumption by 40% compared to flash-write all data. By sharing the sampling information via LoRa channel, the overhead in sampling data is distributed, to reduce the sampling load on each node, so that the 66% reduction of total power consumption is achieved in several IoT edge nodes by removing the sampling operation of duplicated data.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.2 s.332
• /
• pp.73-82
• /
• 2005

Test data volume and power consumption for scan vectors are two major problems in system-on-a-chip testing. Therefore, this paper proposes a new test data compression/decompression method for low power testing. The method is based on analyzing the factors that influence test parameters: compression ratio, power reduction and hardware overhead. To improve the compression ratio and the power reduction ratio, the proposed method is based on Modified Statistical Coding (MSC), Input Reduction (IR) scheme and the algorithms of reordering scan flip-flops and reordering test pattern sequence in a preprocessing step. Unlike previous approaches using the CSR architecture, the proposed method is to compress original test data, not $T_{diff}$, and decompress the compressed test data without the CSR architecture. Therefore, the proposed method leads to better compression ratio with lower hardware overhead and lower power consumption than previous works. An experimental comparison on ISCAS '89 benchmark circuits validates the proposed method.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.14 no.6
• /
• pp.6-9
• /
• 1977

A general purpose language is defined and a computer architecture suitable for this language is proposed. The proposed architecture utilities the microprogramming technique. The significant features of the proposed architecture are the reduction of the overhead in micro-module swapping and graceful degradation of the execution upon detection of the micro.module fault in the time-sharing environment.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2006.07a
• /
• pp.539-539
• /
• 2006

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.477-480
• /
• 2003

Packet losses in the Internet can dramatically degrade quality of multimedia streams. Forward Error Correction (FEC) is one of the best methods that can protect data from packet erasures by means of sending additional redundant information. Proposed control algorithm provides the possibility of receiving real-time multimedia streams of given quality wifth minimal traffic overhead. The traffic optimization is reached by adjusting packet size as well as block code parameters. Calculations and simulation results show that for non-bursty network conditions traffic optimization can lead to more than 50% bandwidth reduction.