• 전력전자학회논문지
• /
• 제10권2호
• /
• pp.117-123
• /
• 2005

LC출력필터는 동적전압보상기(DVR)의 인버터 스위칭에 따른 전압리플을 억제하는 반면에, 전압제어 밴드폭에 제한을 가져온다. 이러한 두 조건을 만족시키기 위한 LC출력펄터의 컷오프 주파수 설계에 대하여는 지금까지 많은 연구가 이루어져 왔다. 그러나 적절히 설계 되어진 필터의 컷오프 주파수에 대하여 무한히 많은 수의 L-C 조합이 가능하며 그에 따라 서로 다른 특성이 나타나지만, 지금까지 분명한 해석적인 기초가 없이 현장의 경험에 의존한 설계를 하여 왔다. 본 논문은 DVR의 크기를 최소화 하면서 우수한 제어성능을 유지할 수 있는 LC출력필터의 설계 방법을 제안한다. 제안된 LC출력필터의 설계에 기초한 DVR 시스템을 구성하여 실험에 의하여 이론을 증명한다.

• 조명전기설비학회논문지
• /
• 제16권6호
• /
• pp.60-65
• /
• 2002

본 연구의 목적은 헬륨의 순도가 셀레늄증기 레이저에서의 출력특성과 광이득에 미치는 영향을 측정, 비교해보는 것이다. 헬륨의 순도는 특수 헬륨필터로써 개선하였다. 본 측정에서는 개개의 선들이 복굴절필터에 의해서 선택 되어졌다. 대부분의 선들이 헬륨필터를 사용한 레이저에서 더 높은 output-coupling 출력과 소신호 이득을 보여 주고, 특히 강력한 선들(497.6 nm, 499.3 nm, 506.9 nm, 517.6 nm, 522.8 nm, 530.5 nm)과 청색선(460.4 nm, 464.8 nm)및 적색선(644.4 nm, 649.1 nm)에서 현저히 더 높은 값을 보여 준다.

• 한국멀티미디어학회논문지
• /
• 제7권12호
• /
• pp.1650-1656
• /
• 2004

In this paper, a multi-adaptive filter is proposed for removing EOG and the 60 Hz power supply noise from EEG measured in the frontal lobe and the feedback output control method is implemented for biofeedback. The multi-adaptive filter has been implemented on the TMS320C6711 DSP system and the feedback output control algorithm has been realized by calculating the ratio of alpha wave on the TMS320C31 DSP system with real time performance. Through the experiment using the implemented multi-adaptive filter and feedback output controller, we demonstrate that the proposed adaptive filter effectively removes EOG and the 60 Hz power supply noise from the measured EEG in the frontal lobe and the feedback algorithm controls the level of stimulation by the ratio of the alpha wave.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 추계학술대회 논문집 학회본부
• /
• pp.296-298
• /
• 1995

This paper proposes a new filter topology that suppresses the high voltage gradient(dv/dt) in ac motor terminals. The high voltage gradient(dv/dt) causes over voltages on the motor windings, the degradation or motor insulation, and the bearing failure. Moreover surge voltage with high voltage gradient(dv/dt) in the PWM inverter red drive system where long line cables are required causes more serious problem to the motor. Thus, the most advisable method is attaching output filter to the inverter output terminals. The conventional output filters have several problems such as bulky size, difficulty or parameter tuning. The proposed filter can be relatively smaller than the conventional filters. By the proposed filter, the shaping or PWM waveform can considerably suppress high dv/dt in motor feeding cable from the inverter. The effectiveness or the proposed filter is compared with that or the conventional one and is verified by the computer simulation.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제50권7호
• /
• pp.347-355
• /
• 2001

The conventional output filter design methods of a voltage source inverter includes two main problems: the performance is not sure to satisfy the specification under the nonlinear load; the designed filter must be occasionally modified when the controller is designed. In this paper, we analyze the relation between both linear and nonlinear loads, the output voltage magnitude, LC lowpass filter parameters, and the control response time. Upon the basis, both filter and controller are simultaneously designed for the performance to satisfy the specification under the nonlinear load as well as linear load. The proposed method sharply enhances the reliability of the performance. P.U is used for the method to be applied to all the quantities of the system. The simulation and the experiment of the proposed method carried out respectively to verify the validity.

• Journal of Power Electronics
• /
• 제11권1호
• /
• pp.74-81
• /
• 2011

The cutoff frequency of the output LC filters of PWM inverters limits the control bandwidth of the converter system while it attenuates voltage ripples that are caused by inverter switching activities. For a selected cutoff frequency of an output LC filter, an infinite number of L-C combinations is possible. This paper analyses the characteristics of output LC filters for PWM inverters terms of the L-C combinations. Practical circuit conditions such as no-loads, full resistive-loads, and inductive-load conditions are considered in the analysis. This paper proposes a LC filter design method for PWM inverters considering both the voltage ynamics and he inverter stack size. An experimental PWM inverter system based on the proposed output LC lter design uideline is built and tested.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2005년도 전력전자학술대회 논문집
• /
• pp.106-108
• /
• 2005

High accuracy and stability digital controlled power supply for magnet is developed at PLS. This power supply has three sections. The first section is digital controller including DSP&FPGA and precision ADC, the second section consists of IGBT driver and four quad IGBT switch, and the third section is LC output filter section. AC input voltage of power supply is 3-phase 21V, output current is 0 ${\sim}$ 150 A dc. Switching frequency of four quad IGBT switch is 25 kHz. The output current of power supply has very high accuracy of 100 A step resolution at full range and the stability of +/- 1.5 ppm for short term and +/- 5 ppm for long term. This paper describes characteristics of filter and output current performance improvement after LC output filter at four quad digital power supplies.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.761-767
• /
• 2001

In this paper, filtering techniques to reduce the adverse effects of motor leads on high-frequency PWM inverter fed AC motor drives will be examined. The filter was designed to keep the motor terminal from the cable surge impedance to reduce overvoltage reflections, ringing, and the dv/dt, di/dt. Therefore, filtering techniques are investigated to reduce the motor terminal overvoltage, ringing, and EMI noise in inverter fed ac motor drive systems. The output filter is used to limit the rate of the inverter output voltage and reduce EMI(common mode noise) to the motor. The performance of the output filter is evaluated through simulations (PSIM) and experiment on PWM inverter-fed ac motor drive(3phase, 3hp(2.2kw), input voltage 220/380V, induction motor). An experimental PWM drive system reduction of conducted EMI was implemented on an available TMS320C31 microprocessor control board. Finally, experimental results showed that the inverter output filter reduces more CM noise than the LPF(low pass filter) and reduce overvoltage and ringing at the motor terminal.

• 전력전자학회논문지
• /
• 제6권6호
• /
• pp.546-555
• /
• 2001

본 논문에서는 PWM 인버터-유도전동기 구동시스템의 전도노이즈 저감을 위한 출력필터 설계에 관한 연구를 수행하였다. 전도노이즈는 고전압 입력, 고용량 구동시스템 그리고 긴 전동기 터미널 등의경우에서 크게 문제가 된다. 고압력을 갖는 시스템에서는 높은 압력에 비례한 직류 링크 전압을 갖고 이에 따라 스위칭 dv/dt가 순간 최대 CM 접지전류를 발생시킨다. 그러므로 이에 대한 대책이 필요하다. 따라서 최근 산업 현장에서 많이 사용되고 있는 PWM 인버터를 설계 제작하여 유도전동기를 구동하고 이에 따라 발생되는 전도노이즈 성분을 감쇠 시킬 수 있는 출력필터를 설계하였고 제작 및 실험을 통하여 그 타당성을 입증하였다.

• 산업기술연구
• /
• 제25권B호
• /
• pp.195-202
• /
• 2005

The rectifier characteristics and the quality of the input current worsens with the increase of unbalances or harmonics of the supply voltages. Rectifier input current harmonics interfere with proper power system operation, reduce rectifier power factor, and limit the power available from a given source. It is of importance to select appropriately the rectifier's output filter inductance to determine the rectifier input current waveform, the input current harmonics, and the power factor. This paper presents a quantitative analysis of single and three phase rectifier input current harmonics, total harmonic distortion, and power factor as a function of the output filter inductance under balanced and unbalanced conditions. Also, its performance under the supply voltage including harmonics be investigated. These results provide a reference for selecting reasonable rectifier's output filter inductance for given harmonics or power factor criterion.