• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.1
• /
• pp.166-172
• /
• 2001

A RF wideband receiver for INMARSAT-B satellite communications system was composed of low noise amplifier and high gain amplifier, The low noise amplifier used to the resistive decoupling circuit for input impedance matching and self-bias circuits for low noise. The high gain amplifier consists of matched amplifier type to improve receiver gain. The active bias circuit can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilization resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 60 dB in gain and less than 1.8:1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio which is input signal level -126.7 dB m at 1537.5 MHz is a 45.23 dB /Hz at a 1.02 kHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.5
• /
• pp.1120-1128
• /
• 2004

In this paper, we has designed and implemented Up-converter for K-band with high IMD3 performance using balanced power amplifier. It is consisted of PA module and, Local Oscillator module with reject Filter, mixer module and If block, and Up-converter has a local loop path to decide whether it operate or not and has the sensing port to inspect output power level. According to the power budget of designed Up-converter, K-band balanced power amplifier was fabricated by commercial MMIC. Measurement results of up-converter show about 40dB Gain, PldB of 29dBm and OIP3 was 38.25dBm, that is good performance compared to power budgets. We has adjusted gate voltage of MMIC to control more than 30 dB gain. This up-converter was used in transceiver for PTP and PTMP, and applied to digital communication system that use QAM and QPSK modulation.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.10 no.5
• /
• pp.508-517
• /
• 2005

This paper describes a high performance voltage controller for 3-phase 4-wire UPS (Uninterruptible Power Supply) system, and proposes a new scheme of synchronous reference frame controller in order to compensate for the voltage distortions due to unbalanced and nonlinear loads. Proposed scheme can eliminate the negative sequence voltage component due to unbalanced loads and also reduce the harmonic voltage component due to non-linear loads, even when the bandwidth of voltage control loop is a very low. In order to compensate for the effects of unbalanced loads, the synchronous reference frame controller with the positive and negative sequence computation block is proposed, and the synchronous frame controller with a bandpass filter is proposed to compensate for the selected harmonic frequency of output voltage. The effectiveness of the proposed scheme has been investigated and verified through computer simulations and experiments by a 30kVA UPS.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.6
• /
• pp.1095-1106
• /
• 1994

This paper presents a method for determining optimal grayscale function processing(FP) morphological filters under the least square (LMS) error criterion. The optimal erosion and dilation filters with a grayscale structuring element(GSE) are determined by minimizing the mean square error (MSE) between the desired signal and the filter output. It is shown that convergence of the erosion and dilation filters can be achieved by a proper choice of the step size parameter of the LMS algorithm. In an attempt to determine optimal closing and opening filters, a matrix representation of both opening and closing with a basis matrix is proposed. With this representation, opening and closing are accomplished by a local matrix operation rather than cascade operations. The LMS and back-propagation algorithm are utilzed for obtaining the optimal basis matrix for closing and opening. Some results of optimal morphological filters applied to 2-D images are presented.

• Korean Journal of Optics and Photonics
• /
• v.15 no.1
• /
• pp.17-21
• /
• 2004

We demonstrate an S/S＋band discretely tunable thulium doped fiber laser (TTDFL), anchored on a 50-㎓ ITU-T grid. Investigating the inversion analysis of the thulium doped fiber (TDF) in applying a dual wavelength (1.4 m and 1.5 m) pumping scheme, a laser whose tuning range covers most of the S/S＋band has been obtained. Within the wide 3-㏈ bandwidth of 65.1 nm, the output power of the tunable laser exceeds 6.1 ㏈m with very flat spectral profile and the number of DWDM channels generated is as large as 178. If we increase the subsidiary pump power to 22 ㎽, the bandwidth is expanded up to 66.2 nm. By controlling the temperature of the fine grid filter, we have also shown that the frequency locking capability of the laser can be improved. The laser developed in this work is expected to be utilized as a practical optical source providing reference wavelengths in the S/S＋band.

• Journal of the Optical Society of Korea
• /
• v.15 no.3
• /
• pp.293-299
• /
• 2011

In this study, we demonstrated Fourier-domain/swept-source optical coherence tomography (FD/SS-OCT) at a center wavelength of 800 nm for in vivo human retinal imaging. A wavelength-swept source was constructed with a semiconductor optical amplifier, a fiber Fabry-Perot tunable filter, isolators, and a fiber coupler in a ring cavity. Our swept source produced a laser output with a tuning range of 42 nm (779 to 821 nm) and an average power of 3.9 mW. The wavelength-swept speed in this configuration with bidirectionality is 2,000 axial scans per second. In addition, we suggested a modified zero-crossing method to achieve equal sample spacing in the wavenumber (k) domain and to increase the image depth range. FD/SS-OCT has a sensitivity of ~89.7 dB and an axial resolution of 10.4 ${\mu}m$ in air. When a retinal image with 2,000 A-lines/frame is obtained, an acquisition speed of 2.0 fps is achieved.

• The Journal of the Acoustical Society of Korea
• /
• v.14 no.2
• /
• pp.40-49
• /
• 1995

Application of the filtered-x LMS adaptive filter to active noise cancellation requires to estimate the transfer charactersitics between the output and the error signal of the adaptive canceler. In this paper, we derive the filtered-x adaptive noise cancellation algorithm and analyze its convergence behavior when the acoustic noise consists of multiple sinusoids. The results of the convergence analysis of the filtered-x LMS algorithm indicate that the effects of the parameter estimation inaccuracy on the convergence behavior of the algorithm are characterized by two distinct components : Phase estimation error and estimated gain. In particular, the convergence is shown to strongly affected by the accuracy of the phase response estimate. Simulation results are presented to support the theoretical convergence analysis.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.37 no.1
• /
• pp.59-68
• /
• 2000

This paper proposes efficient VLSI architectures for computation of the 2- D discrete wavelet transform (DWT). The two proposed VLSI architectures for the 2- D DWT are constructed based on block-based computation Each $M{\times}N$ ($N{\times}M$) block DWT is performed along the row (column) direction simultaneously, where M and N denote the number of filter taps and the number of columns (rows), respectively The proposed architectures compute the lowpass and highpass output sequences of the 1 - DWT along the row and column directions using a single architecture In alternate clock cycles Therefore the extra processing units required for the proposed architectures are much smaller than those of the conventional architectures They are modeled In very high speed Integrated circuit hardware description language (HIDL) and Simulated to show their functional validity.

• 전자공학회논문지 IE
• /
• v.44 no.4
• /
• pp.1-10
• /
• 2007

In this thesis, we study the implementation of hands-free phone in a car, taking acoustic echo canceller, in order to remove acoustic echo effectively. Conventional coustic echo canceller used for only adaptive filtering has much difficulty to solve both echo and double-talk problem. To tackle this problem, we propose acoustic echo canceller consisting of adaptive filter using a modified NLMS, VAD to catch exact voice activity duration using two independent forgetting factors, double-talk detector to detect fast and precise double talk duration using cross-correlation between microphone signal and residual echo, and output controller using VAD and double-talk detector. The proposed hands-free phone taking acoustic echo canceller shows the performance that has not acoustic echo and guarantees full duplex.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.157-165
• /
• 2013

In this paper, efficient digit-serial VLSI architecture for 1D (9,7) lifting-based discrete wavelet transform (DWT) filter has been proposed. The proposed architecture computes the DWT in digit basis, so that the required hardware is reduced. Also, the multiplication is replaced with the shift and add operation to minimize the hardware requirement. Bit allocation for input, output, and the internal data has been determined by analyzing the PSNR. We have carefully designed the data feedback latency not to degrade the performance in the recursive folded scheduling. The proposed digit-serial architecture requires small amount of hardware but achieve 100% of hardware utilization, so we try to optimize the tradeoffs between the hardware cost and the performance. The proposed architecture has been designed and verified by VerilogHDL and synthesized by Synopsys Design Compiler with a DongbuHitek $0.18{\mu}m$ STD cell library. The maximum operating frequency is 330MHz with 3,770 gates in equivalent two input NAND gates.