• Proceedings of the KIEE Conference
• /
• 2000.07b
• /
• pp.1300-1302
• /
• 2000

In the charge system, a contact type-convenient-charging method is insufficient because of the contact failure around moist environment and troublesome question to put in and pull out. For the solution of this problem, an electromagnetically coupled non-contact charger for the rechargeable cell is proposed using ZVS multi-resonant forward converter. In this paper magnetizing inductance, leakage inductance and coupling coefficient, k are observed. By using the obserbed value, the proposed circuit is simulated by the PSPICE and implemented and the peak voltage of switch and output power are measured.

• Proceedings of the IEEK Conference
• /
• 2000.07b
• /
• pp.1005-1008
• /
• 2000

This paper presents a simple method to estimate short-circuit power dissipation and propagation delay for static CMOS logic circuits. Short-circuit current expression is derived by accurately interpolating peak points of actual current curves which is influenced by the gate-to-drain coupling capacitance. The macro model and its expressions estimating the delay of CMOS circuits, which is based on the current modeling expression, are also proposed after investigating the voltage waveforms at transistor output modes. It is shown through simulations that the proposed technique yields better accuracy than previous methods when signal transition time and/or load capacitance decreases, which is a characteristic of the present technological evolution.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.5
• /
• pp.35-41
• /
• 1998

This paper presents a decoupling controller of the missile seeker scan loop with a spin-stabilized platform. A precise seeker motion with respect to the scan command is essential for the higher acquisition probability of the target. As the seeker scan loop is a deeply cross-coupled two input two output system, an accurate pointing or scanning for each axis to the target is very difficult, even though provided with the help of a high performance controller. When a decoupling control is applied to the seeker scan loop, the cross-coupling between two axes can be reduced to a remarkable amount. As a low order of controller is required for the real time operation, a PI controller with decoupling filter is suggested and compared with other controllers. A linearized dynamic model of seeker scan loop is used and validated through the comparison of experimental results of step responses.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.5
• /
• pp.98-104
• /
• 2009

In this paper, improved VCO(voltage controlled oscillator) with push-push structure and high impedance-inverter is designed and implemented. Two harmonic oscillators are combined into push-push structure. As a result, the fundamental suppression and the output power have been progressed. For the improved coupling characteristics between hair-pin resonator and two parallel microstrip line using high impedance inverter, the phase noise has been suppressed.

• Korean Journal of Optics and Photonics
• /
• v.4 no.1
• /
• pp.66-72
• /
• 1993

Additive-pulse mode-locking (APM) was performed in a $1.053{\mu}m$ cw Nd:YLF laser by coupling a nonlinear external external cavity to the main cavity. The APM pulsewidth was 4.5 ps and the average output power was 1.5 W. This APM pulse was compressed by an optical fiber and a grating pair to be as short as 210 fs with a peak power of 17 kW.

• 전기의세계
• /
• v.28 no.6
• /
• pp.61-77
• /
• 1979

This paper is concerned with minimization process of the binary logic function. This paper describes an algorithm called the SIMPLE TABLE METHOD that well suited to minimization a switching function of any number of variables. For the Simple Table construction, a theorem based upon the numerical properties of the logic function is derived from the relationships governing minterms of the given function. Finally the minimal sum of products can be obtained in terms of the Direct Method or the Indirect Method from the table and table characteristics derived from the Simple Table. The properties and table characteristics used in this paper are described. All the minterms of a switching function are manipulated only by decimal numbers, not binary numbers. Some examples are used as a vehicle to guide the readers who are familiar with the Karnaugh map and Quine-McCluskey tabular method to this New method. These examples not only treat how to handle Don't Care miterms but also show the multiple output functions.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.18 no.5
• /
• pp.485-491
• /
• 2013

A new passive lossless snubber for boost converter based on magnetic coupling is proposed. It is composed of a winding coupled with boost inductor, one snubber inductor, two snubber capacitor and three additional diodes. Especially, the snubber inductor can not only limit the reverse recovery current of output diode but also minimize switch turn-on losses greatly. Moreover, all of the energy stored in the snubber is transferred to the load in the manner of resonance. To confirm the validity of proposed system, theoretical analysis, design consideration, and verification of experimental results are presented.

• Proceedings of the KIEE Conference
• /
• 2003.11a
• /
• pp.327-330
• /
• 2003

This paper proposes an estimation algorithm for the generating power of distributed generations(DG) interconnected with distribution networks. These days, DG are rapidly increasing and most of them are interconnected with distribution networks. The DG can supply power into the distribution network, which may make significant impact on fault current and the protection scheme of the interconnected distribution networks. Generally these influences of DG is proportioned as the distributed generator's power. Therefore, it is important to forecast the output power of distributed generator in PCC(point of common coupling). This paper presents the prediction method of DG's power by monitoring the current and phase difference.

• Proceedings of the KIPE Conference
• /
• 2001.07a
• /
• pp.685-688
• /
• 2001

This paper proposes an SSSC based on multi-bridge inverters. The dynamic characteristic of the proposed SSSC was analyzed by EMTP simulation and a scaled handware model, assuming that the SSSC is inserted in the transmission line of the one-machine-infinite-bus power system. The proposed SSSC has 6 multi-bridge inverters per phase, which generates 13 pulses for each half period of power frequency. The proposed SSSC generates a quasi-simusoidal output voltage by 90 degree phase shift to the line current The proposed SSSC does not require the coupling transformer for voltage injection, and has a flexibility in operation voltage by increasing the number of series connection.

• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.351-352
• /
• 2015

This paper proposed a new control strategy for voltage source inverter (VSI) of effective fifth and seventh harmonic reduction in the point of common coupling (PCC) in islanded microgrid under nonlinear load without any additional hardware devices. The non-linear load regularly causes such harmonic distortion, which harmfully affect the performance of other loads or other distributed generation (DG) sources connect to the PCC. In order to improve the quality of delivered output voltage, these harmonic must be rejected. The proposed control strategy is developed based on the current controller formed by resonant controller parallel with a proportional integral controller, which perform on the fundamental reference frame. The reference current is estimated based on the voltage harmonic and the injecting power. The simulation and experimental results are shown to verify the effectiveness of proposed control method.