• Journal of Environmental Health Sciences
• /
• v.22 no.3
• /
• pp.116-122
• /
• 1996

This study has been focused on the applicability of microwave treatment of soil contaminated by volitile organic chemicals. Substrates studied were sand and sandy soil. These substrates were impregnated with toluene, tetrachloroethylene, o-xylene and p-dichlorobenzene. The microwave treatment was conducted in a modified domestic microwave oven: 2450 MHz, 700 W. The sandy soil temperature added water went up rapidly to about 130$\circ$C for 4 minutes. And then, the temperature appeared to plateau out. A series of tests were performed to depict the effectiveness of microwave treatment technique to organic contaminants from soils. Removal efficiencies in sandy soil and sand were increased with increasing water content and exposure time. Microwave radiation penetrates the soil and heats water throughout the matrix. Therefore, addition of a certain amount of water to the contaminated soil can efficiently enhance the ability of the soil to absorb microwave energy and promote the evaporation of the volitile contaminants. And the vapour pressure of impregnated organic contaminants becomes lower. the removal efficiency becomes poor.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.6
• /
• pp.144-152
• /
• 2003

Laboratory experiments were carried out to investigate the influence of pore water contamination on the treatment effect of sandy soil which was solidified by Portland cement. In the experiments, setting time of hydraulic cement that was mixed with contaminated mixing water was measured using Vicat equipment and observed the tendency of setting process with the kind of contaminants, organic or inorganic components. It was shown that organic contaminants of the mixing water affect largely on the initial setting process of hydraulic cement and inorganics, expecially heavy metals, did not affect on the initial setting process, otherwise it was appeared that setting time of the sandy soil that was contaminated with inorganic components was apparently faster than the sandy soil that did not include inorganic components even though organic concentrations was relatively low level (COD=200∼300) in the mixing water. The results of unconfined compression strength test (UCST) were well consistent with the results of Vicat equipment test.

• Geomechanics and Engineering
• /
• v.16 no.3
• /
• pp.247-255
• /
• 2018

Organic-sandy soils that contain abundant organic matters are widely encountered in estuarine cities. Due to the existence of organic matters, the strength and stiffness of this type of soil are significantly low. As a result, various geotechnical engineering problems such as difficulties in piling and constructing embankments and a lack of strength in poured concrete may occur in many estuarine sites; ground improvement such as cement treatment to this type of soils is needed. In this study, laboratory tests were performed to investigate the compressive strength of organic-sandy soil reinforced with primarily cement, in which the influences of several factors, namely types of cement and additional stabilizing agent, cement content, and water-cement ratio, were investigated and the orthogonal experimental design scheme was adopted. Based on the test results, an optimal permutation of these influencing factors is suggested for the reinforcement of organic-sandy soils, which can provide a useful reference for the relevant engineering practice.

• Korean Journal of Agricultural Science
• /
• v.41 no.4
• /
• pp.369-377
• /
• 2014

This study was carried out to evaluate the effect of rice husk (RHB) and food waste biochar (FWB) on upland soil with sandy loam texture, in terms of physico-chemical analysis, lettuce seed germination test, and orgainc carbon leaching experiment. RHB and FWB had different physico-chemical properties each other. Carbon to nitrogen ratio (C/N ratio) of RHB was 32, showing two times higher than that of FWB. FWB had high salt and heavy metal content, compared to RHB. This is probably due to different ingredients and production processing between two biochars each other. Results of germination test with Lettuce showed lower germination rate when FWB was applied because of higher salt concentration compared to control and RHB. Organic carbon leaching test using saturated soil column (${\Phi}75{\times}h75mm$) with $10MT\;ha^{-1}$ biochar application rate, showed higher saturated hydraulic conductivity in rice husk biochar treatment column, compared to control and food waste biochar treatment. The highest total organic carbon concentration in column effluent was lower than those in both of rice husk biochar and food waste biochar, whereas the differences was negligible after 9 pore volumes of effluent. Consequently, biochars from byproducts such as rice husk and food waste in sandy loam textured upland soil could enhance a buffer function such as reduction of leaching from soil, but the harmful ingredient to crops such as high salt and heavy metals could limit the agricultural use of biochars.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.04a
• /
• pp.125-130
• /
• 2004

This study has been assessed the influence of applying sewage sludge to soil amendments on the sorption properties, and leaching potential of three commonly used organophosphorus pesticides, Diazinon, Fenitrothion, and Chlorpyrifos. A sandy soil with a low content of organic carbon was treated with sewage sludge with a ratio sandy soil : sludge ratio of 30:1. The sorption was determined with the batch equilibrium technique. The sorption isotherms could be described by Freundlich equation. The Freundlich constant, K value which measures sorption capacity, were 3.97, 9.94, 22.48 for Diazinon, Fenitrothion, Chlorpyrifos in non-amended soil. But in amended soil, K value was 12.58, 28.47, and 61.21 for Diazinon, Fenitrothion, and Chlorpyrifos. The overall effect of sewage sludge addition to soil was to increase pesticides adsorption, due to the high sorption capacity of the organic matter. The effect of sludge on tile leaching of pesticides in the soil was studied using packed soil columns. Total recoveries of pesticides in soil and leachate with leaching in soil column, were in the range of about 73～84%, was reduced with the passage of time. Diazinon moved more rapidly than Chlorpyrifos in the unamended soil due to greater sorption and lower water solubility of Chlorpyrifos. Total amounts of pesticides leached from the sewage sludge amended soils were significantly reduced when compared with unamended soils. This reduction may be mainly due to and increase in sorption in amended soils, as a consequence of the increase in the organic matter content.

• Korean Journal of Soil Science and Fertilizer
• /
• v.19 no.1
• /
• pp.76-82
• /
• 1986

A laboratory experiment was conducted to find out the denitrification rate upon the levels of nitrogen and source of organic matter in submerged sandy and sandy loam soil. The results obtained were sumarized as follows; 1. Evolution of nitrous oxide was increased at 1st and 10 days after incubation. And dinitrogen was increased at 1st and 30 days after incubation. Applications of green manure was enhanced the evolution of nitrous oxide ($N_2O$) and dinitrogen ($N_2$). 2. The cumulative denitrification rates at 50 days was high in Gyuam sandy loam soil (O-M: 1.52%) than that of Hamchang sandy soil (O-M: 3.81%). On the other hand, the cumulative emission of dinitrogen was high in Gyuam sandy loam soil while nitrous oxide was high in Hamchang sandy soil. The total mount of denitrification rate was high in order of green manure > rice straw > compost > control soil. 3. Increases of fertilizer nitrogen was enhanced the rate of emission of dinitrogen and nitrous oxide during the incubation time. 4. According to Michaelis-Menten kinetic equation, denitrification rates and reaction efficiency were remarkably increased by application of readily decomposable organic matter with in higher organic matter content of soil. 5. The negative relationship was observed between the evolution of dinitrogen and carbon ($CO_2+CH_4$) while the nitrous oxide with carbon was positive. 6. Under the this experiment conditions 1 mg of carbon was required for production of 4 mg N as $N_2O$ and 3 mg of N as $N_2$, respectively.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.6
• /
• pp.751-760
• /
• 2015

Management of renewable organic resources is important in attaining the sustainability of agricultural production. However, nutrient management with organic resources is more complex than fertilization with chemical fertilizer because the composition of the organic input or the environmental condition will influence organic matter decomposition and nutrient release. One of the most effective methods for estimating nutrient release from organic amendment is the use of N mineralization models. The present study aimed at parameterizing N mineralization models for a number of organic amendments being used as a nutrient source for crop production. Laboratory incubation experiment was conducted in aerobic condition. N mineralization was investigated for nineteen organic amendments in sandy soil and clay soil at $20^{\circ}C$, $25^{\circ}C$, and $30^{\circ}C$. N mineralization was facilitated at higher temperature condition. Negative correlation was observed between mineralized N and C:N ratio of organic amendments. N mineralization process was slower in clay soil than in sandy soil and this was mainly due to the delayed nitrification. The single and the double exponential models were used to estimate N mineralization of the organic amendments. N mineralization potential $N_p$ and mineralization rate k were estimated in different temperature and soil conditions. Estimated $N_p$ ranged from 28.8 to 228.1 and k from 0.0066 to 0.6932. The double exponential model showed better prediction of N mineralization compared with the single exponential model, particularly for organic amendments with high C:N ratio. It is expected that the model parameters estimated based on the incubation experiment could be used to design nutrient management planning in environment-friendly agriculture.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.4
• /
• pp.15-22
• /
• 2017

Application of organic resources to agricultural land can increase crop yield by improving soil characteristics. The objective of this study was to evaluate effect of crop yield and soil physical properties including aggregate stability to application of organic resources in upland. The soybean was cultivated in a sandy loam field and a clay loam field located at Suwon and a sandy loam field located at Pyeongchang. The organic resources used in this study were rice straw compost (RSC), composted pig manure with sawdust (CPIG), composted poultry manure with sawdust (CPM), and cocopeat applied before sowing crop. Application rate of organic resources was determined based on carbon content and water content. The inorganic fertilizers were applied based on soil testing. In addition, the decomposition of RSC, CPIG, and cocopeat was characterized by isothermal incubation with sandy loam soil. The decomposition rate was highest for RSC followed by CPIG and cocopeat. Organic resource application increased yield of soybean, which effect was greater in clay loam than in sandy loam. In addition, increase in gas phase proportion by organic resource application was distinct in clay loam soil compared with sandy loam soil. In terms of aggregate stability, increasing effect was more obvious in sandy loam soils than in a clay loam soil. The highest yield was observed in RSC treatment plots for all the fields. Improvement of soybean yield and soil physical characteristics by cocopeat was not as much as that of the other organic resources. The results implied that RSC could be recommended for promoting aggregate stability and crop yield in upland cultivation.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.367-367
• /
• 2017

Crimson clover, a legume crop, is a landscape crop and green manure crop that can be sowing in spring and autumn. Its red flower blooms in May, and serves various roles such as landscape composition, weeds suppressing, prevention of soil loss and nutrient on sloping land and supplying nitrogen and organic matter in soil. Thus, in order to utilize this crop in agriculture land, we evaluated the growth characteristics of crimson clover cultivated in four different soil textures, sand, sandy loam, loam, and clay loam. The nitrogen content of crimson clover was 15.8 g kg-1 and C/N rate was 20.3. Its growth was good in sandy loam and loam. Its plant height was 42.5 cm in sandy loam and 49.5 cm in loamy, respectively, which are approximately 20 cm longer than the sand and clay loam. The crimson clover in sandy loam and loam bloomed about seven days earlier than those in sand and clay loam. Regarding number of flower per hill and flower length, there were no difference between soil textures. Dry weight of crimson clover was 2.5 Mg ha-1, 2.3 Mg ha-1 each in sandy loam and loam. Therefore, it was approximately 0.8 ~ 1.1 Mg ha-1 higher than dry weight of sand and sandy loam. Plant height and dry weight of crimson clover was increased late harvest time. Nitrogen contribution were higher in loam and clay loam, when it was respectively 51.3 kg ha-1, 53.5 kg ha-1. Therefore, according to flowering properties and dry weight, the growth and development of crimson clover was finest in sandy loam and loam.

• Korean Journal of Soil Science and Fertilizer
• /
• v.49 no.6
• /
• pp.705-711
• /
• 2016

Crimson clover, a legume crop, is a landscape crop and green manure crop that can be sowing in spring and autumn. Its red flower blooms in May, and serves various roles such as landscape composition, weeds suppressing, prevention of soil loss and nutrient on sloping land and supplying nitrogen and organic matter in soil. Thus, in order to utilize this crop in agriculture land, we evaluated the growth characteristics of crimson clover cultivated in four different soil textures; sand, sandy loam, loam, and clay loam. The nitrogen content of crimson clover was $15.8g\;kg^{-1}$ and C/N ratio was 20.3. Its plant height was 42.5 cm in sandy loam and 49.5 cm in loamy, respectively, approximately 20 cm longer than the sand and clay loam. The crimson clover in sandy loam and loam bloomed about seven days earlier than those in sand and clay loam. Regarding number of flower per hill and flower length, there were no difference among the soil textures. Dry weight of crimson clover for sandy loam and loam was $2.5Mg\;ha^{-1}$ and $2.3Mg\;ha^{-1}$, respectively, $0.8{\sim}1.1Mg\;ha^{-1}$ higher than that of sand and sandy loam. Plant height and dry weight of crimson clover increased with delaying harvest time. Nitrogen contribution in loam and clay loam was $51.3kg\;ha^{-1}$ and $53.5kg\;ha^{-1}$, respectively. Therefore, in terms of flowering properties and dry weight, the proper soil texture for the growth and development of crimson clover was sandy loam and loam.