• Journal of Information Display
• /
• v.4 no.2
• /
• pp.1-6
• /
• 2003

In this paper, we demonstrate that the organic electrophosphorescent device is driven by the organic thin film transistor with spin-coated photoacryl gate insulator. It was found that electrical output characteristics in our organic thin film transistors using the staggered-inverted top-contact structure showed the non-saturated slope in the saturation region and the sub-threshold nonlinearity in the triode region, where we obtained the maximum power luminance that was about 90 $cd/m^2$. Field effect mobility, threshold voltage, and on-off current ratio in 0.45 ${\mu}m$ thick gate dielectric layer were 0.17 $cm^2/Vs$, -7 V, and $10^6$ , respectively. In order to form polyimide as a gate insulator, vapor deposition polymerization process was also introduced instead of spin-coating process, where polyimide film was co-deposited by high-vacuum thermal evaporation from 4,4'-oxydiphthalic anhydride (ODPA) and 4,4'-oxydianiline (ODA) and cured at 150${\sqsubset}$for 1hr. It was also found that field effect mobility, threshold voltage, on-off current ratio, and sub-threshold slope with 0.45 ${\mu}m$ thick gate dielectric films were 0.134 $cm^2/Vs$, -7 V, and $10^6$ A/A, and 1 V/decade, respectively.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1336-1339
• /
• 2007

Since organic thin film transistor (OTFT) provides simple and low cost processes, its application to the OTFT display has been studied. We developed an RC oscillator using organic thin film transistor and inverters with bootstrapping transistors. Device parameters were optimized by the simulation and OTFT RC oscillators were fabricated. The oscillator frequency and its dependence on resistance and bias voltage were studied. The organic TFT is adequate for low cost and simple process integrated circuits. The frequency of oscillation was simulated and measured. It is acceptable for low-cost microelectronic device and flat panel displays.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.6
• /
• pp.512-518
• /
• 2006

In this paper, we investigated the deposition of pentacene thin film on a large area substrate by Organic Vapor Phase Deposition(OVPD) and applied it to fabrication of Organic Thin Film Transistor(OTFT). We extracted the optimum deposition conditions such as evaporation temperature of $260^{\circ}C$, carrier gas flow rate of 10 sccm and chamber vacuum pressure of 0.1 torr. We fabricated 72 OTFTs on the 4 inch size Si Wafer, Which produced the average mobility of $0.1{\pm}0.021cm^2/V{\cdot}s$, average subthreshold slope of 1.04 dec/V, average threshold voltage of -6.55 V, and off-state current is $0.973pA/{\mu}m$. The overall performance of pentacene TFTs over 4 ' wafer exhibited the uniformity with the variation less than 20 %. This proves that OVPD is a suitable methode for the deposition of organic thin film over a large area substrate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.271-272
• /
• 2008

We fabricated a pentacene thin-film transistor with Ni/Ag source/drain electrodes. Also, we obtained similar electrical characteristics as compared with source/drain electrode with Au. This device was found to have a field-effect mobility of about 0.021 $cm^2$/Vs, a threshold voltage of -5, -7 V, an subthreshold slope of 2.0, 4.5 V/decade, and an on!off current ratio of $3.6\times10^5$, $2.0\times10^6$.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1115-1118
• /
• 2006

Using a thermally-crosslinkable organosiloxane-based organic-inorganic hybrid material, solution processable gate dielectric layer for organic thin-film transistors (OTFTs) have been fabricated. The hybrid dielectrics are synthesized by the sol-gel process, followed by the heat-treatment at $190{\bullet}\;.{\bullet}$ To investigate the electrical property of hybrid dielectric, leakage current behavior and capacitance were measured. To fabricate coplanar-type OTFTs, Au/Cr electrode was deposited onto the heavily doped silicon substrate with the organic-inorganic hybrid dielectric layer and then ${\alpha},{\omega}-dihexylquaterthiophene$ was drop-cast between source and drain electrical performance of the fabricated transistor.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2002.08a
• /
• pp.184-187
• /
• 2002

In this work, the electrical characteristics of organic thin film transistors with the stacked organic gate insulators have been studied. PVP(Polyvinylphenol) and polystyrene were used as gate insulating materials. Both the high dielectric constant of PVP and better insulating capability of polystyrene were compensatorily adopted in two different stacking orders of PVP-polystyrene and polystyrene-PVP. The output characteristics of the device with the stacked gate insulator showed substantial improvement compared with those of the devices with either PVP or polystyrene gate insulator: Furthermore, these stacked organic gate insulators can differently affect the TFT characteristics with the stacking orders. The electrical properties of TFTs with organic gate insulators stacked in different orders are discussed.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1107-1110
• /
• 2006

We investigate the effect of processing temperature of gate insulator and optical anisotropy on organic thin-film transistors (OTFTs). The insulator film which was processed lower temperature than solvent boiling temperature can lead more aligned pentacne molecules compare to higher processed insulator film. It finally gives rise to the big increase of carrier mobility in OTFTs, although there are little difference at the seriously affecting properties to device performance, for example roughness of gate insulator film.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.649-652
• /
• 2003

Organic thin-film transistors were fabricated using pentacene as an active electronic material. Device characteristics are improved with increasing the deposition rate of pentacene. It is observed that the deposition rate influences on the interface properties between pentacene and polystyrene, and the molecular ordering of pentacene film. In this paper, we report the effects of the deposition rate of pentacene film on the device performance.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1044-1045
• /
• 2004

In this work, the characteristics of organic thin film transistors (OTFTs) with self-assembled monolayers (SAMs) on polymeric gate insulator have been investigated. The SAMs were formed using atomic layer deposition (ALD) method onto gate insulator. Upon the investigations, it was observed that SAMs modify the wettability of polymeric insulator and influence the growth of subsequent organic semiconductor, and thereby, electric conductivity and roughness of the pentacene film are improved.

• Journal of Information Display
• /
• v.12 no.4
• /
• pp.199-203
• /
• 2011

Reported herein is the film morphology control of inkjet-printed 6,13-bis(triisopropylsilylethynyl) pentacene (TIPS-pentacene) organic thin-film transistors for the improvement of their performance and of the device-to-device uniformity. The morphology of the inkjetted TIPS-pentacene films was significantly influenced by the bank geometry such as the bank shapes and confinement area for the channel region. A specific confinement size led to the formation of uniform TIPS-pentacene channel layers and better electrical properties, which suggests that the ink volume and the solid concentration of the organic-semiconductor solutions should be considered in designing the bank geometry.