• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.7A
• /
• pp.535-541
• /
• 2005

This paper proposes a hybrid optical lines composed of single-mode fiber(SMF) and multi-mode fiber(MMF) for gigabit-capable Passive Optical Network(GPON) using a WDM method with a single light source per each channel, and reports the results of transmission performance the proposed lines. The transmission link uses a direct modulated DFB-LD for high speed downstreams at the optical line terminal(OLT) of central office(CO) and a low cost SFP type transceiver for low-speed upstream in optical network unit(ONU). To split or combine the transmission channels, wavelength MUX/DEMUX are used in the optical line section, and MMFs not longer than 1 km are attached to the SMF lines at the ONU side of the WDM-PON links. We have performed the transmission experiment on the downstream of 2.5 Gbit/s, and 1.25 Gbit/s, and the upstream of 1.25 Gbit/s, and 622 Mbit/s which are recommended by ITU-T G.984.2. The transmission margin and feasibility of the proposed links have been tested to be suitable up to 2.5 Gbit/s transmission.

• Journal of the Optical Society of Korea
• /
• v.2 no.1
• /
• pp.30-33
• /
• 1998

We present the analysis of phase-shifted fiber Bragg gratings by coupled-mode equations. The transmission is expressed as that of a Fabry-Perot resonator with complex reflectance and complex transmittance. The transmission spectrum, the effective cavity length, and the behaviors with different phase-shifts are investigated. A very flattered transmission peak is obtained by introducing three phase-shifts in a grating.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.9
• /
• pp.4462-4466
• /
• 2013

In optical system, the signal and additive noise for statistical properties of a variety of ways to evaluate the performance of the system is essential for the optimization. In this paper, performance analysis of spectrum-sliced optical system in the optical pre-amplifier in the receiver the received signal by including the error limits for the bit that is, the bit error rate (BER: Bit Error Rate) required to maintain the average optical power represents the number of photons per bit is included in this paper to digital form, noticeable signal the receiver to calculate the sensitivity of the method for the calculation was performed. The general strength of the transmission of the modulated signal and digital signal transmission was required for the comparison of optical power. As shown in Figure 3, the general strength of the digital signal transmission system for transmitting a modulated signal compared with the case is improved by at least 10dB.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.3
• /
• pp.43-49
• /
• 2014

This paper presents a theoretical study of transmission performance for an optical duobinary transmitter employed a Mach-Zehnder modulator and a electrical low pass filter at 40Gbps optical communication links. It depends on the bandwidth of the low pass filter in the transmitter, the optical filter and the filter in the receiver. Also, each filter affected to the various parts of the optical power spectrum. By optimizing the bandwidth of each filter, we could control the side robes and the ripples and improve the dispersion tolerance of the transmission system.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.21 no.1
• /
• pp.95-101
• /
• 2022

This paper proposes a method to process the shape of an optical transmission road and attempts to determine the most suitable single processing method for an acrylic plate optical transmission road. In addition, by manufacturing an automatic pattern processing device to generate certain shapes on the acrylic plate at regular intervals, and measuring the illuminance of the patterned acrylic plate optical transmission road, the measured illuminance was confirmed to fall under the KS illuminance values presented in Table 1. In conclusion, when an incident light of approximately 20,000 lx is applied, the transmission illumination is approximately 200 lx, which represents a transmission rate of approximately 1% for incident light and corresponds to the KS illumination criterion F. Additionally, the right-angle triangular pyramid base size (A) processed at a temperature of 350 ℃ for one second was 2 mm, exhibiting the largest transmission illumination of 280 lx. When the transparent acrylic plate was set to a constant size of 1.6 mm at the bottom of the right-angle triangular pyramid, the fastest response occurred at a processing tip temperature of 350 ℃ (0.04 s). On the other hand, it took 10 s to process the size of the bottom of the right-angled triangular pyramid at a temperature of 200 ℃ to 1.6 mm, and it was confirmed that the optical transmission efficiency was significantly reduced because of the burr that occurred at this time.

• Journal of the Optical Society of Korea
• /
• v.19 no.4
• /
• pp.371-375
• /
• 2015

The impact of equivalent optical bandwidth on the performance of a system using a reflective electroabsorption modulator (R-EAM) based optical source has been experimentally evaluated with signals operating at 2.5 Gb/s and beyond. The equivalent optical bandwidth of our source with a broadband seed light was simply adjusted by using a bandwidth tunable optical filter. From the measurements, we have estimated the required equivalent optical bandwidth of our source for an error-free transmission (@ bit-error-rate of $10^{-12}$) and a forward error correction (FEC) threshold of $2{\times}10^{-4}$.

• Journal of the Optical Society of Korea
• /
• v.8 no.4
• /
• pp.149-155
• /
• 2004

Newly developed modal transmission-line theory(MTLT) is used to analyze rigorously the optical power distribution in grating-assisted directional couplers(GADCs) with three guiding channels. By defining a novel coupling efficiency ${\eta}$ amenable to the rigorous analytical solutions of modal transmission-line theory, we explicitly evaluate the power coupling and distribution of TM modes. The results reveal that the incident power is sensitively partitioned through three output channels in terms of such grating parameters as the grating period, the duty cycle, and the operating wavelength.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12A
• /
• pp.1251-1260
• /
• 2008

Diffuse wireless optical communication offers more robust optical links in terms of coverage and shadowing than line-of-sight links. However, traditional diffuse wireless infrared (IR) transceiver systems are more susceptible to multi-path distortion and great power decrease, which results in limiting high-speed performance. Multi-beam is an effective technique to compensate for multi-path distortion in a wireless infrared environment. The goal of this paper is to analyze the transmission characteristics by replacing traditional diffuse system (TDS) which contains single wide angle transmitter and single element receiver by system consisting of three-beam transmitter and non-imaging receiver (TNS) attached with compound parabolic concentrator (CPC). In the simulation, we use the recursive model developed by Barry and Kahn and build the scenario based on 10 different cases which have been listed in Table 1. Moreover, we also check the reliability of the TNS diffuse link channel by BER test on the basis of different receiver positions and room sizes. The simulation results not only show the basic transmission characteristics of TNS diffuse link, but also are references to design more efficient and reliable indoor infrared transmission systems.

• Korean Journal of Optics and Photonics
• /
• v.12 no.2
• /
• pp.129-134
• /
• 2001

Novel supervisory system for WDM transmission link using conventional optical time domain reflectometry was presented. By modifying the structure of erbuim doped fiber amplifier to support bi-directional transmission at arDR pulse wavelength and launching the optical pulse into transmission link in the opposite direction of data signal propagation to avoid the distortion by cross-gain modulation, it is possible to monitor the WDM link in service. To prove the validity of proposed scheme, the supervision result of 2.5 Gbps $\times$ 8 channel WDM 320 km transmission system in service by arDR was presented. And power penalty due to monitoring was measured as smaller than 0.3 dB. .3 dB.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.753-757
• /
• 2011

The possibility of implementing nonuniform residual dispersion per span (RDPS) in optical links with net residual dispersion (NRD) controlled by precompensation and postcompensation for 960 Gbps WDM transmissions is studied and discussed. The fiber optic communication links investigated in this paper consist of inline dispersion management (DM) for each fiber spans and optical phase conjugator (OPC) at mid-way of total transmission length in order to compensate for WDM signal distortions due to group velocity dispersion (GVD) and nonlinearities. It is confirmed that the effect of nonuniform RDPS distribution on system performance is not significant. It is also confirmed that the optimal NRD is obtained to be one of two values of +10 ps/nm or -10 ps/nm, which depend on the deciding of NRD controlled by precompensation or postcompensation, and the exact RDPS configurations. The effective NRD ranges resulting eye opening penalty (EOP) below 1 dB are independent on the exact RDPS distribution for relative low launch power. Therefore, results show the possibility of implementing the flexible optical links to expand network construction for WDM transmission of high bit-rate capability.