• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.10
• /
• pp.43-47
• /
• 2002

A simple optical signal to noise ratio monitoring method using fiber Bragg grating is proposed for monitoring performance of OADM. OSNR of each channel is determined by monitoring the optical power transmitted and reflected from fiber Bragg gratings, simultaneously. We have obtained OSNR with accuracy better than 0.8㏈ compared with OSA of 0.1nm optical resolution in the wide input power range between -6 ㏈m and -23㏈m per channel.

• Proceedings of the KIEE Conference
• /
• 2006.07c
• /
• pp.1659-1660
• /
• 2006

After end of the 20th environmental problem was became issue. So about mercury free lighting sources are being studied very much. In this paper, a mercury and electrode free bulb was designed. in this bulb was injected mixed of Xe, Ne and Kr Gases. and then the bulb was discharged by 13.56MHz RF Power after spectrum, color coordinates and brightness were measured by spectrum meter CS-1000. Measured results were compared and analyzed, also analysis was able to do a characteristic of a gas defensive fight in proportion to a mixing ratio. Therefore the most of high brightness which was 4500cd/m2 was gained in 1:1 ratio of Xe:Ne at 60W input power.

• Journal of the Optical Society of Korea
• /
• v.14 no.2
• /
• pp.104-108
• /
• 2010

We proposed an axis transformation technique which reveals a distance parameter directly from optical scanning holography (OSH). After synthesis of a real-only spectrum hologram and power fringe adjusted filtering, we transform an original frequency axis to a new frequency axis using interpolation. In the new frequency axis, the filtered hologram has a single frequency which is linearly proportional to the distance parameter. Thus, the inverse Fourier transformation of the filtered hologram gives a delta function pair in the new spatial axis. Finally, we extract the distance parameter by detecting the location of the delta function pair.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1984.12a
• /
• pp.33-35
• /
• 1984

A new type single beam photoacoustic spectrometer suitable for measuring optical absorption of condensed powder matter with the automatic calibration capability of a source power spectrum is introduced. The signal processing until of this spectrometer consists of a photoacoustic cell a lock-in amp., a switching circuit and a personal computer. The measured optical absorption spectra of a few material by this method are good agreement with the results obtained by the double-beam photoacoustic spectrometer.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1993.04a
• /
• pp.208-212
• /
• 1993

Third order correlation function is to be advantageous to detect unique features embedded in various random signals that are undtectable with second order correlation or power spectrum. In order paper, we will introduce a real time third order correlator which consists of a laser light source, an acousto-optical modulator with signal controlling circuitry, and a CCD camera connected to computer for image processing. With this correlator, the third order correlation pattern of a signal can be immediately obtained at the camera due to parallelnature of optical computing.

• Proceedings of the Optical Society of Korea Conference
• /
• 2008.02a
• /
• pp.211-212
• /
• 2008

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.19 no.4
• /
• pp.322-327
• /
• 2006

CdS films have been prepared on polycarbonate, polyethylene terephthalate, and Coming 7059 substrates by r.f magnetron sputtering technique at room temperature. A comparison of the properties of the films deposited on polymer and glass substrates was performed. In addition, the influence of the sputter power on the structural and optical properties of these films was evaluated. The XRD measurements revealed that CdS films were polycrystalline and retained the mixed structure of hexagonal wurtzite and cubic phase, regardless of substrate types. As the sputter power was increased from 75 to 150 Watt, the structure of CdS films was converted from the mixed of hexagonal and cubic phase to hexagonal phase. The morphology of CdS films is found to be continuous and dense. Also, the grain of CdS films is larger with increasing the sputter power. The average transmittance exceeded 80 % in the visible spectrum for all films and decreases slightly with the sputter power.

• Journal of Sensor Science and Technology
• /
• v.26 no.5
• /
• pp.324-330
• /
• 2017

In this paper, the automation of sweeping center setting for wavelength swept laser used in SS-OCT has implemented. For 3 regions where the initial FFP-TF pass wavelength can be located, each different DC voltage pattern is applied to FFP-TF. Through its performance test to the laser, fast and exact setting to sweeping central wavelength, flat sweeping with ${\pm}0.5dB$ fluctuation range, and 10 mW average optical power were obtained. This shows that the realized automatic setting process can replace an inconvenient manual setting operation used for current wavelength swept laser. Additionally it cuts costs for optical spectrum analyzer necessary to laser spectrum monitoring.

• Journal of the Optical Society of Korea
• /
• v.14 no.1
• /
• pp.49-54
• /
• 2010

In this study, the use of a continuous-wave (CW) supercontinuum (SC) seeded by an erbium-doped fiber's amplified spontaneous emission (ASE) for optical-coherence tomography imaging is experimentally demonstrated. It was shown, by taking an in-depth image of a human tooth sample, that due to the smooth, flat spectrum and long-term stability of the proposed CW SC, it can be readily applied to the spectral-domain optical-coherence tomography system. The relative-intensity noise level and spectral bandwidth of the CW SC are also experimentally analyzed as a function of the ASE beam power.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.10
• /
• pp.784-789
• /
• 1998

In this work, the optical properties of freestanding GaN single crystalline substrate grown by hydride vapor phase epitaxy(HVPE) were investigated. The low temperature PL spectrum in freestanding GaN consists of free and bound exciton emissions, and a deep DAP recombination around at 1.8eV. The optically-pumped stimulated emission in freestanding GaN substrate was observed at room temperature. At the maximum power density of 2MW/$\textrm{cm}^2$, the peak energy and FEHM of stimulated emission were 3.318 eV and 8meV, respectively. The excitation power dependence on the integrated emission intensity indicates the threshold pumping power density of 0.4 MW/$\textrm{cm}^2$.