• Journal of Satellite, Information and Communications
• /
• v.7 no.1
• /
• pp.97-101
• /
• 2012

The TC&R(Telemetry, Command & Ranging) antennas should have the hemispherical omni antenna patterns to make sure that the communication link between the satellite and the ground station can be established under whatever satellite attitude during after launch to on-orbit mission. The hemispherical omni-antennas are typically placed on the +z axis and -z axis of the satellite to provide the spherical omni patterns. The S-band qaudrifilar helix antennas having RHCP and LHCP hemispherical omni pattern are designed to meet the antenna gain and the axial ratio requirements. To investigate the omni-antenna pattern characteristics depending on four cases of antenna polarization combination placed on the +z axis and -z axis, the antenna pattern of each case is analyzed. Based on the result, after installing the designed RHCP and LHCP S-band omni-antennas on the +z axis and -z axis of the satellite, the combined antenna gain is obtained and finally analyzed in conjunction with the communication link influence.

• Proceedings of the IEEK Conference
• /
• 2002.06a
• /
• pp.163-166
• /
• 2002

Recently, two kinds of the digital satellite receiver for radio and television have been developed as the global receiving system. The frequency bands of the satellite radio system are ranging from 1, 400MHz to 2, 600MHz, while the satellite television system are ranging from 11, 000MHz to 13, 000MHz New anti-discern antennas have been developed so that satisfies the Omni-characteristics in the horizontal directivity and approximately 45$^{\circ}$'elevation angle in the vertical directivity. These results were similar to the discern antenna except the anti-vertical directivity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.11
• /
• pp.982-989
• /
• 2013

Omni-directional antennas of UHF-Band are located on the top and bottom side of the Smart UAV in order to connect a link always. Therefore one of each antennas should be connected to a ground antenna. Because the communication link of the omni-directional antennas is influenced by the objectives around aircraft, the clearance of LOS(Line of Sight) should be achieved in order to avoid a loss of link. In this paper, the analysis results on the influence of the complex objectives placed around the antenna on the communication link are presented according to the change of attitude angles. The best positions of antennas are selected based on the electromagnetic analysis using XGTD tool which supports the modeling of antenna pattern. The flight tests of the Smart UAV were successfully performed with the selected antenna position.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.61 no.1
• /
• pp.1-4
• /
• 2012

In this paper, the planar type modified folded loop antennas for S-DMB band is proposed. The proposed antenna consisted of opened center of a conventional closed loop and folded terminal of microstrip line to inside loop antenna. The sizes proposed antenna was minimized by folding the terminal of the loop. Also, It was minimized reactance value by increasing capacitances between coupled microstrip line. Therefore the proposed antennas compacted about 20% than a conventional loop antenna and increased efficiency of antenna. The proposed antennas got an omni-directional pattern, the antenna gain was 3.67 [dBi] and the bandwidth was 900 MHz (2.6-3.56 GHz) with VSWR${\leq}$2 from the simulated and the measured results. The frequency utilization coefficient was 29.9 %. These properties could satisfy the S-DMB band.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.6
• /
• pp.1169-1176
• /
• 2018

The C-band omni-directional antenna for drone control is mounted on the top or bottom and used to configure the communication link. The communication link is affected by the LOS depending on the mounting position of the omni-directional antenna. In this paper, two kinds of embedded antennas were designed with a commercial simulation tool CST MWS, and EM analysis was performed to consider the mounting environment. Also, we propose the PTMP ground antenna to control a large number of drones. The ground antenna has a communication link of 30km, and it consists of four sector antennas in the horizontal direction and one directional antenna at the top.

• Journal of information and communication convergence engineering
• /
• v.8 no.5
• /
• pp.489-492
• /
• 2010

This paper proposes the planar-type modified monopole antennas of loop structure. This antenna has an opened center of a conventional closed loop structure with an inside-folded terminal of the loop microstrip line. The size of the proposed antenna was minimized by folding the end of the loop. Also, the reactance value has been minimized by increasing capacitances between the coupled microstrip line. Therefore the proposed antenna has been compacted to about 20% from a conventional loop antenna and has increased its efficiency. The proposed antennas have an omni-directional pattern, the antenna gain was 3.67 [dBi] and the bandwidth was 900 MHz (2.6~3.56 GHz) with VSWR$\leq$2 from the simulated and the measured results. The frequency utilization coefficient was 29.9%. These properties could satisfy the S-DMB band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.6
• /
• pp.550-557
• /
• 2003

In this paper, two dualband internal antennas for GPS/PCS handset are proposed. At first, the monopole antenna with parasitic dipole element is designed to print PCB of handset directly. At second, the antenna with bended loop structure is designed to bend to use internal space of handset maximumly. The proposed dualband internal antennas provide a 2:1 VSWR bandwidth of over 19.1 % which are possible to cover two bands at once. the antennas have a gain between -0.4 and 3.33 ㏈i at all bands and they have almost omni-directional patterns.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.7
• /
• pp.72-76
• /
• 2008

In this paper, the several printed square loop antennas which modified monopole antennas are proposed. The proposed antennas are reduced about 20% physical size of antenna and miniaturized reactance value of impedance due to fold center part of the loop. They obtained omni-directional radiation patterns with broad bandwidth and feed method used coplanar waveguide to composed single planar. The proposed antenna bandwidth is about 900MHz($2.63{\sim}3.56GHz]$) resonance frequency on $VSWR{\le}2$. it can be sufficiency of S-DMB band.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.48 no.8
• /
• pp.641-651
• /
• 2020

This paper implements an antenna selection logic that automatically selects omni-directional antennas mounted on the top and bottom of an unmanned helicopter to maintain the link margin of the data link at 0dB or higher during flight. The selection criteria were derived by simulating and analyzing the radiation pattern. In addition, it is implemented to select the optimal antenna in real time during the flight by deriving the directivity angle function.

• Journal of Advanced Navigation Technology
• /
• v.19 no.1
• /
• pp.60-65
• /
• 2015

In the present study, compact $0^{th}$ order resonant antenna for 2.4 GHz ISM frequency band is newly proposed. In case of wireless communication systems such as wi-fi, bluetooth and Zigbee, antennas with omni-directional radiation pattern are necessary because of the demands for uniformly received electric field strength without variation for direction. It is well-known that $0^{th}$ order resonant antennas are not only advantageous for miniaturization but also have advantage of maintaining omni-directional radiation pattern. The proposed antenna is composed of two-element array in which the size of unit element should be smaller than ${\lambda}/4$ correspondent to the resonant length of typical monopole antennas The proposed antenna which is placed at middle and upper side of PCB with $50{\times}50mm^2$ size is designed and fabricated within limited space of $8{\times}5mm^2$. The measured impedance bandwidth ($S_{11}{\leq}-10dB$) is about 100 MHz (2.4~2.5 GHz) which corresponds to quite wide bandwidth in comparison with the antenna size, and also the measured peak gain over the passband is more than 3 dBi which is thought to be slightly wider than the other $0^{th}$ order resonant antenna.