• Journal of the Korean Association of Geographic Information Studies
• /
• v.13 no.4
• /
• pp.67-77
• /
• 2010

Growth of oil and chemical industries has been remarkable during recent years. Hazardous materials (Hazmat) make frequent use in the wide range of industries. It increases the frequency of Hazmat transport and it leads to increase the number of accidents. Optimal Hazmat routes can reduce damage. Thus, the objective of this study is to minimize the areas impacted by Hazmat accidents by adopting experts' opinion in planning the route. We calculated weights using AHP (Analytic Hierarchy Process) and deduced the best route by applying this weights. Results showed that in the case of shortest route versus weighted route, the percentage of population damage has been decreased by 33.4% in the comparison between shortest route and optimally weighted route. And the percentage of environmental damage also has been decreased by 21.8%. Social damage has been decreased by 1521.7%. In the case of none weighted route versus weighted route, the percentage of population damage has been decreased by 2.6% when we adopted weighted route. Consequently, the recommended route with weighted risk assessment avoids densely populated area comparing with none weighted route. Further research needs to be carried out in order to figure out the specific cost-effectiveness analysis applying the equal cost unit for each factor.

• Korean Chemical Engineering Research
• /
• v.52 no.6
• /
• pp.796-806
• /
• 2014

The key for the commercial deployment of IGCC power plants or chemical (methanol, dimethyl ether, etc.) production plants based on coal gasification is their economic advantage over plants producing electricity or chemicals from crude oil or natural gas. The better economy of coal gasification based plants can be obtained by co-production of electricity and chemicals. In this study, we carried out the economic feasibility analysis on the process of co-producing electricity and DME (dimethyl ether) using coal gasification. The plant's capacity was 250 MW electric and DME production of 300,000 ton per year. Assuming that the sales price of DME is 500,000 won/ton, the production cost of electricity is in the range of 33~58% of 150.69 won/kwh which is the average of SMP (system marginal price) in 2013, Korea. At present, the sales price of DME in China is approximately 900,000 won/ton. Therefore, there are more potential for lowering the price of co-produced electricity when comparing that from IGCC only. Since the co-production system can not only use the coal gasifier and the gas purification process as a common facility but also can control production rates of electricity and DME depending on the market demand, the production cost of electricity and DME can be significantly reduced compared to the process of producing electricity or DME separately.

• Journal of the Korea Convergence Society
• /
• v.11 no.6
• /
• pp.173-182
• /
• 2020

Since 2000, Korea has seen a big trend in the market, as the EU tightened regulations on environment due to global warming, high oil prices and aging rural population distribution, strengthening the need for multi-purpose electric moto vehicles for small farmers based on eco-friendly energy. Multi-purpose electric motor vehicles for rural small businesses will be a very innovative means of transportation, not only maintained at a low cost and to reduce greenhouse gases through the activation of eco-friendly energy, but also be a very innovative means of transportation for reducing the labor intensity of the aging farming industry and transporting night work and logistics. In this paper, with the implementation of eco-friendly energy policies, small and medium-sized rural small business owners can easily operate on unpaved roads and well-drawn farming environments, while the intensity of labor can be reduced when transporting crops also can simply replace parts at a low cost in the event of an accident. To propose rural multi-purpose modular electric vehicles, the existing literature is reviewed and 12 modular parts are presented by benchmarking electric vehicles at home and abroad. This paper is thought to be helpful for the research of the industry as well as the design industry of modular electric vehicles.

• Journal of Life Science
• /
• v.27 no.10
• /
• pp.1185-1190
• /
• 2017

Insects are gaining recognition as an alternative source of protein. As a result, more and more domestic farms have begun mass rearing of edible insects. In order to produce high quality insects, studies on the development of safe and nutritious feed sources are needed. Given the cost of rearing insects, agricultural and industrial by-products are good sources for feed. The efficient utilization of these by-products can help in reducing the cost of production and preventing environmental pollution. In the current study, Citrus unshiu peel (CP), soybean curd cake (SCC), soybean oil meal (SOM), and brewers dried grain (BDG) were investigated for their effects on larval growth and development of Protaetia brevitarsis. Interestingly, the feed with 10% SCC increased larval weight by 3.5 times. For the larval period, the group of 10% SCC was significantly shorter than the control. Furthermore, minerals such as Zn, Ca, K, Mg, Na, and P were recorded to be high in 10% SCC. A total of 17 amino acids were present in 10% SCC, of which tyrosine and arginine were predominant. The heavy metal contents were very small amounts or not detected in any of the investigated groups. These findings provided a scientific basis for the utilization of soybean curd cake as a nutritional feed source to promote larval growth and produce quality insects.

• Journal of Navigation and Port Research
• /
• v.34 no.3
• /
• pp.213-220
• /
• 2010

Following the application of Formal Safety Assessment(FSA) to bulk carriers, crude oil tankers and large passenger ships, an urgent need to consider the safety of general cargo ships has recently been raised through the International Maritime Organization(IMO)(IMO, 2006a), and related FSA studies are being carried out by International Association of Classification Societies(IACS) as a preparatory work for the discussion on the issue of general cargo ship safety in the IMO committee. FSA is a structured and systematic methodology which is based on the techniques of risk analysis and cost benefit assessment to assist in the decision-making process, and aims at enhancing maritime safety, including protection of life, health, the marine environment and property. FSA can be used as a tool to facilitate the development of regulatory changes equitable to the various parties, with a view to aiding the achievement of consensus, and to help in the evaluation of new regulations and in making a comparison between existing and possibly improved regulations(IMO, 2007). This study aims at verifying the usefulness of FSA methods as a tool to conduct a safety assessment of general cargo ships flying the Korean flag, and providing useful information on 'the safety of general cargo ships' for IMO committee's discussion on the matter at a future session. FSA comprises five steps, however, steps 1(Hazard identification) and 2 (Risk analysis) from the FSA study for the Korean-flagged general cargo ships are discussed in this paper.

• Journal of the Korean Institute of Gas
• /
• v.24 no.1
• /
• pp.17-22
• /
• 2020

Light Naphtha is distillated from crude oil unit and separated into the methane, ethylene and propylene by boiling point difference in sequence. This separation is conducted using a series of binary-like columns. This separation method is known that the energy consumed in the reboiler is used to separate the heaviest components and most of this energy is discarded as vapor condensation in the overhead cooler. In this study, the first two columns of the separation process are replaced with the Petlyuk column. A structural design was exercised by the stage computation with ideal tray efficiency in equilibrium condition. Compared with the performance of a conventional system of 3-column model, The design outcome shows that the procedure is simple and efficient because the composition of the liquid component in the column tray was designed to be similar to the equilibrium distillation curve. The performance of the new process indicates that an energy saving of 12.1% is obtained and the cost savings of 44 million won per day based on gross domestic product is reduced under same total number of trays and the initial investment cost is saved.

• Geophysics and Geophysical Exploration
• /
• v.24 no.3
• /
• pp.113-130
• /
• 2021

Recently, ground-penetrating radar (GPR) surveys have been actively employed to obtain a large amount of data on occurrences such as ground subsidence and road safety. However, considering the cost and time efficiency, more intuitive and accurate interpretation methods are required, as interpreting a whole survey data set is a cost-intensive process. For this purpose, GPR data can be subjected to attribute analysis, which allows quantitative interpretation. Among the seismic attributes that have been widely used in the field of exploration, complex trace analysis and similarity are the most suitable methods for analyzing GPR data. Further, recently proposed attributes such as edge detecting and texture attributes are also effective for GPR data analysis because of the advances in image processing. In this paper, as a reference for research on the attribute analysis of GPR data, we introduce the useful attributes for GPR data and describe their concepts. Further, we present an analysis of the interpretation methods based on the attribute analysis and past cases.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.6
• /
• pp.631-638
• /
• 2022

Microgrid, which enables the production and consumption of electricity to be done independently on a small scale, has been studied on one of the solutions of reinforcement for flexibility of electronic system. This study examined the application effect of new microgrid by applying hybrid battery in electric power storage device. We designed the system to highlight the advantage of each battery and complement the disadvantage by using hybrid system with Lithium-ion battery and interval Redox flow battery. It runs with lithium-ion battery during the initial startup while the Redox flow battery operates for a long time at the end of excessive period, and it enables a discharge of Lithium-ion and Redox flow battery at the same time when the load has a large output. We chose Maldives as a subject of this study for organizing and optimizing independent microgrid. Maldives is the country to accomplish 100% domestic electricity in South Asia, but the whole electric power is supplied through diesel generation imported fossil fuel. We organized and optimized microgrid for energy independence on Malahini island to solve Maldives energy cost problem and global energy environment matters. We analyzed the daily power supply and accumulated the power supply from September 18, 2018~February 11, 2019. The accumulated power supply was about 120.4 MWh and the daily power supply was about 800~1000 kWh. Based on the collected information, we divided the cases into three models which are only diesel generator, solar generator as well as diesel generator, and solar+ESS+diesel generator. We analyzed the amount of oil consumption compared to the cost of construction and power output. The result showed that solar+ESS+diesel generator was most economically feasible. As well, we obtained that our considering hybrid battery system reduced the fuel consumption for diesel power generation about 10~15%.

• Journal of Appropriate Technology
• /
• v.5 no.2
• /
• pp.91-96
• /
• 2019

Microalgae do not require much land and make a higher efficient oil production. However, it costs still much higher than other biodiesel resources, such as crops. Sugars charge 80% of culture media when microalgae are massively cultured in the fermenter. This study aims to develop a cost-efficient process for sugar production from Chinese cabbage byproducts. Pre-treatment with 0.25% H₂SO₄ was most effective when chopped cabbage was incubated 50℃/130 rpm for 24 hours. To hydrolyze cabbage cellulose, we used cellulases secreted from Trichoderma. harzianum. T. harzianum was cultured at 28℃/pH 7/130 rpm for five days. Optimal enzymatic activity of cellulase was obtained by incubating at 0.24 FPU/ml/45℃/pH 5/130 rpm for three days. In comparison to other agricultural waste, such as rice straw, green tea leaves, and palm residue, Chinese cabbage produced the highest sugar yield. We found the optimal conditions to produce sugar from Chinese cabbage byproducts as a carbon source to culture biodiesel-producing microalgae. The efficient process developed in this study helps microalgae as a sustainable alternative energy source by cost-down.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.17 no.3
• /
• pp.89-96
• /
• 2013

Now-a-days, a manhole adopted since the late 1990s and produced using the polymer concrete has widely used due to the various benefits. While entering the High oil prices times, however, and with the price increase of the petrochemical materials, the cost of manufacture of polymer concrete was elevated and the resulting polymer concrete's weakness is being put on. Accordingly, the development of economic cement concrete manholes, which can replace the outstanding bending strength of manhole made of high-price polymer concrete, has been required. In this study, based on the cement technology of fast hardening armorphous calcium aluminate (ACA), by minimizing the amount of cement using the industrial byproducts, to develop the eco-friendly high-toughness concrete manhole, which can reduce $CO_2$ reduction, was intended. As the results, the cement concrete manhole, which economic, eco-friend, and meeting the performance requirements, was developed.