• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.24 no.4
• /
• pp.150-157
• /
• 1988

The oceanographic condition around the set net fishing ground in Yeosu Bay was investigated by the oceanographic observation in June, July and August, 1988. Also the catch of the set net was analized by daly catch data of the three set net fishing ground from April to September, 1988. The results obtained are as follows: 1) The coastal surface water is high temperature and low salinity through the influence of land, and the off shore water and bottom water are low temperature and high salinity. 2) The eddy current and the sharp thermocline in June appeared in August at the set net fishing ground, and a good catch appeared in June and August. 3) The surface temperature and salinity at the set net fishing ground are 11$^{\circ}C$ to 27$^{\circ}C$ and 31.60$\textperthousand$ to 34.80$\textperthousand$. The surface temperature and salinity of a maximum good catch are 21$^{\circ}C$ and 33.80$\textperthousand$ to 33.99$\textperthousand$ respectively. 4) The dominant species of fish were spanish mackerel, scad, anchovy, sardine, common mackerel, hairtail, crab, yellow tail, in order of catch.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.53 no.4
• /
• pp.413-422
• /
• 2017

The objective of this study was to prove possible effects of a habitable place for fish around semi-submersible drilling rig which measured underwater radiated noise, irradiance distribution of rig's light and conducted experimental fishing in Malaysia territory and observed for distribution of fishes around the rig by ROV during drilling operation in the East Sea of Korea. As a result underwater radiated noise was $130dB/{\mu}Pa$ from 156.25 to 187.50 Hz, irradiance distribution of light was between 21.5 and 43.1 lx. Despite this result, underwater radiated noise was not a threat to fish around rig and low irradiance distribution of light also played a role in the luring influence of the fishes at night. Fish showed up in the beginning of drilling operation and at the end of drilling operation. However, there are few fish in the midst of drilling operation. The main reason for this result was the destruction of the habitable place due to blow out mud and broken pieces of ground formation in drilling hole. The results are expected to contribute to reasonable fishery management around rig.

• 한국해양학회지
• /
• v.13 no.2
• /
• pp.11-16
• /
• 1978

The contents of heavy metals were studied on sediments collected from the southeastern coastal area of Korea.Concentrations of the elements showed Cu 14∼ 48ppm (av. 18ppm), Pb 14∼49ppm (av. 28ppm), Zn 79∼187ppm (av. 11ppm), Co 11∼ 15ppm (av. 13ppm), Ni 22∼32ppm (av. 29ppm), Fe 3.1∼5.3% (av. 4.3%) and Mn 333 ∼1010ppm (av. 499ppm). When these values are compared with those of the unpolluted near-shore sediments from other countries,there seems to be little environmental contamination of heavy metals in the sediments of the study area. However, from the fact that the nearer to harbor the stations are, the higher the contents of copper, lead and zinc are in the sea off Pusan Bay, it is suggested that heavy metals in the sediments are starting to show some contamination from man's activities.

• Nuclear Engineering and Technology
• /
• v.50 no.1
• /
• pp.68-79
• /
• 2018

The Ki-Jang research reactor (KJRR), a new research reactor in Korea, is being planned to fulfill multiple purposes. In this study, as an assessment of the environmental radiological impact, we characterized the atmospheric dispersion and deposition of radioactive materials released by an unexpected incident at KJRR using the weather research and forecasting-mesoscale model interface program-California Puff (WRF-MMIF-CALPUFF) model system. Based on the reproduced three-dimensional gridded meteorological data obtained during a 1-year period using WRF, the overall meteorological data predicted by WRF were in agreement with the observed data, while the predicted wind speed data were slightly overestimated at all stations. Based on the CALPUFF simulation of atmospheric dispersion (${\chi}/Q$) and deposition (D/Q) factors, relatively heavier contamination in the vicinity of KJRR was observed, and the prevailing land breeze wind in the study area resulted in relatively higher concentration and deposition in the off-shore area sectors. We also compared the dispersion characteristics between the PAVAN (atmospheric dispersion of radioactive release from nuclear power plants) and CALPUFF models. Finally, the meteorological conditions and possibility of high doses of radiation for relatively higher hourly ${\chi}/Q$ cases were examined at specific discrete receptors.

• Journal of Welding and Joining
• /
• v.32 no.1
• /
• pp.15-21
• /
• 2014

FCAW(Flux Cored Arc Welding), SAW(Submerged Arc Welding), EGW(Electro Gas Welding), and three-pole SAW are applicable in manufacturing the offshore wind tower. In this paper, mechanical properties of these welded-joints for TMCP steels were evaluated in all above welding processes. The tensile strength of welded-joints for all the welding methods satisfied the standard guideline (KS D 3515). No cracking on weldment was found after the bending test. Changes of weldedments hardness with welding processes were observed. In a weld HAZ (heat-affected zone), a softened HAZ-zone was formed with high heat input welding processes (SAW and EGW). However, the welded-joint fractures were found in the base metal for all cases and small decrease in welded-joint strength was caused by a softened zone. The multi-pole SAW welds exhibited similar mechanical properties comparing to the one with one-pole SAW process.

• Journal of Welding and Joining
• /
• v.32 no.1
• /
• pp.6-14
• /
• 2014

This paper has an aim to evaluate microstructure and fracture toughness of TMCP steel weldment applied for off-shore wind tower with the focus on the effect of heat input on the weldment with various welding processes; FCAW(13kJ/cm and 30kJ/cm), SAW(62kJ/cm), and EGW(177kJ/cm). Based on experimental results developed from this study, it was found that the impact toughness of top side for TMCP steel weldments with heat input up to 62 kJ/cm satisfied the required minimum value except the EGW(177kJ/cm). The heat input and microstructure are the main factors of impact toughness. The heat input of 13kJ/cm on back side with low heat input increased the amount of grain boundary ferrite which has low impact toughness, and heat input of 177kJ/cm on top side is significant enough to produce the austenite grain growth. The compositions and sizes of inclusions which are the dominant factors for the formation of acicular ferrite were analyzed by OM and EDS. As the heat input increased, the inclusions also grew and a nucleation site decreased. The size of nonmetallic inclusions and the crack width was nearly similar, therefore the inclusions were related with the crack propagation.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.9 no.1
• /
• pp.135-145
• /
• 2005

Geotechnical design routinely requires that in-situ strength, stiffness of the ground be determined. In the working stress conditions, the strain level in a ground experienced by existing structures and during construction is less than about 0.1%~1%. In order to analyze the deformational behavior accurately, the in-situ testing technique which provides the reliable deformational characteristics at small strains, needs to be developed. Cone pressuremeter tests were performed on the western off-shore region of korea, and analyzed using cavity expansion theory and curve fitting technique to obtain the shear modulus at small strain level of $10^{-1}%$. The value of $E_u/S_u$ ratio for the marine clay shows about 589 at the small strain. However the value of $E_u/S_u$ estimated by lab tests are much smaller values ranged from 81 to 91. It is indicated that the curve fitting technique from CPM tests results can be used to obtain the shear modulus at small strain.

• The Journal of Fisheries Business Administration
• /
• v.24 no.2
• /
• pp.17-53
• /
• 1993

Pusan is the largest fishing port in Korea, and deals with more than I million ton of fish catches annually, including catches of coastal and off-shore fisheries as well as those of deep-sea fishery. However, it hen had no fishing port facilities specialized fer deep-sea fishery since it started 30 years ago. Economic and physical losses resulting from this have teen enormous. Although fishing port facilities are a part of infra-structures built by Governments, the construction of them has been delayed due to financial difficulties of Central or local governments. To overcome this harsh situation to which deep-sea fishery cooperations faced, some cooperations have decided to construct fishing port facilities including fish-pier specialized for deep-sea fishery in Gamcheon port. The construction expenses of these facilities were financed by private funds to which they themselves jointly contributed. As a result, a fish-[pier, which has the capacity of serving one fishing vessel of 10, 000 ton or four of 5, 000 ton or four of 1, 000 ton at the same time, will be opened in here by 1994. The paper examines the master plan to revitalize the deep-sea fisheries industry in a deep depression with the opening of these physical facilities. The framwork of the plan is pursued in two different aspects, which are both hardware and software. In a hardware aspect, the plan in to develop Pusan into a city which is suitable for one of the best fishing ports in the world. That is, it is to develop the city into a place famous for sightseeing as well as the distribution and processing of fish-products centering around fish-piers. On the other hand, in a software aspet, it is regarding improvement of the distribution system of fish-products. One way to do that is to make up some deficiencies of the current system of a producers' joint sale. And the other is to establish an exchange of fish-products futures. Through these institutions, we could abrsorb speculative funds, which would otherwise be invested in speculation on fish-products, into productive investment opportunities, We believe that if the plan is realized, the deep-sea fishery in Korea will revive from a long-tasted depression and make progress to become one of the mai industries of Korea.

• Journal of Navigation and Port Research
• /
• v.36 no.5
• /
• pp.357-361
• /
• 2012

Anemometer is a meteorological instrument that measures wind direction and wind speed in real time, and is mounted to the cranes that are used at ports, shipbuilding yards, off-shore structure, or construction sites that are influenced by wind, and it is used in conjunction with the safety system. Load cell-type anemometer measures the wind direction through the ratio of load between 4 positions by mounting the thin plate to 4 load cells, and measures wind velocity through the summation of loads. In this study, we compared and analyzed the results in the theoretic approach, analytic approach and experimental approach to derive the correlation between load ratio and wind direction. Wind direction was selected as the design variable, and selected 9 wind direction conditions from $0^{\circ}{\sim}90^{\circ}$ with $11.25^{\circ}$ space for analysis, and 10 wind direction conditions with $10^{\circ}$ space for experiment.

• The Journal of Fisheries Business Administration
• /
• v.1 no.1
• /
• pp.19-68
• /
• 1970

This is a study of a long term project to encourage the Korean fishing industry. It seeks to supply a sound theoretical background in an attempt to liberalize the capital investment of the industry. However, the discussions developed in this thesis are based on, the existing world's fisheries resources, the possibility of their prospective cultivation, and the analysis of the evolution of Korean fisheries and fisheries organization. According to the reasults of the analysis ; out of the prospective world fisheries resources which are estimated at about 200 millions m/t the total yield per year is only about 70 millions m/t (1969), and Korea occupies only 850 thousands m/t. This therefore means that the Korean fishing industry allows much room for further growth. But the purpose of Korea's existing fishing industry organizations is entirely directed toword coastal fisheries and their functions never reache beyond the limit of off-shore fisheries. Thus almost 99% of the fisheries population engage in small scale fisheries along the coast line. The result is that the resource are almost exhausted by such over-exploitation. Being faced by this fact, it is of urgent necessity to modernize the management of fisheries as well as to encourage larger scale management of fisheries industries. This should be accompanied by the liberalization of capital investment. For this purpose this study also recommends the unification or annexation of small organizations to establish larger ones that will function for a larger scale industry. and further this study recommends that, in order to reorganize the existing fisheries organizations, a principle of selection should be applied in the areas of (1) maximum sustainable yields, (2) the possibility of forming an enterprise and (3) the maintenance of organization stability.