• Elastomers and Composites
• /
• v.51 no.1
• /
• pp.63-67
• /
• 2016

Poly(ethylene-co-vinyl acetate) (EVA) was pyrolyzed to eliminate acetic acid of VA unit using off-line pyrolysis, and the deacetylated EVA was analyzed infrared spectroscopy (IR) and pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS). EVA film for deacetylation was prepared by solution casting on aluminum foil and it was pyrolyzed at low temperature of $300^{\circ}C$ in the off-line pyrolysis apparatus. After deacetylation, carbon-carbon double bond (C=C) was formed by 1,2-elimination of the VA unit in the EVA backbone. Most of C=C bonds were trans-1,4-unit and 1,2-unit was also observed. Presence of the 1,2-unit in deacetylated EVA indicates that terminal or branch VA units exist in the raw EVA. Py-GC/MS chromatogram of deacetylated EVA displayed much smaller acetic acid and much more abundant other pyrolysis products than that of raw EVA, which means that the pyrolysis efficiency and separation condition were improved.

• Journal of the Korean Chemical Society
• /
• v.41 no.10
• /
• pp.524-534
• /
• 1997

Analysis of additives in cured rubber is often a difficult task for analytical chemists because of a wide variety of complex components. Conventional analyses of additives and rubbers have been done in multistep, off-line processes with large sample size and extensive sample preparations. The coumarone-indene resin, resorcinol-formaldehyde resin, and prevulcanization inhibitor have been characterized by their pyrolysis pathways and mass spectra of characteristic pyrolyzates. Pyrolysis Gas Chromatography/Mass Spectrometry (Py-GC/MS) was used in the identification of additives without any sample pretreatment. This result shows that several organic additives in cured rubber can be directly analyzed.

• Membrane Journal
• /
• v.15 no.4
• /
• pp.330-337
• /
• 2005

Water selective silica membranes were prepared fur use as membrane reactor for synthesis of dimethyl ether (DME) by methanol dehydration. Silica membranes formed on a Porous SUS tube by ultrasonic spray Pyrolysis (USP) and chemical vapor deposition (CVD) using tetraethoxysilane (TEOS) as precursor. The CVD-derived membranes formed higher level of trade-off line between water permeance and water/methanol selectivity than that of the USP-derived membranes. The membrane reactor possessing water permeance of $1.2\times10^{-7}\;mol\;{\cdot}\;m^{-2}\;{\cdot}\;S^{-1}\;{\cdot}\;Pa^{-1}$ and water/methanol selectivity of 10 exhibited increase in methanol conversion of about $20\%$ comparing to conventional reactor system. These findings led us to conclude that the dehydration membrane reactor simultaneously separating the water vapour produced in the reaction zone was effective in increasing the reaction conversion.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.60 no.3
• /
• pp.114-119
• /
• 2011

Large Power transformer is a complex and critical component of power plant and consists of cellulosic paper, insulation oil, core, coil etc. Insulation materials of transformer and related equipment break down to liberate dissolved gas due to corona, partial discharge, pyrolysis or thermal decomposition. The dissolved gas kinds can be related to the type of electrical faults, and the rate of gas generation can indicate the severity of the fault. The identities of gases being generated are using very useful to decide the condition of transformation status. Therefore dissolved gas analysis is one of the best condition monitoring methods for power transformer. Also, on-line multi-gas analyzer has been developed and installed to monitor the condition of critical transformers. Rogers method, IEC method, key gas method and Duval Triangle method are used to failure diagnosis typically, and those methods are using the ratio or kinds of dissolved gas to evaluate the condition of transformer. This paper analyzes the reliability of transformer diagnostic methods considering actual dissolved gas concentration. Fault diagnosis is performed based on the dissolved gas of five transformers which experienced various fault respectively in the field, and the diagnosis result is compared with the actual off-line fault analysis. In this comparison result, Diagnostic methods using dissolved gas ratio like Rogers method, IEC method are sometimes fall outside the ratio code and no diagnosis but Duval triangle method and Key gas method is correct comparatively.