• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.12
• /
• pp.4927-4945
• /
• 2020

A newfangled family of Nyquist-I pulses is proposed and named improved dual sinc pulse (IDSP). The IDSP is designed to improve performance in orthogonal frequency division multiplexing (OFDM)-based systems. The IDSP is a generalization of the dual sinc pulse (DSPP). This is because the DSP was formulated for α = 1 whereas the IDSPP is valid for 0 ≤ α ≤ 1. The behavior of the IDSP is promising in terms of its frequency and time domain responses. Theoretical and numerical outcomes indicate that the IDSP outperformed other existing pulses applied in OFDM-based systems for various key evaluation metrics.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.27 no.9
• /
• pp.1321-1326
• /
• 1990

In this paper, the eye-opening conditions are investigated for the minimum bandwidth digital transmission systems where the sinc functions is used as a basic pulse so that only the Nyquist bandwidth is required for the channel. In order for these systems to be tolerant to the timing jitter in the receiver, the eye pattern should be open horizontally. It is proved that an eye opening condition which has been understood only as a sufficiency becomes a necessity as well. As its result, having a spectral null at teh Nyquist frequency is shown to have the same meaning as eye opening.

• The Journal of Engineering Geology
• /
• v.3 no.2
• /
• pp.167-176
• /
• 1993

The high resolution studies for shallow seismic reflection are carried out using 24-channel seismograph and the high sensitivity geophone(50-500Hz). In order to study the underground structures such as small faults, fractures, cracks and cavities, it is of great importance to enhance high resolution of the seisrnic records for the targets vertically and laterally. In analysis of high resolution seismic reflection, Nyquist frequency($F_N$) should be lager than the highest frequency in the records and the highest wave number should not be exceed the Nyquist wave number($1/2{\Delta}x$). The highest frequency above the Nyquist will be removed using low pass filter or antialias filter. The trace interval Ax should be taken into account so that the highest wave number(f/v) can be less than $1/2{\Delta}x$. The Fraunhofer diffraction of a hyperbola seismic section above the tunnel appeares on the common offset method, and little first arrivals of direct wave on the single-end shooting, delayed strong impulsive reflections are also shown above the tunnel. Ray Method(Cherveney and Psencik, 1983) also represents the same results that the reflected waves from the tunnel are delayed and single impulsive with little first arrivals, while transrnitted waves through the tunnel are delayed with low frequency.

• Nuclear Engineering and Technology
• /
• v.22 no.4
• /
• pp.371-379
• /
• 1990

The Xenon spatial oscillation may give rise to operational difficulties in a nuclear power plant. In this study, in order to investigate the Xenon instability for a PWR, the frequency-domain technique is adopted by using Generalized Nyquist Criterion, which is more general and suitable for the multi-input/multi-output system. Also linearized modal fluxes are obtained by a modal expansion. This model has been implemented to test the axial Xenon stability of YGN-1 unit against the changes in plant operating parameters ; power level, control rod position, and core average burnup. The results show that the increase of power level and the deeper insertion of control rod have the destabilizing effect, and that the burnup progress makes the core less stable. Also the results show that the overestimation due to modal interaction was found not to be significant.

• Journal of Communications and Networks
• /
• v.5 no.4
• /
• pp.319-327
• /
• 2003

We consider the problem of low-sampling rate high-resolution channel estimation and timing for digital ultrawideband (UWB) receivers. We extend some of our recent results in sampling of certain classes of parametric non-bandlimited signals and develop a frequency domain method for channel estimation and synchronization in ultra-wideband systems, which uses sub-Nyquist uniform sampling and well-studied computational procedures. In particular, the proposed method can be used for identification of more realistic channel models, where different propagation paths undergo different frequency-selective fading. Moreover, we show that it is possible to obtain high-resolution estimates of all relevant channel parameters by sampling a received signal below the traditional Nyquist rate. Our approach leads to faster acquisition compared to current digital solutions, allows for slower A/D converters, and potentially reduces power consumption of digital UWB receivers significantly.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.619-620
• /
• 2006

This paper presents a design of a 6-bit 2.704Gsamples/s D/A converter (DAC) for DS-CDMA UWB transceivers. The proposed DAC was designed with a current steering segmented 4+2 architecture for high frequency sampling rate. For low glitches, optimized deglitch circuit is adopted for the selection of current sources. The measured integral nonlinearity (INL) is -0.081 LSB and the measured differential nonlinearity (DNL) is -0.065 LSB. The DAC implemented in a 0.13um CMOS technology shows s spurious free dynamic range (SFDR) of 50dB from dc to Nyquist frequency. The prototype DAC consumes 28mW for a Nyquist sinusoidal output signal at a 2.704Gsamples/s. The chip has an active area of $0.76mm^2$.

• Korean Journal of Optics and Photonics
• /
• v.8 no.3
• /
• pp.175-182
• /
• 1997

To design a high resolution three-mirror telescope for visible spectral region, initial design technique based on the generation of flat field anastigmatic solutions limited by mechanical structure was proposed. An initial design of the three-mirror telescope that features relatively high focal ratio(F/14.5), large aperture diameter(600 mm), and squared field of view(0.27$^{\circ}$$\times$1.3$^{\circ}$) was done using an initial design program. Code V was used to optimized the initially designed optical system. As a result, MTF value of the telescope was about 0.5 at Nyquist frequency in each field except for the edge of the CCD.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.10
• /
• pp.1074-1080
• /
• 1992

A(5,8) block binary line code is proposed. The new line code called MB58 has the properties of being dc-free and runlength-limited, and it is strictly bandwidth-limited to the Nyquist frequency, such that bandwidth efficiency is improved. This new code is a memoryless code with a simple decoding rule and capability of error monitoring. The power spectrum and the eye pattern of the new code are obtained by simulation, wherein spectral nulls at DC(f=0) and Nyquist frequency (f=1/2Ts) are clearly identified.

• Journal of Biomedical Engineering Research
• /
• v.20 no.3
• /
• pp.275-281
• /
• 1999

Conventional PW Doppler systems suffer from the ambiguity of measured blood velocities due to the spectrum aliasing when the corresponding Doppler frequencies are greater than the Nyquist frequency. Base-line shift is a customary method for dealiasing the Doppler spectrums. I lowever, Doppler audio signals still remain unchanged even when the base-line shift method is applied. This paper de scribes an method for dealiasing both the Doppler spectra and audio signals by using sampling rate expansion, frequency shifting, and filtering poerations. For undirectional flows, the method can increase the maximum detectable Doppler frequency from the Nyquist limit of one-half of the Pulse Repetition Frequency(PRF) to the PRF. Experiments with real data have been performed to verify the proposed method.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.32 no.2
• /
• pp.122-128
• /
• 2019

Porcelain insulators have been used mainly for power line fixing and electrical insulation in transmission towers. Porcelain insulators have generally a 30 years desired life, but over 50% exceed their life expectancy. Since the damage to porcelain insulators is usually accompanied by enormous loss of human resource material, their efficient maintenance has emerged as an important issue. In this regard, this study applied a frequency response function (FRF) for integrity assessment of the insulator. The characteristics of the FRF according to damage types were identified and analyzed by the change in natural frequencies, curve shape, attenuation, and Nyquist diagram stability. The results showed significant differences in the FRF according to damage types, which can be used as basic data for the effective integrity assessment of porcelain insulators.