• Current Photovoltaic Research
• /
• v.2 no.3
• /
• pp.115-119
• /
• 2014

$Cu(In,Ga)Se_2$ (CIGS) thin films have been used as a light absorbing layer in high-efficiency solar cells. In order to improve the quality of the CIGS thin film, often selenization step is applied. Especially when the thin film was formed by non-vacuum powder process, selenization can help to induce grain growth of powder and densification of the thin film. However, selenization is not trivial. It requires either the use of toxic gas, $H_2Se$, or expensive equipment which raises the overall manufacturing cost. Herein, we would like to deliver a new, simple method for selenization. In this method, instead of using a costly two-zone furnace, use of a regular tube furnace is required and selenium is supplied by a mixture of selenium and ceramic powder such as alumina. By adjusting the ratio of selenium vs. alumina powder, selenium vaporization can be carefully controlled. Under the optimized condition, steady supply of selenium vapor was possible which was evidently shown by large grain growth of CIGS within a thin powder layer.

• Korean Journal of Materials Research
• /
• v.31 no.11
• /
• pp.619-625
• /
• 2021

Cu₂ZnSn(S,Se)₄ (CZTSSe) based thin-film solar cells have attracted growing attention because of their earth-abundant and non-toxic elements. However, because of their large open-circuit voltage (V_oc)-deficit, CZTSSe solar cells exhibit poor device performance compared to well-established Cu(In,Ga)(S,Se)₂ (CIGS) and CdTe based solar cells. One of the main causes of this large V_oc-deficit is poor absorber properties for example, high band tailing properties, defects, secondary phases, carrier recombination, etc. In particular, the fabrication of absorbers using physical methods results in poor surface morphology, such as pin-holes and voids. To overcome this problem and form large and homogeneous CZTSSe grains, CZTSSe based absorber layers are prepared by a sputtering technique with different RTA conditions. The temperature is varied from 510 ℃ to 540 ℃ during the rapid thermal annealing (RTA) process. Further, CZTSSe thin films are examined with X-ray diffraction, X-ray fluorescence, Raman spectroscopy, IPCE, Energy dispersive spectroscopy and Scanning electron microscopy techniques. The present work shows that Cu-based secondary phase formation can be suppressed in the CZTSSe absorber layer at an optimum RTA condition.

• Ecology and Resilient Infrastructure
• /
• v.6 no.4
• /
• pp.227-235
• /
• 2019

This study monitored Daecheong 1-bo, Daecheong-stream, which carried out the project in 2014, from 2015 to 2016. The technology applied to the stream was evaluated using Periphytic Algae to check contamination indicators and ecological health of the area with an integral river-bed protection using non-toxic materials. The water quality of the monitoring section was confirmed to be above the river environment standard (II), and it was confirmed that the Saproxenic taxa of the river bed protection were higher than the upper and downstream sections. The TDI, which is an index of attachment algae, was shown in the average 51.03 and 52.15 for the pilot project sections in 2015 and 2016, confirming that the index is of the "normal" grade. This is the other sections in the upstream and downstream sections showed higher than "bad", which is thought to have a positive effect on the habitat of the river ecosystem components, especially the microbial population in river bed protection.

• Journal of the Korean Ceramic Society
• /
• v.43 no.2 s.285
• /
• pp.136-141
• /
• 2006

The stabilizing behavior of heavy metals in the silicate glass containing Electric Arc Furnace dust (EAF dust) were studied by the Toxic Characterization Leaching Procedure (TCLP) test, and the change of crystalline phase and glass network structure were investigated as a function of EAF dust content added. The glass containing EAF dust of $30\;wt\%$ an oxygen/network former ratio(R) of $2\~3$ allowing a fairly stable network structure thus showed much lower heavy metal leaching concentration than that for containing EAF dust above $50\;wt\%$ at TCLP test. For the glass containing EAF dust $50\~60\;wt\%$, however, the R was over 3, which weakened the glass network structure and increased the heavy metals leachate. Adding the EAF dust to a glass decreased the degree of Si-O-Si symmetry and increased the number of non-bridging oxygen, which decreased the chemical durability of glasses. When the dust content in a glass was over $70\;wt\%$, the Zn and Fe ions reacted to form the spinel crystal rather than to bind to network structure of glass and leaching concentration of those ions from the specimen decreased, so the spinel phase could be attributed to lowering a heavy metal leaching.

• Biomedical Science Letters
• /
• v.10 no.2
• /
• pp.85-92
• /
• 2004

Immortalization of primary corneal cells has influence on pharmacy, medical and biological fields. Especially, investigation of immortalization mechanism using viral oncoproteins is useful for medical treatments, and these cell lines will be useful materials for toxic test of medical supplies and cell biological experiments. Rabbit corneal fibroblasts in culture undergo a finite number of divisions before they reach a terminally non-proliferating state known as replicative senescence. Therefore, we attempted to induce immortalization of rabbit corneal fibroblasts with SV 40 large T antigen. As a result of experiment, expression of SV 40 large T antigen was confirmed, and expression of proteins related to cell cycle repressor was decreased in the transfection group compared with non-transfection group. According to the results of cell cycle phase distribution test, SV 40 large T antigen-transfected cells had obtained higher proliferation rate than primary cells. It was confirmed that during induction of immortalization, SV 40 large T antigen was not able to increase telomerase activity. In conclusion, we made a rabbit corneal fibroblast cell line with SV40 large T antigen. This cell line will be useful for further studies of mammalian fibroblast biology, particularly with regard to angiogenesis and malignant transformation. In addition, this cell line offers opportunity for testing potential therapeutics and can be used for toxicity tests of materials or cosmetics. In the future, our cell line can potentially be utilized in a wide range of biology related fields.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.28 no.2
• /
• pp.292-302
• /
• 2004

The purpose of this study was to evaluate thermal properties of lab gowns developed from the point of safety and work efficiency. We evaluated thermal and subjective responses of subjects wearing functional new lab gowns (Type B, C, D) and a popular lab gown on the market (Type A). Type B was a new lab gown made of woven fabric with functional cuffs. Type C was a new apron made of woven fabric with arm protectors. Type D was a new lab gown made of non-woven material with functional cuffs and openings around the armpits. Temperature in the climatic chamber was set at 19$^{\circ}$C as an indoor temperature in winter and at 24$^{\circ}$C in summer. There were no significant differences in rectal temperature and heart rate among four types of gowns and between two air temperatures for 120 min. Mean skin temperature was much higher in the type A and B than in He type C and D (p .05). In the 19$^{\circ}$C air, clothing microclimate temperature on the back was the highest in the type B and was the lowest in the type C (p .05). Clothing microclimate humidity was not significant differences among gowns. In subjective .esponses, subjects perceived that Type B was the warmest gown in the 19$^{\circ}$C and the hottest and more humid in the 24$^{\circ}$C than other gowns. Inversely, type C was the coolest gown among four gowns. Both in the 19$^{\circ}$C and in the 24$^{\circ}$C, the Type D had gained most responses of being comfortable. In conclusion, the temperature difference of 5$^{\circ}$C was more of an influencing factor than the difference from four types of lab gowns. Secondly, we recommend the manufacturers to make lab gowns with functional cuffs for safety purposes. Thirdly, the spread of the type of apron with arm protector will contribute to increase of the frequency of wearing in summer. Fourthly, it is necessary to study continuously about lab gowns with non-woven materials for researchers exposed to toxic chemical and biological materials.

• Journal of The Korean Society of Clinical Toxicology
• /
• v.18 no.2
• /
• pp.94-101
• /
• 2020

Purpose: This study examined the clinical and epidemiological characteristics of intensive care unit (ICU) patients admitted or died in the emergency medical center with acute-poisoning to investigate the variables related to the prognosis. Methods: The data were collected from poisoning patients admitted or died in the emergency medical center of a general hospital located in Seoul, from January 2014 to February 2020. The subjects of this study were 190 patients. The medical records were screened retrospectively, and the clinical and epidemiological characteristics of the patients in the emergency room (ER) and ICU were examined to investigate the contributing factors that influence the poor prognosis. Results: The study analyzed 182 patients who survived after being admitted to the intensive care unit (ICU). The results are as follows. The mental change (87.4%) was the most common symptom. Sedative poisoning (49.5%) was the commonest cause. For most patients, pneumonia (26.9%) was the most common complication. Hypotension (23.7%), tachycardia (42.1%), fever (15.8%), seizures (10.5%), dyspnea (2.6%), high poisoning severity score (PSS), type of toxic material, mechanical ventilator application (39.5%), inotropes application (39.5%), and pneumonia (55.3%) were correlated the LOS over 5 days in the ICU. 8 patients died. In the case of death pesticides and carbon monoxide were the main toxic materials; tachycardia, bradycardia, and hypotension were the main symptoms, and a mechanical ventilator and inotropes were applied. Conclusion: Patients with unstable vital signs, high PSS, and non-pharmaceutical poisoning had a prolonged LOS in the ICU and a poor prognosis.

• Journal of The Korean Society of Clinical Toxicology
• /
• v.14 no.1
• /
• pp.16-25
• /
• 2016

Purpose: Patients suffering from acute poisoning by different substances often visit the emergency department (ED) and receive various prognoses according to the toxic material and patients' condition. Hyperlactatemia, which is an increased blood lactate level that generally indicates tissue hypoperfusion, is commonly utilized as a prognostic marker in critically ill patients such as those with sepsis. This study was conducted to investigate the relationships between blood lactate and clinical prognosis in acute poisoned patients. Methods: This retrospective study was conducted from January 2013 to June 2014 at a single and regional-tertiary ED. We enrolled study patients who were examined for blood test with lactate among acute intoxicated patients. The toxic materials, patient demographics, laboratory data, and mortalities were also reviewed. Additionally, we analyzed variables including blood lactate to verify the correlation with patient mortality. Results: A total of 531 patients were enrolled, including 24 (4.5%) non-survivors. Patient age, Glasgow coma scale (GCS), serum creatinine (Cr), aspartate transaminase (AST), and serum lactate differed significantly between survivors and non-survivors in the binary logistic regression analysis. Among these variables, GCS, AST, and lactate differed significantly. The median serum lactate levels were 2.0 mmol/L among survivors and 6.9 mmol/L among non-survivors. The AUC with the ROC curve and odds ratio of the initial serum lactate were 0.881 and 3.06 (0.89-8.64), respectively. Conclusion: Serum lactate was correlated with fatalities of acute poisoning patients in the ED; therefore, it may be used as a clinical predictor to anticipate their prognoses.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.5
• /
• pp.1741-1747
• /
• 2012

Water-dispersible ZnS:Mn nanocrystals were synthesized by capping the surface of the nanocrystals with conventional aminoacids ligands: serine and threonine. The aminoacids capped ZnS:Mn nanocrystal powders were characterized by XRD, HR-TEM, EDXS, ICP-AES and FT-IR spectroscopy. The optical properties were also measured by UV/Vis and solution photoluminescence (PL) spectroscopies in aqueous solvents. The solution PL spectra showed broad emission peaks around 600 nm with PL efficiencies of 9.7% (ZnS:Mn-Ser) and 15.4% (ZnS:Mn-Thr) respectively. The measured particle sizes for the aminoacid capped ZnS:Mn nanocrystals by HR-TEM images were about 3.0-4.0 nm, which were also supported by Debye-Scherrer calculations. In addition, cytotoxic effects of four aminoacids capped ZnS:Mn nanocrsystals over the growth of wild type E. coli were investigated. Although toxicity in the form of growth inhibition was observed with all the aminoacids capped ZnS:Mn nanocrystals at higher dose (1 mg/mL), ZnS:Mn-Met and ZnS:Mn-Thr appeared non-toxic at doses less than 100 ${\mu}g$/mL. Low biological toxicities were seen at doses less than 10 ${\mu}g$/ mL for all nanocrystals.

• Current Photovoltaic Research
• /
• v.3 no.3
• /
• pp.75-79
• /
• 2015

Recently, $Cu_2ZnSn(S_xSe_{1-x})_4$ (CZTSSe) has been received a tremendous attraction as light absorber material in thin film solar cells (TFSCs), because of its earth abundance, inexpensive and non-toxic constituents and versatile material characteristics. Kesterite CZTSSe thin films were synthesized by sulfo-selenization of sputtered Cu/Sn/Zn stacked metallic precursors. The sulfo-selenization of Cu/Sn/Zn stacked metallic precursor thin films has been carried out in a graphite box using rapid thermal annealing (RTA) technique. Annealing process was done under sulfur and selenium vapor pressure using Ar gas at $520^{\circ}C$ for 10 min. The effect of tuning Se/(S+Se) precursor composition ratio on the properties of CZTSSe films has been investigated. The XRD, Raman, FE-SEM and XRF results indicate that the properties of sulfo-selenized CZTSSe thin films strongly depends on the Se/(S+Se) composition ratio. In particular, the CZTSSe TFSCs with Se/(S+Se) = 0.37 exhibits the best power conversion efficiency of 4.83% with $V_{oc}$ of 467 mV, $J_{sc}$ of $18.962mA/cm^2$ and FF of 54%. The systematic changes observed with increasing Se/(S+Se) ratio have been discussed in detail.